Effect of Mg-Ga powder addition on the superconducting properties of MgB2 samples

MgB2 bulk samples containing different proportions of Mg-Ga powder were prepared by an in situ reaction technique. The Mg-Ga powder was obtained via high energy ball milling of a Mg-10 at.% Ga composite, which was fabricated by melting of pure magnesium and gallium metals inside encapsulated stainless steel tube at 655 °C in a controlled atmosphere. The MgB2 samples containing 0, 1, 3, 5 and 7 wt.% of MgGa addition were sintered at 650 °C for 30 min in argon atmosphere. Magnetic measurements performed at 5 K and 20 K showed improved critical current density, Jc, in the low magnetic field range for samples with MgGa addition. The critical temperature, Tc, for all samples with gallium additions is consistently higher when compared to the pure MgB2. © 2007 Elsevier B.V. All rights reserved.

Direct and simultaneous determination of As, Cu, and Pb in Brazilian sugar cane spirits by graphite furnace AAS using tungsten permanent modifier with co-injection of Pd/Mg(N03)2

A method was developed using the multi-element graphite furnace atomic absorption spectrometry technique for the direct and simultaneous determination of As, Cu, and Pb in Brazilian sugar cane spirit (cachaça) samples. Also employed was the end-capped transversely heated graphite atomizer (THGA) with platforms pre-treated with W permanent modifier and co-injection of Pd/Mg(N03)2. Pyrolysis and atomization temperature curves were established in a cachaça medium (1+1; v/v) containing 0.2% (v/v) HN03 and spiked with 20 μg L-1 As and Pb and 200 μg L-1Cu. The effect of the concentration of major elements usually present in cachaça matrices (Ca, Mg, Na, and K) and ethanol on the absorbance of As, Cu, and Pb was investigated. Analytical working solutions of As, Cu, and Pb were prepared in 10% (v/v) ethanol plus 5.0 mg L-1 Ca, Mg, Na, and K. Acidified to 0.2% (v/v) HNO3, these solutions were suitable to build calibration curves by matrix matching. The proposed method was applied to the simultaneous determination of As, Cu, and Pb in commercial sugar cane spirits. The characteristic mass for the simultaneous determination was 16 pg As, 119 pg Cu, and 28 pg Pb. The pretreated tube lifetime was about 450 firings. The limit of detection (LOD) was 0.6 μg L-1As, 9.2 μg L-1 Cu, and 0.3 μg L-1Pb. The found concentrations varied from 0.81 to 4.28 μg L-1As, 0.28 to 382 mg L-1 Cu and 0.82 to 518 μg L-1 Pb. The recoveries of the spiked samples varied from 94-112% (As), 97-111% (Cu), and 95-101% (Pb). The relative standard deviation (n=12) was 6.9%, 7.4%, and 7.7% for As, Cu, and Pb, respectively, present in a sample at 0.87 μgL-1, 0.81 mgL-1, and 38.9 μgL-1concentrations.

Levantamento gravimétrico na região de Franca - SP e delfinópolis - MG, no reconhecimento e delimitação de feições estruturais (Zonas de Sutura)

This paper presents the results of a geophysical study carried out in northeastern São Paulo State and southwestern Minas Gerais State over an area 80 km wide and 97.5 km long in SE Brazil. The Bouguer anomaly map, and geological and structural data allowed to identify three different gravity domains - crustal blocks limited by major discontinuities -related to the structural pattern of the area. These discontinuities were interpreted as geosuture zones underlying the Paraná Basin sediments which have extensions in the Pre-cambrian Basement. The crustal discontinuities named Alterosa and Ribeirão Preto may be seen as A - type collision sutures in a triple junction arramgement. Two prominent linear anomalies are recognized in the Bouguer anomaly map, as well as the limit between the Brasilia and São Paulo crustal blocks or paleoplates. The Alterosa suture zone trends NW-SE while the Ribeirão Preto suture has a NE-SW direction. The Bouguer anomaly map provides subsidies and information on new concepts and theories leading to the refinement of tectonic models.

