Tin(II)-EDTA complex: kinetic of thermal decomposition by non-isothermal procedures

Tin on the oxide form, alone or doped with others metals, has been extensively used as gas sensor, thus, this work reports on the preparation and kinetic parameters regarding the thermal decomposition of Sn(II)-ethylenediaminetetraacetate as precursor to SnO2. Thus, the acquaintance with the kinetic model regarding the thermal decomposition of the tin complex may leave the door open to foresee, whether it is possible to get thin film of SnO2 using Sn(II)-EDTA as precursor besides the influence of dopants added.The Sn(II)-EDTA soluble complex was prepared in aqueous medium by adding of tin(II) chloride acid solution to equimolar amount of ammonium salt from EDTA under N-2 atmosphere and temperature of 50degreesC arising the pH similar to 4. The compound was crystallized in ethanol at low-temperature and filtered to eliminate the chloride ions, obtaining the heptacoordinated chelate with the composition H2SnH2O(CH2N(CH2COO)(2))(2).0.5H(2)O.Results from TG, DTG and DSC curves under inert and oxidizing atmospheres indicate the presence of water coordinated to the metal and that the ethylenediamine fraction is thermally more stable than carboxylate groups. The final residue from thermal decomposition was the SnO2 characterized by X-ray as a tetragonal rutile phase.Applying the isoconversional Wall-Flynn-Ozawa method on the DSC curves, average activation energy: E-a = 183.7 +/- 12.7 and 218.9 +/- 2.1 kJ mol(-1), and pre-exponential factor: log A = 18.85 +/- 0.27 and 19.10 +/- 0.27 min(-1), at 95% confidence level, could be obtained, regarding the loss of coordinated water and thermal decomposition of the carboxylate groups, respectively. The E-a and logA also could be obtained applying isoconventional Wall-Flynn method on the TG curves.From E-a and log A values, Dollimore and Malek procedures could be applied suggesting R3 (contracting volume) and SB (two-parameter model) as the kinetic model to the loss of coordinated water (177-244degreesC) and thermal decomposition of the carboxylate groups (283-315degreesC), respectively. Simulated and experimental normalized DTG and DSC curves besides analysis of residuals check these kinetic models. (C) 2003 Elsevier B.V. All rights reserved.

U(2) flavor physics without U(2) symmetry

We present a model of fermion masses based on a minimal, non-Abelian discrete symmetry that reproduces the Yukawa matrices usually associated with U(2) theories of flavor. Mass and mixing angle relations that follow from the simple form of the quark and charged lepton Yukawa textures are therefore common to both theories. We show that the differing representation structure of our horizontal symmetry allows for new solutions to the solar and atmospheric neutrino problems that do not involve modification of the original charged fermion Yukawa textures, or the introduction of sterile neutrinos. (C) 2000 Elsevier Science B.V.

Efeito do nível de energia metabolizável da dieta no desempenho e metabolismo energético de frangos de corte

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Nutritional support and outcome in hospitalized dogs and cats

This study investigated the effect of assisted nutritional support on the outcome and time of hospitalization (TH) of dogs and cats. The study compared two groups of 400 hospitalized animals. The animals in group 1 did not receive assisted nutritional support because they were hospitalized before the clinical nutrition service was implemented; animals in group 2 were nutritionally managed. Animals in group 1 received a low-cost diet with no consumption control. Group 2 animals had their maintenance energy requirement (MER) calculated, received a high-protein and high-energy super-premium diet, had their caloric intake (CI) monitored, and received enteral and parenteral nutritional support when necessary. The statistical analysis of the results included the standard T test (group 1 versus group 2) and chisquare and Spearman's correlation to evaluate group 2 (CI and outcome, body condition score (BCS) and outcome, BCS and CI). For group 2, favorable outcome (FO), defined as the percent responding to therapy and dis-charged from the hospital, was 83%, and the TH was 8.59 days. These values were lower (P < .001) for group 1 (63.2% FO and TH of 5.7 days). For group 2, 65.5% of the animals received voluntary consumption (93.1% outcome), 14.5% received enterai support (67.9% FO), 6.5% received parenteral support (68% FO), and 6.17% did not eat (38.5% FO), demonstrating an association between the type of nutritional support and outcome (P < .01). Group 2 animals that received 0% to 33% of their MER had 62.9% FO, and those receiving more than 67% had 94.3% FO, which shows that lower mortality rates are associated with higher CI (P < .001). TH was higher for animals with higher CI (P < .001). The BCS did not correlate with Cl (P > .05) but did correlate with outcome (P < .01). FO was 68.7% for animals with low BCS, 85.7% for animals with ideal BCS, and 86.6% for overweight animals. Nutritional support could allow for longer therapies, thus increasing the TH and FO rate.

