Composite materials obtained from textile fiber residue

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Evaluation of fatigue behavior on repaired carbon fiber/epoxy composites

The continuous use of structural polymer composites in aeronautical industry has required the development of repairing techniques of damages found in different types of laminates. The most usually adopted procedure to investigate the repair of composite laminates has been by repairing damages simulated in laminated composite specimens. This work shows the influence of structural repair technique on mechanical properties of a typical carbon fiber/epoxy laminate used in aerospace industry. When analyzed by tensile test, the laminates with and without repair present tensile strength values of 670 and 892 MPa, respectively, and tensile modulus of 53.0 and 67.2 GPa, respectively. By this result, it is possible to observe a decrease of the measured mechanical properties of the repaired composites. When submitted to fatigue test, it is observed that in loads higher than 250 MPa, this laminate presents a low life cycle (lower than 400,000 cycles). The fatigue performance of both laminates is comparable, but the non-repaired laminate presented higher tensile and fatigue resistance when compared with the repaired laminate.

CHEMICAL MODIFICATION EFFECT on THE MECHANICAL PROPERTIES of HIPS/COCONUT FIBER COMPOSITES

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Fractography analysis and fatigue strength of carbon fiber/RTM6 laminates

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Flexural behavior of Sisal/Castor oil-Based Polyurethane and Sisal/Phenolic Composites

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Assessment of cumulative damage by using ultrasonic C-scan on carbon fiber/epoxy composites under thermal cycling

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Carbon fiber non-crimp multi-axial reinforcement and epoxy mono-component system composite: fatigue behavior

Fiber reinforced polymer composites have been widely applied in the aeronautical field. However, composite processing, which uses unlocked molds, should be avoided in view of the tight requirements and also due to possible environmental contamination. To produce high performance structural frames meeting aeronautical reproducibility and low cost criteria, the Brazilian industry has shown interest to investigate the resin transfer molding process (RTM) considering being a closed-mold pressure injection system which allows faster gel and cure times. Due to the fibrous composite anisotropic and non homogeneity characteristics, the fatigue behavior is a complex phenomenon quite different from to metals materials crucial to be investigated considering the aeronautical application. Fatigue sub-scale specimens of intermediate modulus carbon fiber non-crimp multi-axial reinforcement and epoxy mono-component system composite were produced according to the ASTM 3039 D. Axial fatigue tests were carried out according to ASTM D 3479. A sinusoidal load of 10 Hz frequency and load ratio R = 0.1. It was observed a high fatigue interval obtained for NCF/RTM6 composites. Weibull statistical analysis was applied to describe the failure probability of materials under cyclic loads and fractures pattern was observed by scanning electron microscopy. (C) 2010 Published by Elsevier Ltd.

Mechanical properties of HIPS/sugarcane bagasse fiber composites after accelerated weathering

The effect of accelerated weathering on the visual appearance and on mechanical properties of high impact polystyrene (HIPS) as well as HIPS reinforced with mercerized and bleached sugarcane bagasse fibers composites are investigated. After accelerated weathering period of 900 h, under UV-B radiation and moisture regular cycles, changes in mechanical properties are investigated by tensile tests. Materials fracture surfaces are investigated by scanning electron microscopy (SEM). The study showed that the exposure time was sufficient to change the visual appearance of HIPS as the composites. From this study, it was observed that composites reinforced with bleached fibers are less susceptible to accelerated weathering exposure than composites reinforced with mercerized fibers, which is explained by the higher amount of lignin present in mercerized fibers. (C) 2010 Published by Elsevier Ltd. Selection and peer-review under responsibility of [name organizer]

A Study of the Effect of Nitrogen and Air Plasma Immersion Ion Implantation Treatments on the Properties of Carbon Fiber

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

High sensitivity fiber optic angular displacement sensor and its application for detection of ultrasound

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Dielectric relaxation of vegetable-based polyurethane

Vegetable-based polyurethane (PU) was prepared in the thin film form by spin coating. This polymer is synthesised from castor oil, which can be extracted from the seeds of a native plant in Brazil called mamona. This polymer is biocompatible and is being used as material for artificial bone. The PU was characterised by dielectric spectroscopy in a wide range of frequency (10(-5) Hz to 10(5) Hz) and by thermally stimulated discharge current (TSDC) measurements. The glass transition temperature (T-g=39degreesC) was determined and using the initial rise method the activation energy was found to be 1.58 eV. (C) 2003 Kluwer Academic Publishers.

Electromechanical properties of 0-3 vegetable based polyurethane and lead zirconate titanate composite.

Composite made of Lead Zirconate Titranate (PZT) ceramic powder and castor oil based polyurethane (PU) were prepared in the thin film form with 0-3 connectivity by spin coating. The composite films were obtained in the thickness range of 100 mum to 300 mum using 33-vol.% of ceramic. The samples mechanical resistance. The material was characterised by dielectric spectroscopy, thermally stimulated discharge current (TSDC), hysteresis measurements and laser-intensity-modulation method (LIMM). The pyroelectric coefficient at 343 K was 7x10(-5) C.m(-2) K-1 for the sample poled with 10 MV/m at 373 K for Ih. The results show that this new composite can be used as suitable piezo and pyroelectric sensors.

