Preparação e estudo termoanalítico dos 4-Clorobenzalpiruvatos de lantanídeos (III) e de ítrio (III) no estado sólido

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Síntese, caracterização, estudo termoanalítico e cinético do 2-metoxibenzalpiruvato de 'MN', 'FE', 'CO', 'NI', 'CU', e 'ZN', no estado sólido

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Magnetoelastic couplings in the distorted diamond-chain compound azurite

We present results of ultrasonic measurements on a single crystal of the distorted diamond-chain compound azurite Cu-3(CO3)(2)(OH)(2). Pronounced elastic anomalies are observed in the temperature dependence of the longitudinal elastic mode c(22) which can be assigned to the relevant magnetic interactions in the system and their couplings to the lattice degrees of freedom. From a semiquantitative analysis of the magnetic contribution to c(22) the magnetoelastic coupling G = partial derivative J(2)/partial derivative epsilon(b) can be estimated, where J(2) is the intradimer coupling constant and epsilon(b) the strain along the intrachain b axis. We find an exceptionally large coupling constant of | G| similar to 3650 K highlighting an extraordinarily strong sensitivity of J(2) against changes of the b-axis lattice parameter. These results are complemented by measurements of the hydrostatic pressure dependence of J2 by means of thermal expansion and magnetic susceptibility measurements performed both at ambient and finite hydrostatic pressure. We propose that a structural peculiarity of this compound, in which Cu2O6 dimer units are incorporated in an unusually stretched manner, is responsible for the anomalously large magnetoelastic coupling.

RAMSY: Ratio Analysis of Mass Spectrometry to Improve Compound Identification

The complexity of biological samples poses a major challenge for reliable compound identification in mass spectrometry (MS). The presence of interfering compounds that cause additional peaks in the spectrum can make interpretation and assignment difficult. To overcome this issue, new approaches are needed to reduce complexity and simplify spectral interpretation. Recently, focused on unknown metabolite identification, we presented a new approach, RANSY (ratio analysis of nuclear magnetic resonance spectroscopy; Anal. Chem. 2011, 83, 7616-7623), which extracts the signals related to the same metabolite based on peak intensity ratios. On the basis of this concept, we present the ratio analysis of mass spectrometry (RAMSY) method, which facilitates improved compound identification in complex MS spectra. RAMSY works on the principle that, under a given set of experimental conditions, the abundance/intensity ratios between the mass fragments from the same metabolite are relatively constant. Therefore, the quotients of average peak ratios and their standard deviations, generated using a small set of MS spectra from the same ion chromatogram, efficiently allow the statistical recovery of the metabolite peaks and facilitate reliable identification. RAMSY was applied to both gas chromatography/MS and liquid chromatography tandem MS (LC-MS/MS) data to demonstrate its utility. The performance of RAMSY is typically better than the results from correlation methods. RAMSY promises to improve unknown metabolite identification for MS users in metabolomics or other fields.

Oil-in-water biocompatible microemulsion as a carrier for the antitumor drug compound methyl dihydrojasmonate

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Fenton-like processes and adsorption using iron oxide-pillared clay with magnetic properties for organic compound mitigation

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Cooperative effects of H+ and H- hydrido carbonyl ruthenium derivatives; role of homogeneous and heterogeneous protonic and lewis acids in catalytic hydrocarbonylation reactions

The role played by H+ hydrido iodocarbonyl and H- hydrido carbonyl ruthenium catalysts in the different catalytic steps of hydroformylation and hydroesterification of olefins, and in the homologation of alcohols has been investigated. The H- hydrido carbonyl species are mainly involved in the activation of olefins and in the hydrogenation of the acyl intermediates to aldehydes and alcohols, whereas the H+ hydrido iodocarbonyl derivatives are involved in the activation of alcohols and other oxygenated substrates, and in their carbonylation to esters. The cooperation between the two species, possible under particular reaction conditions, results in an improvement of the selectivity towards homologation (carbonylation plus hydrogenation) products. Heterogeneous Lewis acid promoters, easily recyclable from the reaction mixture, have also been successfully used in the hydrocarbonylation of alcohols, resulting in an increase of the carbonylation and homologation products. A reaction pathway in agreement with the experimental results is discussed. © 1989.

Synthesis and total 1H- and 13C-NMR assignment of cephem derivatives for use in ADEPT approaches

We report the synthesis and total NMR characterization of 5-thia-1-azabicyclo-[4.2.0]oct-2-ene-2-carboxylic acid-3-[[[(4″- nitrophenoxy)carbonyl]oxy]-methyl]-8-oxo-7-[(2-thienyloxoacetyl)amino] -diphenylmethyl ester-5-dioxide (5), a new cephalosporin derivative. This compound can be used as the carrier of a wide range of drugs containing an amino group. The preparation of the intermediate product, 5-thia-1-azabicyclo[4.2.0] oct-2-ene-2-carboxylic acid-3-[methyl 4-(6-methoxyquinolin-8-ylamino) pentylcarbamate]-8-oxo-7-[(2-thienyloxoacetyl)amino]-diphenylmethyl ester-5-dioxide (6), as well as the synthesis of the antimalarial primaquine prodrug 5-thia-1-azabicyclo[4.2.0]oct-2-ene-2-carboxylic acid-3-[methyl 4-(6-methoxyquinolin-8-ylamino)pentylcarbamate]-8-oxo-7-[(2-thienyloxoacetyl) amino]- 5-dioxide (7) are also described, together with their total 1H- and 13C-NMR assignments. © 2008 by MDPI.

