A comparative study of the low energy HD plus o-/p-H-2 rotational excitation/de-excitation collisions and elastic scattering

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Short Comments on an Energy Pumping Levels in a MEMS Gyroscope Vibrating Problem, by Using of an Global and Local Optimal Linear Control Design

This paper deals with an energy pumping that occurs in a (MEMS) Gyroscope nonlinear dynamical system, modeled with a proof mass constrained to move in a plane with two resonant modes, which are nominally orthogonal. The two modes are ideally coupled only by the rotation of the gyro about the plane's normal vector. We also developed a linear optimal control design for reducing the oscillatory movement of the nonlinear systems to a stable point.

Nanoscale electromechanical properties of CaCu3Ti4O12 ceramics

Piezoresponse Force Microscopy (PFM) is used to characterize the nanoscale electromechanical properties of centrosymmetric CaCu3Ti4O12 ceramics with giant dielectric constant. Clear PFM contrast both in vertical (out-of-plane) and lateral (in-plane) modes is observed on the ceramic surface with varying magnitude and polarization direction depending on the grain crystalline orientation. Lateral signal changes its sign upon 180 degrees rotation of the sample thus ruling out spurious electrostatic contribution and confirming piezoelectric nature of the effect. Piezoresponse could be locally reversed by suitable electrical bias (local poling) and induced polarization was quite stable showing long-time relaxation (similar to 3 hrs). The electromechanical contrast in unpoled ceramics is attributed to the surface flexoelectric effect (strain gradient induced polarization) while piezoresponse hysteresis and ferroelectric-like behavior are discussed in terms of structural instabilities due to Ti off-center displacements and structural defects in this material. (C) 2011 American Institute of Physics. [doi:10.1063/1.3623767]

Nutrição e produtividade da cultura do milho em sistemas de culturas e fontes de adubação

A utilização de esterco animal na agricultura, aliada ao cultivo de plantas de cobertura, pode conferir sustentabilidade ao sistema agrícola. Com o objetivo de avaliar o efeito de dois sistemas de culturas e de três fontes de nutrientes, na cultura do milho, conduziu-se um experimento, em Latossolo Vermelho, no município de Marechal Cândido Rondon (PR). O delineamento experimental utilizado foi de blocos casualizados, com quatro repetições, e, os tratamentos, dispostos em esquema fatorial 2 x 3, compostos por dois sistemas de culturas (sucessão trigo/milho e consórcio aveia+ervilhaca+nabo/milho) e três fontes de nutrientes (mineral, orgânica e organomineral). em junho de 2006, implantou-se a cultura do trigo e o consórcio de plantas de cobertura. em outubro de 2006, semeou-se milho sob os dois sistemas. As adubações orgânica e organomineral consistiram na aplicação de dejetos de suínos, unicamente, e combinada com fertilizante mineral, respectivamente. O consórcio de aveia preta, ervilhaca peluda e nabo forrageiro mostrou-se capaz de fornecer a quantidade adequada de biomassa, concretizando sua viabilidade para produção de cobertura vegetal ao solo, durante o inverno. O cultivo de milho em sucessão ao trigo proporcionou a maior absorção de N e K e a maior produtividade. A adubação mineral proporcionou maior absorção de N e maior produtividade de milho, em comparação com as adubações orgânica e organomineral com dejetos de suínos.

Manipulation of anchoring strength in an azo-dye side chain polymer by photoisomerization

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Dynamics of aggregate stability influenced by soil management and crop residues

The type of tillage and crop systems used can either degrade or cause a recovery of the structure of agricultural soils. The objective of this study was to determine the structural stability of the soil using mean weight diameter (MWD) of soil aggregates in three different periods of a succession of crops consisting of beans/cover plants/maize under no tillage (NT) and conventional tillage (CT) management systems. Soils were sampled at 0- to 5-cm and 5- to 15-cm depths in three periods (P1, P2, P3): 1) November 2002 (spring/summer), 2) April 2003 (beginning of autumn), and 3) December 2003 (end of spring/beginning of summer). Aggregate stability was determined by wet sieving. The effects of the tillage systems, vegetal residues, and sampling depths on the structural stability of the aggregates were assessed and then related to organic matter (OM) contents. Aggregate stability showed temporal variation as a function of OM contents and sampling period. No tillage led to high MWD values in all study periods. The lowest MWD values and OM contents were observed 4 months after the management of the residues of cover plants. This finding is consistent with the fact that at the time of the samplings, most of the OM had already mineralized. The residues of sunn-hemp, millet, and spontaneous vegetation showed similar effects on soil aggregate stability.

