Embryos of common thresher shark Alopias vulpinus in southern Brazil, south Atlantic Ocean

Eight embryonic thresher sharks Alopias vulpinus (53.9-124 cm total length) were collected from two females caught by commercial longline off southern Brazil in September and November 2004. Morphometric measurements are provided. (c) 2006 the Authors.

Use of primers derived from a new sequence of the bovine Y chromosome for sexing Bos taurus and Bos indicus embryos

A bovine male-specific marker was identified in our laboratory through random amplified polymorphic DNA (RAPD) analysis. This fragment of 3216 bp was cloned, sequenced and mapped by fluorescent in situ hybridization (FISH) on the taurine Yq. Primers derived from this sequence were initially screened by polymerase chain reaction (PCR) for their ability to detect Y-specific segments in zebu and taurine genomic DNA. Two of these primers amplified a 655 bp Y-specific sequence present in taurine and zebu male genomic DNA. These primers were then used for detecting the 655 bp male sequence in DNA from 173 zebu and 30 taurine embryos, which had been previously sexed using primers for the sequence BC 1.2. The results revealed an accuracy of 100%. (C) 2002 Elsevier B.V. All rights reserved.

Effects of histone hyperacetylation on the preimplantation development of male and female bovine embryos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Influence of sire breed (Bos indicus versus Bos taurus) and interval from slaughter to oocyte aspiration on heat stress tolerance of in vitro-produced bovine embryos

Based on in vitro experiments, Bos indicus embryos were more resistant to heat stress (HS) than Bos taurus embryos. To increase knowledge regarding differences between Bos indicus and Bos taurus in resistance to HS, the primary objective of this study was to determine if tolerance to HS is due to the breed, origin of the oocyte, sperm, or both. Additionally, the influence of the interval between ovary acquisition (in the abattoir) and oocyte aspiration in the laboratory, on early embryo development was ascertained. Oocytes were collected from Nelore and Holstein cows in an abattoir; 4.0 or 6.5 h later, oocytes were aspired in the laboratory, and then matured and fertilized using semen from Nelore (N), Gir (GIR), or Holstein (H) bulls. Ninety-six h post insemination (hpi), embryos with >= 16 cells were divided in two groups: control and HS. In the control group, embryos were cultured at 39 degrees C, whereas in the HS group, embryos were subjected to 41 degrees C for 12 h, and then returned to 39 degrees C. Rates of cleavage, and formation of morula and blastocysts were higher (P < 0.05) for oocytes aspirated at 4.0 versus 6.5 h after ovaries were acquired. Heat stress decreased rates of blastocyst formation for all breeds (N X N; H x H; and H X GIR) and in both time intervals (4.0 and 6.5 h). However, N X N had higher cleavage rate (P < 0.05) in both time intervals when compared with H X H and H X GIR. In addition, Nelore oocytes fertilized with Nelore semen (N X N) had higher blastocyst yields (P < 0.05) in the control and HS group, when compared with the other two breeds (H X H and H X GIR). We concluded that the breed of origin of the oocyte was more important than that of the sperm for development of thermotolerance, because bull breed did not influence embryo development after HS, and in vitro early embryonic development was impaired by increasing (from 4 to 6.5 h) the interval between ovary acquisition and oocyte aspiration. (C) 2011 Elsevier B.V. All rights reserved.