Effect of polyol excess on the electrical property of vegetable-polyurethane film

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of soluble fiber on hypertriglyceridemia and immune profile in HIV-positive individuals undergoing highly active antiretroviral therapy

The advent of highly active antiretroviral therapy (HAART), since 1996, represented a profound impact on the natural history of HIV-infection by promoting important and sustainable viral replication suppression and increasing survival and quality of life among seropositive patients. Nonetheless, antiretroviral therapy has been observed to be accompanied by metabolic alterations such as dyslipidemia, especially hypertriglyceridemia, insulin resistance, hyperglycemia and lipodystrophy (body fat redistribution). Epidemiological studies have demonstrated a correlation between high triglyceride (TG) levels and higher incidence of coronary artery disease (CAD). Some investigators suggest dietary intervention as part of hyperlipidemia treatment, including an increase in soluble fiber intake (10-25g/day). Whereas some studies have demonstrated that both cholesterol and serum triglyceride levels decrease with the use of food fiber, others have shown just a serum triglyceride decrease, and others failed to observe any alteration in lipid metabolism. The purpose of this study was to assess the effect of soluble fiber (R) (partially hydrolyzed guar gum) supplementation on hypertriglyceridemia and immune profile in HIVpositive individuals on HAART. Nineteen HIV-positive individuals with hypertriglyceridemia (serum levels >= 150 to < 500mg/dl) were studied. of these individuals, 63.16% were males and 36.84% females, with mean age of 43.52 +/- 9.22 years. These individuals had been on the same HAART regimen for at least six months, had no change in therapy during the study and received 20g/day of soluble fiber for four months at pre-established times. Clinical-nutritional, biochemical (total proteins, albumin, globulin, total cholesterol, LDL-c, HDL-c, TG, TG/HDL-c and LDLc/HDL-c), hematimetric (hemoglobin, hematocrit and total lymphocytes), and immunologic (lymphocytes T CD4(+), T CD8(+); T CD4(+)/CD8(+) ratio, viral load, TNF-alpha and IL-6) parameters were assessed in all patients at three time points (M0: pretreatment, M1: 30 days, and M2: four months after intervention). Significance level was set at 5% for all data statistically analyzed. Serum TG and TG/HDL-c ratio reduction was observed at all time points, but statistical significance was found just at M0 and M2. The remaining biochemical, hematimetric and immunologic parameters (lymphocytes T CD4(+), T CD8(+); T CD4(+)/ CD8(+) ratio, and viral load) showed no significant difference at all times. Regarding serum cytokines, TNF-alpha and IL-6 significantly decreased between M0 and M2, and only IL-6 reduced between M1 and M2. The data collected show that dietary and anthropometric parameters remained unchanged excluding potential confounding factors related with the effect of fiber supplementation on serum TG, TNF-alpha and IL-6. Thus, soluble fiber (R) contributed to an important reduction in hypertriglyceridemia and in the serum levels of the proinflammatory cytokines TNF-alpha and IL-6 in HIV-seropositive individuals on HAART. In addition, soluble fiber (R) might have minimized the process of atherosclerosis in these individuals, given that elevated serum levels of TG, TNF-alpha and IL-6 have been associated with the development of these lesions.

Prospective Evaluation of Dietary Treatment in Childhood Constipation: High Dietary Fiber and Wheat Bran Intake Are Associated With Constipation Amelioration

Objectives: The aim of the study was to evaluate, over 24 months, the intake of dietary fiber (DF) and the bowel habit (BH) of constipated children advised a DF-rich diet containing wheat bran.Patients and Methods: BH and dietary data of 28 children with functional constipation defined by the Boston criteria were obtained at visit 1 (V1, n = 28) and at 4 follow-up visits (V2-V5, n = 80). At each visit the BH was rated BAD (worse/unaltered; improved but still complications) or RECOVERY (REC) (improved, no complications; asymptomatic), and a food intake questionnaire was applied. DF intake was calculated according to age (year)+5 to 10 g/day and bran intake according to international tables. Nonparametric statistics were used.Results: Median age (range) was 7.25 years (0.25-15.6 years); 21 children underwent bowel washout (most before V1/V2), and 14 had the last visit at V3/V4. DF intake, bran intake, and the BH rate significantly increased at V2 and remained higher than at V1 through V2 to V5. At V1, median DF intake was 29.9% below the minimum recommended and at the last visit 49.9% above it. Twenty-four children accepted bran at 60 visits, at which median bran intake was 20 g/day and median proportion of DF due to bran 26.9%. Children had significantly higher DF and higher bran intake at V2 to V5 at which they had REC than at those at which they presented BAD BH. DF intake > age+10 g/day was associated with bran acceptance and REC. At the last visit 21 children presented REC (75%); 20 of them were asymptomatic and 18 were off washout/laxatives.Conclusions: High DF and bran intake are feasible in constipated children and contribute to amelioration of constipation.