Propriedades mecânicas de três fios de sutura no reparo do tendão do músculo flexor profundo do dedo de cães

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Sistemas de preparo de solos de cerrado: efeitos nas propriedades físicas e na cultura do milho

The purpose of this work was to assess the effects of soil preparation methods (with or without subsoiling) on physical properties of a cerrado soil cropped to corn during the, 1986/87 season, in the Selviria county (Mato Grosso do Sul, Brazil). Also, the objective of this was to check the changes in the soil (dark red latosol-Acrustox) caused by the preparation after nine years of cultivation in comparison with natural state. The experiment consisted of six soil preparation systems: conventional, superpreparation, reversed, revolving hoe, reduced and no-tillage. Along with these systems subsoiling was also tested. The reversed system showed the best com grain yield. Subsoiling only presented positive results in productivity with the no-tillage system. All the preparation system tested degraded the physical properties in comparison with the natural soil.

Estudo das propriedades de troca iônica e/ou adsorção da celulose e celuloses modificadas

In this work it was studied the capacity of cellulose and chemically modified celluloses (carboxymethylcellulose, cellulose phosphate and oxicellulose) to adsorb copper(II) cations of aqueous and non aqueous solutions. The influence of the principal physical chemical parameters on the adsorption process was examined using the batch adsorption method and copper(II) perchlorate solutions, the maximum adsorption capacity determined for adsorbents were as follows (mol.g(-1)): cellulose, 0.54 . 10(-5); carboxymethylcellulose, 1.28 . 10(-4); cellulose phosphate, 1.12 . 10(-4); oxicellulose, 0.38 . 10(-4).

Propriedades des fisicas dos Arenitos Caiua.

The Caiua Sandstones, sedimentary Cretaceous rocks, have a grain specific gravity nearly that of quartz, its main mineralogical component. The remaining properties, such as the apparent dry density, apparent and effective porosity, water absorption and saturation voids, present high values, but decrease with depth. -from English summary

Estudo das propriedades analgésicas da Achillea millefolium L. (Asteraceae)

This study was designed to separately evaluate the analgesic capacity of 15% tea from Achillea millefolium leaves and florid ends. Three different tests were performed. The animals were separated in 3 groups: group I (control) that received water, group II that received florid end tea, and group III that received leaf tea. The first test was the writhing test induced by intraperitoneal injection of acetic acid in male Swiss mice. The second test consisted of the measurement of tail flick reflex latency (TFRL) in male Wistar rats after receiving a painful thermal stimulus. The groups received the teas or water per os, prior to observation. In the third test, the Wistar rats were submitted to an approximately 1 cm long incision in their tails to test the effect of the teas on induced inflammatory pain. The results showed that the effect of the 15% leaf tea on the mice writhing and TFRL test were not statistically significant. The florid ends tea showed a significantly increase in number of writhes in mice and TFRL in rats after administration. With regard to the effect of the teas on inflammatory pain, ingestion of both preparations caused an increase in the force threshold necessary for the avoidance reflex, indicating antihyperalgesic action of both the leaf and florid ends 15% teas of Achillea millefolium.

Glifosato: Propriedades, toxicidade, usos e legislação

This paper supplies a compact revision on the herbicide glyphosate physic-chemistry characteristic mains, including toxicity and valid Brazilian legislation for its use.

Propriedades de contração na madeira juvenil e adulta de Pinus taeda L.

This paper had the objective of studying variability of radial, tangential, longitudinal and volumetric shrinkage between the juvenile and mature wood, from a 35 year-old Pinus taeda L., from Horto Florestal of Manduri at São Paulo State, Brazil. First of all the experimental program determinations were related to the juvenile wood, region of the transition and region of the mature wood, using anatomical analysis (length of the axial tracheids), according to ABNT and IAWA codes. Results had shown that the area of juvenile wood of this species occurs approximately until the 20th growth ring, being more representative until the 12th ring. The transition area of this wood occurs between the 12th and 20th growth ring. In the second part of the work the shrinkage of the juvenile and mature wood were evaluated. Values of the radial, tangential and volumetric shrinkage were smaller and more variable on the juvenile wood. The longitudinal shrinkage did not present significant differences between the two wood types; medium values were slightly inferior and very variable on juvenile wood related to mature wood.

