Optical and electrical diagnostics of a spark-plug discharge in air

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Evaluation of residual iron in carbon nanotubes purified by acid treatments

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Meta-análise de parâmetros genéticos relacionados ao consumo alimentar residual e a suas características componentes em bovinos

The objective of this work was to estimate, by meta-analysis, the heritability (h(2)) and the genetic (r(g)) and phenotypic (r(f)) correlations of residual feed intake (RFI), and of its component traits in beef cattle from 19 breeds or genetic groups. Twenty-two scientific papers published from 1963 to 2011, from eight countries, totaling 52,637 cattle of ages from 28 days up to slaughter, were evaluated. The estimates of RFI, dry matter intake (DMI), average daily gain (ADG) and metabolic weight (BW0.75) were weighted by the inverse of sample variance. The variation between studies of h(2) for each trait was analyzed by weighted least squares. The effects of sex, country and breed were significant for h(2) of RFI, explaining 67% of variation between studies. For DMI, country and breed effects were significant and explained 96% of variation. Pooled estimates of h(2) were: 0.255+/-0.008, 0.278+/-0.012, 0.321+/-0.015, and 0.397+/-0.032 for RFI, DMI, ADG and BW0.75, respectively. Pooled estimates of genetic and phenotypic correlations were low between RFI and ADG and between RFI and BW0.75 (from -0.021+/-0.034 to 0.025+/-0.035), and moderate between RFI and DMI (0.636+/-0.035 and 0.698+/-0.041) and between DMI, ADG and BW0.75 (0.441+/-0.062 to 0.688+/-0.032). The trait RFI has lower heritability estimates than its components.

Squamous cell carcinoma in a residual mandibular cyst

Described is a case of squamous-cell carcinoma arising in a residual cyst in a 60-year-old edentulous woman. The clinical and radiographic diagnosis was residual cyst, and the treatment employed was conservative surgical enucleation. The cause of these changes is unknown. Theoretically, the inflammatory reaction may have been a predisposing factor.

Densification and residual stresses induced in glass surfaces by Vickers indentations

Images and profiles of Vickers impressions produced on as-received float-glass were obtained using atomic force microscopy (AFM). The images show that the impression edges undergo elastic recovery parallel to surface. The profiles made it possible to measure vertical elastic recovery, ev(r). For a 40 g nominal load, maximum penetration depth of indenter was (2.20 ± 0.03) μm, and recovery at the impression center was ev(0) = (0.98 ± 0.03) μm. Vertical elastic recovery was non-uniform along profiles. Permanent impressions produced resulted from glass mass displacement downward, producing an increase in glass density in impression vicinity, which is discussed in terms of changes in O-Si-O and Si-O-Si bond angles and Si-O bond length. Near impression edges, pileup was observed for which a simplified model is proposed taking into account the compaction and stresses near the impressions. © 2000 Elsevier Science B.V. All rights reserved.

Residual antibacterial activity of chlorhexidine digluconate and camphorated p-monochlorophenol in calcium hydroxide-based root canal dressings

The purpose of this study was to evaluate the residual antibacterial activity of several calcium hydroxide [Ca(OH) 2]-based pastes, placed in root canals of dogs' teeth with induced chronic periapical lesions. Root canals were instrumented with the ProFile rotary system and filled with 4 pastes: G1 (n=16): Ca(OH) 2 paste + anesthetic solution; G2 (n=20): Calen® paste + camphorated pmonochlorophenol (CMCP); G3 (n=18): Calen®; and G4 (n=18): Ca(OH) 2 paste + 2% chlorhexidine digluconate. After 21 days, the pastes were removed with size 60 K-files and placed on Petri plates with agar inoculated with Micrococcus luteus ATCC 9341. Pastes that were not placed into root canals served as control. After pre-diffusion, incubation and optimization, the inhibition zones of bacterial growth were measured and analyzed by Mann-Whitney U test at 5% significance level. All pastes showed residual antibacterial activity. The control samples had larger halos (p<0.05). The mean residual antibacterial activity halos in G1, G2, G3 and G4 were 7.6; 10.4; 17.7 and 21.4 mm, respectively. The zones of bacterial growth of G4 were significantly larger than those of G1 and G2 (p<0.05). In conclusion, regardless of the vehicle and antiseptic, all Ca(OH) 2-based pastes showed different degrees of measurable residual antibacterial activity. Furthermore, unlike CMCP, chlorhexidine increased significantly the antibacterial activity of Ca(OH) 2.

