New chelate complexes of trivalent Y and lanthanides (Eu, Ho, Yb) with a triazene N-oxide: Synthesis, structural characterization and luminescence properties

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Molecular genetic maps of the group 6 chromosomes of hexaploid wheat (Triticum aestivum L. em. Thell.)

Restriction fragment length polymorphism (RFLP) maps of chromosomes 6A, 6B, and 6D of hexaploid wheat (Triticum aestivum L. em. Thell.) have been produced. They were constructed using a population of F 7-8 recombinant inbred lines derived from a synthetic wheat X bread wheat cross. The maps consist of 74 markers assigned to map positions at a LOD ≥ 3 (29 markers assigned to 6A, 24 to 6B, and 21 to 6D) and 2 markers assigned to 6D ordered at a LOD of 2.7. Another 78 markers were assigned to intervals on the maps. The maps of 6A, 6B, and 6D span 178, 132, and 206 cM, respectively. Twenty-one clones detected orthologous loci in two homoeologues and 3 detected an orthologous locus in each chromosome. Orthologous loci are located at intervals of from 1.5 to 26 cM throughout 70% of the length of the linkage maps. Within this portion of the maps, colinearity (homosequentiality) among the three homoeologues is strongly indicated. The remainder of the linkage maps consists of three segments ranging in length from 47 to 60 cM. Colinearity among these chromosomes and other Triticeae homoeologous group 6 chromosomes is indicated and a consensus RFLP map derived from maps of the homoeologous group 6 chromosomes of hexaploid wheat, tetraploid wheat, Triticum tauschii, and barley is presented.

Method for marginal measurements of restorations: accessory device for toolmakers microscope.

Standardization of measurements for marginal fit of castings is critical. This study describes the fabrication of a device that allowed fixation of specimens on a Toolmakers microscope with identical conditions according to tri-dimensional positioning of specimens, measuring location, and seating force. The device also allows mapping of the marginal discrepancies on the entire marginal perimeter of the tooth preparation.

Study of a fuel cell cogeneration system applied to a Brazilian tertiary sector

In this paper, a methodology for the study of a molten carbonate fuel cell cogeneration system and applied to a computer center building is developed. This system permits the recovery of waste heat, available between 600°C and 700°C, which can be used to the production of steam, hot and cold water, hot and cold air, depending on the recuperation equipment associated. Initially, some technical information about the most diffusing types of the fuel cell demonstration in the world are presented. In conclusion, the fuel cell cogeneration system may have an excellent opportunity to strengthen the decentralized energy production in the Brazilian tertiary sector.

The use of pulsed electric acoustic technique for measuring electric field profiles in ferroelectric ceramic

The pulsed electric acoustic technique, PEA, have been usually applied to probe space charge profiles in polymers. In this work we show preliminary results obtained with lead zirconate-titanate and niobium, PZTN, ferroelectric ceramic samples. Experiments showed that induced charge densities on sample electrodes are mainly due to the ferroelectric polarization of the sample. We present results of the typical PEA response and the procedure to deconvolute the signal in order to obtain the charge densities and the electric field profiles. The PEA setup allows us to show a non-uniform polarization during ferroelectric switching.

Morphological aspects of the capybara stomach (Hydrochaeris hydrochaeris): Gross and microscopic structure

The digestive system of the capybara has been investigated because of its coprofagia habits, important for their absorptive activity. These species present differences in terms of gastrointestinal morphological characters when compared with other rodents. Macroscopiclly, the stomach of the capybara is constituted of the following parts: cardiac, pyloric, body, fundic and gastric diverticulum. It presents two curvatures, one big and another small. Externally, the presence of gastric bands (tenias) is observed. With regards to the volumetric view, the gastric capacity varies from 850 to 2010 ml, with an average of 1498.57 ml. So, the stomach of this animal can be classified as a simple stomach, in the format of a curved sack and similar to an inverted letter 'J'. The gastric mucous membrane presents a surface filled by numerous tortuous gastric folds and longitudinally distributed along all its extension. The mucous tunic also possesses recesses located among the successive gastric folds, which were denoted as gastric parts with numerous openings described as gastric pits. In the cardiac part, a glandular epithelium with cardiac glands is noticed containing a lot of parietal and mucous neck cells. The fundic part, body and gastric diverticulum contain proper gastric glands with main, parietal and mucous neck cells. Finally, the pyloric part has pyloric glands with two cellular types, mucous neck and parietal cells.

