Marginal adaptation of class II cavities restored with bulk-fill composites

Objectives: To determine the marginal adaptation of bulk-fill composites in class II MO cavities.Methods: Standardized class II MO cavities with bevelled enamel margins were prepared in 40 extracted human molars. The teeth were randomly assigned to one of the five experimental groups (n = 8). The teeth were restored with two horizontal increments of composite (4 mm and 2 mm thickness). The experimental groups were (1st/2nd increment): Gr. A - Venus Bulk-Fill/Venus Diamond; Gr. B - Tetric EvoCeram BulkFill/Tetric EvoCeram; Gr. C - Surefil SDR/Ceram-X; Gr. D - SonicFill; Gr. E - Ceram-X/Ceram-X (control). After finishing procedures, impressions were made using a polyvinyl siloxane and epoxy resin replicas were obtained. Thermo-mechanical stressing was carried out 24 h after the restorative procedure. All specimens were submitted to 240,000 occlusal loading and simultaneous 600 thermal cycles in water at 5 degrees C and 50 degrees C. After loading, a new set of epoxy resin replicas was obtained. Scanning electron microscopy was carried out at 200x magnification. Results for the marginal adaptation were expressed as percentages of continuity relative to the exposed interface and analyzed by ANOVA and Duncan post hoc test (p < 0.05).Results: In enamel, no significant differences were detected before and after thermo-mechanical loading between groups. In dentine, the worst results were observed in Gr. A.Conclusion: By applying simple layering techniques, bulk-fill materials do not allow better marginal adaptation than a standard composite. Clinical significance: A new class of resin-base composite (bulk-fill) was recently launched on the market. The bulk-fill composites exhibited adequate marginal adaptation and similar to the results of the standard composite. (C) 2014 Elsevier Ltd. All rights reserved.

SEM Evaluation of the Interface Between Filling and Root- End Filling Materials

The aim of this ex vivo study was to evaluate, by scanning electron microscopy (SEM), the presence of gaps at the interface between filling material and three root-end filling materials. Thirty human upper molars disto-buccal roots were instrumented and filled with gutta-percha and eugenol-based sealer. The apicoectomy was performed 2mm from the apex and retrograde cavities were prepared with ultrasonic points (3mm in deep). The samples were divided into three experimental groups (n=10): Group Iwhite mineral trioxide aggregate (MTA); Group IISuper EBA; and Group IIIPortland cement. The root-end filling materials were inserted into the retocavities using a MTA carrier. After 48h, the roots were transversally sectioned in order to obtain the apical 5mm. Next, each specimen was prepared longitudinally with crescent granulation of abrasives water-wet sandpapers in order to expose the filling and root-end filling materials. Then, the specimens were subjected to slow dehydration with silica gel, mounted onto specific stubs and coated with paladium coverage for SEM analysis of the interface between filling and root-end filling materials. The percentage of gaps at the interfacial area was calculated by using Image Tool 3.0 software. Super EBA presented the higher percentage of gaps (1.5 +/- 0.67%), whereas MTA presented the lowest values (0.33 +/- 0.20%; p=0.0004). Despite the statistical differences observed between Super EBA and MTA, all the root-end filling materials presented great adaptation to the filling material, presenting small amount of gaps. SCANNING 36:252-257, 2014. (c) 2013 Wiley Periodicals, Inc.

Characterization of Chemically Induced Ovarian Carcinomas in an Ethanol-Preferring Rat Model: Influence of Long-Term Melatonin Treatment

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Interaction of Maternal Separation on the UCh Rat Cerebellum

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Pre-treatment with glutamine reduces genetic damage due to cancer treatment with cisplatin

