Effect of fruit maturation stage and light on seed germination of Aiphanes aculeata

Despite their spiny nature, Aiphanes palms are popular as ornamentals. They can be grown in various soil conditions, but achieve fast, luxuriant growth in sheltered positions with plenty of water. Shaded conditions are the best when plants are young. The objective of this study was to evaluate the effect of fruit maturation stage and light on the germination of seeds of A. aculeata. Fruits were collected at three different maturation stages: (1) yellow, (2) red, (3) collected on the ground without the fleshy mesocarp (removed by birds and insects). The fleshy mesocarp was also removed in treatments (1) and (2). All fruits were then treated with thiram and 25 seeds per plot were seeded in trays full of sand. The treatments (2) and (3) were subdivided in two other treatments: (a) 12 h photoperiod, (b) continuous darkness. The temperature was maintained at 30 degrees C. Seed germination began 34 days after sowing. After 160 days, the final germination percentage was (1) 54,67%, (2a) 61,33%, (2b) 65,33%, (3a) 38,00% and (3b) 45,33%. The best treatment was (2) independently of the light conditions.

The effect of hetero- and homosexual experience and long-term treatment with fluoxetine on homosexual behavior in male rats

Introduction the selective serotonin reuptake inhibitors have become the most frequently prescribed drugs for the treatment of depression. Sexual side effects have been noted to occur with this treatment on heterosexual behavior in rats. Heterosexual experience facilitates sexual orientation of male rats and decreases the latencies to first mount and first intromission. on the other hand, homosexual behavior in male rats induced by female hormones has not been evaluated.Aim the objective of this work is to evaluate the effects of heterosexual and homosexual experience in male rats long-term treated with fluoxetine (FLX) on homosexual hormone-induced behavior.Materials and Methods Male rats were treated with FLX or saline solution (10 mg/kg for 65 days). At days 36, 50, and 65 of the treatment, the rats were evaluated for homosexual behavior. Other rats treated with FLX or saline solution for 60 consecutive days were submitted to heterosexual behavior at 14, 21, and 28 days of the treatment. After this, they were orquiectomized and homosexual hormone-induced behavior was observed at 45 and 60 days of the treatment.Results (1) Only treatment with FLX did not affect the homosexual behavior. (2) the homosexual experience facilitated the homosexual behavior mainly on the animals from the control group. (3) the heterosexual experience facilitated the homosexual behavior on both groups.Conclusions Only long-term administration of FLX does not interfere with the homosexual behavior in male rats. The homosexual and the heterosexual experience facilitated the homosexual behavior on the control and experimental groups. We suggested that learning aspects related to sexual behavior are responsible by these results.

Effect of chronic treatment with Clomipramine on food intake, macronutrient selection and body weight gain in rats

Long-term treatment with clomipramine (CMI), a tricyclic antidepressant, induces food craving and body weight gain in patients. The present study investigated the effects of chronic treatment with CMI on total food intake, macronutrient selection, and body weight gain in rats. Male Wistar rats were maintained on a dietary self-selection regime with separate sources of protein, fat and carbohydrate. Animals received i.p. injections of CMI (0, 3, 10, 30 mg/kg) during 27 consecutive days. Food consumption and body weight were recorded daily and results were calculated as average of three consecutive days, namely during pre-treatment (3 d before pharmacological treatment), treatment (7th-9th; l6th-l8th and 25th-27th days), and post-treatment (28th-33rd days). Results showed that CMI (30 mg/kg) significantly decreased energy intake during all treatment period, an effect that was related to a decrease in both carbohydrate-rich diet intake and body weight gain. At dose of 3 mg/kg CMI increased the total energy intake in the 16th-18th days, suggesting an apparent biphasic effect of chronic treatment with CMI on caloric intake. Chronic administration with CMI (27 d) did not alter protein-rich or fat-rich diet consumption. The main result of this study indicated that chronic treatment with CMI decreases rather than increase food consumption and body weight gain in rats exposed to a macronutrient self-selection procedure.

The effect of ceramic surface treatment on bonding to densely sintered alumina ceramic

Statement of problem. Ceramic surface treatment is crucial for bonding to resin. High crystalline ceramics are poorly conditioned using traditional procedures.Purpose. The purpose of this study was to evaluate the effect of silica coating on a densely sintered alumina ceramic relative to its bond strength to composite, using a resin luting agent.Material and methods. Blocks (6 X 6 X 5 mm) of ceramic and composite were made. The ceramic (Procera AllCeram) surfaces were polished, and the blocks were divided into 3 groups (n = 5): SB, airborne-particle abrasion with 110-mu m Al(2)O(3); RS, silica coating using Rocatec System; and CS, silica coating using CoJet System. The treated ceramic blocks were luted to the composite (W3D Master) blocks using a resin luting agent (Panavia F). Specimens were stored in distilled water at 37 degrees C for 7 days and then Cut in 2 axes, x and y, to obtain specimens with a bonding area of approximately 0.6 mm(2) (n = 30). The specimens were loaded to failure in tension in a universal testing machine, and data were statistically analyzed using a randomized complete block design analysis of variance and Tukey's test (alpha=.05). Fractured surfaces were examined using light microscopy and scanning electron microscopy to determine the type of failure. Energy-dispersive spectroscopy was used for surface compositional analysis.Results. Mean bond strength values (MPa) of Groups RS (17.1 +/- 3.9) (P = .00015) and CS (18.5 +/- 4.7) (P=.00012) were significantly higher than the values of Group SB (12.7 +/- 2.6). There was no statistical difference between Groups RS and CS. All failures occurred at the adhesive zone.Conclusion. Tribochemical silica coating systems increased the tensile bond strength values between Panavia F and Procera AllCeram ceramic.

