Analytical and semi-analytical analysis of an artificial satellite's rotational motion

The rotational motion of an artificial satellite is studied by considering torques produced by gravity gradient and direct solar radiation pressure. A satellite of circular cylinder shape is considered here, and Andoyers variables are used to describe the rotational motion. Expressions for direct solar radiation torque are derived. When the earth's shadow is not considered, an analytical solution is obtained using Lagrange's method of variation of parameters. A semi-analytical procedure is proposed to predict the satellite's attitude under the influence of the earth's shadow. The analytical solution shows that angular variables are linear and periodic functions of time while their conjugates suffer only periodic variations. When compared, numerical and analytical solutions have a good agreement during the time range considered.

Comparison of fracture surface and plane section analysis for ceramic grain size characterisation

A method has been developed to obtain quantitative information about grain size and shape from fractured surfaces of ceramic materials. One elaborated a routine to split intergranular and transgranular grains facets of ceramic fracture surfaces by digital image processing. A commercial ceramic (ALCOA A-16, Al2O3-1.5% of CrO) was used to test the proposed method. Microstructural measurements of grain shape and size taken from fracture surfaces have been compared through descriptive statistics of distributions, with the corresponding measurements from polished and etched surfaces. The agreement between results, with the expected bias on grain size values from fractures, obtained for both types of surfaces allowed to infer that this new technique can be used to extract the relevant microstructural information from fractured surfaces, thus minimising the time consuming steps of sample preparation. (C) 2003 Elsevier Ltd. All rights reserved.

Boundary identification criteria and geometry analysis of Al 7050 stretch zone from elevation profiles

This article describes the development of a method for analysis of the shape of the stretch zone surface based on parallax measurement theory and using digital image processing techniques. Accurate criteria for the definition of the boundaries of the stretch zone are established from profiles of fracture surfaces obtained from crack tip opening displacement tests on Al-7050 alloy samples. The elevation profiles behavior analysis is based on stretch zone width and height parameters. It is concluded that the geometry of the stretch zone profiles under plane strain conditions can be described by a semi-parabolic relationship. (C) Elsevier B.V., 1999. All rights reserved.

Morphological analysis of colon goblet cells and submucosa in type I diabetic rats submitted to physical training

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Ultrastructural Analysis of the Oocytes of Female Rhipicephalus sanguineus (Latreille, 1806) (Acari: Ixodidae) Ticks Subjected to the Action of Azadirachta indica A. Juss (Neem)

The present study provides ultrastructural information about the acaricidal effects of neem (Azadirachta indica A. Juss) on the ovaries of R. sanguineus engorged females. In general, the main damage caused in the oocytes was alteration in the shape of the cell and of the germinal vesicle, ring-shaped nucleolus, cytoplasmic vacuolation, and disorganization of the organelles and of the cell membranes (including the chorion), all of which indicate that these cells could be in the process of death. The results showed that azadirachtin would be an efficient acaricide agent for inhibiting and/or neutralizing the reproduction process of R. sanguineus females, impairing the reproductive ability of this species.

Ultrastructural analysis of the fat body in workers of Attini ants (Hymenoptera: Formicidae)

In the present study a comparative morphological analysis of the fat body cells of ant workers of the basal Attini species Cyphomyrmex rimosus and Mycetarotesparallelus, and the derived species Acromynnex disciger and Atta laevigata was conducted. The results revealed that the fat body is located mainly in the abdomen around organs (perivisceral) and near the integument (parietal). The main cells observed are spherical or polygonal trophocytes with a slightly rough surface. The oenocytes, another cell type found, are closely associated with trophocytes, and present a spherical or polygonal shape and a smoother surface. The morphometric analysis showed that the area of trophocytes and oenocytes of C rimosus and M parallelus is significantly smaller when compared to those of A. disciger and A. laevigata. In the cytoplasm of parietal and perivisceral trophocytes and oenocytes, electronlucent droplets (probably lipids) and electrondense granules (probably proteins) indicate the participation of these cells in the storage of these elements, while digestive vacuoles, residual bodies, and multivesicular bodies suggest a role in intracellular digestion. In perivisceral trophocytes and oenocytes of C rimosus, the presence of mitochondria, lamellar rough endoplasmic reticulum, and Golgi complex suggests that these cells synthesize proteins. Based on these data, no significant differences were observed between the fat body cells of basal and derived ants, except regarding the larger size of trophocytes and oenocytes of the derived species A. disciger and A. laevigata. (C) Koninklijke Brill NV, Leiden, 2009

Landmark-based morphometric analysis in selected species of serranid fishes (Perciformes : Teleostei)

Morphological differences among 6 species of marine fishes belonging to 2 subfamilies of the family Serranidae (Serraninae: Dules auriga, Diplectrum formosum, and D, radiale; Epinephelinae: Epinephelus marginatus, Mycteroperca acutirostris, and M. bonaci) were studied by the geometric morphometric method of thin-plate splines and multivariate analysis of partial-warp scores. The decomposition of shape variation into uniform and nonaffine components of shape change indicate that major differences among species are related to both components of shape variation. Significant differences were found among species with respect to the uniform components, but there is no clear separation of taxonomic groups related to these components, and species are instead separated on the basis of body height and caudal peduncle length. Non-uniform changes in body shape, in turn, clearly differentiate the species of Serraninae and Epinephelinae. These shape changes are probably related to differences in habitat and feeding habits among the species.