Diagnóstico das áreas de preservação permanente na bacia hidrográfica do rio Tijuco, Ituiutaba - MG, utilizando tecnologia SIG

The present work had the objective to elaborate the map of land use and vegetation covering from Tijuco river watershed, Ituiutaba-MG, based on digital images obtained by satellite from CBERS 2, through automatic delimitation of permanent preservation areas followed by identification of land use conflict based on the Brazilian Forest Code (Law no 4771/1965) and National Council of Environment's Resolution no 303/02. This paper analyzes, through quantitative parameters and the use of Geographic Information System, the maintenance tracks of width recommended by the legislation for permanent preservation areas over water bodies. The results showed a deficit of conserved areas along the riverbanks of 2334 ha that are not in compliance with the legislation. The pasture occupies unduly 0.97% of the area of the basin in the permanent preservation areas at the riverbanks, while agriculture occupies 0.38%.

Dielectric tunability in (1-x)[Pb(Mg 1/3Nb 2/3)O 3]-xPbTiO 3 ceramics for tunable devices application

The dielectric properties of the 0.65[Pb(Mg 1/3Nb 2/3)O 3]-0.35PbTiO 3 ferroelectric ceramic composition were investigated viewing the capability to be used for tunable microwave applications. The dielectric response has been studied for three selected temperatures (300 K, 370 K and 400 K), below the paraelectric- ferroelectric phase transition temperature, as a function of the applied 'bias' electric field. The obtained dielectric tunability was found to be around 60 %, under an electric field of 19 kV/cm, which makes the studied ceramic composition an excellent candidate for application in the electro-electronic industry, as tunable devices. © 2010 IEEE.

High-yield direct synthesis of Mg 2FeH 6 from the elements by reactive milling

Magnesium complex hydrides as Mg 2FeH 6 are interesting phases for hydrogen storage in the solid state, mainly due to its high gravimetric and volumetric densities of H2. However, the synthesis of this hydride is not trivial because the intermetallic phase Mg2Fe does not exist and Mg and Fe are virtually immiscible under equilibrium conditions. In this study, we have systematically studied the influence of the most important processing parameters in reactive milling under hydrogen (RM) for Mg 2FeH 6 synthesis: milling time, ball-to-powder weight ratio (BPR), hydrogen pressure and type of mill. Low cost 2Mg-Fe mixtures were used as raw materials. An important control of the Mg 2FeH 6 direct synthesis by RM was attained. In optimized combinations of the processing parameters, very high proportions of the complex hydride could be obtained. © (2011) Trans Tech Publications.

Geotermobarometria de Granulitos Associados à Supracrustais na Porção Norte do Complexo Guaxupé - Região de Arceburgo - Santa Cruz do Prata, MG

This paper is a contribution for the understanding of the geological evolution of Guaxupé Complex. New data on petrography and mineral chemistry as well as estimates of metamorphic (P-T) conditions in the region of Arceburgo - Santa Cruz do Prata (MG) Brazil, at the southern portion of the Brasília Belt, more specifically at the Guaxupé Complex (Domain) are now presented. The lithotypes are high-grade metamorphic rocks subdivided into two groups: metasediments and granulites (orthoderivates). Chemical analysis of minerals was performed in three steps including core and rim of amphibole, pyroxene, feldspar, biotite, and garnet from samples of the following rock types: enderbites, mafic granulites, charnockites, and alkali feldspar charnockites. Results obtained with geothermobarometric calculations show metamorphic peak around 900°C of T and 10 kbar of P. Enderbites and tonalite granulites (mafic) show the highest values of temperature and pressure, while alkali feldspar charnockites show the lowest probably due to their late generation in relation to mafic rock types (enderbites and mafic tonalite granulite). Chemical mineral analysis in metamorphic parageneses and geothermobarometric calculations indicate that the possible metamorphic peak may be higher than 900°C of temperature and around 10 kbar of pressure, within a isothermal decompression (ITD) regime.

