Foundry sand recycling in the troughs of blast furnaces: a technical note

The foundry sand agglomerated with alkaline phenolic resin, used for the manufacture of molds, was found to be a residue which is able to be recycled, minimizing the costs of disposal and the environmental impact. This paper analyzes the thermomechanical regeneration and leaching processes and also assesses the influence of additives on the improvement of the mechanical properties of the sands. Besides, the industrial experiments carried out at CSN aiming at the foundry sand recycling in the covering of the blast furnace troughs are presented. (C) 2003 Elsevier B.V. All rights reserved.

Structural and spectroscopic analysis of gamma-Al2O3 to alpha-Al2O3-CoAl2O4 phase transition

Co-doped alumina powders were synthesized by means of the polymeric precursor method to obtain ceramic pigments. The effect of different contents of Co2+ on phase transition gamma to alpha-Al2O3 and appearing of CoAl2O4 spinel were studied by means of X-ray diffraction. A partial phase diagram of the system CoAl2O3 was proposed from these data by means of determination of the percentages of these phases according to the calcining temperature. Critical particle size to phase transition was determined by means of calculations of crystallite size and determination of superficial area through the BET method. UV-vis spectroscopy of the samples allow to compare the band shift with the phase transition. Besides, a study of thermal stability and intensity of the blue coloration of the synthesized powders with the presence of cobalt in relation to the calcining temperature was accomplished and compared to the phase transition. The results show that the higher blue color intensity was obtained for the powders with Co-doped gamma-Al2O3 closest of phase transition to alpha-Al2O3 + CoAl2O4. (c) 2005 Elsevier B.V. All rights reserved.

Interfacial photoluminescence emission properties of core/shell Al2O3/ZrO2

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Effect of temperature on glass-ceramic films prepared by impregnation of commercial float glass surfaces with oxide powders under pressure

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Nanomechanical properties of glass-ceramic films obtained by pressure impregnation of oxide powders on commercial float glass surfaces

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

IR reflectance characterization of glass-ceramic films obtained by high pressure impregnation of SnO2 nanopowders on float glass

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Efeitos do pentobarbital sódico e do enfluorano sobre a circulação sanguínea hepática: fluxometria eletromagnética e manometria (estudo experimental no cão)

In 18 dogs, previously anesthetized with sodium pentobarbital for the surgical preparation, catheterism and monitoring, the action of sodium pentobarbital (7.5 mg/kg) and enflurane (1.5 - 2%) in the liver circulation was studied. Measurements of the following parameters were made in four different times, before and 15, 30 and 60 min after the drug administration. By direct determination: hepatic artery flow, portal vein flow, mean pressure of the abdominal aorta, peripheral arterial pressure (mean), pressure in the caudal cava vein, portal pressure; and by indirect determination: total flow, arterial-cava gradient, portal-cava gradient, resistance in the hepatic artery territory, resistance in the territory of the portal vein, and total resistance. Based on the results, it is concluded that in the experiment's conditions: sodium pentobarbital doesn't change significantly the hepatic circulation, and enflurance produces a fall in the total hepatic flow, by reducing the portal flow, without alterations of the hepatic arterial flow. It diminishes the total hepatic resistance by diminishing the arterial resistance without alterations of the portal resistance; it diminishes the arterial-cava gradient in consequence of the reduction of the abdominal aorta pressure and of the portal pressure, but it seems that the caudal cava pressure is not altered. It also occurs a fall in the peripheral mean pressure.

Efeitos do pentobarbital sódico sobre o fluxo sanguíneo renal. Estudo experimental no cão

In six dogs, previously anesthetized with sodium pentobarbital (30 mg/kg) for surgical preparation, catheterism and monitoring, the action of sodium pentobarbital (7,5 mg/kg) on renal flow was studied. Determinations of mean arterial pressure, venous pressure, cardiac rate, arterio-cava pressure gradient and renal arterial resistance were made. Pentobarbital doesn't change significantly the renal blood flow or any of the other parameters studied, with the exception of venous pressure in the inferior caval vein where the drug produces a significant fall.

