Herbicide selectivity in herbaceous ornamental gardens of tagetes erecta L.

One of the major problems in landscaping in tropics is weed management. The herbaceous ornamental plant, Tagetes erecta L. (Asteraceae), is very popular for its beautiful flowers which can be used in landscape and also as cut flowers. The increase use of this plant and lack of selective herbicides led to the objective of this study to evaluate the herbicide metribuzin selectivity for this ornamental plant. The experimental design was completely randomized using four treatments (herbicide metribuzin doses: 0, 0.5, 1.0 and 1.5 L ha-1, equivalent to 0, 240, 480 and 720 g ha-1) and five replicates. The herbicide was applied over the seedling of T. erecta as pre-emergence of the weed seeds. Evaluations were performed at 7, 14, 21 and 28 days after application (DAA) by visual analysis of the toxicity symptoms over the ornamental, using the European Weed Research Council (EWRC) scale (1 to 9), where 1 is the total absence of symptoms and 9 to death plants. Polynomial regression statistical analysis was used. It was verified that, from the dose of 1.0 L ha-1, T. erecta plants died by 14 DAA, which the most of them had presented a very strong toxicity symptom; for the 0.5 L ha-1 treatment the plants had survived until 28 DAA. However, most of them already exhibited the high toxicity level, dying at 35 DAA. Thus, metribuzin was not suitable for T. erecta even at the lowest rate tested in this study.

Three-dimensional finite element analysis of stress distribution in retention screws of different crown-implant ratios

The retaining screw of the implant-supported dental prosthesis is the weakest point of the crown/implant system. Furthermore, crown height is another important factor that may increase the lever arm. Therefore, the aim of this study was to assess the stress distribution in implant prosthetic screws with different heights of the clinical crown of the prosthesis using the method of three-dimensional finite element analysis. Three models were created with implants (3.75 mm × 10 mm) and crowns (heights of 10, 12.5 and 15 mm). The results were visualised by means of von Mises stress maps that increased the crown heights. The screw structure exhibited higher levels of stresses in the oblique load. The oblique loading resulted in higher stress concentration when compared with the axial loading. It is concluded that the increase of the crown was damaging to the stress distribution on the screw, mainly in oblique loading. © 2013 Taylor & Francis.

Extrusion of flavored corn grits: Structural characteristics, volatile compounds retention and sensory acceptability

The effects of the moisture content of the raw material, extrusion temperature and screw speed on flavor retention, sensory acceptability and structure of corn grits extrudates flavored with isovaleraldehyde, ethyl butyrate and butyric acid were investigated. Higher temperature resulted in more expanded extrudates with lower density and cutting force, while higher moisture content increased ethyl butyrate retention. The most acceptable extrudates were those obtained with low moisture content, under conditions of high extrusion temperature and high screw speed, or low screw speed and low extrusion temperature, whereas the aroma intensity closest to the ideal was observed under conditions of low extrusion temperature and low moisture content of the raw material. © 2013 Elsevier Ltd.

Eficácia do herbicida amicarbazone em aplicação conjunta com a colheita de cana-de-açúcar no controle das principais plantas daninhas da cultura

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Determinação da eficiência e da vida útil de conjuntos de proteção individual aos agrotóxicos em função do procedimento de usos e lavagens

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Classificação e eficiência de materiais e de vestimentas de proteção no trabalho com agrotóxico

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Interferência de Digitaria insularis em Coffea arabica e respostas destas espécies ao glyphosate

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Efeito de adjuvantes na dinâmica de ametryn em palha de cana-de-açúcar

Pós-graduação em Agronomia (Proteção de Plantas) - FCA

Influence of spray mixture volume and flight height on herbicide deposition in aerial applications on pastures

The objective of the present study was to analyze the influence of spray mixture volume and flight height on herbicide deposition in aerial applications on pastures. The experimental plots were arranged in a pasture area in the district of Porto Esperidião (Mato Grosso, Brazil). In all of the treatments, the applications contained the herbicides aminopyralid and fluroxypyr (Dominum) at the dose of 2.5 L c.p. ha-1, including the adjuvant mineral oil (Joint Oil) at the dose of 1.0 L and a tracer to determine the deposition by high-performance liquid chromatography (HPLC) (rhodamine at a concentration of 0.6%). The experiment consisted of nine treatments that comprised the combinations of three spray volumes (20, 30 and 50 L ha-1) and three flight heights (10, 30 and 40 m). The results showed that, on average, there was a tendency for larger deposits for the smallest flight heights, with a significant difference between the heights of 10 and 40 m. There was no significant difference among the deposits obtained with the different spray mixture volumes.

