Quality of natural coffee subjected to different rest periods during the drying process

O parcelamento da secagem pode ser eficiente tanto no que diz respeito à qualidade final do café, quanto na redução do consumo específico de energia. Diante disso, objetivou-se, com o presente trabalho, avaliar o efeito do teor de água dos frutos no momento da interrupção da secagem e do período de repouso até a retomada da secagem na qualidade do café natural, por meio da análise sensorial e dos testes de condutividade elétrica e lixiviação de potássio. Frutos de café maduros foram colhidos manual e seletivamente e, em seguida, secados ao sol em terreiros de concreto por dois dias e, então, submetidos à secagem mecânica em secadores de camada fixa. Quando o café atingiu os teores de água de 20%, 17% e 14% (base úmida, bu), a secagem foi interrompida e o café permaneceu em repouso por cinco, quinze e trinta dias e, posteriormente, foi secado em secadores mecânicos até o teor de água de 11% (bu). O controle constituiu-se na secagem completa em terreiro. Observou-se que as combinações entre o menor teor de água e o maior período de repouso e entre o maior teor de água e o menor período de repouso, proporcionam menores valores de lixiviação de potássio. A qualidade da bebida melhora progressivamente com o aumento do período de repouso. A interrupção da secagem com teores de água de 17% e 20% (bu) não altera a qualidade do café natural, comparativamente à secagem completa em terreiro.

Maize germ recovery and quality using the intermittent milling and dynamic steeping process

The intermittent milling and dynamic steeping (IMDS) process is an alternative method developed for wet milling of maize. In this process, the steeping stage can be reduced to 5 h by soaking maize in water at 60°C for 2 h and cracking the kernels to remove solution components diffusional barriers with minimum germ damage. Maize was dynamically steeped in solutions with 0.0, 0.1, and 0.2% sulphur dioxide (SO2) and 0.00, 0.55% lactic acid. Germ recovery, germ damage, fibre in germ, oil content and uncracked kernels were determined. A conventional steeping procedure was also performed. Germ recovery was higher for all tests using both SO2 and lactic acid than for the others with best germ yield for concentrations of 0.2% SO2 and 0.55% lactic acid. Germ damage ranged from 7.4 to 18.2% for all tests. The presence of lactic acid in the steeping solution decreased the amount of fibre in germ fraction. Germ oil content ranged from 39.3% (0-0% SO2, 0.55% lactic acid) to 44.0% (0.2% SO2, 0.55% lactic acid) for all treatments using IMDS. The smallest difference was 5.5% between IMDS (0.2% SO2, 0.55% lactic acid) and the conventional 36 h steeping process. An average of 1.3% of kernels remained uncracked after IMDS process. © 2002 Silsoe Research Institute. Published by Elsevier Science Ltd. All rights reserved.

The knowledge conversion SECI process as innovation indicator analysis factor

It highlights the innovation importance in the current society and presents innovation indicators applied in 125 countries. We made an analysis in the 80 variables distributed through seven GII pillars, trying to identify the direct, indirect or null incidences of the knowledge conversion way described by the SECI Process. The researched revealed the fact that knowledge management, in this case specifically the knowledge conversion SECI Process, is present in the variables that, according to the GII, make clear innovative activity in countries.

Alteração da fertilidade do solo como indicador do processo de antropização e presença de atividades não agrícolas no assentamento rural Horto Aimorés, municípios de Bauru e Pederneiras/SP =: Change of soil fertility as an indicator of the anthropization process and presence of non agricultural activities at the rural settlement Horto Aimorés, cities of Bauru and Pederneiras/ SP

Pós-graduação em Geografia - FCT

Production of alcoholic beverage from ginger: study of fermentation process and final product quality

