Fibras reforçadas por resina (FRC) em Ortodontia. Versatilidade clínica: parte 2

As fibras de vidro e de polietileno podem ser utilizadas na prática ortodôntica em diversas situações clínicas, nos casos com ou sem extrações dentárias. Este artigo tem como objetivo mostrar algumas das aplicações clínicas nas quais as fibras contribuíram de forma significativa para a realização dos tratamentos ortodônticos, simplificando-os e aumentando a eficiência clínica. As fibras foram utilizadas principalmente em segmentos de ancoragem e na substituição da banda pela colagem da associação fibra/tubo nos molares.

Fadiga de grampos de retenção em prótese parcial removível. Efeito de ligas, espessuras e técnicas de fusão. Parte I.

The authors looked for the verification of the fatigue of retentive clasps utilized on the removable partial denture. According to this, it was idealized and built on assay machine, that through movements, simulate the insertion and removal of the clasp for a pattern tooth, manufactured on cobalt-chromium which has all the preparation normally utilized to the correct confection of this type of prosthesis. It was utilized three different commercial alloys based on cobalt-chromium: L1-Biosil; L2-Steldent; L3-Duracron. It was utilized the T clasp of Roach, with was tested upon three different proportions among width and thickness: E1-1.7;E2-2.0 and E3-2.3 and was casted through two casting techniques: F1-oxygen-gas and F2-oxygen-acetylene. The clasps were tested on the machine, which allowed the reading of the number of insertion and removal cycles made until fatigue appeared. The obtained results were submitted to the statistic analysis and the authors concluded that: a) L3 (Duracrom) obtained the best results followed by L1 (Biosil) and finally L3 (Steldent); b) among the analyzed thickness, the best results were obtained by E3, followed by E2 and after this E1; c) form the casting techniques, F2 gave us the best results.

Fadiga de grampos de retenção em prótese parcial removível. Efeito de ligas, espessuras e técnicas de fusão. Parte II.

The authors tested the T clasp of Roach in three differents proportions among width and thickness: E1-1.7; E2-2.0 and E3-2.3, with a constant length of 15 mm. These clasps were casted with three cobalt-chromium alloys (L1-Biosil; L2-Steldent and L3-Duracrom), through two casting techniques (F1-oxygen-gas and F2-oxygen-acetylene). The fatigue of the clasps were verified by using and assay machine, that through movements, simulate the insertion and removal of the clasps for a pattern which were obtained from a premolar, prepared in a surveyor. This machine detect the fatigue of the clasps and count the number of cycles of insertion and removal realized. The obtained results of the interaction between the analysed factors, were submitted to the statistic analysis and the authors concluded that: a) the interaction of factors, Alloy x Thickness, Alloy x Casting Technique and Thickness x Casting Technique did not change the order of effects that the factors showed separately but gave rise to effects of different magnitude for any observed sense; b) the simultaneous interaction of the factors Alloy x Thickness x Casting Technique confirmed the superiority of the L3 alloy, the thickness E3 and the F2 casting technique.

Extra̧ão de Macro e Micronutrientes Pela Parte Aérea de Erva-Doce EM Fuņão de Calagem e Aduba̧ão com Esterco de Cama de Frango

A greenhouse experiment was conducted in the Soil Science Department of the Botucatu College of Agricultural Sciences (UNESP), Brazil, using a Dark Red Latosol in 25 L pots. The soil was limed to 50 and 70% of base saturation; and doses 0, 10, 20, 30 and 40 t ha-1 of chicken manure were applied, in December of 1999. The experimental design was completely randomized blocks with a factorial arrangement 5x2, 10 treatments and three replications. This work was carried to evaluate leaf number, height plants, fresh and dry weight by aerial part of sweet fennel, and macronutrients and micronutrients removal. The organic fertilization affected the accumulation of N, P, K, S, B and Mn; liming affected the nutrient uptake, except for the Ca, Mg, S and Fe; the interaction of factors affected K, Mg and Mn.