ESTUDO DA UMIDIFICACAO E DO AQUECIMENTO DOS GASES INSPIRADOS DURANTE A VENTILACAO MECANICA NO CAO

The authors studied the effect of temperature and humidity of inhaled gases on the respiratory tract of dogs submitted to mechanic ventilation. According to these two variables, fourty dogs were divided in five groups: -G1: 22-26°C and 17-20 mg H2O.l-1; G2: 27-31°C and 23-27 mg H2O.l-1; G3: 32-36°C and 30-36 mg H2O.l-1; G4: 37-41°C and 40-49 mg H2O.l-1; G5: 42-46°C and 59-65 mg H2O.l-1. The following parameters were evaluated: medial arterial pressure, cardiac frequency, venous pressure of inferior cava (CVP), endotracheal pressure, arterial pH, PaO2, PaCO2, rectal temperature, and the histology of the tracheobronchial tree. In the groups G1 and G5, the endotracheal pressure and CVP presented a slight raise. In the groups G1, G2 and G3, there was no histological modification or progressive hypothermia. The group G5 presented metabolic acidosis and great histological alteration; in this group the rectal temperature remained stable. The group G4 presented great histological alteration and hypothermia. In conclusion, the temperature and humidity of inhaled gases should not be higher than 36°C and 36 mm H2O.l-1, respectively. However, the stability of body temperature only is achieved when the temperature of the inhaled air is 42°C or higher.

Innovaciones en la gestión y calidad de los revestimientos refractarios en la Compañía Sideŕurgica Nacional (Brasil)

The work describes actions carried out in colaboration among the National Steel Company - (CSN)-Brazil and the Interdisciplinary Laboratory of Electrochemistry and Ceramic - LIEC of the Federal University of Sao Carlos Brazil (UFSCar-Brazil), in the area of I&D, for integral management and improvement of the quality and performance of the refractory linings in the sintering areas, blast furnace, hot air pipe lines transferency to the blast furnace, pig-iron ladles, running channels, blast furnaces hearths, torpedo car, etc., as well as, the economic impact generated by the installation of the adopted measures.

Heating time required for an MgO-graphite refractory during a hot modulus of rupture test

In the work described in the present paper, an analytical solution of the general heat conduction equation was employed to assay the temperature profile inside a solid slab which is initially at room temperature and is suddenly plunged into a fluid maintained at a high temperature. The results were then extrapolated to a simulation of a hot modulus of rupture test of typical MgO-graphite refractory samples containing different amounts of graphite in order to evaluate how fast the temperature equilibrates inside the test specimens. Calculations indicated that, depending on the graphite content, the time to full temperature homogenization was in the range of 80 to 200 s. These findings are relevant to the high temperature testing of such refractories in oxidizing conditions in view of the graphite oxidation risks in the proper evaluation of the hot mechanical properties.

Anomalia congênita em vasos da base do coração de um potro

Congenital anomalies of heart and large vessels are among more common found in animals, however rare in horses. This survey describes a cardiac anomaly that presents confluence between aorta wall and lung trunk, ramification of caudal cava vein in left atrium with presence of valve and consequently erroneous position of heart in thoracic cavity of one foal found dead after birth. The diagnostic was carried out for macroscopic finds association during the necropsy and histopathologic exams carried out at School of Veterinary Medicine - Unesp Araçatuba.

Microwave-assisted hydrothermal synthesis of ZnO powders with different reagents

In this work, zinc oxide powders were synthesized by microwave-assisted hydrothermal method in basic medium. These powders were analyzed by X-ray diffraction (XRD), Field-emisson gum scanning electron microscopy (FEG-SEM), Ultraviolet-visible (UV-vis) absorption spectroscopy and photoluminescence (PL) measurements. XRD pattern confirmed that the pure ZnO phases were obtained after MH processing performed at 130°C/ 1h. FEG-SEM micrographs reveals that these nanostructures are made up of ZnO plates. UV-vis results were employed to determine the optical band gap these materials. Also, it showed existence of photoluminescence (PL) in the different zinc powders. An orange PL emission when excited by 350 nm wavelength at room temperature was observad in the different powders.

Sintering of porous alumina obtained by biotemplate fibers for low thermal conductivity applications

In this research report, a sintering process of porous ceramic materials based on Al2O3 was employed using a method where a cation precursor solution is embedded in an organic fibrous cotton matrix. For porous green bodies, the precursor solution and cotton were annealed at temperatures in the range of 100-1600°C using scanning electron microscopy (SEM) and thermogravimetric (TG) analysis to obtain a porous body formation and disposal process containing organic fibers and precursor solution. In a structure consisting of open pores and interconnected nanometric grains, despite the low porosity of around 40% (calculated geometrically), nitrogen physisorption determined a specific surface area of 14m2/g, which shows much sintering of porous bodies. Energy dispersive X-ray (EDX) and X-ray diffraction (XRD) analytical methods revealed a predominant amount of α-Al2O3 in the sintered samples. Thermal properties of the sintered Al2O3 fibers were obtained by using the Laser Flash which resulted in the lower thermal conductivity obtained by α-Al2O3 and therefore improved its potential use as an insulating material. © 2012 Elsevier Ltd.

Estruturação ex-vivo de vasos sanguíneos a partir da diferenciação de células tronco de coelhos

Pós-graduação em Pesquisa e Desenvolvimento (Biotecnologia Médica) - FMB