Analysis on the formation of a FRC by flux measurements and MHD simulations

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

On energy harvesting form time-limited excitations: simulations and case study

Linear resonant harvesters have been the most common type of generators used to scavenge energy from mechanical vibrations. When subject to harmonic excitation, good performance is achieved once the device is tuned so that its natural frequency coincides with the excitation frequency. In such a situation, the average power harvested in a cycle is proportional to the cube of the excitation frequency and inversely proportional to the suspension damping, which is sought to be very low. However, a very low damping involves a relatively long transient in the system response, where the classical formulation adopted for steady-state regimes do not hold. This paper presents an investigation into the design of a linear resonant harvester to scavenge energy from time-limited harmonic excitations involving a transient response, which could be more likely in some practical situations. An application is presented considering train-induced vibrations.

Application of reverse Monte Carlo simulations to diatomic molecules. Part 1. Noncomplete radial distribution functions

The reverse Monte Carlo (RMC) method generates sets of points in space which yield radial distribution functions (RDFS) that approximate those of the system of interest. Such sets of configurations should, in principle, be sufficient to determine the structural properties of the system. In this work we apply the RMC technique to fluids of hard diatomic molecules. The experimental RDFs of the hard-dimer fluid were generated by the conventional MC method and used as input in the RMC simulations. Our results indicate that the RMC method is only satisfactory in determining the local structure of the fluid studied by means of only mono-variable RDF. Also we suggest that the use of multi-variable RDFs would improve the technique significantly. However, the accuracy of the method turned out to be very sensitive to the variance of the input experimental RDF. © 1995.

Structural and functional insights into the conductive pili of Geobacter sulfurreducens revealed in molecular dynamics simulations

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Temperature dependence of conformational properties of short polyelectrolytes from simulations at a single temperature

We use a series expansion method introduced recently by Rickman and Phillpot (Phys. Rev. Lett. 1991, 66, 349) to study the temperature dependent conformational properties of short ionized polyelectrolyte chains in ionic solutions by conducting simulations at a single temperature. The charged beads located at the sites of a cubic lattice interact through screened Coulombic interactions. It is shown that this method provides results that correlate with other Monte Carlo simulations, performed over a range of temperatures, where conformational transitions induced by thermal and screening effects occur. It is also shown that the method can be used successfully when the potential is weakly dependent on temperature. © 1994 American Chemical Society.

Simulations of the Frequency Modulated Atomic Force Microscope (FM-AFM) nonlinear control system

The Frequency Modulated - Atomic Force Microscope (FM-AFM) is apowerful tool to perform surface investigation with true atomic resolution. The controlsystem of the FM-AFM must keep constant both the frequency and amplitude ofoscillation of the microcantilever during the scanning process of the sample. However,tip and sample interaction forces cause modulations in the microcantilever motion.A Phase-Locked Loop (PLL) is used as a demodulator and to generate feedback signalto the FM-AFM control system. The PLL performance is vital to the FM-AFMperformace since the image information is in the modulated microcantilever motion.Nevertheless, little attention is drawn to PLL performance in the FM-AFM literature.Here, the FM-AFM control system is simulated, comparing the performancefor di erent PLL designs.