Otimização das propriedades mecânicas por meio de modificações microestruturais em aços de baixo carbono

This paper discusses the formation of microstructures with different volume fractions, as an outcome of a specific heat treatment, with the following phases: ferrite, martensite, bainite and retained austenite. For the microstructure characterization it is developed a chemical etching that allows to distinguish the phases by optical microscopy. The evaluation of the mechanical properties is done based on the results of tensile and fatigue tests. The experimental results show that appropriate heat treatments can contribute to a significant improvement in the mechanical properties of the steel. In this process it is essential to control the fraction volume, morphology of the phases, and grain size.

Propriedades físicas e infiltração de água de um Latossolo Vermelho Amarelo (Oxisol) do noroeste do estado de São Paulo, Brasil, sob três condições de uso e manejo

This study presents the results obtained in a field experiment carried out at Glicério, Northwest of São Paulo state, Brazil, whose objective was to analyze changes of selected soil physical properties and water infiltration rates on a Yellow-Red Latosol, under three different management conditions. The experimental design was arranged as completely randomized split-block with twelve treatments, which corresponded to four depths (0-0.05 m; 0.05-0.10 m; 0.10-0.20 m and 0.20-0.40 m) and three conditions of soil use and management with four replications. The soil surface conditions were: conventional tillage (one disking with moulboard plus two levelling passes with harrow), nine months before starting filed experiences; recent conventional tillage (also one disking with moulboard plus two levelling passes with harrow) and native forest. The conventional tillage areas were cropped for about fifteen years with annual cultures. The considered soil general physical properties were: macroporosity, microporosity, total porosity, bulk density, soil moisture and penetration resistance and, in addition; soil water infiltration rates were also recorded. According to our results, differences on general soil physical properties and infiltration rates appeared when both tilled sub-treatments and native forest were compared. Both, plots recently prepared by conventional tillage and those prepared by tillage but left nine months in rest, presented a statistically significant decrease of constant (final) water infiltration rates of 92.72% and 91.91% when compared with native forest plots.

Variabilidade espacial das propriedades físicas e químicas do solo em áreas intensamente cultivadas

The spatial variability of physical and chemical properties of soil were evaluated to provide subsidies for management of the agricultural input. The chemical variables: P, organic matter (OM), K, Ca, Mg, pH, CEC and base saturation (BS); and physical variables: sand and clay were analysed. Soil samples were collected at two depths (0-0.2 and 0.6-0.8 m) located at irregular mesh of sampling in the region of Monte Alto, in a Yellow-Red Podzol (Alfissolo) (PVA), under different managements, resulting in 88 points in 1465 ha of total area; and at the region of Jaboticabal in a Red Latosol (LV) cultivated with sugarcane, resulting in 128 points in 2597 ha of total area. The chemical and physical soil properties studied showed spatial dependence, except CEC in 0.6-0.8 m layer for LV; Ca and clay at 0-0.2 m layer and P, OM, K, Mg, sand and clay in 0.6-0.8 m layer for PVA. The chemical and physical variables studied were adjusted to spherical and exponential models and some of them showed semivariogram without defined structure. The PVA showed low spatial continuity of chemical and physical properties, mainly in 0.6-0.8 m layer, which suffers less antropic influence. The LV soil showed more homogenous zones of fertility and granulometric composition.

Efeito de resíduos vegetais de milheto (Pennisetum americanum) e da calagem em algumas propriedades físicas e químicas de um nitossolo vermelho em sistema de semeadura direta

This work studied alterations of physical properties of a distroferric red nitosol due to millet (Pennisetum americanum) covering, with or without liming, in a no-tillage system during the agricultural years of 1999/2000 and 2000/2001, using soybean and corn as culture succession. 6m×10m plots, with and without millet as vegetal covering, received only one initial superficial application of limestone, 3.1 t ha-1 in the first half of each plot in order to obtain 70% base saturation (V), after the desiccation of the millet. Some physical properties as soil density, aggregate stability, > 2 mm aggregate proportion, macro and micro porosity were analyzed whereas the chemical analysis determined Ca and Mg macro nutrients, organic matter, soil pH and H+Al. Millet vegetal residues and surface liming did not alter soil density nor the average weight diameter (AWD), > 2 mm aggregate, soil macro porosity and organic matter content, twenty-four months after the no-tillage system implantation for studied experimental conditions. Soil micro porosity was significantly affected in layers deeper than 0.20 m, in treatment with millet and limestone. Calcium, magnesium and H + Al contents and the soil pH values suffered significant alterations in superficial layer, between 0-0.05 m.

