Search for Sneutrino Production in e mu Final States in 5.3 fb(-1) of p(p)over-bar Collisions at root s = 1.96 TeV

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Search for Higgs Boson Production in Dilepton and Missing Energy Final States with 5.4 fb(-1) of p(p)over-bar Collisions at root s=1.96 TeV

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Measurement of the W boson helicity in top quark decays using 5.4 fb(-1) of p(p)over-bar collision data

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Measurement of sin(2)theta(l)(eff) and Z-light quark couplings using the forward-backward charge asymmetry in p(p)over-bar -> Z/gamma* -> e(+)e(-) events with L=5.0 fb(-1) at root s=1.96 TeV

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Evidence for Spin Correlation in t(t)over-bar Production

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

On semiclassical analysis of pure spinor superstring in an AdS(5) x S-5 background

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

The influence of gun transverse speed on electrochemical behaviour of thermally sprayed Cr3C2-NiCr coatings in 0.5 M H2SO4 solution

In the present study, different types of 75% Cr3C2-25% NiCr coatings were applied on a steel substrate by means of high velocity oxygen fuel spraying (HVOF), and studied using ac and dc electrochemical measurements in an aerated and unstirred 0.5 M H2SO4 solution. Structural characterization was determined before and after electrochemical tests. Differences between all sprayed systems are related to the gun transverse speed and number of deposited layers, which strongly affected the electrochemical characteristics of the coated steels. The coating obtained with a higher torch speed showed better resistance against corrosion. The electrochemical impedance results were analyzed using an equivalent circuit where porosity of the coatings and substrate oxidation were considered. (C) 2003 Elsevier Ltd. All rights reserved.

PM2.5 and PM10: The influence of sugarcane burning on potential cancer risk

In Brazil, sugarcane fields are often burned to facilitate manual harvesting, and this burning causes environmental pollution from the large amounts of soot released into the atmosphere. This material contains numerous organic compounds such as PAHs. In this study, the concentrations of PAHs in two particulate-matter fractions (PM2.5 and PM10) in the city of Araraquara (SE Brazil, with around 200,000 inhabitants and surrounded by sugarcane plantations) were determined during the sugarcane harvest (HV) and non-harvest (NHV) seasons in 2008 and 2009. The sampling strategy included four campaigns, with 60 samples in the NHV season and 220 samples in the HV season. The PM2.5 and PM10 fractions were collected using a dichotomous sampler (10 L min(-1), 24 h) with Teflon (TM) filters. The filter sets were extracted (ultrasonic bath with hexane/acetone (1:1 v/v)) and analyzed by HPLC/Fluorescence. The median concentration for total PAHs (PM2.5 in 2009) was 0.99 ng m(-3) (NHV) and 3.3 ng m(-3) (HV). In the HV season, the total concentration of carcinogenic PAHs (benz(a)anthracene, benzo(b)fluoranthene, benzo(k)fluoranthene, and benzo(a)pyrene) was 5 times higher than in the NHV season. B(a)P median concentrations were 0.017 ng m(-3) and 0.12 ng m(-3) for the NHV and HV seasons, respectively. The potential cancer risk associated with exposure through inhalation of these compounds was estimated based on the benzo[a]pyrene toxic equivalence (BaPeq), where the overall toxicity of a PAR mixture is defined by the concentration of each compound multiplied by its relative toxic equivalence factor (TEF). BaPeq median (2008 and 2009 years) ranged between 0.65 and 1.0 ng m(-3) and 1.2-1.4 ng m(-3) for the NHV and HV seasons, respectively. Considering that the maximum permissible BaPeq in ambient air is 1 ng m(-3), related to the increased carcinogenic risk, our data suggest that the level of human exposure to PAHs in cities surrounded by sugarcane crops where the burning process is used is cause for concern. (C) 2010 Published by Elsevier Ltd.