The influence of residual salivary fluoride from dentifrice on enamel erosion: An in situ study

The objective of this study was to assess the salivary residual effect of fluoride dentifrice on human enamel subjected to an erosive challenge. This crossover in situ study was performed in two phases (A and B), involving ten volunteers. In each phase, they wore acrylic palatal appliances, each containing 3 human enamel blocks, during 7 days. The blocks were subjected to erosion by immersion of the appliances in a cola drink for 5 minutes, 4 times a day. Dentifrice was used to brush the volunteers' teeth, 4 times a day, during 1 minute, before the appliance was replaced into the mouth. In phases A and B the dentifrices used had the same formulation, except for the absence (PD) or presence (FD) of fluoride, respectively. Enamel alterations were determined using profilometry, microhardness (%SMHC), acid- and alkali-soluble F analysis. The data were tested using ANOVA (p < 0.05). The concentrations (mean ± SD) of alkali- and acid-soluble F (μgF/cm 2) were, respectively, PD: 1.27 a ± 0.70/2.24∧ A ± 0.36 and FD: 1.49 a ± 0.44/2.24∧ ± 0.67 (p > 0.05). The mean wear values (± SD, μm) were PD: 3.63 a ± 1.54 and FD: 3.54 a ± 0.90 (p > 0.05). The mean %SMHC values (± SD) were PD: 89.63 a ± 4.73 and FD: 87.28 a ± 4.01 (p > 0.05). Thus, we concluded that the residual fluoride from the fluoride-containing dentifrice did not protect enamel against erosion.

Efeito residual de calcário, nitrogênio e zinco na produção de matéria seca de Brachiaria decumbens em condições de campo

The balance of liming and fertilization practice with nitrogen and zinc could affect the production of the pasture. Thus, the present work has as objective to evaluate the residual effect of the application of calcareous rock, nitrogen, and zinc on the dry matter production of Brachiaria decumbens, during three cuts. For this, an experiment was installed in Selvíria, Brazil, on a distrofic red Latosol, from october 1997 to may 1998. The experimental design was randomized blocks, in a factorial project 3×3×2, with four repetitions. The treatments were three doses of nitrogen: 0, 50, and 100 kg/ha, three doses of lime: 0, 267, and 556 kg/ha, corresponding to 41, 50, and 60% of the levels of base saturation, respectively, and two doses of zinc 0 and 5 kg/ha, applied in the first year and reapplied in the second year, except for the limestone. Four cuts were done in the grass at 10 cm of height, with intervals of 49 days, to obtain the dry matter production. The limestone application in the first year did not provide to residual effect on the production of Brachiaria decumbens. However, the nitrogen fertilization increased the dry matter production of the grass. The application of zinc in the first year and the reapplication in the second year did not result in a productive response of B. decumbens. © 2009 Instituto Nacional de Investigaciones Agricolas INIA.

Influence of grinding on the roundness, residual stresses and microstructure of VC131 steel analysed by varying the type of cutting fluid

This paper by R. E. Catai, E. C. Bianchi, P. R de Águia and M. C. Alves reports on the results of an analysis made of roundness errors, residual stresses, and SEM micrographs of VC131 steel. The analysis involved workpieces ground with two types of cutting fluid: synthetic cutting fluid and emulsive oil. In this study, the cutting parameters were kept constant while the type of cutting fluid was varied. The amount of cutting fluid injected in the process was also varied, aiming to identify the ideal amount required to obtain good results without causing structural damage to the workpiece. The SEM analyses of roundness errors and residual stresses revealed that, of the two cutting fluids, emulsive oil provided better tensions due to its greater lubricating power.