The energetic cost of maintenance in ruminants: From classical to new concepts and prediction systems

The cost of maintenance makes up a large part of total energy costs in ruminants. Metabolizable energy (ME) requirement for maintenance (MEm) is the daily ME intake that exactly balances heat energy (HE). The net energy requirement for maintenance (NEm) is estimated subtracting MEm from the HE produced by the processing of the diet. Men cannot be directly measured experimentally and is estimated by measuring basal metabolism in fasted animals or by regression measuring the recovered energy in fed animals. MEm and NEm usually, but not always, are expressed in terms of BW0.75. However, this scaling factor is substantially empirical and its exponent is often inadequate, especially for growing animals. MEm estimated by different feeding systems (AFRC, CNCPS, CSIRO, INRA, NRC) were compared by using dairy cattle data. The comparison showed that these systems differ in the approaches used to estimate MEm and for its quantification. The CSIRO system estimated the highest MEm, mostly because it includes a correction factor to increase ME as the feeding level increases. Relative to CSIRO estimates, those of NRC, INRA, CNCPS, and AFRC were on average 0.92, 0.86, 0.84, and 0.78, respectively. MEm is affected by the previous nutritional history of the animals. This phenomenon is best predicted by dynamic models, of which several have been published in the last decades. They are based either on energy flows or on nutrient flows. Some of the different approaches used were described and discussed.

Comparação entre as necessidades energéticas prescritas e administradas a pacientes em terapia nutricional enteral

Objective: evaluating the adequacy, prescription and energy supply of enteral nutrition therapy in hospitalized patients. Methods: was performed a retrospective survey of the evolution of TNE protocol of 59 patients hospitalized in a general hospital in Marília / SP / BR. Data collected included gender, age, clinical diagnosis, anthropometric and dietary data related to the prescribed dietary formula, route and method of administration of the enteral nutrition, the daily volume prescribed and administered, the daily amount of energy required and offered in the diet, as well as possible complications. Body mass index (BMI), triceps skinfold (TSF) and arm muscle circumference (AMC) were used to establish the nutritional status of the patients. The adequacy of ENT was done according to the daily energy requirement compared to the average energy received during the daily use of ENT. Results: The average found to the BMI was 21.4 kg/m 2, and no differences were found comparing male and female. The data for TSF and AMC were different between genders (p<0.05) and suggest a more severe muscle mass in relation to adipose tissue. The averaged to the energy requirements was 1642 kcal/day but the average of energy prescribed was 1045 kcal/day and the amount offered was 1035 kcal/day. There was a significant difference between the necessity and the supplied energy offered through enteral nutrition (p=0.00) as well between the energy required and prescribed (p =0.00), both were shorter than the necessity. There was no significant difference (p>0.05) in energy supply, volume of enteral nutrition prescribed and administered among eutrophic, underweight or overweight patients. Conclusion: The results of this study indicate that the prescription and energy supply were not based on the needs of these patients, causing a significant energy deficit, which can lead to worsening of the nutritional status of the same. In hospitalized patients in use of ENT, the energy requirement must be made by a qualified professional within the multidisciplinary team, based on the needs of each patient.

Padrão alimentar de mulheres obesas que subnotificam ou não a ingestão energética

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Modelo estatístico de rede de resistores para o estudo de processos de condução em nanocompósitos poliméricos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Exigências nutricionais de cabritas saanen em crescimento dos 30 aos 45 kg

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Influência do teor protéico da dieta hipocalórica e do sexo sobre a perda e posterior manutenção do peso em gatos obesos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Nível de fibra e tipo de processamento na digestibilidade, ingestão e parâmetros bioquímicos da arara-canindé (Ara ararauna L. – Aves, Psittacidae)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Composição corporal e exigências nutricionais de energia e proteína de tourinhos Santa Gertrudes confinados, recebendo alto concentrado e subproduto da produção de lisina

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Análise de propostas de sequestro mineral de carbono para usinas termoelétricas no Brasil

Pós-graduação em Engenharia Mecânica - FEG

Utilização de trocadores de calor de placas em espiral em processos da indústria siderúrgica

Stricter environmental policies are shown necessary to ensure an effective pollutant emission control. It is expected for the present year of 2015, that Brazil will assume, at the 21th United Nation's Climate Change Conference (COP21), implementation of commitment to a low carbon economy. This positioning affects the industrial environment, so that is deemed necessary to search for new technologies, less aggressive to the environment, so the adequacies to the new emission policies do not cause a negative effect on production. Almost all of the processes performed in the steel industry demand burning fuel and, therefore, flue gases are sent to the atmosphere. In this present work is discussed the utilization of heat exchangers so, by recovering part of the available heat from the flue gases of certain industrial process, the combustion air is preheated. The combustion air preheat results in less energy requirement, i.e., less need of fuel consumption and, in addition, minor amount of pollutants to be emitted. Due to better fitting to the process, it is studied the utilization of spiral plate heat exchangers. The heat exchanger dimensioning is made by an iterative method implemented in the software Microsoft Excel. Subsequently are analyzed the gains in terms of process's thermal efficiency improvement and the percentage of fuel saving. The latter implies in reduction of the same percentage of greenhouse gases emission

Validation of the Deardorff model for estimating energy balance components for a sugarcane crop

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)