Osmotic dehydration process for low temperature blanched pumpkin

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of pectinolitic enzymes on the physical properties of caja-manga (Spondias cytherea Sonn.) pulp

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Análise de consistência de iogurte: correlação entre medida sensorial e instrumental

O efeito das variáveis independentes: soro desmineralizado em pó (0,0; 1,5 e 3,0 %), cultura láctica (1,0; 2,0 e 3,0 %) e temperatura de tratamento da mistura (85; 90 e 95°C) foi estudado nas respostas consistência sensorial e instrumental do iogurte. A metodologia de superfície de resposta foi usada para efetuar tratamentos estatísticos dos experimentos e desenvolver modelos matemáticos da relação entre as variáveis e as respostas. A consistência instrumental e sensorial apresentaram resultados semelhantes e correlacionáveis entre si, r = 0,65 (p < 0,01), ambas foram maiores quando aumentou-se a temperatura da mistura e diminuiu-se o teor de soro desmineralizado em pó.

Optimisation of the glycerol-to-ornithine molar ratio in the feed medium for the continuous production of clavulanic acid by Streptomyces clavuligerus

Amino acids are well metabolized by Streptomyces clavuligerus during the production of clavulanic acid using glycerol as main carbon and energy source. However, only a few amino acids such as arginine and ornithine are favorable for CA biosynthesis. The aim of this work was to optimize the glycerol:ornithine molar ratio in the feed medium containing only these compounds to maximize CA production in continuous cultivation. A minimum number of experiments were performed by means of a simple two-level full-factorial central composite design to investigate the combined effect of glycerol and ornithine feeding on the CA concentration during the intermittent and continuous process in shake-flasks. Statistical analysis of the experimental data using the response surface methodology showed that a glycerol-to-ornithine molar ratio of approximately 40:1 in the feed medium resulted in the highest CA concentration when fermentation was stopped. Under these optimized conditions, in bench-scale fermentor runs, the CA concentration reached more than double the concentration obtained in shake-flasks runs. (C) 2009 Elsevier B.V. All rights reserved.

Development, optimization and validation of gas chromatographic fingerprinting of Brazilian commercial gasoline for quality control

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Desenvolvimento de snacks extrusados a partir de misturas de farinha de soja, fécula e farelo de mandioca

Neste trabalho, objetivou-se avaliar o efeito das condições de extrusão sobre as propriedades físicas de produtos extrusados. Foi utilizado o delineamento central composto rotacional com quatro variáveis independentes (2(4)) e a metodologia de superfície de resposta para avaliar os resultados de índice de expansão, volume específico, índice de absorção de água, índice de solubilidade em água e cor, de acordo com as variações de temperatura de extrusão, rotação da rosca, porcentagem de farelo de mandioca e porcentagem de farinha de soja. Os resultados indicam que é possível produzir novos produtos extrusados com boas propriedades físicas a partir de misturas de farinha de soja, fécula e farelo de mandioca.

Physical characteristics of extruded cassava starch

Considerando a importância do amido de mandioca para as indústrias brasileiras, este trabalho teve por objetivo avaliar os efeitos de parâmetros de extrusão sobre as características físicas e propriedades de pasta do amido de mandioca extrusado. Foi utilizado o delineamento fatorial do tipo central composto rotacional com três variáveis independentes (2³) e a metodologia de superfície de resposta para avaliar os resultados de índice de expansão, volume específico, índice de absorção de água, índice de solubilidade em água, cor e propriedades de pasta, de acordo com as variações de umidade, temperatura de extrusão e rotação da rosca. A temperatura de extrusão influenciou o índice de expansão, volume específico, índice de absorção de água, todos os parâmetros de cor e a viscosidade inicial, pico e viscosidade final. Já a umidade teve influência sobre o volume específico, parâmetros de cor, viscosidade final e tendência a retrogradação. A rotação da rosca teve efeito no índice de absorção de água, nos componentes de cor bem como viscosidade final e na tendência à retrogradação do amido extrusado. Nas condições operacionais de elevada umidade inicial da matéria-prima, baixa rotação da rosca e temperatura de extrusão no nível intermediário ocorreu menor degradação do amido, o que é desejável em amidos pré-gelatinizados.