Y2O3:Eu3+ (5 mol%) with Ag nanoparticles prepared by citrate precursor

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Reversion by calcium of a yeast-like development to the original filamentous form, of the 10V10 5-fluorocytosine-sensitive mutant of Aspergillus niger

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Comparison of methods for the identification of coagulase-negative staphylococci

Coagulase-negative staphylococci (CNS) species identification is still difficult for most clinical laboratories. The scheme proposed by Kloos and Schleifer and modified by Bannerman is the reference method used for the identification of staphylococcal species and subspecies; however, this method is relatively laborious for routine use since it requires the utilization of a large number of biochemical tests. The objective of the present study was to compare four methods, i.e., the reference method, the API Staph system (bioMérieux) and two methods modified from the reference method in our laboratory (simplified method and disk method), in the identification of 100 CNS strains. Compared to the reference method, the simplified method and disk method correctly identified 100 and 99% of the CNS species, respectively, while this rate was 84% for the API Staph system. Inaccurate identification by the API Staph method was observed for Staphylococcus epidermidis (2.2%), S. hominis (25%), S. haemolyticus (37.5%), and S. warneri (47.1%). The simplified method using the simple identification scheme proposed in the present study was found to be efficient for all strains tested, with 100% sensitivity and specificity and proved to be available alternative for the identification of staphylococci, offering, higher reliability and lower cost than the currently available commercial systems. This method would be very useful in clinical microbiology laboratory, especially in places with limited resources.

Palha de sorgo associada ao herbicida imazamox no controle de plantas daninhas na cultura da soja em sucessão

Os resíduos vegetais de uma cultura de cobertura de outono/inverno podem interferir na infestação das plantas daninhas das culturas de verão subseqüentes. Dessa forma, com o objetivo de avaliar o efeito da palha de híbridos de sorgo (Sorghum bicolor), associada ao uso do herbicida imazamox, no controle de plantas daninhas na cultura da soja (Glycine max), cv. 'Conquista', em sucessão, foi conduzido no ano agrícola 2000/2001 um experimento em Uberlândia-MG. Foram utilizados quatro tipos de cobertura: três provenientes de resíduos culturais de híbridos de sorgo (Sara, DKB 860 e Ambar) e uma sem restos vegetais (anteriormente sob pousio). Aos 24 dias após aplicação do herbicida, o controle das espécies Leonotis nepetifolia, Alternanthera tenella, Amaranthus hibridus, A. retroflexus, A. spinosus, Ipomoea grandifolia, Commelina benghalensis e Nicandra physaloides foi mais eficaz nas palhas dos híbridos Sara e Ambar, na ausência de imazamox, com porcentagens de controle de 40 e 41%, respectivamente. Quando associada a 15 g ha-1 de imazamox, a palha do Ambar resultou em melhor controle dessas espécies de plantas daninhas, com controle de 76%; e a 30 g ha-1 a palha do DKB 860 foi a mais eficaz, promovendo 85% de controle. Sem cobertura do solo, com 30 g ha-1 de imazamox obteve-se controle de 62,5%, e 47,5% com metade da dosagem. Os resultados indicaram variabilidade de controle em relação ao híbrido de sorgo estudado e a possibilidade de redução de dosagens do herbicida imazamox quando associado aos resíduos vegetais de sorgo.

Modelling frequency distributions of 5 minute-averaged solar radiation indexes using Beta probability functions

Five minute-averaged values of sky clearness, direct and diffuse indices, were used to model the frequency distributions of these variables in terms of optical air mass. From more than four years of solar radiation observations it was found that variations in the frequency distributions of the three indices of optical air mass for Botucatu, Brazil, are similar to those in other places, as published in the literature. The proposed models were obtained by linear combination of normalized Beta probability functions, using the observed distributions derived from three years of data. The versatility of these functions allows modelling of all three irradiance indexes to similar levels of accuracy. A comparison with the observed distributions obtained from one year of observations indicate that the models are able to reproduce the observed frequency distributions of all three indices at the 95% confidence level.

1.5 mu m emission and infrared-to-visible frequency upconversion in Er+3/Yb+3-doped phosphoniobate glasses

Sodium phosphoniobate glasses with the composition (mol%) 75NaPO(3)-25Nb(2)O(5) and containing 2 mol% Yb3+ and x mol% Er3+ (0.01 <= x <= 2) were prepared using the conventional melting/casting process. Er3+ emission at 1.5 mu m and infrared-to-visible upconversion emission, upon excitation at 976 nm, are evaluated as a function of the Er3+ concentration. For the lowest Er3+ content, 1.5 mu m emission quantum efficiency was 90%. Increasing the Er3+ concentration up to 2 mol%, the emission quantum efficiency was observed to decrease to 37% due to concentration quenching. The green and red upconversion emission intensity ratio was studied as a function of Yb3+ co-doping and the Er3+-Er3+ energy transfer processes. (c) 2006 Elsevier B.V. All rights reserved.