114 resultados para Hydatidiform mole


Relevância:

10.00% 10.00%

Publicador:

Resumo:

Introduction: The radiographic characteristics of a biomaterial, such as its density, may influence the evaluation of the results obtained following its clinical use. Objective: The aim of this study was to evaluate the radiographic density of biomaterials used as bone substitutes, inserted into dental sockets and bone defects in created in the jaws of pigs. The influence of a soft tissue simulator on the results was also evaluated. Material and method: Two and three-millimeter-deep bone defects were created in the pigs mandible and the right first molar extraction socket were used. Commercial samples of five biomaterials were tested: Hydroxyapatite, Lyophilized Bovine Bone, 45S5 bioglass (generic), PerioGlass and β-Tri-Calcium Phosphate, and compared to a positive (mandibular bone) and negative (empty alveolar bone defects) controls. Radiographic images were acquired with and without a 10 mm thick soft-tissue simulator. Result: The results for the extraction sockets showed no differences between the biomaterials and the negative control. For the bone defects, the depth of the defect density influenced the density, both in the negative control (p < 0.01) and biomaterials (p < 0.05) groups. The soft- tissue simulator did not alter the results. Conclusion: The type of the evaluated defect can interfere in the radiographic features presented by each biomaterial, while the simulation of soft tissues was not statistically significant.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Osteodistraction is a clinical reality, available in the last decades for the resolution of large bone deficiencies, in cases that there are pre-existing, but misplaced implants and teeth. The aims of thearticle is to present a case report in which a new possibility for bone distraction, based on tooth-implant bone distractors, made from standard orthodontic expansion-screws, was used in an area where there was an extensive need of alveolar bone and aesthetical recovery, allied to teeth and dental implant misplacement. This technique presented good clinical results, associated to effective simplicity and low cost, becoming viable clinical solution for bone tissue augmentation and aesthetical optimization. In resume, it is possible to say that the suggested technique achieved its objectives, improving the hard and soft tissue profile, whilst allowing completion of oral rehabilitation.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

As fraturas de rádio e ulna em animais de companhia são ocorrências ortopédicas de grande incidência em Medicina Veterinária. Cães de pequeno porte parecem ter uma maior incidência de fraturas em terço distal do rádio e ulna. A consolidação de ossos fraturados baseia-se na redução anatômica ou na aproximação dos maiores fragmentos. Para haver uma correta cicatrização óssea, os implantes ortopédicos devem anular todas as forças atuantes no foco de fratura. O tratamento dessas fraturas é descrito como difícil, em porte do tipo toy e miniatura. A ocorrência da não consolidação óssea é alta chegando a 60% dos casos estudados. Alguns fatores identificados afetam a osteossíntese em cães de raças de pequeno porte, pois são inerentes à instabilidade biomecânica, como, o mínimo contato da superfície do osso após a redução, devido ao pequeno diâmetro existente, diminuição da cobertura de tecido mole, formação constante de cartilagem no foco da fratura, e diminuição da densidade vascular na junção diáfise-metafisária distal em comparação com cães de raças de grande porte. O objetivo da presente revisão sistemática foi avaliar o melhor método de tratamento para fraturas distais de rádio e/ou ulna em cães de raças de pequeno porte. Como metodologia foram utilizados 14 artigos científicos, sendo 11 internacionais e quatro nacionais. A aplicação de placas, nesse estudo sistemático, foi considerado o método mais eficaz para fixação de fraturas distais de rádio e ulna em cães de pequeno porte

Relevância:

10.00% 10.00%

Publicador:

Resumo:

