Caracterização físico-química de cervejas elaboradas com mel

The aim of this study was to produce and physicochemically characterize beer elaborated with honey. Beer production assays were carried out with nine treatments, the combination of three concentrations of the original extract (11, 13 and 15 ºBrix) with three percentages of honey in the wort formulation (0, 20 and 40%). The experiment was completely randomized with two replicates, giving a total of eighteen trials. Mashing was carried out by infusion and the honey was added during the boiling step. After clarification, the extract content was corrected with water and the wort then inoculated with bottom-fermenting yeast. Fermentation was at 10 ºC. The beer was bottled manually and stored in a freezer at a temperature of 0 ºC for 15 days, for maturation. The beers were analyzed for their alcohol content, true extract, apparent extract, colour, bitterness, turbidity, pH, total acidity, carbon dioxide, foam density and total foam. The results of the physicochemical analysis were subjected to an analysis of variance, and the means compared by Tukey's test at 5% probability. All beers were considered to be pale. The presence of honey in the formulation enhanced carbonation, foam density and total foam, but the beers were less bitter and less acid.

Fruit quality in the peach and nectarine with application of hydrogenated cyanamide and mineral oil

This work evaluated the quality of the fruit in peach and nectarine cultivars with and without the application of hydrogenated cyanamide and mineral oil, for two production cycles (2009 and 2010). The experiment was carried out at the School of Agricultural Science of the São Paulo State University (UNESP), at Botucatu in the Brazilian state of São Paulo, located at latitude 22º51'55 S and longitude 48º26'22 E, at an altitude of 810 m. The predominant climate type is warm temperate (mesothermal) with rains in the summer and dry in the winter. The following were evaluated: soluble solids, titratable acidity, pH, ratio, firmness, vitamin C and pulp yield. The use of hydrogenated cyanamide and mineral oil had no effect on the quality attributes of the fruit, except for pH, where those fruits under application of the products showed higher values. The cultivars all had a pulp yield greater than 90%, with 'Tourmaline' showing the highest yield (96 %). The levels of vitamin C varied according to the cultivars, where 'Marli' (16.9 mg 100 g-1) and 'Dourado-2' (16.5 mg 100 g-1), stood out for having the highest levels.

Determination of reactivity rates of silicate particle-size fractions

The efficiency of sources used for soil acidity correction depends on reactivity rate (RR) and neutralization power (NP), indicated by effective calcium carbonate (ECC). Few studies establish relative efficiency of reactivity (RER) for silicate particle-size fractions, therefore, the RER applied for lime are used. This study aimed to evaluate the reactivity of silicate materials affected by particle size throughout incubation periods in comparison to lime, and to calculate the RER for silicate particle-size fractions. Six correction sources were evaluated: three slags from distinct origins, dolomitic and calcitic lime separated into four particle-size fractions (2, 0.84, 0.30 and <0.30-mm sieves), and wollastonite, as an additional treatment. The treatments were applied to three soils with different texture classes. The dose of neutralizing material (calcium and magnesium oxides) was applied at equal quantities, and the only variation was the particle-size material. After a 90-day incubation period, the RER was calculated for each particle-size fraction, as well as the RR and ECC of each source. The neutralization of soil acidity of the same particle-size fraction for different sources showed distinct solubility and a distinct reaction between silicates and lime. The RER for slag were higher than the limits established by Brazilian legislation, indicating that the method used for limes should not be used for the slags studied here.

Doses de lodo de esgoto compostado em produção de tapete de grama esmeralda imperial

The efficiency of nitrogen fertilization for sod production can be increased by using slow-release sources such as sewage sludge compost, which, due to its characteristics can be a substitute of part or all inorganic fertilization for grass. No results were found for the use of sludge compost in sod production in Brazil. This study evaluated the effect of rates of sewage sludge compost on the production of zoysiagrass. Treatments consisted of five rates of composted sewage sludge compost (0, 12, 24, 36 and 48 Mg ha-1, on a dry basis), plus a treatment of inorganic fertilization (300 kg ha-1 N, 80 kg ha-1 P2O5, and 200 kg ha-1 K2O). The results indicated different mineralization rates of the organic compounds present in the sludge; 120 days after sludge application, more Mg (100 %), K (90 %) and N (67 %) has been released than S (57 %), P (40 %) and Ca (31 %). The use of composted sewage sludge for zoysiagrass adequately supplied nutrients when applied to the soil surface at rates more than 36 Mg ha-1. After sod cutting, the rates of sewage sludge compost provided a linear increase in potential soil acidity, soil contents of OM, P, S, Fe, Cu, Mn, Zn, Cu and Ni, and linear decrease in pH, soil concentration of Ca and Mg and base saturation. Compost rates, increasing from 0 to 48 Mg ha-1, reduced the sod mass, reaching values of 4.0 kg/sod at the highest rate. High compost doses (36 and 48 Mg ha-1, respectively) also induced the highest resistance, with values in the order of 35 and 33 kgf.