Alternative methods for detecting soybean seeds genetically modified for resistance to herbicide glyphosate

The objective of this study was to verify application of two methodologies: substrate moistened with herbicide solution (SM) and immersion of seeds in herbicide solution (IH) for detecting soybean seeds genetically modified. For this, non-transgenic and transgenic soybean seeds, harvested in the 2008/2009 crop seasons were used. The treatments with substrate moistened were: SM1) 0.03% herbicide solution, at 25 ºC, with evaluation in the sixth day (hs -0.03% -25 ºC, 6th d); SM2) HS -0.03% -35 ºC, 5th d; SM3) HS -0.03% - 40 ºC, 5th d; and SM4) hs -0.06% -5 ºC, 5th d. In the methodology of immersion of seeds the following treatments were performed: IH1) seed immersion in a 0.6% herbicide solution, at 25 ºC, for 1 h, (si -0.06% -25 ºC, 1 h; IH2) si -0.06% - 35 ºC, 30 min.; IH3) si -0.06% -40 ºC, 30 min.; IH4) si -0.12% -35 ºC, 30 min.; and IH5) si -0.12% -40 ºC, 30 min. Bioassays allow detecting soybean seeds tolerant to glyphosate herbicide within five days. The seeds of non-genetically modified and genetically modified soybean cultivars may be easily distinguished through the treatments SM2 and SM4 of the moistened substrate methodology; and treatments IH3, IH4, and IH5 of seed immersion methodology. Both methodologies are easily feasible, practical, and applicable in seed analysis laboratories, once do not require special equipments.

Halotolerance, ligninase production and herbicide degradation ability of basidiomycetes strains

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Leaching potential and residual effect of amicarbazone in soils of contrasting texture

The infestation of weeds is a major biotic factor in the agroecosystem of cane sugar that may interfere in development and crop productivity. This study aimed to evaluate the potential for leaching and residual effects of the herbicide amicarbazone in contrasting soils. Samples were Quartzarenic Neosol (NR - sandy texture) and Red Latosol (LR - clay texture). For the leaching potential, after application of herbicide amicarbazone (NR 1.05 kg ha(-1) and LR 1.40 kg ha(-1)), layers of 0, 20, 40, 60, 80 and 100 mm of water were applied to soil columns. We evaluated the residual effect after the permanence of the herbicide in soil of clay texture and sandy for periods of 0, 25, 50, 75 and 100 days after application (DAA) of amicarbazone (0, 1.05, 1.40 kg ha(-1)) treatments. The amicarbazone started showing high leaching from the 60 mm layer of water in sandy texture soils, evidencing a shorter residual effect. In clay soil, slides from 20 to 80 mm of water reduced the biomass until a depth of 5-10 cm, with the use of this herbicide. Based on these results, we conclude that the amicarbazone showed higher leaching and lower residual effects in sandy soil. The residual effect of amicarbazone was prolonged as the content of clay and organic matter present in the soil increased.

Effects of the acute exposition to glyphosate-based herbicide on oxidative stress parameters and antioxidant responses in a hybrid Amazon fish surubim (Pseudoplatystoma sp)

The aim of this study was to investigate the effects of acute glyphosate (active ingredient) exposure on the oxidative stress biomarkers and antioxidant defenses of a hybrid surubim (Pseudoplatystoma sp). The fish were exposed to different herbicide concentrations for 96 h. The thiobarbituric acid-reactive substances (TBARS), protein carbonyls and antioxidant responses were verified. The 15 mg a.p L-1 of herbicide resulted in the death of 50% of the fish after 96 h. An increase in liver and muscle TBARS levels was observed when fish were exposed to the herbicide. The protein carbonyl content was also increased in the liver (4.5 mg a.p L-1 concentration) and brain (2.25 mg a.p L-1 concentration). The antioxidant activities decreased in the liver and brain after exposure to herbicide. Levels of ascorbic acid in the liver (2.25 mg a.p L-1 and 4.5 mg a.p L-1 concentrations) and brain (2.25 mg a.p L-1 concentration) were increased post-treatment. Levels of total thiols were increased in the liver and brain (2.25 mg L-1 and 7.5 mg a.p L-1, respectively). Glyphosate exposure, at the tested concentrations affects surubim health by promoting changes that can affect their survival in natural environment. Some parameters as TBARS and protein carbonyl could be early biomarkers for Roundup exposure in this fish species. (C) 2014 Elsevier Inc. All rights reserved.

Application of poly(epsilon-caprolactone) nanoparticles containing atrazine herbicide as an alternative technique to control weeds and reduce damage to the environment

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)