Analytical study of the nonlinear behavior of a shape memory oscillator: Part II-resonance secondary

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Analytical study of the nonlinear behavior of a shape memory oscillator: Part I-primary resonance and free response at low temperatures

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

On the reversed crystal growth of BaZrO3 decaoctahedron: shape evolution and mechanism

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Rietveld analysis of mechanically activated BaCO(3)-TiO(2) system

BaTiO(3) powders were prepared through mechanical activation chemistry and analyzed by Rietveld refinement with X-ray diffraction data. Raw BaCO(3) and TiO(2) powders were dry milled for 5 and 20 h and then calcinated for 2 and 4 h at 800 degrees C. The milling process was found to have broken up the BaCO(3) and TiO(2) crystals into smaller crystals and formed only small amounts ( 1.5 wt%) of BaTiO(3). Subsequence calcinations for 2 and 4 h at 800 degrees C successfully produced large amounts (>97.7 wt%) of BaTiO(3) crystals. The calcination process also generated microstrains and crystallite-size anisotropy in BaTiO(3). An increase in the calcination time from 2 to 4 h increased the BaTiO(3) weight percentage and the crystal lite-shape anisotropy, but decreased the tetragonal distortion anisotropic microstrains in BaTiO(3) crystals. (C) 2008 International Centre for Diffraction Data.

Morphological analysis of the corneal endothelium in eyes of dogs using specular microscopy

Foram estudados 20 olhos de 10 cães sem raça definida, machos e fêmeas com 6 anos de idade. A morfologia das células do endotélio da córnea foi analisada utilizando-se microscópio especular de contato. Foram estudadas as regiões central e periférica da córnea. de cada região da córnea foram realizadas três micrografias. de cada micrografia foram analisadas no mínimo 100 células endoteliais. Foram obtidos os valores do polimegatismo e pleomorfismo. O endotélio corneano de cães caracterizou-se por uma monocamada de células poligonais uniformes em tamanho e forma. A forma predominante das células endoteliais foi hexagonal. O índice de polimegatismo foi 0.22. Este estudo demonstrou que a morfologia das células do endotélio da córnea de cães é semelhante à observada em humanos.

Testicular shape and andrological aspects of young Nellore bulls under extensive farming

Aiming to determine the relationship between the frequency of testicular shape and the andrological aspects in young Nellore bulls, 18,676 animals were assessed. All andrological examinations were performed between the years 2000 and 2008. Animals were classified as able for breeding, able for breeding in natural mating system, unable for breeding and discarded. The testicular shape was classified as long, fairly long, oval-long, spherical-oval, and spherical. The analysis of Pearson correlations was performed for testicular shape with scrotal circumference, testicular volume, progressive motility, sperm vigor, major defects, minor defects and total defects. Testicles with oval shape prevailed (99.61%). It was obseved that 76.34; 66.34; 64.34; 58.33 and 50.00% of the animals were classified as sound for breeding for shapes long, fairly long, oval-long, spherical-oval, and spherical, respectively. Correlations between testicular shape with scrotal circumference, testicular volume, progressive motility, sperm vigor, major, minor and total defects were 0.26; 0.08; 0.00; 0.11; -0.02; 0.02 and -0.01, respectively. Testicular shape had no influence upon the andrological examination results. Testicles of long shape were prevalent within the population.

Analysis of beef cattle longitudinal data applying a nonlinear model

The objective of this work was to evaluate the Nelore beef cattle, growth curve parameters using the Von Bertalanffy function in a nested Bayesian procedure that allowed estimation of the joint posterior distribution of growth curve parameters, their (co)variance components, and the environmental and additive genetic components affecting them. A hierarchical model was applied; each individual had a growth trajectory described by the nonlinear function, and each parameter of this function was considered to be affected by genetic and environmental effects that were described by an animal model. Random samples of the posterior distributions were drawn using Gibbs sampling and Metropolis-Hastings algorithms. The data set consisted of a total of 145,961 BW recorded from 15,386 animals. Even though the curve parameters were estimated for animals with few records, given that the information from related animals and the structure of systematic effects were considered in the curve fitting, all mature BW predicted were suitable. A large additive genetic variance for mature BW was observed. The parameter a of growth curves, which represents asymptotic adult BW, could be used as a selection criterion to control increases in adult BW when selecting for growth rate. The effect of maternal environment on growth was carried through to maturity and should be considered when evaluating adult BW. Other growth curve parameters showed small additive genetic and maternal effects. Mature BW and parameter k, related to the slope of the curve, presented a large, positive genetic correlation. The results indicated that selection for growth rate would increase adult BW without substantially changing the shape of the growth curve. Selection to change the slope of the growth curve without modifying adult BW would be inefficient because their genetic correlation is large. However, adult BW could be considered in a selection index with its corresponding economic weight to improve the overall efficiency of beef cattle production.

Morphometric analysis of the corneal endothelium of Yacare caiman (Caiman yacare) using scanning electron microscopy

The objective of this study was to examine the endothelial surface morphology and to perform morphometric analysis of the corneal endothelial cells of Yacare caiman (Caiman yacare) using scanning electron microscopy. Morphometric analysis with regard to polygonality, mean cell area, cell density and coefficient of variation of mean cell area was performed. Cell areas were measured using image analysis software. The normal corneal endothelium of Yacare caiman consisted of polygonal cells of uniform size and shape with interdigitations of the cell borders. Microvilli appeared as protrusions on the cellular surface. The average cell area was 270 +/- 24 mum(2) and the endothelial cell density was 3704 +/- 324 cells/mm(2). The coefficient of variation of cell area was 0.22. This study demonstrates that the Yacare caiman corneal endothelium is similar to those described in other vertebrates.