Interaction of the nonionic surfactant C12E8 with high molar mass poly(ethylene oxide) studied by dynamic light scattering and fluorescence quenching methods

Dynamic light scattering has been used to investigate ternary aqueous solutions of n-dodecyl octaoxyethylene glycol monoetber (C12E8) with high molar mass poly(ethylene oxide) (PEO). The measurements were made at 20 °C, always below the cloud point temperature (Tc) of the mixed solutions. The relaxation time distributions are bimodal at higher PEO and surfactant concentrations, owing to the preacute of free surfactant micelles, which coexist with the slower component, representing the polymer coil/micellar cluster comptex. As the surfactant concentration is increased, the apparent hydrodynamic radius (RH) of the coil becomes progressively larger. It is suggested that the complex structure consists of clusters of micelles sited within the polymer coil, as previously concluded for the PEO-C12E8-water system. However. C12E8 interacts less strongly than C12E8 with PEO; at low concentrations of surfactant the complex does not contribute significantly to the total scattered intensity. The perturbation of the PEO coil radius with C12E8 is also smaller than that in the C12E8 system. The addition of PEO strongly decreases the clouding temperature of the system, as previously observed for C12E8/PEO mixtures in solution Addition of PEO up to 0.2% to C12E8 (10 wt %) solutions doss not alter the aggregation number (Nagg) of the micelles probably because the surfactant monomers are equally partitioned as bound and unbound micelles. The critical micelle concentration (cmc), obtained from the I1/I3 ratio (a measure of the dependence of the vibronic band intensities on the pyrene probe environment), does not change when PEO is added, suggesting that for neutral polymer/surfactant systems the trends in Nagg and the cmc do not unambiguously reflect the strength of interaction.

Different doses of exogenous surfactant for treatment of meconium aspiration syndrome in newborn rabbits.

OBJECTIVE: To evaluate the effects of 2 different doses of exogenous surfactant on pulmonary mechanics and on the regularity of pulmonary parenchyma inflation in newborn rabbits. METHOD: Newborn rabbits were submitted to tracheostomy and randomized into 4 study groups: the Control group did not receive any material inside the trachea; the MEC group was instilled with meconium, without surfactant treatment; the S100 and S200 groups were instilled with meconium and were treated with 100 and 200 mg/kg of exogenous surfactant (produced by Instituto Butantan) respectively. Animals from the 4 groups were mechanically ventilated during a 25-minute period. Dynamic compliance, ventilatory pressure, tidal volume, and maximum lung volume (P-V curve) were evaluated. Histological analysis was conducted using the mean linear intercept (Lm), and the lung tissue distortion index (SDI) was derived from the standard deviation of the means of the Lm. One-way analysis of variance was used with a = 0.05. RESULTS: After 25 minutes of ventilation, dynamic compliance (mL/cm H2O.kg) was 0.87 +/- 0.07 (Control); 0.49 +/- 0.04 (MEC*); 0.67 +/- 0.06 (S100); and 0.67 +/- 0.08 (S200), and ventilatory pressure (cm H2O) was 9.0 +/- 0.9 (Control); 16.5 +/- 1.7 (MEC*); 12.4 +/- 1.1 (S100); and 12.1 +/- 1.5 (S200). Both treated groups had lower Lm values and more homogeneity in the lung parenchyma compared to the MEC group: SDI = 7.5 +/- 1.9 (Control); 11.3 +/- 2.5 (MEC*), 5.8 +/- 1.9 (S100); and 6.7 +/- 1.7 (S200) (*P < 0.05 versus all the other groups). CONCLUSIONS: Animals treated with surfactant showed significant improvement in pulmonary mechanics and more regularity of the lung parenchyma in comparison to untreated animals. There was no difference in results after treatment with either of the doses used.

Transição vesícula-micela em misturas de dispersões de vesículas com soluções de micelas

Pós-graduação em Biofísica Molecular - IBILCE

Textured macro- and mesoporous alumina samples designed in the presence of different surfactant types

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Surfactant-cosurfactant interactions and process parameters involved in the formulation of stable and small droplet-sized benznidazole-loaded soybean O/W emulsions

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Enhancement of voltammetric determination of quinizarine based on the adsorption at surfactant-adsorbed-layer in disposable electrodes

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Design and Characterization of Silicone and Surfactant Based Systems for Topical Drug Delivery

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Interaction of cyclic and linear labaditin peptides with anionic and zwitterionic micelles

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Estudo de interação entre um hormônio estrógeno e modelos simples de membrana biológica

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Interaction of cyclic and linear Labaditin peptides with anionic and zwitterionic micelles

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Development and in vitro skin delivery of dexamethasone acetate-loaded surfactant-based systems