Introduction: In Brazil part of the production of ginger is of inadequate quality for export. The production of spirit from felt-over rhizomes is an alternative of great interest to producers of these rhizomes. Aim: Aiming to increase the value of felt-over rhizomes, this work aimed to study the use of ginger as a raw material for alcoholic beverage production. It was evaluated the effect of fermentation conditions on the components of fermented alcoholic, as well as, the quality of alcoholic distilled beverage of ginger. Methods: Dehydrated ginger passed by enzymatic hydrolysis-saccharification processes. The hydrolysate obtained was analyzed for sugar profile in HPLC. The alcoholic fermentation process followed the central composite rotational design for three factors: fermentation temperature (23 to 37ºC), time of fermentation (17 to 33 h) and concentration of inoculum (0.22 to 3.00%). The fermented alcoholic obtained was analyzed in HPLC for the contents of ethanol, methanol, glycerol and residual sugars. The distillated alcoholic beverage of ginger was analyzed for ethanol, methanol, acetaldehyde, ethyl acetate and higher alcohols in the gas chromatography (GC). In addition, copper content and acidity were analyzed Results: Sugar profile of the ginger hydrolysate revealed the presence of 77.8% of glucose. Data analysis of fermentation process showed influence of temperature on ethanol and methanol content of the fermented alcoholic of ginger. Time of fermentation had effect on glycerol content. All parameters of process had influence on residual sugars contents. The HPLC analysis has shown presence of methanol, ethyl acetate, aldehyde, acids, higher alcohols and esters in distilled alcoholic beverage of ginger. Conclusion: Fermented alcoholic of ginger with higher levels of ethanol can be obtained under the conditions of 1.5% w/w of inoculum, 30°C of temperature and 24 hours of fermentation time. In this condition of fermentation process the beverage of ginger had good quality.

Effects of dredging operations on sediment quality: contaminant mobilization in dredged sediments from the Port of Santos, SP, Brazil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Eutrophization process in a system used for rearing the nile tilapia (Oreochromis niloticus), São Paulo State, Brazil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Electrical conductivity as an indicator of pea seed aging of stored at different temperatures

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Spittlebug impacts on sugarcane quality and ethanol production

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Investigation on Surface Finishing of Components Ground with Lapping Kinematics: Lapgrinding Process

Over the last three decades, researchers have responded to the demands of industry to manufacture mechanical components with geometrical tolerance, dimensional tolerance, and surface finishing in nanometer levels. The new lapgrinding process developed in Brazil utilizes lapping kinematics and a flat grinding wheel dressed with a single-point diamond dresser in agreement with overlap factor (U(d)) theory. In the present work, the influences of different U(d) values on dressing (U(d) = 1, 3 e 5) and grain size of the grinding wheel made of silicon carbide (SiC = 800, 600 e 300 mesh) are analyzed on surface finishing of stainless steel AISI 420 flat workpieces submitted to the lapgrinding process. The best results, obtained after 10 minutes of machining, were: average surface roughness (Ra) 1.92 nm; 1.19 mu m flatness deviation of 25.4 mm diameter workpieces and mirrored surface finishing. Given the surface quality achieved, the lapgrinding process can be included among the ultra-precision finishing processes and, depending on the application, the steps of lapping followed by polishing can be replaced by the proposed abrasive process.

Control charts for individual observations of a bivariate Poisson process

In this paper, three single-control charts are proposed to monitor individual observations of a bivariate Poisson process. The specified false-alarm risk, their control limits, and ARLs were determined to compare their performances for different types and sizes of shifts. In most of the cases, the single charts presented better performance rather than two separate control charts ( one for each quality characteristic). A numerical example illustrates the proposed control charts.

A QUALITY MANAGEMENT SYSTEM FOR POSITIONING WITH GNSS TECHNOLOGY

This paper presents a proposal for a Quality Management System for a generic GNSS Surveying Company as an alternative for management and service quality improvements. As a result of the increased demand for GNSS measurements, a large number of new or restructured companies were established to operate in that market. Considering that GNSS surveying is a new process, some changes must be performed in order to accommodate the old surveying techniques and the old fashioned management to the new reality. This requires a new management model that must be based on a well-described procedure sequence aiming at the Total Management Quality for the company. The proposed Quality Management System was based on the requirements of the Quality System ISO 9000:2000, applied to the whole company, focusing on the productive process of GNSS surveying work.