Determination of Cu, Ni and Pb in Aqueous Medium by FAAS after Pre-Concentration on 2-Aminothiazole Modified Silica Gel

This work describes the synthesis and characterization of 2-aminothiazole modified silica gel (SiAT), and the results of a study of the adsorption and pre-concentration (in batch and using a flow-injection system coupled to an absorption atomic spectrometer) of Cu(II), Ni(II) and Pb(II) in aqueous medium. The adsorption capacities for each metal ions in mmol g -1 were: Cu(II)= 1.18, Ni(II)= 1.15 and Pb(II)= 1.10. The results obtained in the flow experiments showed a recovery of practically 100% of the metal ions adsorbed in a mini-column packed with 100 mg of SiAT, using 100 μL of 2.0 mol L -1 HCl solution as eluent. The sorption-desorption of the metal ions made possible the application of a flow-injection system for the pre-concentration and quantification by FAAS of metal ions at trace level in natural water samples digested and not digest by an oxidizing UV photolysis.

Evaluation of transfer impressions for osseointegrated implants at various angulations

The accuracy of impressions that transfer the relationship of the implant to the metal framework of the prosthesis continues to be a problem. This study was designed to evaluate the accuracy of the transfer process under variable conditions with regard to implant analog angulations, impression materials, and techniques. Replicas (n = 60) of a metal matrix (control) containing four implants at 90°, 80°, 75°, and 65° in relation to the horizontal surface were obtained by using three impression techniques: T1 - indirect technique with conical copings in closed trays; T2 - direct technique with square copings in open trays; and T3 - square copings splinted with autopolymerizing acrylic resin; and four elastomers: P-polysulfide; I-polyether; A-addition silicone; and Z-condensation silicone. The values of the implant analog annulations were assessed by a profilometer to the nearest 0.017°, then submitted to analysis of variance for comparisons at significance of 5% (P < .05). For implant analog at 90°, the material A associated with T2 and material Z with T3 behaved differently (P < .05) from all groups. At 80°, all materials behaved differently (P < .01) with T1. At 75°, when T1 was associated, materials P and A showed similar behavior, as well as materials I and Z; however, P and A were different from I and Z (P < .01). When T3 was associated, all experimental groups behaved differently among them (P < .01). At 65°, the materials P and Z behaved differently (P < .01) from the control group with T1, T2, and T3; the materials I and A behaved differently from the control group (P < .01) when T1 and T2, respectively, were associated. The more perpendicular the implant analog annulation is in relation to the horizontal surface, the more accurate the impression. The best materials were material I and A and the most satisfactory technique was technique 3.

Studies on the formation of complex coacervates between chitosan and alginate during microparticles preparation

The formation of complex coacervates between chitosan and alginate was evaluated during microparticles formation. Mass ratio between polyelectrolytes and calcium chloride concentration were determinated by conductimetric analysis and by calcium ions quantification, respectively. Inert microparticles were prepared using a complex coacervation method in W/O emulsion and morphological analyses of microparticles were carried out. This method enabled the production of spherical particles, with slightly rough surface and narrow size distribution with maximal diameter of 10 μm.

Espécies reativas de oxigênio no controle neurovegetativo da pressão arterial

The control of the blood pressure depends on the activity of select groups of neurons present in the central nervous system. Evidence has demonstrated that the redox state (a balance between oxidizing and reducing species) is involved in the control of neuronal activity, which suggests that the redox state can influence the neuronal transmission within the central nervous system acting on the neuronal modulation of biological functions. For instance, the glutamatergic transmission may be widely affected by reactive oxygen species, oxidizing agents that have been extensively investigated due to their involvement in physiological and pathological processes. In the present article, we discuss the main experimental finds that support the hypothesis that reactive oxygen species have important role in physiological (and pathological) modulation of the cardiovascular function through alterations in the sympathetic and parasympathetic system. Therefore, reactive oxygen species can actively participate in the development of cardiovascular diseases like hypertension when the balance in the redox state is disrupted.

Incidência de malformações congênitas em crianças concebidas através de injeção intracitoplasmática de espermatozóides