Determination of Mg (II) in biodiesel by adsorptive stripping voltammetry at a mercury film electrode in the presence of sodium thiopentone

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Florística e fitossociologia em áreas de campo sujo e cerrado sensu stricto na Estação Ecológica de Pirapitinga-MG

The objectives of this study were to characterize the floristic and to calculate the phytosociological parameters of species present in the areas of 'campo sujo' and 'cerrado' sensu stricto in the Ecological Station of Pirapitinga, Minas Gerais state (ESEC). For the floristic and phytosociologic survey, a total of 190 plots of 100 m2 each were allocated, where all the individuals with circumference at soil level (CSL) ≥ 16 cm in areas of 'campo sujo' and 'cerrado' sensu stricto were sampled. The parameters of frequency, density, dominance, and importance values and Shannon and Pielou indexes were calculated. The floristic similarity between areas was determinated by Sorensen index. In the study areas, a total of 3,224 individuals distributed in 81 species, 70 genera and 40 families were sampled. The richest families were Vochysiaceae and Fabaceae. The cerrado sensu stricto was the vegetal formation with the highest richness of species (81) and highest density (2.257 ind ha-1). Both areas have studied with high diversity and ecological dominance and have low diameter distribution in the form of inverted-J, indicating the predominance of young individuals.

Influência da aptidão aeróbia no running anaerobic sprint test (RAST)

The aim of this study was to investigate the possible influence of different levels of aerobic fitness (VO2MAX) on the parameters of the running anaerobic sprint test (RAST). Thirty-eight subjects (Age = 18.1 ± 2.5 years, Height = 173 ± 1 cm and Body mass = 65.1 ± 6.5 kg) were classified into two groups, low and high aerobic fitness (LAF: n = 22 and HAF: n = 16). The VO2MAX was determined by an incremental exercise performed until exhaustion. The RAST was composed of six maximal efforts of 35m separated by 10s passive recovery. The VO2MAX was significantly different between groups (LAF = 51.7 ± 1.9 mL.kg -1.min-1; HAF = 58.6 ± 3.1 mL.kg -1.min-1). The mean power (MP) was significantly higher in the LAF (552.7 ± 132.1 W) in relation to the HAF group (463.6 ± 132.8 W). The impulse (ImP) was significantly correlated with the VO 2MAX in HAF. It can be concluded that there is an indication that the aerobic metabolism exerts an influence on the completion of RAST.

Corrosion and tribocorrosion behaviour of Al-Si-Cu-Mg alloy and its composites reinforced with B4C particles in 0.05M NaCl solution

The corrosion behaviour of metal matrix composites (MMCs) is strictly linked with the presence of heterogeneities such as reinforcement phase, microcrevices, porosity, secondary phase precipitates, and interaction products. Most of the literature related to corrosion behaviour of aluminium matrix composites (AMCs) is focused on SiC reinforced AMCs. On the other hand, there is very limited information available in the literature related to the tribocorrosion behaviour of AMCs. Therefore, the present work aims to investigate corrosion and tribocorrosion behaviour of Al-Si-Cu-Mg alloy matrix composites reinforced with B4C particulates. Corrosion behaviour of 15 and 19% (vol) B4C reinforced Al-Si-Cu-Mg matrix composites and the base alloy was investigated in 0.05M NaCl solution by performing immersion tests and potentiodynamic polarisation tests. Tribocorrosion behaviour of Al-Si-Cu-Mg alloy and its composites were also investigated in 0.05M NaCl solution. The tests were carried out against alumina ball using a reciprocating ball-on-plate tribometer. Electrochemical measurements were performed before, during, and after the sliding tests together with the recording of the tangential force. Results suggest that particle addition did not affect significantly the tendency of corrosion of Al-Si-Cu-Mg alloy without mechanical interactions. During the tribocorrosion tests, the counter material was found to slide mainly on the B4C particles, which protected the matrix alloy from severe wear damage. Furthermore, the wear debris were accumulated on the worn surfaces and entrapped between the reinforcing particles. Therefore, the tendency of corrosion and the corrosion rate decreased in Al-Si-Cu-Mg matrix B4C reinforced composites during the sliding in 0.05M NaCl solution. © 2013 Elsevier B.V.

Atlas ambiental como subsídio aos estudos de sustentabilidade - a bacia do Araçuaí no Vale do Jequitinhonha - MG

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Chuvas e escorregamentos na região Noroeste da área urbana de Juiz de Fora - MG: uma abordagem genética em climatologia

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Revisitação de Bromeliaceae na APA Santuário ecológico da Pedra Branca Caldas, MG

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Monitoramento hídrico e determinação de áreas de conflito da sub-bacia do Córrego Saudade, Uberaba-MG

Pós-graduação em Agronomia (Ciência do Solo) - FCAV