Between freedom and reclusion: Social support as a quality-of-life component in the family caregiver-dependent person binomial

This is a qualitative study which uses Grounded Theory as its methodological framework and Symbolic Interactionism as a theoretical base to understand the experience of family caregivers for Cerebrovascular Accident (CVA) patients with regard to social support during their rehabilitation process at home. The components (themes and categories) of the phenomenon assuming home care and specifically the themes assuming care with support and assuming care without support were inter-related for the purpose of comparison and analysis, in order to apprehend how the interaction between them occurred, It was observed that, in addition to the recovery of the patient's autonomy, social support is one of the intervenient components in the quality of life for the family caregiver-disabled person binomial, particularly with respect to the caregiver's freedom to resume his/her life plan.

Breed and season influence on milk quality parameters and in mastitis occurrence

Os objetivos do presente estudo foram avaliar a performance das raças Jersey e Holandesa em diferentes condições de pluviosidade (estações seca e chuvosa) através do monitoramento de aspectos relacionados com a mastite subclínica (contagem de células somáticas, isolamento microbiológico, tipo de patógeno isolado), qualidade do leite (lactose, proteína, gordura e sólidos totais) e produção (media da produção de leite) de ambas as raças. O estudo foi conduzido em propriedade leiteira localizada no estado de São Paulo, Brasil. Oito visitas foram realizadas a propriedade, quatro em período de alta pluviosidade e outro em período de baixa pluviosidade. Amostras de leite foram colhidas de todos os animais para contagem eletrônica de células somáticas e determinação dos principais componentes do leite (proteína, gordura, sólidos totais, lactose). Gordura, proteína, sólidos totais e produção leiteira foram influenciadas tanto pela raça como pela estação, apresentando tendências similares para ambas raças em ambas estações. A contagem de células somáticas (CCS) apresentou resultados similares para ambas as raças. Vacas holandesas com infecção intramamária (IIM) apresentaram um maior aumento na CCS quando comparadas as vacas Jersey (P<0.001). Na estação seca, 53 animais tiveram IIM em pelo menos um mês do estudo. Destes, 32 eram da raça Holandesa e 21 da raça Jersey. Na estação chuvosa, 65 animais possuíram infecção intramamária, dos quais 43 eram da raça Holandesa e 22 da raça Jersey. A frequência de casos de IIM foi maior na estação chuvosa em comparação à estação seca. Vacas Jersey apresentaram uma menor chance de desenvolver sinais e sintomas de IIM em relação às vacas holandesas na estação chuvosa (razão de chances=0.52). O maior numero de casos de IIM na estação chuvosa pode ter contribuído para uma menor taxa de lactose no leite para ambas as raças, sendo que esta pode ser considerada como um indicador do status de IIM. Existiu uma prevalência de patógenos contagiosos durante todo o experimento. O modelo estatístico aplicado mostrou que patógenos ambientais foram mais frequentemente isolados da raça Jersey, independentemente do período do estudo. Aparentemente existem diferenças na resposta imune das raças Jersey e Holandesa.

Storage temperature and quality of red mombin fruits (Spondias purpurea L.)

The aim was to study the effect of different storage temperatures on quality of red mombin fruit. The red mombin fruits were obtained from the Company CEAGESP/São Paulo/Brazil and transported in cool boxes to the laboratory, where they were selected on the base of appearance, maturity lack of physical damage, sanitized in 50 ppm chlorine-free solution and packaged in polystyrene trays wrapped with film of polyvinyl chloride (PVC). The experiment was a completely randomized design with three temperatures (4, 8 and 25 degrees C) and 5 time intervals (0, 2, 4, 6 and 8 days after the experiment installation). In each survey firmness, titratable acidity, soluble solids, ascorbic acid content, the skin color and also the release of CO(2) by the fruit over time were evaluated. It was observed that low temperatures prolong the fruits shelf life and the storage temperature influences the characteristics, the temperature of 8 degrees C was most suitable for the storage of red mombin fruits. Besides, the fruit color was a good indicator of changes in the pulp during storage.