Effectiveness of the compound chlorpyrifos plus cypermethrin plus citronellal against Alphitobius diaperinus. Laboratory analysis and residue determination in carcasses

Biological security and the absence of residues in meat Effectiveness, and/or eggs must be considered when recommending options for the control Alphitobius diaperinus in poultry production environments. This research study evaluated the effectiveness of cypermethrin+chlorpyrifos+citronellal in the control of A. diaperinus, including analysis for the presence of residues of this compound in poultry carcasses (experimental farm). Two studies were carried out under laboratory conditions. One used paper filters a four dilutions of the compound, and the other used a container including with pulverized broiler litter and the compound. The analysis of carcasses for residues was conducted in broilers that raised in a broiler house treated (floor and/or litter) with the compound at a dilution of 1:800. Birds were regularly sacrificed, submitted to necropsy, and liver, muscle and fat fragments were collected. Gas chromatography was used to identify the possible presence of any chemical residue in these samples. High effectiveness rates against A.diaperinus were observed in the two laboratory studies, as well as the absence of residues in the carcasses. This compound, can be recommended as a valuable used in the studied concentrations, alternative for the control and treatment of A. diaperinus.

Anthocyanin incorporated dental copolymer: bacterial growth inhibition, mechanical properties, and compound release rates and stability by (1)h NMR

Objective. To evaluate bacterial growth inhibition, mechanical properties, and compound release rate and stability of copolymers incorporated with anthocyanin (ACY; Vaccinium macrocarpon). Methods. Resin samples were prepared (Bis-GMA/TEGDMA at 70/30 mol%) and incorporated with 2 w/w% of either ACY or chlorhexidine (CHX), except for the control group. Samples were individually immersed in a bacterial culture (Streptococcus mutans) for 24 h. Cell viability (n = 3) was assessed by counting the number of colony forming units on replica agar plates. Flexural strength (FS) and elastic modulus (E) were tested on a universal testing machine (n = 8). Compound release and chemical stability were evaluated by UV spectrophotometry and (1)H NMR (n = 3). Data were analyzed by one-way ANOVA and Tukey's test ( α = 0.05). Results. Both compounds inhibited S. mutans growth, with CHX being most effective (P < 0.05). Control resin had the lowest FS and E values, followed by ACY and CHX, with statistical difference between control and CHX groups for both mechanical properties (P < 0.05). The 24 h compound release rates were ACY: 1.33 μg/mL and CHX: 1.92 μg/mL. (1)H NMR spectra suggests that both compounds remained stable after being released in water. Conclusion. The present findings indicate that anthocyanins might be used as a natural antibacterial agent in resin based materials.

Impacted permanent incisors associated with compound odontoma

Odontomas are the most common odontogenic tumours of the maxillary bones, characterised by a slow growth and benign behaviour. They are usually small, asymptomatic and diagnosed after routine radiographic examination. The aim of this study was to report a case of a compound odontoma in the anterior maxilla of a 7-year-old girl, which was causing the impaction of the maxillary right central and lateral incisors, as well as the prolonged retention of the corresponding primary teeth. We also aimed to review the literature about these tumours, since they are not part of the dentist's day-to-day clinical practice. The clinical and radiographic features, the diagnosis and treatment of the case were discussed in this work.

Genes differentially expressed by Mycobacterium tuberculosis after exposure to ruthenium phosphinic compound and isoniazid

Background- The evaluation of the effects of new compounds and nonconventional anti-tuberculous drugs have grown and become increas-ingly more popular in recent years. Studies have shown anti-tuberculous activity for Ruthenium complexes, including organometallic com-pounds containing phosphine ligands such as picolinic acid generating great expectations and hopes. Methods- The Representational Difference Analysis (RDA) was applied in order to gain insight about differences in expression of Mycobacte-rium tuberculosis H37Rv exposed to [Ru(dppb)(pic)(bypy)] PF6 (SCAR1) and isoniazid (INH). Total RNA was extracted from the bacillus not exposed and exposed to SCAR1 and INH separately at concentration of MIC for 12 hours at 35°C. RDA was carried out and differentially expressed products were sequenced. Results- RDA-sequencing identified, for both compounds, orthologs that encode hypothetical and predict proteins. One related cell wall syn-thesis gene, identified by RDA, and genes related to INH target as inhA, katG and ahpC had their expression confirmed and quantified by real-time PCR. The gene encoding the cell wall associated hydrolase was induced 4.627 and 1.189, inhA 0.983 and 1.027, katG 1.111 and 1.345 and ahpC 1.063 and 1.039 fold after exposure to SCAR1 and INH respectively, compared to not exposed growth. Conclusion- The RDA brings, for the first time, directions to study related genes with metabolic pathways of SCAR1. RDA and Real-Time PCR highlight the idea that one of the SCAR1 interaction, in M tuberculosis may be in the cell wall biosynthesis considering the differential expression of a cell wall hydrolase and warrants further investigation.

Study of elastic properies of Ti3Al intermetallic compound using the ab initio calculation

The elastic properties of a Ti3Al intermetallic compound were studied using full potential (FP LAPW ) with the APW+lo method. The FP-LAPW is among the most accurate band structure calculations currently available and is based on the density functional theory with general gradient approximation for the exchange and correlation potential. This method provides the structural properties of the ground state as bulk modulus, equilibrium lattice parameter, and equilibrium minimum energy, and the elastic properties as shear modulus, young modulus, Zener coefficient (anisotropy), and Poisson coefficient. The calculated elastic properties are coherent with the elastic properties of the material.