232 resultados para Load test on SPT sampler
Resumo:
Ovigerous females of Ucides cordatus were collected at different mangrove areas in Iguape, SP, Brazil, and reared in the laboratory in order to describe each embryonic stage. Accounts of the biometry, internal morphology, and coloration of the eggs were taken. The embryonic development took 19 +/- 1d (27degreesC, 12:12 h) with eight well-defined stages. A salinity test on embryonic development was conducted, and a better result was obtained in a rearing at 15parts per thousand. Eggs are slightly ellipsoid through development and undergo an increase of 13.9% in diameter to 91.7% in volume. Cluster analysis revealed three different groups for diameter (Stages I-II, III-VI, and VII-VIII) and volume (Stages I-III, IV-V, and VI-VIII), supporting the classification of embryos into initial, intermediate, and final stages, which are currently used in studies on the reproductive biology of decapod crustaceans. In this species, the identification of the different embryonic stages can be achieved only if biometric data are combined with information on the internal morphology of embryos and coloration of the eggs.
Resumo:
In a program of seed quality assurance, the evaluation of seed vigor is fundamental and necessary to the global production process outcome. The objective of this study was to evaluate the efficiency of the precocity of primary root emission test, for the substrates paper roll, on paper and between papers, on vigor of pearl millet seeds. Ten seed lots evaluated in four replication of 100 pearl millet seeds cultivar ADR 500 were sown in three different humidified substrates: between papers, paper roll and on paper. These were incubated at a temperature of 20-30 degrees C. Fifteen hours after the germination test was established, the emission of seed primary roots started to be observed every 2 hours up to 25 hours and then after 48 hours. For the comparison among lots, seeds were also evaluated by moisture content, weight of 1000 seeds, germination and vigor (first count, electrical conductivity, accelerated aging and seedling emergence). The statistical design was completely randomized, and the means comparisons were accomplished by the Tukey test at 0.05 level of probability. It was concluded that the precocity of primary root emission test on paper is promising for vigor evaluation of pearl millet seeds.
Resumo:
Objetivou-se com esse trabalho estabelecer parâmetros para a avaliação da qualidade fisiológica de sementes de mamoneira (Ricinus communis L.) pelo teste de tetrazólio. Avaliaram-se cinco lotes de sementes quanto à viabilidade e ao vigor pelo teste de tetrazólio e os resultados comparados aos obtidos nos testes de germinação em areia, germinação em papel, primeira contagem da germinação em papel, emergência de plântulas em campo, índice de velocidade de emergência, classificação do vigor de plântulas, comprimento das plântulas, massa da matéria seca de plântulas e envelhecimento acelerado. O delineamento experimental empregado foi o inteiramente casualizado, e a comparação de médias realizada pelo teste de Tukey a 5% de probabilidade. Os resultados de viabilidade do teste de tetrazólio se correlacionaram com o teste de germinação em areia, com a emergência em campo e com o comprimento de plântulas, e os de vigor do teste de tetrazólio com a classificação do vigor de plântulas. Concluiu-se que os parâmetros estabelecidos são eficientes para a avaliação da viabilidade e promissores para a avaliação do vigor de sementes de mamoneira pelo teste de tetrazólio.