Topical corticosteroids, e.g., dexamethasone acetate (DMA), are extensively used to treat cutaneous inflammatory disorders even though their use is correlated with potential local and systemic side effects. The objective of this study was to develop and test the topical delivery of DMA-loaded surfactant based systems in vitro; these studies could guarantee a suitable delivery and therapeutic efficacy, as well as minimize DMA's side effects. A phase diagram was constructed using polyoxypropylene (5) polyoxyethylene (20) cetyl alcohol as the surfactant (S), isopropyl myristate as the oil phase (O) and water (W). The systems were characterized using polarization light microscopy (PLM), as well as rheological and small angle X-ray scattering (SAXS) measurements. Depending on the concentration of the constituents, it was possible to obtain microemulsions (MEs) and liquid crystalline mesophases (lamellar and hexagonal). These types of arrangement were verified using PLM measurements. The SAXS results revealed that increasing the W/S ratio led to ME, as well as lamellar (LAM) and hexagonal (HEX) arrangements. The MEs displayed typical Newtonian behavior while the LAM and HEX phases exhibited pseudoplasticity and plasticity, respectively. The MEs displayed excellent drug solubilization that was approximately 10-fold higher than was observed with the individual components. The in vitro cutaneous permeation studies using pig ear skin and analysis of the mechanical parameters (hardness, compressibility, cohesiveness and adhesiveness) were carried out with a HEX phase and O/W emulsion. The HEX phase achieved better drug permeation and retention in the skin while its mechanical properties were suitable for skin administration. PPG-5-CETETH-20-based systems may be a promising platform delivering DMA and other topical corticosteroids through the skin.

Surfactant-based transdermal system for fluconazole skin delivery

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Biosurfactants production by yeasts using soybean oil and glycerol as low cost substrate

Biosurfactants are bioactive agents that can be produced by many different microorganisms. Among those, special attention is given to yeasts, since they can produce many types of biosurfactants in large scale, using several kinds of substrates, justifying its use for industrial production of those products. For this production to be economically viable, the use of residual carbon sources is recommended. The present study isolated yeasts from soil contaminated with petroleum oil hydrocarbons and assessed their capacity for producing biosurfactants in low cost substrates. From a microbial consortium enriched, seven yeasts were isolated, all showing potential for producing biosurfactants in soybean oil. The isolate LBPF 3, characterized as Candida antarctica, obtained the highest levels of production - with a final production of 13.86 g/L. The isolate LBPF 9, using glycerol carbon source, obtained the highest reduction in surface tension in the growth medium: approximately 43% of reduction after 24 hours of incubation. The products obtained by the isolates presented surfactant activity, which reduced water surface tension to values that varied from 34 mN/m, obtained from the product of isolates LBPF 3 and 16 LBPF 7 (respectively characterized as Candida antarctica and Candida albicans) to 43 mN/m from the isolate LPPF 9, using glycerol as substrate. The assessed isolates all showed potential for the production of biosurfactants in conventional sources of carbon as well as in agroindustrial residue, especially in glycerol.

Germination and mycelial growth of Bipolaris euphorbiae Muchovej & Carvalho as influenced by herbicides and surfactants

Bipolaris euphorbiae Muchovej & Carvalho é um forte candidato para o controle de Euphorbia heterophylla L. (amendoim bravo). Este fungo pode ser aplicado em combinação com herbicidas para controlar um maior espectro de espécies daninhas. Para tanto, experimentos laboratoriais foram realizados para verificar a possibilidade da utilização de mistura de tanque de esporos de B. euphorbiae e herbicidas ou surfatantes recomendados para a cultura da soja. Crescimento micelial e germinação de conídios foram avaliados em meio BDA acrescido dos herbicidas, nas concentrações recomendadas dos produtos comerciais, oxasulfuron (80 g/ha), glifosato (4 L/ha), bentazon (1.5 L/ha), fomesafen (1 L/ha), chlorimuron-ethyl (80 g/ha), lactofen (1 L/ha) e imazetaphyr (1 L/ha) e dos surfatantes Energic (2 ml/L), Aterbane (2,5 ml/L), Silwet L-77Ag (1 ml/L), Herbitensil (2 ml/L) e Natur L'óleo (10 ml/L). Diluições dos herbicidas de 50% e 25% foram avaliadas com um consumo de calda equivalente a 300 L/ha. Os surfatantes foram somente utilizados nas concentrações recomendadas. O crescimento micelial não foi afetado por bentazon e fomesafen e apenas levemente por oxasulfuron. Porém, glifosato, chlorimuron-ethyl, lactofen, Energic, Herbitensil, Silwet, e Aterbane o reduziram drasticamente. A redução observada com imazetaphyr foi intermediária e Natur L' óleo promoveu o crescimento micelial. Na presença dos surfatantes, observou-se que todos permitiram uma porcentagem de germinação equivalente àquela alcançada na presença de água. Energic e Herbitensil causaram um retardamento expressivo. Com Herbitensil, o processo germinativo iniciou somente aos 120 minutos. Com herbicidas, foi observado que somente na presença de glifosato e imazetaphyr a germinação dos conídios não seguiu a tendência observada com água, como ocorreu com os outros produtos testados.