O Brasil ocupa uma posição de destaque como produtor e exportador de carne de frango. Um parâmetro importante na qualidade da carne de frango é a quantidade de água absorvida pela carcaça durante o processamento. No Brasil, o resfriamento das carcaças é feito por imersão em água refrigerada e, neste processo, a carcaça é reidratada, recuperando a água perdida durante o transporte e as operações iniciais. Este projeto teve como objetivo avaliar os fatores extrínsecos que podem influenciar a absorção de água pela carne de frango. Para isso, foram utilizados 144 frangos da linhagem Cobb, divididos em 24 grupos de seis aves. Aos 42 dias de idade, uma ave de cada grupo, com peso variando até 10% para mais ou para menos, em relação à média do grupo, foram abatidas em abatedouro experimental. A etapa de resfriamento foi realizada seguindo um delineamento inteiramente casualizado com arranjo fatorial 3x2, onde os fatores foram: três temperaturas na primeira seção do sistema de refrigeração (4, 10 e 16 º C) e dois graus de dureza da água (água dura e água mole), com seis tratamentos e quatro repetições. A legislação brasileira estabelece que a temperatura da água na primeira seção do resfriador não deve ser superior a 16ºC. Todas as carcaças permaneceram na primeira seção do resfriador durante 30 minutos e, em seguida, foram transferidas para outro tanque com água a 4ºC, permanecendo até atingir 7ºC. As carcaças foram pesadas antes e após o resfriamento por imersão, para avaliação da percentagem de água absorvida. A absorção de água foi influenciada pela temperatura inicial da água no pré-resfriador e pela dureza da água. Quando imersas inicialmente em água a 4ºC, as carcaças absorveram, em média, 2,70%, uma absorção significativamente menor do que a média de 3,83% observada nas carcaças que foram inicialmente imersas em água a 16ºC (p<0,05). As carcaças imersas em água a 10ºC apresentaram média de absorção de água de 3,66%, não diferindo das médias observadas nos outros tratamentos (p>0,05). Em água dura, a média de absorção de água foi de 2,46% e, em água mole, de 4,33% (p<0,05). Em todos os tratamentos, a absorção de água não excedeu o limite estabelecido pela legislação brasileira, que é de, no máximo, 8%. Esta informação é importante para controlar a absorção de água pelas carcaças em processamento de carne de frango, impedindo que os consumidores sejam prejudicados.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Soft tissue recessions frequently cause esthetic disharmony and dissatisfaction. The results of coverage in peri-implant sites, in comparison with soft tissue coverage around a tooth, is less predictable. This clinical report describes the correction of an esthetic problem with a single-tooth implant-supported using a subepithelial connective tissue graft (SCTG) combined with the re-establishment of a new limit of gingival margin, and emergence crown profile. After anamnese and clinical exam it was observed an implant in the region of tooth 22 in vestibular position to alveolar ridge with a recession of 5 mm in its vestibular face. In the first cirurgical procedure the crown and the abutment were removed and a SCTG associated with a coronally positioned flap was performed in order to re-establish the limit of gingival margin. After 90 days, it was observed that the tissue in the implant site showed no adequate volume or thickness. Because of that, another SCTG was performed. The reopening procedure to install the healing cap was performed after 4 weeks. Then the prosthesis was installed. At 180 and 360 days postoperative, the implant adjacent tissue presented regular contour, color compatible with health and absence of bleeding. The patient was satisfied with the esthetic result. According to the clinical results and favorable esthetics it was possible to conclude that the use of ETC to correct an esthetic deficiency may be a feasible approach to establish new and stable peri-implant soft tissue contours.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Zirconia abutments are used to obtain satisfactory aesthetic results in implant fixed anterior prostheses when metal abutments promote a grayish mucosal discoloration of the peri-implant soft tissues. However, there is a lack of studies to confirm the clinical performance of the peri-implant soft tissues surrouding zirconia abutments. This study described a case report of a patient treated with implant fixed all-ceramic crown made out on zirconia abutment after 3 years of followup. A 47-year-old female patient was admitted to the dental clinic (Aracatuba Dental School) complaining about the fracture of her implant fixed single crown in the region of the left lateral incisor. The patient chose the replacement of the fractured prosthesis for an allceramic crown. After 3 years of follow-up it was observed that maintenance of the aesthetic results and the peri-implant soft tissue without any inflammation or gingival recessions. Within the limitations of a case report, it can be conclude that zirconia abutments is a effective rehabilitation treatment because it preserves the aesthetics and function through the maintenance of peri-implant tissues.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

The study of antioxidant has a great interest to biochemistry and medicine, due to of used in the human body as inhibitor to free radical process, which can cause premature aging and degenerative diseases. Furthermore, antioxidant is widely used in food industry that i s used to prevent food deterioration, in fats and oils (autoxidation, known as rancidity). Thereby, the survey data labels of vegetable oils such as soybean one, corn one and sunflower one, it is very important, with this survey data label was possible to verify the antioxidants used on vegetable oils and describe their chemical structure, molecular formula, lethal dose and daily dose by review. Following this review, it was possible to create a website with in formation and description of antioxidants. This database has free access to the public, in order to help the population about these chemicals compounds, and help them to choose the more beneficial food to eat

Relevância:

10.00% 10.00%

Publicador:

Resumo:

The objective of this work was to evaluate the effect of processing two corn hybrids conserved, dry and humid grains, the dry matter (DM) and crude protein (CP) degradability in situ. The particle size was determined and difference was verified in MGD (Medium Geometric Diameter) of processed ingredients. Three sheep were used with rumen canulated, in a completely randomized design, using a factorial outline 2 x 2 x 3, being two corn hybrid, two conservation methods and three processing forms (whole, coarsely and finely ground), with five times of incubation (3, 6, 12, 24 and 48 hours). The fraction A in SDC (silage of dent corn) of DM was superior to GDC (grain of dent corn) in all of the particles size. The ensiling process increased the DM solubility, reducing the fraction B in comparison to dry grain. The values regarding the fractions DP and DE the 5% per hour of the protein, were larger for SDC and GDC, it presents a decreasing when the incubation time advances. The fermentation rate was superior for SDC and GDC. The ensiling process has positive effect in the decreasing of DM and CP in comparison to GDC.