Clinical Satisfaction and Quality of Ceramic Fixed Dentures

It is known that several factors can affect the clinical success and durability of fixed partial dentures. Therefore, the aim of the present study was to present a literature review about the longevity, clinical success, and quality, as well as, patients' and dental surgeons' satisfaction of ceramic fixed dentures. High rate of patients' satisfaction has been observed in relation to the esthetic of ceramic crowns. In addition, the literature has shown that dental ceramics can be used in several clinical situations with high success rate and longevity. Despite of failures and complications of ceramic restorations, nowadays, with the improvement of mechanical properties of such materials, ceramic crowns present a favorable prognosis and can be used in several clinical situations with high success rate, clinical quality, and great patients' satisfaction. © 2013 The American Ceramic Society.

Comparison of different designs of implant-retained overdentures and fixed full-arch implant-supported prosthesis on stress distribution in edentulous mandible - A computed tomography-based three-dimensional finite element analysis

A finite element analysis was used to compare the effect of different designs of implant-retained overdentures and fixed full-arch implant-supported prosthesis on stress distribution in edentulous mandible. Four models of an human mandible were constructed. In the OR (O'ring) group, the mandible was restored with an overdenture retained by four unsplinted implants with O'ring attachment; in the BC (bar-clip) -C and BC groups, the mandibles were restored with overdentures retained by four splinted implants with bar-clip anchor associated or not with two distally placed cantilevers, respectively; in the FD (fixed denture) group, the mandible was restored with a fixed full-arch four-implant-supported prosthesis. Models were supported by the masticatory muscles and temporomandibular joints. A 100-N oblique load was applied on the left first molar. Von Mises (σvM), maximum (σmax) and minimum (σmin) principal stresses (in MPa) analyses were obtained. BC-C group exhibited the highest stress values (σvM=398.8, σmax=580.5 and σmin=-455.2) while FD group showed the lowest one (σvM=128.9, σmax=185.9 and σmin=-172.1). Within overdenture groups, the use of unsplinted implants reduced the stress level in the implant/prosthetic components (59.4% for σvM, 66.2% for σmax and 57.7% for σmin versus BC-C group) and supporting tissues (maximum stress reduction of 72% and 79.5% for σmax, and 15.7% and 85.7% for σmin on the cortical and trabecular bones, respectively). Cortical bone exhibited greater stress concentration than the trabecular bone for all groups. The use of fixed implant dentures and removable dentures retained by unsplinted implants to rehabilitate edentulous mandible reduced the stresses in the periimplant bone tissue, mucosa and implant/prosthetic components. © 2013 Elsevier Ltd.

Determinação da resistência à flexão de ligas odontológicas, utilizadas em prótese parcial fixa e prótese sobre implante, soldadas por brasagem e a laser

Pós-graduação em Odontologia Restauradora - ICT

Clinical evaluation of failures in removable partial dentures

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of the addition of wheat fiber and partial pork back fat on the chemical composition, texture and sensory property of low-fat bologna sausage containing inulin and oat fiber

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Zirconia-based dental crown to support a removable partial denture: a three-dimensional finite element analysis using contact elements and micro-CT data

Veneer fracture is the most common complication in zirconia-based restorations. The aim of this study was to evaluate the mechanical behavior of a zirconia-based crown in a lower canine tooth supporting removable partial denture (RPD) prosthesis, varying the bond quality of the veneer/coping interface. Microtomography (μCT) data of an extracted left lower canine were used to build the finite element model (M) varying the core material (gold core - MAu; zirconia core - MZi) and the quality of the veneer/core interface (complete bonded - MZi; incomplete bonded - MZi-NL). The incomplete bonding condition was only applied for zirconia coping by using contact elements (Target/Contact) with 0.3 frictional coefficients. Stress fields were obtained using Ansys Workbench 10.0. The loading condition (L = 1 N) was vertically applied at the base of the RPD prosthesis metallic support towards the dental apex. Maximum principal (σmax) and von Mises equivalent (σvM) stresses were obtained. The σmax (MPa) for the bonded condition was similar between gold and zirconia cores (MAu, 0.42; MZi, 0.40). The incomplete bonded condition (MZi-NL) raised σmax in the veneer up to 800% (3.23 MPa) in contrast to the bonded condition. The peak of σvM increased up to 270% in the MZi-NL. The incomplete bond condition increasing the stress in the veneer/zirconia interface.