Desempenho dinâmico de um trator agrícola utilizando biodiesel destilado de óleo residual

The objective of this study was to evaluate the dynamic performance of an agricultural tractor utilizing distilled biodiesel (50% ethylic + 50% methylic) as a function of the proportion of biodiesel and diesel of petroleum (0 and 100%, 5 and 95%, 15 and 85%, 25 and 75%, 50 and 50%, 75 and 25% and 100 and 0%), respectively. This research was done in the area of the Department of Rural Engineering of the Paulista State University (UNESP), Jaboticabal Campus, SP, located in the latitude 21° 14′ 28″ S and longitude 48° 17′12″ W. A tractor 4 x 2 FWA was used, with a 73.6 kW (100 HP) motor and a ballast tractor. The biodiesel used was produced from spent oil from food frying. The experimental design was entirely randomized, with 7 treatments and 5 repetitions, totaling 35 observations. The results showed that the biodiesel and diesel blend significantly influenced the hourly volumetric consumption, hourly mass consumption, fuel consumption per worked area and specific fuel consumption variables. When the tractor operated with 100% of biodiesel (B100) the specific fuel consumption increased 18% on average in relation to diesel (B0).

Qualidade química da água residual da criação de peixes para cultivo de alface em hidroponia

Aiming to evaluate the association of hydroponic lettuce cultivation with residues from a fish intensive breeding system, a project was carried out in the Aquaculture Center in the FCAV-UNESP at Jaboticabal, SP, Brazil. A closed system was designed in order to allow the water to circulate through the fish tanks, a clarifier tank for removal of residues, a reservoir for biological conversion of ammonia into nitrate, and the hydroponic system. After this process, water returned back to the fish tanks. Three varieties of lettuce, constituting the treatments with four repetitions were evaluated. The results of the chemical analysis of the residual water from the fish tanks indicated the presence of the majority of the mineral nutrients necessary for vegetable development. Their concentration was close to that found in nutrient solutions, used for lettuce hydroponic cultivation, except for potassium and magnesium. The low concentration of magnesium in the water did not prevent lettuce development, although the plants presented visual symptoms of deficiency of this nutrient. Differences were not found between the varieties produced, regarding productivity and the mean weight of fresh plants.

The use of molecular spectra simulation for diagnostics of reactive flows

The C 2 * radical is used as a system probe tool to the reactive flow diagnostic, and it was chosen due to its large occurrence in plasma and combustion in aeronautics and aerospace applications. The rotational temperatures of C 2 * species were determined by the comparison between experimental and theoretical data. The simulation code was developed by the authors, using C++ language and the object oriented paradigm, and it includes a set of new tools that increase the efficacy of the C 2 * probe to determine the rotational temperature of the system. A brute force approach for the determination of spectral parameters was adopted in this version of the computer code. The statistical parameter c 2 was used as an objective criterion to determine the better match of experimental and synthesized spectra. The results showed that the program works even with low-quality experimental data, typically collected from in situ airborne compact apparatus. The technique was applied to flames of a Bunsen burner, and the rotational temperature of ca. 2100 K was calculated.

Plasma suíno e ovo inteiro em rações de leitões sobre desempenho na fase inicial e efeito residual até a terminação

Were used 64 weaned pigs, distributed in eight treatments: ration with skim milk (SM), three rations with crescent levels of swine plasma (SP), three rations with whole egg (WE) and a ration with high inclusion of soybean meal (SB). Daily weight gain (DWG), daily feed intake (DFI) and feed conversion (FC) were evaluated. The animals that consumed ration SB have the mean of DWG higher that other treatments, and inferior FC, from 35 to 48 days of age. The crescent levels of SP promoted linear reduction in DWG, from 21 to 35, and from 35 to 48 days of age, in DFI from 48 to 138 days of age and linear increased in FC from 21 to 35 of age. Considering the weaned phase until finishing, initial rations can be formulated with SP and WE substituted partially the CP of skim milk in 25 and 45%, respectively.