Polissacarídeos biodegradáveis úteis para a preparação de sistemas de liberação controlada de fármacos. Parte 1: Quitosana

Due to an increasing interest, a vast number of biodegradable polymers have been obtained recently. Polymers naturally produced, such as cellulose, starch, chitosan and alginate, represent biodegradable materials, with low toxicity and low cost. Among polysaccharides, chitosan has been of great interest of the industrial and academic research, due to its special qualities of biodegradability and biocompatibility and, on the other hand, to the versatility of its use in several physical forms and products. A significant growth in the development of new dosage forms capable to deliver the drug in a controlled and targeted way has been observed in these last years. Such pharmaceutical forms search, mainly, the reduction of the dose administered and of the administration frequency, the reduction of adverse side effects and, consequently, a better patient compliance. The present paper describes the use of chitosan in pharmaceutical products, especially in drug controlled delivery systems.

Efeito alelopático de extratos de parte aérea de barbatimão [Stryphnodendron adstringens (Mart.) Coville] na germinação e desenvolvimento da plântula de pepino

Stryphnodendron adstringens (Mart.) Coville (barbatimão), belonging to Mimosaceae family; it is used as ornamental and the wood is used in civil buildings, edification in wet places, lathe and joinery jobs, being very used also in home-made medicine against hemorrhage, diarrhea, hemorrhoids, conjunctivitis, injury cleaning, uterus hemorrhage, ulcerous hurt and excessive oily skin. The objective of this research was to determine the allelopathic potential of an aqueous extract, boiled or not of S. adstringens (Mart.) Coville, in the Cucumis sativus germination and initial development. Thus, the aqueous vegetable extract was extracted from the shoot, which was triturated in 1L of distilled water to 100g of leaf, being the extract filtrated and separated in boiled and not boiled. The treatments used were distilled water (0%) and boiled and not boiled extracts, in the concentrations of 50 and 100%. The cucumber seeds were put to germinate in Gerbox, having filter paper as substrate, which was wet with 25mL from different treatments, in constant temperature of 25°C. The reading germination was accomplished in breaks of 24 hours, for a period of five consequently days after the beginning of the experiment, considering germinated the seeds that showed 2mm of root, approximately. To dry matter determination, the seedlings with five days after the germination were separated in shoot and root, dried during three days to a constant weight in a 60°C forced draft oven. Through results, it can be concluded that the extract of S. adstringens affected more the Cucumis sativus seedling development than the germination, and it didn't show difference if boiled or not.

Avaliação de diferentes híbridos suínos submetidos à insensibilização elétrica e gasosa (CO 2). Parte 3 - Mensurações visuais de qualidade

Three pig genetics lineages A, B and C marketed in Brazil, were stunning with the manual electric stunning (Karl Schermer 220-230/250 volts, 45-60 Hz and 1.4 - 1.5 A) and the collective gaseous system (COMBI-BUTINA 90% CO 2). The electric stunning provided higher blood splashed levels in the areas of the inside round (0.477 and 0.26, p ≤ 0.01), shoulder/cranial (0.154 and 0.039, p ≤ 0.005), shoulder/central (0.261 e 0.052, p ≤ 0.001), shoulder/caudal (0.180 and 0.030, p ≤ 0.01), loin/central (0.185 and 0.065, p ≤ 0.01), loin/caudal (0.06 and 0.207, p ≤ 0.01) and loin/lateral external (0.061 and 0.013, p ≤ 0.05), as well as more diffuse blood splashed in the areas of the inside round (0.461 and 0.279, p ≤ 0.05), shoulder/cranial (0.154 and 0.039, p ≤ 0.001), shoulder/central (0.231 and 0.039, p ≤ 0.001) and shoulder/caudal (0.185 and 0.026, p ≤ 0.001). The electric stunning also provided higher skin damage levels in the areas of the shoulder (1.098 and 0.795, p ≤ 0.001), body (1.04 and 0.948, p ≤ 0.05) and ham (0.84 and 0.68, p ≤ 0.001), as well as higher eyelid reflex levels (11.57%) comparatively to the gaseous system (2.86%) of a total of 426 pigs. Small indexes of bone fractures and muscle bruises were found in both systems.