Estimation of genetic parameters for partial egg production periods by means of random regression models

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Controle estatístico aplicado ao processo de colheita mecanizada diurna e noturna de cana-de-açúcar

The system of mechanized harvesting can seek process improvements using quality tools that can assist in reducing losses, damaged ratoons and increase the longevity of sugarcane crop. Therefore, the objective this study was to detect the effective control of the variability of losses and damage to ratoon and identify whether they are within acceptable standards. Thus, 40 points were sampled in two periods of harvest, diurnal and nocturnal, in rectangular grids (55 x 45 m) for determining visible losses (whole and shattered billets, fixed and loose piece, stump and shrapnel), using frames of 10 m(2). Also, we measured the height of cut and degree of damage to ratoon (without damage, partial injury and fragmentation). The statistic used was descriptive variables for the loss of sugarcane during the diurnal (D) and nocturnal (N) periods, analysis of variance using the F test at 5% probability and the Tukey test for comparison of the mean, also using the statistical control through charts process. There was no difference to ratoon damage. In the process of harvest, losses of whole and shattered billets by grinding were considered under control, so as losses from the stump. on the other hand, the losses of fixed piece, shrapnel and whole-cane were not controlled. The cutting height and total losses were higher during the nocturnal harvest. The charts were shown to be effective for the evaluation of control process of diurnal and nocturnal harvests.

Fertility Rates Following Fixed-Time Artificial Insemination in Dairy Heifers in a Practical Progesterone-Based Protocol

Background: In bovines, more efficient management practices are important for maximizing profitability. In order to increase the pregnancy rates in artificial insemination (AI) programs, several hormonal protocols were developed to synchronize the follicular wave and the moment of ovulation in beef and dairy cattle. In dairy cattle, detection of estrus can be difficult due to a number of factors including the incidence of silent estrus. Hormonal treatments designed to control both luteal and follicular function has permitting efficient synchronizations of time of ovulation. Thus, the AI can be performed in a large number of animals on a fixed schedule without the need for detection of estrus. Using these management techniques, the fixed-time artificial insemination (TAI) can overcome the problem of accurate estrus detection and help in reducing the incidence of repeat breeding. In addition, with TAI in cattle operations, it is possible to facilitate management practices and commercialization, and to reduce the time and semen wasting with animals inseminated at incorrect times. The investigation of practical and efficient TAI protocols is important for reducing the labor and animal handling of TAI in dairy cattle, as well as for increasing the profitability of the cattle management system. This study was carried out in order to investigate the effectiveness of TAI in dairy heifers treated with a practical progesterone-based protocol.Materials, Methods & Results: This experiment was conducted at the university farm located in southwestern Brazil, during May 2009. Thirty-nine cycling crossbred dairy heifers were employed in this study. All animals received a single intramuscular injection of estradiol benzoate and intravaginal progesterone releasing device in a random stage of the estrous cycle (Day 0). on day 7 the animals were treated with PGF2a analogue and on day 9 the device was removed. Forty-eight hours after the device removal (day 11) a synthetic analogue of GnRH was administered and the animals were fixed-time artificially inseminated at the time of GnRH injection. The inseminations were performed using four different batches from the same Holstein bull. Among the heifers that were synchronized (87.2%), 30.8% ovulated until 24 h after TAI and 56.4% ovulated between 24 and 32 h after TAI. The conception rate was 61.5%. No effects of ovulation time in conception rates were detected. The conception rate from heifers that ovulated until 24 h after TAI was 58.3% and from heifers that ovulated between 24 and 32 h after TAI was 77.3%. The mean of ovulatory follicle in heifers that ovulated until 24 h was 14.3 mm and in heifers that ovulated between 24 and 32 h was 11.9 mm.Discussion: Taking together, the findings of the present study, along with those of others, emphasize the concept that development of practical methods for TAI offers significant advantages to dairy producers if conception rates are close or greater to those obtained after breeding at detected estrus. Thus, the results of the present study reinforce the possibility of making dairy cattle production more cost-effective using TAI. In conclusion, with the progesterone-based TAI protocol of the present experiment all synchronized animals ovulated up to 32 h after GnRH+TAI and no effects of ovulation time related to conception rate was detected. The exogenous control of luteal and follicular development facilitated the reproductive management and animal handling. Also, inseminating the heifers at the moment of GnRH injection in a progesterone-based TAI protocol is a practical strategy and provided satisfactory results regarding ovulation and conception rates in dairy heifers.

