Fault location in underground systems using artificial neural networks and PSCAD/EMTDC

The need for high reliability and environmental concerns are making the underground networks the most appropriate choice of energy distribution. However, like any other system, underground distribution systems are not free of failures. In this context, this work presents an approach to study underground systems using computational tools by integrating the software PSCAD/EMTDC with artificial neural networks to assist fault location in power distribution systems. Targeted benefits include greater accuracy and reduced repair time. The results presented here shows the feasibility of the proposed approach. © 2012 IEEE.

A new sufficient condition for optimal impulsive control problems

In this article we introduce the concept of MP-pseudoinvexity for general nonlinear impulsive optimal control problems whose dynamics are specified by measure driven control equations. This is a general paradigm in that, both the absolutely continuous and singular components of the dynamics depend on both the state and the control variables. The key result consists in showing the sufficiency for optimality of the MP-pseudoinvexity. It is proved that, if this property holds, then every process satisfying the maximum principle is an optimal one. This result is obtained in the context of a proper solution concept that will be presented and discussed. © 2012 IEEE.

Active vibration control using delayed resonant feedback

Delayed feedback (DF) control is a well-established technique to suppress single frequency vibration of a non-minimum phase system. Modal control is also a well-established technique to control multiple vibration modes of a minimum phase system. In this paper these techniques are combined to simultaneously suppress multiple vibration modes of a non-minimum phase system involving a small time delay. The control approach is called delayed resonant feedback (DRF) where each modal controller consists of a modal filter to extract the target mode signal from the vibration response, and a phase compensator to account for the phase delay of the mode. The methodology is first discussed using a single mode system. A multi-mode system is then studied and experimental results are presented to demonstrate the efficacy of the control approach for two modes of a beam. It is shown that the system behaves as if each mode under control has a dynamic vibration absorber attached to it, even though the actuator and the sensor are not collocated and there is a time delay in the control system. © 2013 IOP Publishing Ltd.

Desenvolvimento de um modelo fuzzy para otimização da energia gerada por um sistema híbrido (solar-fotovoltaico e eólico)

Pós-graduação em Agronomia (Energia na Agricultura) - FCA

Monitoramento da Integridade Estrutural de Sistemas Mecânicos via Observador de Estado Modal

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Implementação de uma plataforma HW/SW para automação industrial, utilizando hardware reconfigurável com processador NIOS II em conformidade com o padrão IEEE 1451

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Redes neurais aplicadas em processos de usinagem da madeira

Pós-graduação em Engenharia Mecânica - FEG

Filippov's selection theorem and the existence of solutions for optimal control problems in time scales

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

On the properness of an impulsive control extension of dynamic optimization problems

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

NASH game and mixed H2/H∞ control

In this work a Nonzero-Sum NASH game related to the H2 and H∞ control problems is formulated in the context of convex optimization theory. The variables of the game are limiting bounds for the H2 and H∞ norms, and the final controller is obtained as an equilibrium solution, which minimizes the `sensitivity of each norm' with respect to the other. The state feedback problem is considered and illustrated by numerical examples.

Neural models for predicting hole diameters in drilling processes

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Neural models for predicting hole diameters in drilling processes

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Aplicação da teoria fuzzy no controle de sistemas de geração de energias alternativas

This paper presents the application and use of a methodology based on fuzzy theory and simulates its use in intelligent control of a hybrid system for generating electricity, using solar energy, photovoltaic and wind. When using a fuzzy control system, it reached the point of maximum generation of energy, thus shifting all energy generated from the alternative sources-solar photovoltaic and wind, cargo and / or batteries when its use not immediately. The model uses three variables used for entry, which are: wind speed, solar radiation and loading the bank of batteries. For output variable has to choose which of the batteries of the battery bank is charged. For the simulations of this work is used MATLAB software. In this environment mathematical computational are analyzed and simulated all mathematical modeling, rules and other variables in the system described fuzzy. This model can be used in a system of control of hybrid systems for generating energy, providing the best use of energy sources, sun and wind, so we can extract the maximum energy possible these alternative sources without any prejudice to the environment.

TORP: The Open Robot Project A Framework for Module-Based Robots

The development of robots has shown itself as a very complex interdisciplinary research field. The predominant procedure for these developments in the last decades is based on the assumption that each robot is a fully personalized project, with the direct embedding of hardware and software technologies in robot parts with no level of abstraction. Although this methodology has brought countless benefits to the robotics research, on the other hand, it has imposed major drawbacks: (i) the difficulty to reuse hardware and software parts in new robots or new versions; (ii) the difficulty to compare performance of different robots parts; and (iii) the difficulty to adapt development needs-in hardware and software levels-to local groups expertise. Large advances might be reached, for example, if physical parts of a robot could be reused in a different robot constructed with other technologies by other researcher or group. This paper proposes a framework for robots, TORP (The Open Robot Project), that aims to put forward a standardization in all dimensions (electrical, mechanical and computational) of a robot shared development model. This architecture is based on the dissociation between the robot and its parts, and between the robot parts and their technologies. In this paper, the first specification for a TORP family and the first humanoid robot constructed following the TORP specification set are presented, as well as the advances proposed for their improvement.

Épocas de consórcio de alho com cenoura em três sistemas de manejo de plantas daninhas, em Caçador-SC

O presente trabalho teve por objetivo avaliar os efeitos do consórcio alho e cenoura em quatro épocas de semeadura de cenoura e em três manejos de plantas daninhas, visando determinar os benefícios do consórcio em relação ao controle destas plantas, à produtividade, à rentabilidade e à sua qualidade comercial. Testaram-se quatro épocas de semeadura da cenoura (0, 15, 30 e 45 dias após o plantio do alho), combinadas a três manejos de plantas daninhas (com herbicida, sem controle e com capinas freqüentes). Utilizou-se o delineamento de blocos casualizados dispostos em parcelas subdivididas, com a época de semeadura da cenoura sendo parcela e o sistema de manejo, a sub-parcela, em quatro repetições. O oxadiazon a 750 g ha-1 não foi tóxico às plantas de alho nem às de cenoura. A rentabilidade do consórcio alho e cenoura foi vantajosa em relação ao monocultivo de alho, principalmente dentro do manejo com capinas freqüentes.