Analysis of the Nicotiana tabacum Stigma/Style Transcriptome Reveals Gene Expression Differences between Wet and Dry Stigma Species

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Mechanical strength and subcritical crack growth under wet cyclic loading of glass-infiltrated dental ceramics

Objectives. Evaluate the flexural strength (sigma) and subcritical crack growth (SCG) under cyclic loading of glass-infiltrated alumina-based (IA, In-Ceram Alumina) and zirconia-reinforced (IZ, In-Ceram Zirconia) ceramics, testing the hypothesis that wet environment influences the SCG of both ceramics when submitted to cyclic loading.Methods. Bar-shaped specimens of IA (n = 45) and IZ ( n = 45) were fabricated and loaded in three-point bending (3P) in 37 degrees C artificial saliva (IA(3P) and IZ(3P)) and cyclic fatigued (F) in dry (D) and wet (W) conditions (IA(FD), IA(FW), IZ(FD), IZ(FW)). The initial sigma and the number of cycles to fracture were obtained from 3P and F tests, respectively. Data was examined using Weibull statistics. The SCG behavior was described in terms of crack velocity as a function of maximum stress intensity factor (K(Imax)).Results. The Weibull moduli (m = 8) were similar for both ceramics. The characteristic strength (sigma(0)) of IA and IZ was and 466 MPa 550 MPa, respectively. The wet environment significantly increased the SCG of IZ, whereas a less evident effect was observed for IA. In general, both ceramics were prone to SCG, with crack propagation occurring at K(I) as low as 43-48% of their critical K(I). The highest sigma of IZ should lead to longer lifetimes for similar loading conditions.Significance. Water combined with cyclic loading causes pronounced SCG in IZ and IA materials. The lifetime of dental restorations based on these ceramics is expected to increase by reducing their direct exposure to wet conditions and/or by using high content zirconia ceramics with higher strength. (C) 2010 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.

Effect of temperature on glass-ceramic films prepared by impregnation of commercial float glass surfaces with oxide powders under pressure

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Nanomechanical properties of glass-ceramic films obtained by pressure impregnation of oxide powders on commercial float glass surfaces

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Fluctuations in Richness and Abundance of Social Wasps During the Dry and Wet Seasons in Three Phyto-Physiognomies at the Tropical Dry Forest of Brazil

The social wasp nests were quantified in three different plant physiognomies (forested Caatinga, shrubby Caatinga, and agricultural systems) to analyze the effect of environmental seasonality and plant physiognomy on the richness, nest abundance, and species composition of social wasps in the region of tropical dry forest of Brazil. The forested Caatinga physiognomy had the greatest richness of species (S = 16), followed by shrubby Caatinga (S 13) and by agricultural system (S = 12). The first axis of detrended correspondence analysis (DCA) explained 67.8% of the variability and shows a gradient of the fauna from agricultural system and shrubby Caatinga to forested Caatinga. In the first axis, wet season scores were much higher than those for the dry season in forested Caatinga. The second axis explained 18.7% of the variability and shows a separation of samples collected during the wet or the dry periods in shrubby Caatinga. This separation was less evident in the agricultural system. Variations in nest abundance were more intense in arbustive caatinga (45% decrease in number of active nests in the dry period), moderate in forested Caatinga (24% decrease in number of active nests in the dry period), and low in agricultural systems (8% decrease in the dry period).

IR reflectance characterization of glass-ceramic films obtained by high pressure impregnation of SnO2 nanopowders on float glass

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

The effects of wet suits on physiological and biomechanical indices during swimming

The objectives of this study were to verify the effects of wet suits (WS) on the performance during 1500m swimming (V1500), on the velocity corresponding to the anaerobic threshold (VAT) and on the drag force (AD) as well as its coefficient (Cx). 19 swimmers randomly completed the following protocols on different days (with and without WS): 1) maximal performance of 1500m swimming; 2) VAT in field test, with fixed concentration of blood lactate (4 mM) and 3) determination of hydrodynamic indices (AD and Cx). The results demonstrated significant differences (p < 0.05) in the VAT (1.27±0.09; 1.21±0.06 m.s-1), and in the V1500 (1.21±0.08; 1.17±0.08 m.s-1), with and without WS, respectively. However the AD, and its Cx did not present significant differences (p>0.05) for the respective maximal speeds of swimming. In summary, we can conclude that WS allows swimmers to reach greater speeds in both, long- and short-course swims. This improvement can be related to the decrease of the AD, since with higher speeds (with WS) the subjects presented the same resistance, as they did when compared to speeds without a WS. Moreover, these data suggest that the methodology used in this study to determine the Cx is unable to detect the improvement caused by WS.

