Phenotypic methods and commercial systems for the discrimination between C-albicans and C-dubliniensis

Candida dubliniensis is a recently described Candida species associated with oral candidosis that exhibits a high degree of phenotypic similarity to Candida albicans. However, these species show differences in levels of resistance to antimycotic agents and ability to cause infections. Therefore, accurate clinical identification of C. dubliniensis and C. albicans species is important in order to treat oral candidal infections. Phenotypic identification methods are easy-to-use procedures for routine discrimination of oral isolates in the clinical microbiology laboratory. However, C. dubliniensis may be so far underreported in clinical samples because most currently used identification methods fail to recognize this yeast. Phenotypic methods depend on growth temperature, carbon source assimilation, chlamydospore and hyphal growth production, positive or negative growth on special media and intracellular enzyme production, among others. In this review, some phenotypic methods are presented with a special emphasis on the discrimination of C. dubliniensis and C. albicans.

Influence of preparation methods and thermal treatment in melt-solidified and cast films of poly(vinylidene fluoride-trifluorethylene) copolymers

This paper is aimed at addressing the differences observed in film properties when poly(vinylidene fluoride-trifluorethylene) P(VDF-TrFE) films are fabricated using distinct methods. Samples were obtained either from casting a solution or by compression molding from a molten phase and characterized by differential scanning calorimetry (DSC). It is shown that the main differences between melt-solidified and cast films arise from the thermal treatment inherent in the former samples.

Real-time monitoring and kinetic parameter estimation of the affinity interaction of jArtinM and rArtinM with peroxidase glycoprotein by the electrogravimetric technique

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Interaction between Li+ and C60 molecules

MNDO calculations with complete geometry optimization were used to calculate the interaction between Li+ and C60, C- 60 and C2- 60 molecules. In order to determine the more stable configuration, Li+ was approximated to the C60 molecule or to their reduced forms from 10 Å up to the geometric center of the molecule. From the simulations we determine that Li+ remains close to the surface at 5 Å from the geometric center of the C60 molecules. © 1995.

Nucleon-nucleon interaction: Central potential and pion production

We show that the tail of the chiral two-pion exchange nucleon-nucleon potential is proportional to the pion-nucleon (πN) scalar form factor and discuss how it can be translated into effective scalar meson interactions. We then construct a kernel for the process NN → πNN, due to the exchange of two pions, which may be used in either three-body forces or pion production in NN scattering. Our final expression involves a partial cancellation among three terms, due to chiral symmetry, but the net result is still important. We also find that, at large internucleon distances, the kernel has the same spatial dependence as the central NN potential and we produce expressions relating these processes directly.

A single-phase single-stage buck-boost inverter intended for low power alternative energy conversion systems: Analysis, design and experimentation

This paper presents the operational analysis of the single-phase integrated buck-boost inverter. This topology is able to convert the DC input voltage into AC voltage with a high static gain, low harmonic content and acceptable efficiency, all in one single-stage. Main functionality aspects are explained, design procedure, system modeling and control, and also component requirements are detailed. Main simulation results are included, and two prototypes were implemented and experimentally tested, where its results are compared with those corresponding to similar topologies available in literature. © 2012 IEEE.

Adaptabilidade e estabilidade de clones de cana-de-açúcar

The objective of this study was to identify clones of sugarcane with good stability and adaptability in the State of São Paulo, Brazil, and also identifying locations most representative for selection and experimentation. Ten clones and two commercial checks of medium-late maturation were evaluated in the first-ratoon of experiments harvested in August 2009, using bissegmented regression and AMMI (Additive Main Effects and Multiplicative Interaction Analysis) methods. The results of two methods were compared and they evidenced that the clones RB975201, RB975157, RB975932, RB975242 and RB975162 are the most promising, showing higher production when compared to the checks, higher stability observed in one or both statistical methods and broader or more specific adaptability. The environment Tarumã presented higher stability and capacity to discriminate genotypes, allowing an ordering more reliable as compared to the overall mean of the environments tested.

Chemical composition of corn and sorghum grains cultivated in oxisol with different application methods and doses of zinc

A.P. Puga, R.M. Prado, B. Mattiuz, D.W. Vale, and I.M. Fonseca. 2013. Chemical composition of corn and sorghum grains cultivated in Oxisol according to different application methods and doses of zinc. Cien. Inv. Agr. 40(1):97-108. In general, tropical soils present low concentrations of zinc (Zn), and the deficiency of Zn is recognized as a world nutritional problem for cereal production and human beings. Therefore, the main goal of this study was to assess the effects of different methods of Zn application on the quality of corn and sorghum grains grown in Oxisol. Two experiments were set up in the experimental area of UNESP (campus of Jaboticabal, Brazil). The following nine treatments were applied: three doses of Zn by banded application (seed furrows), three doses of Zn by incorporation into soil (0-20 cm depth), foliar application, seed application, and control (no Zn applied). The treatments were arranged in randomized blocks with four replicates. The contents of Zn, carbohydrates and proteins were determined for corn and sorghum grains. Regardless of the method, Zn application promoted higher contents of this micronutrient in corn and sorghum grains. The banded application method of Zn in soil promoted greater contents of total carbohydrates, starch and protein in both cultures. The incorporation of Zn into the soil method provided higher contents of soluble carbohydrates in both corn and sorghum grains.

Development of diagnostic methods and study of the immunoreactivity of a mixture of recombinant core and E2 proteins fused to GST with control serum positive for hepatitis C

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Defining functional urban regions in Bahia, Brazil, using roadway coverage and population density variables

The concept of Functional Urban Regions (FURs), also called Metropolitan Regions (MRs), is not simple. It is clear, though, that they are not simply a combination of adjacent municipalities or areas. Different methods can be used for their definition. However, especially in developing countries, the application of some methods is not possible, due to the unavailability of detailed data. Alternative approaches have been developed based on spatial analysis methods and using variables extracted from available data. The objective of this study is to compare the results of two spatial analysis methods exploring two variables: population density and an indicator of transport infrastructure supply. The first method regards Exploratory Spatial Data Analyses tools, which define uniform regions based on specific variables. The second method used the same variables and the spatial analysis technique available in the computer program SKATER - Spatial 'K'luster Analysis by Tree Edge Removal. Assuming that those classifications of regions with similar characteristics can be used for identifying potential FURS, the results of all analyses were compared with one another and with the 'official' MR. A combined approach was also considered for comparison, but none of the results match the existing MR boundaries, what challenges the official definitions. (C) 2014 Elsevier Ltd. All rights reserved.