92 resultados para damping off


Relevância:

20.00% 20.00%

Publicador:

Resumo:

The spin injector part of spintronic FET and diodes suffers from fatigue due to rising heat on the depletion layer. In this study the stiffness of Ga1-xMnxAs spin injector in terms of storage modulus with respect to a varying temperature, 45 degrees C <= T <= 70 degrees C was determined. It was observed that the storage modulus for MDLs (Manganese Doping Levels) of 0%, 1% and 10% decreased with increase in temperature while that with MDLs of 20% and 50% increase with increase in temperature. MDLs of 20% and 50% appear not to allow for damping but MDLs <= 20% allow damping at temperature range of 45 degrees C <= T <= 70 degrees C. The magnitude of storage moduli of GaAs is smaller than that for ferromagnetic Ga1-xMnxAs systems. The loss moduli for GaAs were found to reduce with increase in temperature. Its magnitude of reducing gradient is smaller than Ga1-xMnxAs systems. The two temperature extremes show a general reduction in loss moduli for different MDLs at the study temperature range. From damping factor analysis, damping factors for ferromagnetic Ga1-xMnxAs was found to increase with decrease in MDLs contrary to GaAs which recorded the largest damping factor at 45 degrees C <= T <= 70 degrees C Hence, MDL of 20% shows little damping followed by 50% while MDL of 0% has the most damping in an increasing trend with temperature. (C) 2013 Elsevier Ltd. All rights reserved.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Cardiopulmonary bypass (CPB) is often associated with renal dysfunction, as measured by plasma creatinine levels and hemodialysis rates. Aim. To compare creatinine clearance (CrCl), estimated with the Cockroft and Gault formula, between patients undergoing off-pump coronary artery bypass grafting (OPCAB) versus on-pump CABG (on-CAB). Material and methods. Between April 2008 and April 2009, 119 patients underwent coronary bypass graft surgery. Fifty-eight (58) of these patients underwent OPCAB while 61 had on-CAB. Creatinine clearance, plasma creatinine levels, and clinical outcome were compared between the groups. A creatinine clearance value of 50 mL/minute was accepted as the lowest limit of normal renal function. Results. There were two hospital deaths caused by sepses after pulmonary infection. Creatinine clearance (Preoperative OPCAB 73,64±33,72 x on-CAB 75,70±34,30mL/min; discharge OPCAB 75,73±35,07 x on-CAB 79,07±34,71 mL/ min; p=0,609), and creatinine levels (Preoperative OPCAB 1,04±0,38 x on-CAB 1,13±0,53 mg/dL; discharge OPCAB 1,12±0,79 x on-CAB 1,04±0,29mg/dL; p=0,407) did not show statistically inter-group differences. Conclusion. Deterioration in renal function is associated with higher rates of postoperative complications. No significant difference in CrCl could be demonstrated between the groups.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

O corte de aços por disco abrasivo é um dos processos que apresentam as melhores características de economia, eficiência e rapidez, e ainda hoje é muito utilizado no meio industrial se comparado a outros processos tradicionais de corte como o cisalhamento (tesourão), torneamento (sangramento), serragem com serras metálicas, serragem por atrito com lâminas circulares sem dentes e chama oxi-acetileno. Da literatura formal mais recente, nota-se que durante os últimos anos as máquinas para a realização dos cortes foram inovadas. Entretanto, esta atenção não foi dada à ferramenta de corte abrasiva. A falta de literatura técnica dificulta a escolha das condições de corte e da sua otimização no meio industrial. Este fato é agravado pela grande diversidade de discos abrasivos disponíveis no mercado, com diferentes qualidades e preço. As decisões sobre as condições de corte são baseadas em experiências pessoais, sem critério definido, e freqüentemente desprezam os aspectos de segurança inerentes ao processo. A concorrência estrangeira, através da globalização da economia, está obrigando as indústrias nacionais a atenderem os padrões internacionais de qualidade e desempenho. Uma forma das indústrias nacionais tornarem-se mais competitivas é através do conhecimento detalhado das operações de corte com discos abrasivos. Neste trabalho é apresentado um estudo sobre o comportamento de discos abrasivos, submetidos a diversas condições de corte. Os resultados são discutidos em função da análise da velocidade de corte, velocidade de mergulho do disco abrasivo na peça, força tangencial de corte média, tempo de corte e relação G.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Gait disorders are identified in people with Parkinson’s disease. The aim of this study was to investigate the effect of auditory cues and medication on kinematic, kinetic and EMG parameters, during different gait phases of people with PD and healthy elderly. Thirty subjects distributed in two groups (Group 1, PD patients off and on medication; Group 2, healthy elderly) participated in this study and were instructed to walk in two experimental conditions: non-cued and cued. Therefore, kinematic, kinetic and electromyography analyses were utilized to investigate the locomotor pattern. Changes in locomotor pattern (greater muscular activity) with auditory cue were observed for PD patients. Regarding the medication, locomotor parameter improvement was observed after levodopa intake in association with the auditory cue. These results confirm the hypothesis about the external cues therapy that could be used as a complement to drug therapy to achieve improvement in the locomotor pattern of PD patients.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

We investigated the influence of environmental factors in spatial and temporal distribution of the seabob shrimp Xiphopenaeus kroyeri in Santos Bay and São Vicente Estuary, state of São Paulo, Brazil. Monthly samples were obtained, from May 2008 through April 2010, from four locations in the estuary and four in the bay. No individual was collected in the estuary and this was attributed to the low salinity means recorded in this environment. We collected 109,153 individuals in the bay and there was no difference in abundance between the two years comprised by the study period. The similarity in spatial distribution can be related to sediment grain size that in all sampling locations showed great amount of very fine sand. The largest amount of reproductive females was obtained in early 2010, when temperature was high, and this could have increased the juvenile recruitment in April 2010. According to our results, the distribution of X. kroyeri in the study area is influenced by temperature, which is related to reproduction, and salinity, limiting the entrance of individuals in the estuarine region.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

This paper deals with a system that describes an electrical circuitcomposed by a linear system coupled to a nonlinear one involving a tunneldiode in a flush-and-fill circuit. One of the most comprehensive models for thiskind of circuits was introduced by R. Fitzhugh in 1961, when taking on carebiological tasks. The equation has in its phase plane only two periodic solutions,namely, the unstable singular point S0 and the stable cycle Γ. If the system isat rest on S0, the natural flow of orbits seeks to switch-on the process by going- as time goes by - toward its steady-state, Γ. By using suitable controls it ispossible to reverse such natural tendency going in a minimal time from Γ toS0, switching-off in this way the system. To achieve this goal it is mandatorya minimal enough strength on controls. These facts will be shown by means ofconsiderations on the null control sets in the process.