Bond strength of adhesive systems with different solvents to dry and wet dentin

Aim: This study evaluates bond strength between dentin and composite using adhesives with different solvents to dry and wet dentin. Materials and methods: Ninety bovine incisors were used; the vestibular surfaces were worn by the exposure of an area with a diameter of 4 mm of dentin. The specimens were divided into 6 groups, according to the type of adhesive used and hydratation stals: Group SB-wet: Single Bond 2 in wet dentin, Group SBdry: Single Bond 2 in dry dentin, Group SL-wet: Solobond M in wet dentin, Group SL-dry: Solobond M in dentin dry. Group XPwet: XP Bond in wet dentin, Group XP-dry: XP Bond in dentin dry. They were cut to obtain specimens in the shape of stick with 1 × 1 mm and subjected to microtensile test in universal testing machine with a cross speed of 1mm/min. The data were analyzed with ANOVA and Tukey's tests (5%). Results: ANOVA showed significant differences for surface treatment and interaction, but no difference was found for adhesive factor. The Tukey's test showed that the samples with wet dentin shown higher values of bond strength. Conclusion: The adhesive did not influence in the bond strength. The groups with wet dentin showed higher values of bond strength than groups with dry dentin.

Osmotic Dehydration of Pineapple with Impregnation of Sucrose, Calcium, and Ascorbic Acid

Mass transfer was evaluated during osmotic dehydration of pineapple in solutions with until four components aiming to investigate the solutes concentration influence on impregnation. In the first step, the experimental trials for optimization of solution concentration were based on 23 factorial design. In the second step, effective diffusion coefficients were determined. Equations representing the influence of the concentration of sucrose, calcium lactate, and ascorbic acid in osmotic solutions on water loss and gains of sucrose, calcium, and vitamin C were found. Results showed that both calcium lactate and sucrose concentration affected calcium and sucrose gain. On the other hand, only vitamin C gain was significantly affected by the ascorbic acid concentration in the studied concentration range. However, when comparing diffusivities in pineapple immersed in sucrose solutions, with and without calcium lactate, with and without ascorbic acid, it was possible to verify that diffusivities of water, sugar, and calcium increased in presence of ascorbic acid in solution. Calcium in solution diminished the water and sucrose diffusivities. High calcium and vitamin C contents were obtained in 1 h immersion in the solutions studied. © 2013 Springer Science+Business Media New York.

Above- and below-ground biomass and carbon dynamics in Brazilian Cerrado wet grasslands

Questions: Grasslands are usually neglected as potential carbon stocks, partially due to the lack of studies on biomass and carbon dynamics in tropical grasslands. What is the importance of Brazilian tropical wet grasslands as carbon sinks? Does fire frequency and season affect biomass and carbon allocation in Brazilian wet grasslands? Location: Wet grasslands, tropical savanna, Jalapão, Tocantins, northern Brazil. Methods: We determined biomass above- and below-ground, estimated carbon stocks in biennially burned plots (B2) and plots excluded from fire for 4 yr (B4). Moreover, we determined biomass in both rainy and dry seasons. Samples were 0.25 m × 0.25 m × 0.2 m (eight samples per treatment, applying a nested design, total of 48 samples). The biomass was classified in above-ground graminoids, forbs and dead matter, and below-ground roots and other below-ground organs. We used ANOVA to compare variables between treatments and seasons. Results: More than 40% of the total biomass and carbon stocks were located below-ground, mostly in roots. A high proportion of dead biomass (B4) was found in the above-ground material, probably due to low decomposition rates and consequent accumulation over the years. Although these grasslands do not experience water stress, we found significant evidence of resource re-allocation from below-ground organs to the above-ground biomass in the rainy season. Conclusions: We found more dead biomass in the rainy season, probably due to low decomposition rates, which can increase fire risk in these grasslands during the following dry season. These tropical wet grasslands stored high amounts of carbon (621 to 716 g C.m-2), mostly in the roots. Thus, policymakers should consider tropical grasslands as potential carbon stocks, since they are one of the most threatened and unprotected ecosystems in Brazil. © 2012 International Association for Vegetation Science.