Purpose: to evaluate the incidence and types of major congenital malformations (MCM) in liveborn children conceived by intracytoplasmic sperm injection (ICSI). Methods: a total of 680 liveborn children resulted from 511 couples submitted to ICSI from January, 1999 to December, 2002. Data collection of the children was performed through standardized questionnaire and clinical examination. Of the 511 couples, 366 had been contacted for a sampling of 371 gestations. Of the 680 liveborn, 520 had been evaluated, 250 of them (48.1%) through questionnaire and 270 (51.9%) through questionnaire and physical examination. Two hundred and fifty children were from singleton pregnancies and 270 from multiple pregnancies. Malformations were classified according to the 10th revision of the International Statistical Classification of Diseases and Related Health. Only MCM were analyzed in this study. The incidence of MCM was compared with that of the general population obtained by the Latin American Collaborative Study of Congenital Malformations. The statistical analysis was performed by the χ 2 test (level of significance p<0.05). Results: of the 520 children, 15 presented MCM, resulting in an incidence of 2.9%. There was no difference in relation to the control group (p>0.05), which showed 2.6% incidence of MCM. The most frequent malformations were of cardiac origin (four isolated and two associated), corresponding to 40% of the total. The other types of MCM were: renal (three), neural tube (two), skull (one), cleft lip (one), genital (one), Down syndrome (associated with cardiac malformations) (two), and musculoskeletal (one). Six MCM occurred in children from singleton pregnancies and nine in children from multiple pregnancies. Conclusion: the liveborn children conceived by ICSI presented incidence of major congenital malformations (2.9%) near to the expected for the general population (2.6%). However, to establish the risks of MCM with precision it is necessary to continue the evaluation of the children conceived by ICSI.

Efficacy of ultrasonic, electric and manual toothbrushes in patients with fixed orthodontic appliances

Objective: This crossover study compared the efficacy of an ultrasonic toothbrush for the reduction of plaque, gingival inflammation, and levels of Streptococcus mutans, in relation to an electric and a manual toothbrush. Materials and Methods: Twenty-one patients with orthodontic appliances were divided into three groups. All patients were evaluated by a periodontist and samples of saliva were collected for quantification of S mutans. The patients received their first brushes with appropriate instructions. For each crossover leg, patients used each toothbrush for a period of 30 days. At the end of each washout period, participants received a periodontal evaluation and new samples of saliva were collected. After 15 days of using their own toothbrushes, patients received the next toothbrushes in the experimental sequence. Results: The ultrasonic brush group presented significant improvement in the reduction of visible plaque on the buccal surfaces (-6.36%, P = .007). The counts of S mutans decreased in the electric (2.04 × 105 to 1.36 × 105 colony-forming units [CFU]/mL) and ultrasonic (2.98 × 105 to 1.84 × 105 CFU/mL) groups. There were no statistical differences among the three brushes for the clinical and microbiological parameters evaluated. Conclusions: This study did not demonstrate that the ultrasonic toothbrush was better in reducing gingival inflammation in adolescent orthodontic patients, but plaque scores were lowered on buccal surfaces of teeth with orthodontic brackets. In addition, S mutans counts were markedly decreased in the electric and ultrasonic groups, which should be related to a reduced risk of oral disease. © 2006 by The EH Angle Education and Research Foundation, Inc.

Characterization of blood mononuclear phagocytes in Phrynops hilarii (Chelonia Chelidae)

The localization of peroxidase activity in different cell regions is used as a criterion for the classification of the stage of maturation of mammalian mononuclear phagocytes with a positive peroxidase reaction indicating the presence of monoblasts, promonocytes, monocytes and macrophages. In this study it was evaluated the peroxidase activity of blood mononuclear phagocytes of this turtle detected at different stages of differentiation. The present observations suggest that, in turtles, the differentiation of mononuclear phagocytes occur in the blood circulation, in contrast to animals, where only are monocytes in circulating blood and macrophage differentiation occurs in other body compartments. © 2007 Sociedad Chilena de Anatomía.

Water table effects on bean yield and nitrate distribution in the soil profile

In order to evaluate the bean yield under different water table levels as well as the moisture and nitrate distribution in the soil profile, a field experiment was carried out in the experimental area of the College of Agricultural Sciences - UNESP, Botucatu, SP, Brazil. Beans were grown in field lysimeters under five water table depths: 30; 40; 50; 60 and 70 cm. The moisture in the soil profile was determined gravimetrically using samples collected at 10; 20; 30; 40; 50; 60 and 70 cm deep. The water table depths of 30cm and 40cm showed the highest productivities (3,228.4kg.ha-1 and 3,422.1kg.ha-1, respectively), with no statistical differences between them. The highest productivity was related to the two highest water table levels (30 and 40cm), which provided the highest moisture average values on the basis of volume in the soil profile (33.3 e 31%) as well as the consumptive use of water (416 and 396mm). The nitrate content during the bean cycle at the extraction depth of 60cm was below the safe drinking limit of 10mg.1-1 for water table depths of 30; 40; 50 and 60cm, which shows the denitrification efficiency as a way of controlling nitrate pollution in water tables. The management of water table can lead to high levels of bean yield and to a better control of nitrate pollution in underground water.