Diurnal effects on spearmint oil yields and composition

'Native'spearmint (Mentha spicata L.) is one of the two spearmint species grown commercially in the United States and other countries for essential oil production. The two major constituents of spearmint oil are carvone and limonene. It is not known if the essential oil yield (content) and composition of spearmint oil are affected by diurnal variation, and when it would be the best time for harvesting flowering spearmints within a 24h period. Therefore, the objective of this study was to evaluate the effect of diurnal variation on yield and composition of spearmint 'Native'essential oil for the environmental conditions of Northern Wyoming, at elevation 1170 m above the sea level. The experiment was conducted on a 3-year old well established spearmint plantation. The harvest times were every 2 h within a 24-h period: 7:00 AM, 9:00 AM, 11:00AM, 1:00 PM, 3:00 PM, 5:00 PM, 7:00 PM, 9:00 PM, 11:00 PM, 1:00 AM, 3:00 AM, and 5:00 AM. Essential oil yield varied from 0.96 to 1.47 g of oil per 100 g of dry herbage; the maximum oil yield was obtained at 9:00 AM and the minimum at 7:00 PM. The concentration of carvone in the oil varied from 44.1% (at 1:00 PM) to 66.4% (at 9:00 PM) of the total oil. However, the yield of carvone (a function of oil yield and carvone concentration in the oil) was the highest at 3:00 AM and the lowest at 1:00 PM. The concentration of limonene (10.7-15.8% of the oil) was the highest at 7:00 PM and the lowest at 1:00 PM, whereas the yield of limonene was the highest at 9:00 PM. For best essential oil yields, flowering spearmint should be harvested at around 9:00 AM. However, to obtain oil with high carvone concentration, spearmint should be harvested at 9:00 PM. Harvests at 1:00 PM would result in spearmint oil with low concentrations of both carvone and limonene, and hence, should be avoided. (C) 2014 Elsevier B.V. All rights reserved.

Controlling Asian soybean rust (Phakopsora pachyrhizi) with Bacillus spp. and coffee oil

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

The application of neural networks to the analysis of dissolved gases in insulating oil used in transformers

The state of insulating oils used in transformers is determined through the accomplishment of physical-chemical tests, which determine the state of the oil, as well as the chromatography test, which determines possible faults in the equipment. This article concentrate on determining, from a new methodology, a relationship among the variation of the indices obtained from the physical-chemical tests with those indices supplied by the chromatography tests.The determination of the relationship among the tests is accomplished through the application of neural networks. From the data obtained by physical-chemical tests, the network is capable to determine the relationship among the concentration of the main gases present in a certain sample, which were detected by the chromatography tests.More specifically, the proposed approach uses neural networks of perceptron type constituted of multiple layers. After the process of network training, it is possible to determine the existent relationship between the physical-chemical tests and the amount of gases present in the insulating oil.

Assessment of cytotoxicity and AhR-mediated toxicity in tropical fresh water sediments under the influence of an oil refinery

Oil refinery effluents contain many chemicals at variable concentrations. Therefore, it is difficult to predict potential effects on the environment. The Atibaia River (SP, Brazil), which serves as a source of water supply for many municipalities, receives the effluents of one of the biggest oil refinery of this country. The aim of this study was to identify the (eco)toxicity of fresh water sediments under the influence of this oil refinery through neutral red (cytotoxicity) and ethoxyresorufin-O-deethylase (EROD) assays (AhR-mediated toxicity) in RTL-W1 cells (derived from fish liver). Once the refinery captures the waters of Jaguarí River for the development of its activities and discharges its effluents after treatment into the Atibaia River, which then flows into Piracicaba River, sediments from both river systems were also investigated. The samples showed a high cytotoxic potential, even when compared to well-known pollution sites. However, the cytotoxicity of samples collected downstream the effluent was not higher than that of sediments collected upstream, which suggested that the refinery discharges are not the main source of pollution in those areas. No EROD activity could be recorded, which could be confirmed by chemical analyses of polycyclic aromatic hydrocarbons (PAHs) that revealed a high concentration of phenanthrene, anthracene, fluoranthene, and pyrene, which are not EROD inducers in RTL-W1 cells. In contrast, high concentrations of PAHs were found upstream the refinery effluent, corroborating cytotoxicity results from the neutral red assay. A decrease of PAHs was recorded from upstream to downstream the refinery effluent, probably due to dilution of compounds following water discharges. On the other hand, these discharges apparently contribute specifically to the amount of anthracene in the river, since an increase of anthracene concentrations could be recorded downstream the effluent. Since the extrapolation of results from acute toxicity to specific toxic effects with different modes of action is a complex task, complementary bioassays covering additional specific effects should be applied in future studies for better understanding of the overall ecotoxicity of those environments.