Partial protection against tissue cysts formation in pigs vaccinated with crude rhoptry proteins of Toxoplasma gondii

A vaccine containing crude Toxoplasma gondii rhoptry proteins incorporated in the immunostimulating complexes (ISCOM) adjuvant was tested in pigs for protecting against tissue cyst formation. For this, 38 mixed breed pigs were divided into four groups, G1 (vaccinated challenged, n = 10) received two doses (100 mu g/dose) of the rhoptry vaccine at days 0 and 21, G2 (vaccinated challenged, n = 10) received viable tachyzoites (7 x 10(7)) of the RH strain at day 0, G3 (unvaccinated challenged, n = 10) and G4 (unvaccinated unchallenged, n = 8). Pigs were challenged with 4 x 10(4) VEG strain oocysts 57 days later. The G1 pigs produced high IgG antibody levels in the indirect enzyme-linked immunosorbent assay (ELISA) after the second dose of rhoptry vaccine, but were not clinically protected against a high dose oocyst challenge. Partial protection was observed in G1 at the chronic phase of infection, when compared with G3. Pigs in group 2 developed high antibody levels and were protected against clinic signs. T gondii was not detected in two (G1) and three (G2) pigs by mouse bioassay. The results indicate partial protection in pigs vaccinated with a rhoptry vaccine. (c) 2005 Elsevier B.V. All rights reserved.

Detection of bovine herpesvirus 5 (BoHV-5) in formalin-fixed, paraffin-embedded bovine brain by nested PCR in Colombian cattle

Fifteen cases of viral meningoencephalitis in Colombian cattle were tested by nested PCR analysis for the detection of bovine herpesvirus 5 (BoHV-5). All fatal cases had shown severe neurological signs and had occurred following natural outbreaks of the disease. The neurological infection was histologically characterized by mild to moderate inflammatory changes in the brain and cerebellum, including meningitis, mononuclear perivascular cuffing, gliosis, haemorrhage, and the presence of Gitter cells (macrophages) accompanying large areas of malacia. No intranuclear inclusion bodies were seen in any of the cases. Results from BoHV-5 molecular extraction analyses showed there were five positive cases thus confirming the presence of the virus in Colombia.

Poultry feed metabolizable energy determination using total or partial excreta collection methods

The aim of this work was to compare the efficiency of total (TC) or partial (PC) collection excreta methods to determine metabolizable energy in poultry feeds. A number of 180 12- to 21-day-old broilers were distributed into two treatments of six replicates of 10 birds each. A reference-diet was formulated to supply broiler requirements, and the test-diets consisted of 60% of reference diets and 40% of corn or soybean meal. Celite was added at 1% to the diets as a marker. Excreta and diet samples were analyzed for dry matter, energy, nitrogen, and acid-insoluble ash (AIA). AME of corn determined by partial collection (PC) was higher (3544 kcal/kg) as compared to total collection (TC) (3133 kcal/kg). However, no difference were observed for soybean meal (1797 vs. 1821 kcal/kg) between both methods. Marker recovery rates in the excreta were 101, 111, and 96% for the basal-diet, and the test-diets with corn or soybean meal, respectively. This result indicates the importance of marker recovery rate in the excreta to evaluate feed AME and digestibility.