Efeitos de parâmetros de extrusão nas propriedades físicas de produtos expandidos de inhame

Effect of extrusion parameters was studied on the expansion index, specific volume, water absorption index (WAI) and water solubility index (WSI) of expanded yam snacks. The central composite design was used to study the parameters effect. It was verified three levels of temperature in the barrel (100, 115 and 130°C), three levels of screw speed (163, 204 and 245 rpm) and three levels of flour moisture (12, 15 and 18%). The results showed that expansion properties (expansion index and specific volume) depend on flour moisture and extrusion temperature. The WSI was dependant of three parameters. Higher levels of temperature and screw speed increase the water solubility index (WSI). The studied parameters did not influence the water absorption index (WAI).

Propriedades físicas e indicador de qualidade de um latossolo vermelho submetido a diferentes sistemas de uso e manejo

The conventional system for soil management and preparation has the intensive mechanization as its basic principle and that changes soil properties, especially physical ones, faster and significantly. This study aimed to obtain and compare physical properties such as distribution of particle sizes, density, distribution of pore sizes, curves of water retention and degradation index of a Red Latosol, under intensive cultivation and no-cultivation for six years. Soil samples were collected at depths of 0.1, 0.2, 0.3, 0.4, 0.6, 0.8 and 1.0 m. There was a clay increment as a result of cultivated soil increase. The no-till soil density decreased as depth increased; however, in the arable layer (0.3 m) of the cultivated soil, the opposite was verified. The largest volume of pores was verified in the cultivated soil, especially in the superficial layers. In the smallest applied tension (0.001 MPa), the cultivated soil retained more water; however, starting from 0.033 MPa, the highest humidity values occurred in the no-till soil. The highest degradation index was observed at a depth of 0.1 m in no-till soil. However, that value was superior (0.020) to what is physically considered very poor soil.

Propriedades mecânicas e de corrosão de dois aços inoxidáveis austeníticos utilizados na fabricação de implantes ortopédicos

ASTM F 138 austenitic stainless steel is extensively used as an orthopedic implant material. However, some aspects, such as low strength in the annealed condition and susceptibility to localized corrosion, limit wider use of this kind of steel. Recently, a high-nitrogen austenitic stainless steel, specified in the standard ISO 5832-9, has been indicated as an alternative to ASTM F 138 steel for more severe loading and permanent application inside the human body. In this work, microstructure, mechanical properties, corrosion resistance and fatigue behavior of both steels were determined and compared. ISO 5832-9 steel displayed better mechanical and corrosion behaviors than did ASTM F 138 steel The combination of these features lead ISO steel to enhanced fatigue performance in both neutral and aggressive environments. Analyzed were the role of nitrogen in solid solution, combined with niobium in the Z-phase, and the factors that led to superior ISO 5832-9 properties.

Alterações de propriedades físicas de um nitossolo vermelho pela sucessão milheto-soja na fase de implantação do sistema de semeadura direta

The aim of this work was to evaluate the effect of a millet-soybean rotation, during the implantation phase of no-tillage system on the physical properties of a Nitossolo Vermelho distroférrico and the dry mass production of millet and the productivity of soybean. The experimental design used was a randomized blocks, in a split splot arrangement, with four replications. The parcels was constituted by three sowings (E1, E2 and E3) and the subparcels was constituted by harvests, where each harvest handling was: M1 - harvest each blooming and covering withdrawal; M2 - harvest each blooming and covering permanency; M3 - only in the first harvest on blooming and covering withdrawal; M4 - only in the first harvest on blooming and covering permanency, and M5-free growing, with no harvest. Samples were collected from three soil layers: 0-0,05, 0,05-0,10 and 0,10-0,20 m. The E2 showed smaller values of soil density and larger values of total porosity. The E3 resulted in smaller values of flocculation degree and mean weight diameter of the aggregates. The E3 showed smaller production of dry mass.