Avaliação de diferentes híbridos suínos submetidos à insensibilização elétrica e gasosa (CO 2). Parte 1 - Mensuração de indicadores sanguíneos de estresse

Pigs of three genetics lineages A, B and C marketed in Brazil, with alive weight from 100 to 120 kg were submitted to the manual electric stunning (Karl Schermer 220-230/250 volts, 45-60 Hz and 1.4 -1.5 A) and to the collective gaseous system (COMBI-BUTINA 90% CO 2). Blood samples, for levels determination of creatine phosphokinase (CPK), lactate and cortisol, as well as samples of the semimembranosus muscle (10 g) for the determination of the gene halothane, were collected. Being compared the electric and gaseous stunning systems, the electric stunning did demonstrate to be more stressful providing larger plasmatic concentrations of cortisol (p ≤ 0.001) and lactate (p ≤ 0.001) for the genetic lineages A and C, in the studied conditions. However it didn't observe significant differences beween the sanguine indicators and stunning systems in subject when the lineage B was considered. Significant differences among the genetic lineages A, B and C were obtained being compared the plasmatic values of creatine phosphokinase (p ≤ 0.001), lactate (p ≤ 0.001) and cortisol (p ≤ 0.001) when stunned with the gaseous system, however when the electric system was used only the cortisol values presented significant differences (p ≤ 0.001). The presence of the gene halothane (Nn) was only observed in the lineage B.

A tectônica meso-cenozóica de parte da borda nordeste da Bacia do Paraná: traços de fissão em apatita

The possible development of thermal events in the central portion of São Paulo state was described based on apatite fission track analysis. Using apatites of sedimentary rocks of the Paraná Basin, modeling the thermal history was made possible due to the homogeneity of the data. Every thermal history begins with a total annealing of fission tracks, related to the Serra Geral magmatism, evolving into a cooling period. In addition to cooling after the magmatism (Early Cretaceous) two other periods of cooling were also detected, registered in the Late Cretaceous/ Paleocene and Eocene, driven as much by uplift with tectonic denudation as by faulting. The nearest portion of the edge of the basin (external to the Dome of Pitanga), registered a period of warming over the Paleocene that can be attributed to the increase in the geothermal gradient. The periods of cooling have a regional and temporal relationship with the tectonic events that occurred in the southeastern Brazil and were described in the crystalline basement. The period of warming, registered in the Late Cretaceous/ Paleocene, has local occurrence and can be found only in the southern portion of the studied area.

Compactação do solo e intervalo hídrico ótimo no crescimento da parte aérea e produtividade da cultura do milho

The aim of this work was to evaluate the effect of soil compaction caused by tractor wheel traffic on the limiting water range (LLWR), shoot growth and levels of compaction and four replications in a completely randomized experimental design. Soil samples with preserved structure were collected in the layers: 0.02-0.05; 0.08-0.11; 0.15-0.18 and 0.22-0.25m to determine macroporosity, microporosity, total porosity, bulk density, resistance to penetration and LLWR. The evaluated corn parameters were: plant and first spike height, steam diameter, number of spikes per plant, plant dry matter, dry matter of 1000 seeds and seed productivity. The soil compaction restricted all corn parameters except the number of spikes per plant and dry matter of 1000 seeds. The LLWR was reduced by the soil resistance to penetration, even in the tilled soil with bulk density of 1.12 Mg m-3. Only the treatment with 11 Mg tractor, repeated four times on the area, demonstrated bulk density above critical bulk density in the LLWR that was 1.37 Mg m-3, where the seed productivity was significantly smaller.

Simulação computacional da parte elétrica do problema de geração de fluxo eletrohidrodinâmico

Pós-graduação em Ciência da Computação - IBILCE

Projeto Veredas: a experiência de formação a distância, proposta pelo governo de Minas Gerais como parte das políticas atuais para a formação de professores no Brasil

Pós-graduação em Educação - IBRC

Geologia e aspectos petrológicos das rochas intrusivas e efusivas mesozóicas de parte da borda leste da Bacia do Paraná no Estado de São Paulo

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Geoecologia da paisagem na avaliação do uso dos recursos Hídricos da parte inicial da bacia do Ribeirão das Posses - SP

Pós-graduação em Agronomia (Irrigação e Drenagem) - FCA