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
No Estado do Tocantins, no Norte do Brasil, a incidência de rizoctoniose no arroz é importante, causando danos significativos em lavouras de arroz irrigado. O principal objetivo deste trabalho foi determinar o grupo de anastomose (AG) de isolados de R. solani associados ao arroz naquela região, testando a hipótese de que esses isolados pertencem ao grupo padrão de anastomose AG-1 IA, que também é o agente causal da mela em soja em áreas úmidas do Norte do Brasil. Todos os quatro isolados de arroz foram caracterizados, através de fusão de hifas, como AG-1 IA. A caracterização cultural, em função das temperaturas basais (mínimas, máximas e ótimas), evidenciou que os isolados de R. solani de arroz apresentaram perfis semelhantes aos padrões AG-1 IA, AG-1 IB e AG-1 IC. Os isolados de arroz foram caracterizados como autotróficos para tiamina assim como os isolados padrões AG-1 IA, IB, IC, AG-4 HGI e o isolado da mela da soja. O teste de patogenicidade em plantas de arroz cultivar IRGA-409 e de patogenicidade cruzada à cultivar IAC-18 de soja (suscetível à mela), indicou que além de causar a queima da bainha em arroz, esses isolados causam mela em soja. da mesma forma, o isolado SJ-047 foi patogênico ao arroz. As seqüências de bases de DNA da região ITS-5.8S do rDNA dos isolados do arroz foram similares às seqüências do AG-1 IA, depositadas no GenBank® - NCBI. A filogenia do ITS-rDNA indicou um grupo filogenético comum formado pelos isolados do arroz, o isolado da soja e o isolado teste do AG-1 IA. Assim, com base em características citomorfológicas, culturais, filogenéticas e patogênicas, foi confirmada a hipótese de que os isolados de R. solani patógenos de arroz do Estado do Tocantins pertencem ao grupo de anastomose AG-1 IA, além da indicação de que esses isolados podem também causar a mela em soja.
Resumo:
Twenty two open-pollinated Hevea progenies from different parental clones of the Asian origin were tested at five sites in the Northwestern São Paulo State Brazil to investigate the progeny girth growth, rubber yield, bark thickness and plant height. Except for the rubber yield, the analysis of variance indicated highly significant (p<0.01) genotype x environment interaction and heterogeneity of regressions among the progenies. However, the regression stability analysis identified only a few interacting progenies which had regression coefficients significantly different from the expected value of one. The linear regressions of the progeny mean performance at each test on an environmental index (mean of all the progenies in each test) showed the general stability and adaptability of most selected Hevea progenies over the test environments. The few progenies which were responsive and high yielding on different test sites could be used to maximize the rubber cultivars productivity and to obtain the best use of the genetically improved stock under different environmental conditions.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
This finite element analysis compared stress distribution on complete dentures and implant-retained overdentures with different attachment systems. Four models of edentulous mandible were constructed: group A (control), complete denture; group B, overdenture retained by 2 splinted implants with bar-clip system; group C, overdenture retained by 2 unsplinted implants with o'ring system; and group D, overdenture retained by 2 splinted implants with bar-clip and 2 distally placed o'ring system. Evaluation was performed on Ansys software, with 100-N vertical load applied on central incisive teeth. The lowest maximum general stress value (in megapascal) was observed in group A (64.305) followed by groups C (119.006), D (258.650), and B (349.873). The same trend occurred it) supporting tissues with the highest stress value for cortical bone. Unsplinted implants associated with the o'ring attachment system showed the lowest maximum stress values among all overdenture groups. Furthermore, o'ring system also improved stress distribution when associated with bar-clip system.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
The present study cross-sectionally investigated the influence of training status, route difficulty and upper body aerobic and anaerobic performance of climbers on the energetics of indoor rock climbing. Six elite climbers (EC) and seven recreational climbers ( RC) were submitted to the following laboratory tests: ( a) anthropometry, (b) upper body aerobic power, and ( c) upper body Wingate test. on another occasion, EC subjects climbed an easy, a moderate, and a difficult route, whereas RC subjects climbed only the easy route. The fractions of the aerobic (WAER), anaerobic alactic (W-PCR) and anaerobic lactic (W-[La(])-) systems were calculated based on oxygen uptake, the fast component of excess post-exercise oxygen uptake, and changes in net blood lactate, respectively. on the easy route, the metabolic cost was significantly lower in EC [ 40.3 ( 6.5) kJ] than in RC [60.1 ( 8.8) kJ] ( P < 0.05). The respective contributions of the WAER, WPCR, and W-[La(])- systems in EC were: easy route = 41.5 (8.1), 41.1 (11.4) and 17.4% (5.4), moderate route = 45.8 (8.4), 34.6 (7.1) and 21.9% (6.3), and difficult route = 41.9 (7.4), 35.8 (6.7) and 22.3% (7.2). The contributions of the WAER, WPCR, and W-[La(])- systems in RC subjects climbing an easy route were 39.7 (5.0), 34.0 (5.8), and 26.3% (3.8), respectively. These results indicate that the main energy systems required during indoor rock climbing are the aerobic and anaerobic alactic systems. In addition, climbing economy seems to be more important for the performance of these athletes than improved energy metabolism.