Effect of thermal treatment temperature on the crystallinity and morphology of LiTaO3 thin films prepared from polymeric precursor method

Lithium tantalate thin films (LiTaO3) with (50:50) stoichiometry were prepared by spin coating method using a polymeric organic solution. The films were deposited on silicon (100) substrates with 4 layers. The substrates were previously cleaned and then the solution of lithium tantalate was deposited by adjusting the speed at 5000 rpm. The thin films deposited were thermally treated from 350 to 600degreesC for 3 hours in order to study the influence of the thermal treatment temperature on the crystallinity, microstructure, grain size and roughness of the final film. X-ray diffraction (XRD) results showed that the films are polycrystalline and secondary phases free. The thickness of films was observed by scanning electron microscopy (SEM). The atomic force microscopy (AFM) studies showed that the grain size and roughness are strongly influenced by thermal treatment.

EFFECT OF TREATMENT WITH GROWTH-REGULATORS AND SCARIFICATION ON THE TOLERANCE TO WATER-STRESS IN SEEDS OF ORYZA-SATIVA LCVIAC-165

The effect of treatment of seeds of Oryza sativa L. cv. IAC 165 with gibberellic acid, 6-benzyladenine and ethrel on the tolerance to the water stress were analysed. Gibberellic acid had no effect and 6-benzyladenine and ethrel promoted slight increase in the tolerance to water stress, specially in darkness. After scarification, those growth regulator presented no effect. Our results suggest that 6-benzyladenine and ethrel promoted water stress tolerance due to the decrease in the resistance of the seed coat to embryo expansion.

The effect of drying and urea treatment on nutritional and anti-nutritional components of browses collected during wet and dry seasons

Fibre, crude protein and tannin concentrations were measured in browse species from the semi-arid region of Northeast Brazil during the dry and wet seasons. The effects of oven-, sun- and shade-drying and of urea treatment were also determined. Crude protein (CP) content varied from 103 to 161 g/kg dry matter (DM) and the browses had similar CP content in the two seasons (during 2002) (102-161 and 107-153 g/kg DM in the wet and dry seasons, respectively). Total tannin concentrations ranged from 13 to 201 g/kg DM amongst the browses and were higher in the dry season. A 30-d treatment with urea reduced extractable tannins significantly (P < 0.05). The urea treatment was also most effective at reducing the in vitro effects of tannins compared to the other drying treatments. This was demonstrated by measuring the effect of polyethylene glycol (PEG) on gas production. Addition of PEG increased gas production of oven- (81.4%), sun- (78.5%) and shade-dried (76.7%) samples much more compared to urea treated samples (10.9%). (c) 2005 Elsevier B.V. All rights reserved.

Effect of foliar and substrate fertilization on lady palm seedling growth and development

Lady palm, [Rhapis excelsa (Thunberg) Henry ex. Rehder] is one of the most cultivated ornamental palms in the world, for use as a vase plant or in shaded landscapes. Because limited information exists on lady palm response to fertilizers, the objective of this study was to evaluate the effect of different types of fertilization and substrates on lady palm seedling growth and development. Three year old lady palms were planted in 8-L pots, filled with a mix of soil, manure, and sand 1:1:1 (v:v:v), placed under a 50% shade, and irrigated with microspray. Treatments were substrate fertilization with 500 g P(2)O(5) and 100 g K(2)O per m(3); fertilization with 1.8 kg of P(2)O(5) (simple superphosphate) per m3; 50 g of nitrogen (N), P(2)O(5), and K(2)O of a granulated fertilizer (10:10:10) per m(3), control (without fertilization), and a foliar fertilization in addition to these treatments using the commercial product Biofert (8:9:9). Treatments were replicated four times in a randomized block design. Each treatment plot consisted of four plants. Data were collected at 140, 170, 200, 230, 260, and 290 days after transplanting (DAT) for plant heights, stem diameter at substrate level, number of leaves, shoots, and canopy, roots fresh and dry matter samples were harvest at 290 days. Foliar fertilization resulted in significantly greater plant height in a 140, 120, 200, and 230 DAT and plant diameter on the 140, 260, and 290 DAT. There was interaction among factors for number of leaves with fertilization based on P(2)O(5) and K(2)O when leaf fertilizer was added that resulted in a greater number of leaves.

Effect of surface treatment on fatigue behavior of metal/carbon fiber laminates

The tension-tension fatigue behavior of metal/fiber laminates (MFLs) has been investigated. These MFLs were produced with carbon fiber and by treating the aluminum foil to promote adhesion bonding by two methods: sulfuric-boric-oxalic acid anodization (SBOA) and chromic acid anodization (CAA). The surface treatments were evaluated by scanning electron microscopy (SEM) techniques and roughness measurements. It was observed that MFL specimens produced with SBOA treatments presents comparable mechanical results when compared with MFLs produced with CAA treatment. Microstructural observations of the fracture surfaces by SEM show hackle formation is the predominant damage mechanism.