Degradação de membrana impermeabilizante de polietileno de alta densidade usada em tanques de armazenamento de vinhaça

High-density polyethylene (HDPE) water-proof membranes are used as coatings in vinasse (leachate from sugar cane) storage tanks. The leachate is pumped into the tanks at temperatures of 80-90 °C. Due to these high temperatures and acidity of the waste, these membranes can be degraded, cracked and then loose the function for which they have been designed. This may cause contamination of the soil and groundwater. This study evaluated the effect of vinasse in HDPE membranes after 4 months of exposure in a controlled environment. An aggressive, alkaline pH liquid (sodium hydroxide) was also used. The objective was to evaluate the membrane resistance in contact with acidic and alkaline residues. Physical and mechanical tests, measurement of the carbon black content and thermo gravimetric analysis (TGA) were used to determine degradation of polymer membranes after chemical immersion. While sodium hydroxide resulted caused only minor changes in the physical properties, vinasse induced a thickness change of 7.8%. With immersion in vinasse, an average decrease in strength and deformability (yield) of 34% and 23.5% were measured, respectively. The stiffness increased by 7.8% (average) and the tear strength decreased by 2.7% (average).

Efeitos da deriva de clomazone, aplicado isoladamente ou em mistura com ametryn, sobre características produtivas de laranjeira 'Hamlin'

This experiment aimed to evaluate the effect of increasing clomazone (sprayed alone or in mixture with ametryn) drift simulation on quantitative and qualitative aspects of orange production when applied at two developmental plant stages: flowering and initial fruit development (fruits 2 cm diameter or smaller). Increasing drifts of clomazone, in two formulations, and clomazone in mixtures with ametryn were tested. Fruit morphological features, fruit color, flower and fruit abortion and leaf chlorophyll content were evaluated. Simulated drift similar to the recommended dose of clomazone and clomazone plus ametryn caused fruit abortion in citrus at the stage of fruits 2 cm diameter or smaller. Lower drift doses did not result in fruit abortion. Fruit diameter reduction was observed with drift off above 25% of clomazone alone recommended rate and 50% when in mixture with ametryn or in microcapsule formulation. Clomazone drift at 50% of the recommended rate (alone or in mixture with ametryn ) caused clorotic and necrotic spots in the fruit peel. Drift did not affect juice quality in any of the treatments tested.

Efeitos do tratamento térmico em separado da polpa e do suco sobre a qualidade físico-química, microbiológica, enzimática e sensorial do suco de laranja mantido sob refrigeração

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Desenvolvimento de néctar à base de mamão (Carica papaya L.) adicionado de inulina e oligofrutose

Pós-graduação em Engenharia e Ciência de Alimentos - IBILCE

Própolis na produção de cachaça orgânica de qualidade

Pós-graduação em Microbiologia Agropecuária - FCAV

Produção de etanol utilizando mix de sorgo sacarino e cana-de-açúcar em processo de maturação

Pós-graduação em Microbiologia Agropecuária - FCAV

Sistemas anfifílicos derivados de megiumina: uma nova abaordagtem no desenvolvimento de biomateriais supramoleculares

Pós-graduação em Química - IQ

Interferência de sistemas de manejo na floresta nacional de Caxiuanã, PA nos atributos físicos e químicos na composição isotópica de solo antropizado

Pós-graduação em Agronomia (Agricultura) - FCA

Avaliação da disseminação de Salmonella Senftenberg isoladas de diversos ambientes avícolas utilizando a técnica de Pulsed Field Gel Electrophoresis

Pós-graduação em Microbiologia - IBILCE

Culturas de cobertura, residual de nitrogênio e reaplicação de calcário em sistema plantio direto: cultura da soja

Pós-graduação em Agronomia - FEIS

Conservação pós-colheita de mangaba (Hancornia Speciosa Gomes)

Pós-graduação em Agronomia - FEIS