Resumo:
OBJETIVO: Verificar se as concentrações de glicose e insulina em jejum são reguladas pela aptidão cardiorrespiratória (VO2máx), independentemente dos efeitos genéticos. MÉTODOS: Dados de 38 pares de gêmeos monozigóticos (11 a 18 anos) foram analisados transversalmente. Os participantes foram submetidos a um teste de esforço máximo com ergoespirometria aberta (MedGraphics VO2000® - Medical Graphics Corp., St. Paul, MN) e à coleta de sangue para estimar a concentração de glicose e insulina em jejum. A zigosidade foi determinada por intermédio da investigação de concordância dos gêmeos em relação a 15 marcadores genéticos polimórficos. Nove pares demonstraram diferença média intrapar para o consumo máximo de oxigênio ≥10mL.kg-1.min-1 e foram divididos em dois grupos, de alta e baixa aptidão. Os grupos foram comparados a partir do teste pareado de Wilcoxon, tendo em vista a assimetria dos dados. RESULTADOS: em média, os gêmeos do grupo de alta aptidão apresentaram consumo máximo de oxigênio 17% superior (13,5±3,7mL.kg-1.min-1) a seus irmãos menos aptos. Não houve diferença entre os grupos para as concentrações de insulina (36,5±34,6 versus 25,3±13,7mg/dL; p<0,813), porém, os gêmeos mais aptos demonstraram menor concentração de glicose do que seus contrapares menos aptos (82,9±7,3 versus 86,7±7,6mg/dL; p<0,010). CONCLUSÕES: Neste estudo, caracterizado como caso-controle (gêmeos monozigóticos discordantes), o irmão com menor aptidão cardiorrespiratória apresentou maior concentração de glicose em jejum, sugerindo que a baixa aptidão cardiorrespiratória está associada a distúrbios no metabolismo de glicose.
Resumo:
Among the osteotomies performed in orthognathic surgery, the sagittal osteotomy of the mandibular ramus (SOMR) is the most common, allowing a great range of movements and stable internal fixation (SIF), therefore eliminating the need of maxillomandibular block in the postoperative period. Objectives: The purpose of this study was to evaluate the biomechanical resistance of three national systems used for SIF in SOMR in sheep mandibles. Material and methods: The study was performed in 30 sheep hemi-mandibles randomly divided into 3 experimental groups, each containing 10 hemi-mandibles. The samples were measured to avoid discrepancies and then subjected to SOMR with 5-mm advancement. In group I, 2.0x12 mm screws were used for fixation, inserted in an inverted "L" pattern (inverted "L" group). In group II, fixation was performed with two 2.0x12 mm screws, positioned in a linear pattern and a 4-hole straight miniplate and four 2.0x6.0 mm monocortical screws (hybrid group). In group III, fixation was performed with two-hole straight miniplates and eight 2.0x6.0 mm monocortical screws (mini plate group). All materials used for SIF were supplied by Osteosin - SIN. The hemimandibles were subjected to vertical linear load test by Kratos K2000MP mechanical testing unit for loading registration and displacement. Results: All groups showed similar resistance during mechanical test for loading and displacement, with no statistically significant differences between groups according to analysis of variance. Conclusion: These results indicate that the three techniques of fixation are equally effective for clinical fixation of SOMR.