Development and Validation of a UV-Spectrophotometric Method for Determination of Flucloxacillin Sodium in Capsules

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Development and validation of a new and rapid HPLC for determination of lyophilized teicoplanin

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Development of a methodology for cost determination of wastewater treatment based on functional diagram

This work describes a methodology developed for determination of costs associated to products generated in a small wastewater treatment station for sanitary wastewater from a university campus. This methodology begins with plant component units identification, relating their fluid and thermodynamics features for each point marked in its process diagram. Following, its functional diagram is developed and its formulation is elaborated, in exergetic base, describing all equations for these points, which are the constraints for exergetic production cost problem and are used in equations to determine the costs associated to products generated in SWTS. This methodology was applied to a hypothetical system based on SWTS former parts and presented consistent results when compared to expected values based on previous exergetic expertise. (C) 2008 Elsevier Ltd. All rights reserved.

Development of a real-time PCR method for rapid sexing of human preimplantation embryos

Genes on the X chromosome are known to be responsible for more than 200 hereditary diseases. After IVF, the simple selection of embryo sex before uterine transfer can prevent the occurrence of affected offspring among couples at risk for these genetic disorders. The aim of this investigation was to develop a rapid method of preimplantation genetic diagnosis (PGD) using real-time polymerase chain reaction (PCR) for the sexing of human embryos, and to compare it to the fluorescence in-situ hybridization technique, considered to be the gold standard. After biopsies were obtained from 40 surplus non-viable embryos for transfer, a total of 98 blastomeres were analysed. It was possible to analyse 24 embryos (60%) by both techniques, generating a total of 70 blastomeres (35 per technique), white 28 blastomeres from 16 embryos (40%) were analysed only by real-time PCR. A rapid and safe method was developed in the present study for the sexual diagnosis of a single human cell (blastomere and buccal cell) using the emerging technology of real-time PCR. (C) 2009, Reproductive Healthcare Ltd. Published by Elsevier Ltd. All rights reserved.

Development and application of methods for determination of residual monomer in dental acrylic resins using high performance liquid chromatography

Two high-performance liquid chromatographic methods for determination of residual monomer in dental acrylic resins are described. Monomers were detected by their UV absorbance at 230 nm, on a Nucleosil((R)) C-18 (5 mu m particle size, 100 angstrom pore size, 15 x 0.46 cm i.d.) column. The separation was performed using acetonitrile-water (55:45 v/v) containing 0.01% triethylamine (TEA) for methyl methacrylate and butyl methacrylate, and acetonitrile-water (60:40 v/v) containing 0.01% TEA for isobutyl methacrylate and 1,6-hexanediol dimethacrylate as mobile phases, at a flow rate of 0.8 mL/min. Good linear relationships were obtained in the concentration range 5.0-80.0 mu g/mL for methyl methacrylate, 10.0-160.0 mu g/mL for butyl methacrylate, 50.0-500.0 mu g/mL for isobutyl methacrylate and 2.5-180.0 mu g/mL for 1,6-hexanediol dimethacrylate. Adequate assay for intra- and inter-day precision and accuracy was observed during the validation process. An extraction procedure to remove residual monomer from the acrylic resins was also established. Residual monomer was obtained from broken specimens of acrylic disks using methanol as extraction solvent for 2 h in an ice-bath. The developed methods and the extraction procedure were applied to dental acrylic resins, tested with or without post-polymerization treatments, and proved to be accurate and precise for the determination of residual monomer content of the materials evaluated. Copyright (c) 2005 John Wiley & Sons, Ltd.

The Tomato (Solanum Lycopersicum cv. Micro-Tom) Natural Genetic Variation Rg1 and the DELLA Mutant Procera Control the Competence Necessary to Form Adventitious Roots and Shoots

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Morphometric changes associated with sex and development in the Malpighian tubules of Aedes aegypti

The Malpighian tubules of Aedes aegypti showed significant differences in their diameters between male and female larvae, male and female pupae, male larvae and male adults and male pupae and male adults. in every case, female values were greater than in males. Measurements of mean nuclear areas of the principal and stellate cells from Malpighian tubules, taken in males and females during development, showed that this parameter in both types of cell was significantly greater in females than in male larvae, pupae and adult stages. In males, significant differences between developmental stages were observed only in comparison with the nuclear area of larvae and adults in the principal cells, but in females, every comparison between stages showed significant differences except between pupae and adults in stellate cells. The frequency distribution of nuclear area values, in development, for male stellate and principal cells, were mostly concentrated in the first seven classes among the 30 classes considered in every stage, while for females, the frequency dropped drastically in the same classes from larvae to pupae and adults, moving to classes of higher values. Considering the importance of Malpighian tubules in insect physiology, the meaning of the differences detected are discussed on the basis of different metabolic levels, between sexes and developmental stages.