User-producer interaction in the Brazilian oil industry: The relationship between petrobras and its suppliers of wet Christmas tree

The objective of this work is to analyze the importance of the user-producer interaction for the innovative process of the Brazilian oil industry from the 2000s. To do so, we selected two of the three providers installed in Brazil that produce the set of valves used in the oil wellhead to control its production, set which is called wet Christmas tree (WCT), the Norway's Aker Solutions and the American FMC Technologies. The results of this analysis indicate not only the development of the oil industry in Brazil is marked by a strategy of cooperative innovation, but they also reveal the importance of geographical proximity and direct cooperation, especially between the centers of engineering and research and development of companies. Furthermore, these partnerships are not limited to the adaptation of products to new needs, but they also include the development of new systems. © Universidad Alberto Hurtado, Facultad de Economía y Negocios.

Performance of UASB reactors in two stages followed by post-treatment with activated sludge in wastewater batch of wet-processed coffee

In this study it was evaluated the efficiency of the treatment of wet-processed coffee wastewater in upflow anaerobic sludge blanket (UASB) reactors in two stages, in bench scale, followed by post-treatment with activated sludge in batch. The first UASB reactor was submitted to an hydraulic retention time (HRT) of 6.2 d and organic loading rates (OLR) of 2.3 and 4.5g CODtotal (L d)-1, and the second UASB reactor to HRT of 3.1 d with OLR of 0.4 and 1.4g CODtotal (L d)-1. The average values of the affluent CODtotal increased from 13,891 to 27,926mg L-1 and the average efficiencies of removal of the CODtotal decreased from 95 to 91%, respectively, in the UASB reactors in two stages. The volumetric methane production increased from 0.274 to 0.323L CH4 (L reactor d)-1 with increment in the OLR. The average concentrations of total phenols in the affluent were of 48 and 163mg L-1, and the removal efficiencies in the UASB reactors in two stages of 92 and 90%, respectively, and increased to 97% with post-treatment. The average values of the removal efficiencies of total nitrogen and phosphorus were of 57 to 80% and 44 to 60%, respectively, in the UASB reactors in two stages and increased to 91 and 84% with the post-treatment.

Chemical composition and metabolizable energy values of corn germ meal obtained by wet milling for layers

An experiment was carried out to determine the chemical composition, metabolizable energy values, and coefficients of nutrient digestibility of corn germ meal for layers. The chemical composition of corn germ meal was determined, and then a metabolism assay was performed to determine its apparent metabolizable energy (AME) and apparent metabolizable energy corrected for nitrogen (AMEn) values and its dry matter and gross energy apparent metabolizability coefficients (CAMDM and CAMGE, respectively). In the 8-day assay (four days of adaptation and four days of total excreta collection), 60 29-week-old white Lohman LSL layers were used. A completely randomized experimental design, with three treatments with five replicates of four birds each, was applied. Treatments consisted of a reference diet and two test diets, containing 20 or 30% corn germ meal. Results were submitted to analysis of variance and means were compared by the Tukey tests at 5% probability level. The chemical composition of corn germ meal was: 96.39% dry matter, 49.48% ether extract, 1.87% ashes, 7243 kcal gross energy/kg, 11.48% protein, 0.19% methionine, 0.21% cystine, 0.48% lysine, 0.40% threonine, 0.72% arginine, 0.35% isoleucine, 0.83% leucine, 0.57% valine, and 0.37% histidine, on as-fed basis. There were no statistical differences in AME, AMEn, CAMDM, and CAMGE values with the inclusion of 20 and 30% corn germ meal in the diets. On dry matter basis, AME, AMEn, CAMDM, and CAMGE values of corn germ meal were: 4,578 and 4,548 kcal/kg, 4,723 and 4,372 kcal/kg, 64.95 and 61.86%, respectively.

Dry and wet seasons set the phytochemical profile of the Copaifera langsdorffii Desf. essential oils

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)