Biosurfactants production by yeasts using soybean oil and glycerol as low cost substrate

Biosurfactants are bioactive agents that can be produced by many different microorganisms. Among those, special attention is given to yeasts, since they can produce many types of biosurfactants in large scale, using several kinds of substrates, justifying its use for industrial production of those products. For this production to be economically viable, the use of residual carbon sources is recommended. The present study isolated yeasts from soil contaminated with petroleum oil hydrocarbons and assessed their capacity for producing biosurfactants in low cost substrates. From a microbial consortium enriched, seven yeasts were isolated, all showing potential for producing biosurfactants in soybean oil. The isolate LBPF 3, characterized as Candida antarctica, obtained the highest levels of production - with a final production of 13.86 g/L. The isolate LBPF 9, using glycerol carbon source, obtained the highest reduction in surface tension in the growth medium: approximately 43% of reduction after 24 hours of incubation. The products obtained by the isolates presented surfactant activity, which reduced water surface tension to values that varied from 34 mN/m, obtained from the product of isolates LBPF 3 and 16 LBPF 7 (respectively characterized as Candida antarctica and Candida albicans) to 43 mN/m from the isolate LPPF 9, using glycerol as substrate. The assessed isolates all showed potential for the production of biosurfactants in conventional sources of carbon as well as in agroindustrial residue, especially in glycerol.

Caracterização da distribuição física dos dolomitos do membro Búzios no Campo de Badejo - Bacia de Campos

In the region of Badejo oil Ffeld (Campos Basin) lies an Lower Albian dolomitic layer that shows reservoir rock and seal conditions, among others and, it is occasionally karstified. This work applies geostatistical techniques of ordinary and indicatior kriging, in an attempt to determine a method that assists the analysis of different scenarios offered for petroleum drilling from a quantitative point of view this fact is justified, because there are different visions and strategies that would be adopted under different dolomite conditions (stable - low porosity and high density; reservoir - high porosity and medium density; instable - high porosity and low dentisty). The main objective is a methodological introduction that has not been tested in dolomites before aiming to characterize the distribution of the three conditions described above by ordinary and indicatior kriging, which was based on the obtained data from the dolomite layer identification through well logs interpretation and correlation, followed by seismic interpretation. In addition, it was generated structural contour maps, based on 2D and 3D seismic data interpretation, and then, seismic attributes maps were calculated, in order to transform them into pseudo-density maps, i.e., maps that correlate the density values with the attribute values. As primary results, structural contour maps and seismic attributes were obtained and ordinary and indicatior kriging maps were done, on which it is possible to interpret the distribution of the main reservoir and risk probability for drilling of exploration wells obtaining trends N35E and N10W direction for areas of stability or reservoir levels, while the central part of the map presents a higher risk for loss of drilling fluid. The cut-off values levels were based on the values of first and third quartiles of cumulative histogram (instable and stable zones, respectively), as well as the reservoir level was set as the interval...

Addition of lipolytic enzyme in anaerobic co-digestion of swine manure and inclusion levels of waste vegetable oil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Sistemas petrolíferos especulativos da bacia de Pelotas (offshore do Uruguai)

Pós-graduação em Geociências e Meio Ambiente - IGCE

Estudo do efeito Bauschinger em tubos de aço API 5l x70 aplicados no transporte de petróleo e gás

Despite the growing concern in seeking more sustainable energy sources, oil demand is likely to grow in coming years. To keep up with this growth, the oil industry has increasingly invested in innovation and efficiency. Knowing that, new technologies have been developed to explore deeper waters, without giving up the best practices in worldwide operational safety. The use of rigid pipelines in deepwater offshore facilities is increasing quickly and because of this, the ways of storing and launching pipe have been studied and perfected. In this paper the Bauschinger effect on API 5L X70 steel was analyzed proving that there was a reduction in yield strength when an effort was applied in a previous direction, then an effort was then applied in the opposite direction. To observe this phenomenon, the tensile test was conducted to determine the mechanical properties of the base metal, such as yield stress, tensile strength, elasticity and maximum tensile, so then compare it with the results obtained in the Bauschinger Effect Test. The analysis results showed that the steel had high resistance, with good plastic deformation capacity without failing, well-defined yield point, showing itself appropriate for the operation of oil and gas pipes