Method development for the simultaneous determination of carboxylic acids, phenolic compounds, and sorbic acid in white wines

A reversed phase liquid chromatographic method was developed for the simultaneous determination of carboxylic acids and phenolics in white wines. The samples, diluted, were injected onto a Spherisorb ODS-2 column with a gradient of sulfuric acid (pH 2.5)/methanol as mobile phase. A diode array detector was used which was set at 210nm for carboxylic acids and altered to 278nm, during the run, far phenolics and sorbic acid. The identification of compounds was based on retention time, co-chromatography and UV spectrum. Some clean-up methods (sep-pak C-18 and an ion exchange column) mere tested and did not improve the results.The analysis was simple, with no sample preparation. Application of this method was illustrated by analyses of Brazilian Welchriesling wines.

Development of a sensitive potentiometric sensor for determination of fumaric acid in powdered food products

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Development of an HPLC-UV/Vis method for the determination of dyes in a gasoline sample employing different pre-treatments

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Development of a sensitive passive sampler using indigotrisulfonate for the determination of tropospheric ozone

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Development of a potentiometric sensor for the determination of saccharin in instant tea powders, diet soft drinks and strawberry dietetic jam

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Biochemical traits useful for the determination of genetic variation in a natural population of Myracrodruon urundeuva

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Modelos matemáticos utilizados para descrever curvas de crescimento em aves aplicados ao melhoramento genético animal

A utilização de funções matemáticas para descrever o crescimento animal é antiga. Elas permitem resumir informações em alguns pontos estratégicos do desenvolvimento ponderal e descrever a evolução do peso em função da idade do animal. Também é possível comparar taxas de crescimento de diferentes indivíduos em estados fisiológicos equivalentes. Os modelos de curvas de crescimento mais utilizados na avicultura são os derivados da função Richards, pois apresentam parâmetros que possibilitam interpretação biológica e portanto podem fornecer subsídios para seleção de uma determinada forma da curva de crescimento em aves. Também pode-se utilizar polinômios segmentados para descrever as mudanças de tendência da curva de crescimento animal. Entretanto, existem importantes fatores de variação para os parâmetros das curvas, como a espécie, o sistema de criação, o sexo e suas interações. A adequação dos modelos pode ser verificada pelos valores do coeficiente de determinação (R2), do quadrado médio do resíduo (QM res), do erro de predição médio (EPm), da facilidade de convergência dos dados e pela possibilidade de interpretação biológica dos parâmetros. Estudos envolvendo modelagem e descrição da curva de crescimento e seus componentes são amplamente discutidos na literatura. Porém, programas de seleção que visem a progressos genéticos para a forma da curva não são mencionados. A importância da avaliação dos parâmetros dos modelos de curvas de crescimento é ainda mais relevante já que os maiores ganhos genéticos para peso estão relacionados com seleção para pesos em idades próximas ao ponto de inflexão. A seleção para precocidade pode ser auxiliada com base nos parâmetros do modelo associados à variáveis que descrevem esta característica genética dos animais. Esses parâmetros estão relacionados a importantes características produtivas e reprodutivas e apresentam magnitudes diferentes, de acordo com a espécie, o sexo e o modelo utilizados na avaliação. Outra metodologia utilizada são os modelos de regressão aleatória, permitindo mudanças graduais nas covariâncias entre idades ao longo do tempo e predizendo variâncias e covariâncias em pontos contidos ao longo da trajetória estudada. A utilização de modelos de regressões aleatórias traz como vantagem a separação da variação da curva de crescimento fenotípica em seus diferentes efeitos genético aditivo e de ambiente permanente individual, mediante a determinação dos coeficientes de regressão aleatórios para esses diferentes efeitos. Além disto, não há necessidade de utilizar fatores de ajuste para a idade. Esta revisão teve por objetivos levantar os principais modelos matemáticos frequentistas utilizados no estudo de curvas de crescimento de aves, com maior ênfase nos empregados com a finalidade de estimar parâmetros genéticos e fenotípicos.

Determination of the probable ontogenic time of action of lethal factors on the second chromosome of Drosophila melanogaster derived from a natural population

From the study of the genetic load of second chromosome factors in a natural population of Drosophila melanogaster, 15 lethal-bearing strains were recovered and maintained in the laboratory balanced against Ins (2L + 2R), Cy, L-4. For each lethal factor, the probable time of action during development was determined by the appearance of a sharp reduction, at any given stage, in the frequency of individuals compared to that expected in the absence of the lethal factor. Carried out in this way, the analysis suggested that seven were embryonic lethals, two larval lethals and three pupal lethals. Additionally, three gave no evidence of affecting any of the above-mentioned stages; these are interpreted as gametic lethals.