Gelatin-immobilized pectinmethylesterase for production of low methoxyl pectin

The optimum conditions for the production of low methoxyl pectin using pectinmethylesterase (PME) from acerola (Malpighia glabra L.), immobilized in gelatin, have been established by factorial design and response surface methodology. In the case of the free enzymes the optimum conditions for activity, within ranges adequate for food processing, are low NaCl concentrations (0.10 M), relatively high temperatures (55 degreesC) and slightly basic pH values (pH = 9). The temperature and pH seem to have strong influence on the observed activity. In the immobilized enzyme, optimum NaCl concentration was 0.15 M, while the optimum pH remained at 9.0. (C) 2003 Elsevier Ltd. All fights reserved.

Evaluation of the influences of solution path length and additives concentrations on the solar photo-Fenton degradation of 4-chlorophenol using multivariate analysis

This study reports the photodegradation of 4-chlorophenol (4-CP) in aqueous solution by the photo-Fenton process using solar irradiation. The influence of solution path length, and Fe(NO3)(3) and H2O2 concentrations on the degradation of 4-CP is evaluated by response surface methodology. The degradation process was monitored by the removal of total organic carbon (TOC) and the release of chloride ion. The results showed a very important role of iron concentration either for TOC removal or dechlorination. on the other hand, a negative effect of increasing solution path length on mineralization was observed, which can be compensated by increasing the iron concentration. This permits an adjustment of the iron concentration according to the irradiation exposure area and path length (depth of a tank reactor). Under optimum conditions of 1.5 mM Fe(NO3)(3), 20.0 mM H2O2 and 4.5 cm solution path length, 17 min irradiation under solar light were sufficient to reduce a 72 mg C L-1 solution of 4-CP by 91 (c) 2006 Elsevier B.V. All rights reserved.

Multivariate analysis of photo-Fenton degradation of the herbicides tebuthiuron, diuron and 2,4-D

The degradation of herbicides in aqueous solution by photo-Fenton process using ferrioxalate complex (FeOx) as source of Fe2+ was evaluated under blacklight irradiation. The commercial products of the herbicides tebuthiuron, diuron and 2,4-D were used. The multivariate analysis, more precisely, the response surface methodology was applied to evaluate the role of FeOx and hydrogen peroxide concentrations as variables in the degradation process, and in particular, to define the concentration ranges that result in the most efficient degradation of the herbicides. The degradation process was evaluated by the determination of the remaining total organic carbon content (TOC), by monitoring the decrease of the concentrations of the original compounds using HPLC and by the chloride ion release in the case of diuron and 2,4-D. Under optimized conditions, 20min were sufficient to mineralize 93% of TOC from 2,4-D and 90% of diuron, including oxalate. Complete dechlorination of these compounds was achieved after 10 min reaction. It was found that the most recalcitrant herbicide is tebuthiuron, while diuron shows the highest degradability. However, under optimized conditions the initial concentration of tebuthiuron was reduced to less than 15%, while diuron and 2,4-D were reduced to around 2% after only 1 min reaction. Furthermore, it was observed that the ferrioxalate complex plays a more important role than H2O2 in the photodegradation of these herbicides in the ranges of concentrations investigated. (C) 2004 Elsevier Ltd. All rights reserved.

Antibiosis associated to Lactobacillus acidophilus growth .2. Optimization of some culture parameters in whey and soy milk medium

Whey supplemented with soy milk has been used as a low-cost alternative in the growth of Lactobacillus acidophilus for the production of antimicrobial compounds. Response Surface Metodology has been employed in order to study the effects of initial pH, incubation temperature and soy milk rate for supplementation in the production of antimicrobial substance. It has been observed that both tested microrganisms used (S. aureus and E. coli) were inhibited by antimicrobial substance produced by L. acidophilus. The results obtained with E. coli inhibition did not follow the employed statistical model. on the other hand, when the tested microorganism S. aureus was used, the best inhibition results have been obtained when L. acidophilus was incubated at 36.80 degrees C in whey with 5.6 initial pH and 31,90% (v/v) rate supplemented with soy milk. The analysed antimicrobial substances were nor acids neither hidrogen peroxid.