Cisplatin is an effective antineoplastic drug. However, it provokes considerable collateral effects, including genotoxic and clastogenic activity. It has been reported that a diet rich in glutamine can help inhibit such collateral effects. We evaluated this activity in 40 Swiss mice, distributed into eight experimental groups: G1 - Control group (PBS 0.1 mL/10g body weight); G2 - cisplatin group (cisplatin 6 mg/kg intraperitoneally); G3, G4, G5 - glutamine groups (glutamine at 150, 300, and 600 mg/kg, respectively; orally); G6, G7, G8 - Pre-treatment groups (glutamine at 150, 300, and 600 mg/kg, respectively; orally and cisplatin 6 mg/kg intraperitonially). For the micronucleus assay, samples of blood were collected (before the first use of the drugs at T0, then 24 (T1) and 48 (T2) hours after the first administration). For the comet assay, blood samples were collected only at T2. The damage reduction percentages for the micronucleus assay were 90.0, 47.3, and 37.3% at T1 and 46.0, 38.6, and 34.7% at T2, for G6, G7, and G8 groups, respectively. For the comet assay, the damage reduction percentages were 113.0, 117.4, and 115.0% for G6, G7, and G8, respectively. We conclude that glutamine is able to prevent genotoxic and clastogenic damages caused by cisplatin.

Alcoholic and isocaloric diet, but not ovariectomy, influence the apoptosis of bone cells within the alveolar bone crest of rats

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Bond Strength of Different Resin Cement and Ceramic Shades Bonded to Dentin

Purpose: To evaluate the microtensile bond strength (MTBS) of ceramic cemented to dentin varying the resin cement and ceramic shades.Materials and Methods: Two VITA VM7 ceramic shades (Base Dentine 0M1 and Base Dentine 5M3) were used. A spectrophotometer was used to determine the percentage translucency of ceramic (thickness: 2.5 mm). For the MTBS test, 80 molar dentin surfaces were etched and an adhesive was applied. Forty blocks (7.2 x 7.2 x 2.5 mm) of each ceramic shade were produced and the ceramic surface was etched (10% hydrofluoric acid) for 60 s, followed by the application of silane and resin cement (A3 yellow and transparent). The blocks were cemented to dentin using either A3 or transparent cement. Specimens were photoactivated for 20 s or 40 s, stored in distilled water (37 degrees C/24 h), and sectioned. Eight experimental groups were obtained (n = 10). Specimens were tested for MTSB using a universal testing machine. Data were statistically analyzed using ANOVA and Tukey's post-hoc tests (alpha <= 0.05).Results: The percentage translucency of 0M1 and 5M3 ceramics were 10.06 (+/- 0.25)% and 1.34 (+/- 0.02)%, respectively. The lowest MTBS was observed for the ceramic shade 5M3. For the 0M1 ceramic, the A3 yellow cement that was photocured for 20 s exhibited the lowest MTBS, while the transparent cement that was photocured for 40 s presented the highest MTBS.Conclusions: For the 2.5-mm-thick 5M3 ceramic restorations, the MTBS of ceramic cemented to dentin significantly increased. The dual-curing cement Variolink II photocured for 40 s is not recommended for cementing the Base Dentine 5M3 feldspathic ceramic to dentin.

Reference Gene Selection for Gene Expression Analysis of Oocytes Collected from Dairy Cattle and Buffaloes during Winter and Summer

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Role of Training and Detraining on Inflammatory and Metabolic Profile in Infarcted Rats: Influences of Cardiovascular Autonomic Nervous System

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Safety assessment of oral photodynamic therapy in rats

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Immunological and parasitological parameters in Schistosoma mansoni-infected mice treated with crude extract from the leaves of Mentha x piperita L.

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Avaliação da suplementação intranasal de oxigênio em burros (Equus caballus x Equus asinus) anestesiados com a associação cetamina, butorfanol e éter gliceril guaiacólico

Pós-graduação em Cirurgia Veterinária - FCAV

Influência do tipo de alimento sobre o estabelecimento de Haemonchus contortus em cordeiros

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Efeito da administração da sulpirida no desenvolvimento folicular em éguas

Pós-graduação em Biotecnologia Animal - FMVZ

Avaliação de compósitos á base de celulose bacteriana-hidroxiapatita com peptídeo osteogênico para reparação óssea

Pós-graduação em Odontologia - FOAR