A metodologia de superfície de resposta como ferramenta para a avaliação da produção de alginato e poli-hidroxibutirato pela Azotobacter vinelandii

The response surface methodology as a tool for assessing the production of alginate and polyhydroxybutirate by Azotobacter vinelandii. Alginate is a polysaccharide extracted from cell walls of brown algae and used in the food, pharmaceuticals and biotech industries. Production is concentrated on the cultivation of brown seaweed, but several bacteria of the genus Pseudomonas and Azotobacter produce alginate. The chemical structure of alginates produced by algae is similar to those synthesized by A. vinelandii. The bacteria also produce intracellular polymers such as polyhydroxybutyrate (PHB), known as bioplastic. This work studied the simultaneous alginate and PHB production by A. vinelandii using sucrose and different parameters of fermentation in an orbital shaker. The optimal values for the production of these compounds were determined by the MSR. The first experiment was a 2(6-2) factorial design. The second was based on significant variables of the first, resulting in a full 3(3-0) factorial design. From the first to the second, an increase was observed in the PHB productivity from 12 to 45 mg g(-1) cell h(-1) and alginate from 100 to 1,600 mg g(-1) of cell h(-1). The productivity of both compounds was in the maximum incubation temperature of 62 degrees C, in the shortest time of incubation (18h) and the sucrose concentration, 11 g L(-1). In both experiments the PHB extracted presented purity of 94%.

Produção de biomassa por fungos Filamentosos em meio de vinhaça de cana-de-açúcar suplementado com melaço

Three species of filamentous fungi, Aspergillus niger, Penicillium fellutanum and Mucor hiemalis, were selected and cultivated in vinasse media with different addition of molasses, pasteurized to 85°C for 30 minutes and with pH = 5.0. The microorganisms, previously adapted to the respective medium for 48 hours, from a solution of 107 spores.ml-1, were cultivated in pure and mixed cultures in Erlenmeyer vessel of 500ml, to 30°C, with constant agitation of 170 rpm, for 24, 48 and 72 hours, with four repetition for each samples. The biomass was separated by vacuum filtration in filter Whatman #1 and dried in oven at 105°C until right weight, the obtained liquid was submited to COD analysis. The datas were statistically analysed using a response surface methodology, to improve the effect on the molasses proportion and culture time, in the biomass production by microorganism in research. According to the obtained results (5.02% of molasses, 55.59h, 70% of spores solution of A. niger and 30% of spores solution of P. fellutanum), cultivating was carried out in Microferm Fermentor New Brunswick for 48 hours at 300 rpm, aired at 1v/v/m, using 5 liters of medium added with 5.0% of molasses on the conditions above described. The average of the results obtained (6.81g.l-1) was higher than the confidence interval (5.937 ; 6.369) and was inside the prediction interval (4.471 ; 7.834) both of them significant at 95% by the statistical test employed.

Influence of carrageenan and total solids content on the rheological properties of lactic beverage made with yogurt and whey

The purpose of this work was to study the influence of carrageenan level (X 1) and total solids content of yogurt/whey mixture (X 2) on starter culture fermentation time, physicochetnical properties (pH, fat and total solids contents) and rheological characteristics of lactic beverages using response surface methodology. The physicochemical characteristics of the lactic beverages were similar to those of commercial products. All beverages showed non-Newtonian fluid behavior with thixotropy and yield stress. The total solids content of the lactic beverages had a greater influence on the rheological behavior of these products than the carrageenan level. Wide ranges of consistency measurements were observed by varying the stabilizer level and total solids content.

Simultaneous effects of total solids content, milk base, heat treatment temperature and sample temperature on the rheological properties of plain stirred yogurt

Response surface methodology was used to establish a relationship between total solids content, milk base, heat treatment temperature, and sample temperature, and consistency index, flow behaviour index, and apparent viscosity of plain stirred yogurts. Statistical treatments resulted in developments of mathematical models. All samples presented shear thinning fluid behaviour. The increase of the content of total solids (9.3-22.7 %) and milk base heat treatment temperature (81.6-98.4°C) resulted in a significant increase in consistency index and a decrease in flow behaviour index. Increase in the sample temperature (1.6-18.4°C) caused a decrease in consistency index and increase in flow behaviour index. Apparent viscosity was directly related to the content of total solids. Rheological properties of yogurt were highly dependent on the content of total solids in milk.