Soil CO2 efflux following rotary tillage of a tropical soil

Stopping the increase of atmospheric CO2 level is an important task and information on how to implement adjustments on tillage practices could help lower Soil CO2 emissions would be helpful. We describe how rotary tiller use on a red latosol affected Soil CO2 efflux. The impact of changing blade rotation speed and rear shield position on soil CO2 efflux was investigated. Significant differences among treatments were observed up to 10 days after tillage. Cumulative CO2 efflux was as much as 40% greater when blade rotation of 216 rpm and a lowered rear shield was compared to blade rotation of 122 rpm and raised shield. This preliminary work suggests that adjusting rotary tiller settings could help reduce CO2 efflux close to that of undisturbed soil, thereby helping to conserve soil carbon in tropical environments. (C) 2004 Elsevier B.V. All rights reserved.

Short-term soil CO2 emission after conventional and reduced tillage of a no-till sugar cane area in southern Brazil

The impact of tillage systems on soil CO2 emission is a complex issue as different soil types are managed in various ways, from no-till to intensive land preparation. In southern Brazil, the adoption of a new management option has arisen most recently, with no-tillage as well as no burning of crops residues left on soil surface after harvesting, especially in sugar cane areas. Although such practice has helped to restore soil carbon, the tillage impact on soil carbon loss in such areas has not been widely investigated. This study evaluated the effect of moldboard plowing followed by offset disk harrow and chisel plowing on clay oxisolCO(2) emission in a sugar cane field treated with no-tillage and high crop residues input in the last 6 years. Emissions after tillage were compared to undisturbed soil CO2 emissions during a 4-week period by using an LI-6400 system coupled to a portable soil chamber. Conventional tillage caused the highest emission during almost the whole period studied, except for the efflux immediately following tillage, when the reduced plot produced the highest peak. The lowest emissions were recorded 7 days after tillage, at the end of a dry period, when soil moisture reached its lowest rate. A linear regression between Soil CO2 effluxes and soil moisture in the no-till and conventional plots corroborate the fact that moisture, and not soil temperature, was a controlling factor. Total soil CO2 loss was huge and indicates that the adoption of reduced tillage would considerably decrease soil carbon dioxide emission in our region, particularly during the summer season and when growers leave large amounts of crop residues on the soil surface. Although it is known that crop residues are important for restoring soil carbon, our result indicates that an amount equivalent to approximately 30% of annual crop carbon residues could be transferred to the atmosphere, in a period of 4 weeks only, when conventional tillage is applied on no-tilled soils. (c) 2005 Elsevier B.V. All rights reserved.

Sperm ultrastructure and a new type of spermiogenesis in two species of Pimelodidae, with a comparative review of sperm ultrastructure in Siluriformes (Teleostei : Ostariophysi)

During spermiogenesis, the spermatids of the pimelodid species Pimelodus maculatus and Pseudoplatystoma fasciatum show a central flagellum development, no rotation of the nucleus, and no nuclear fossa formation, in contrast to all previously described spermatids of Teleostei. These characteristics are interpreted as belonging to a new type of spermiogenesis, named here type III, which is peculiar to the family Pimelodidae. In P. maculatus and P. fasciatum, spermatozoa possess a spherical head and no acrosome; their nucleus contains highly condensed, homogeneous chromatin with small electron-lucent areas; and a nuclear fossa is not present. The centriolar complex lies close to the nucleus. The midpiece is small, has no true cytoplasmic channel, and contains many elongate and interconnected vesicles. Several spherical to oblong mitochondria are located around the centriolar complex. The flagellum displays the classical axoneme (9 + 2) and no lateral fins. Only minor differences were observed among the pimelodid species and genera. Otherwise, spermiogenesis and spermatozoa in the two species of Pimelodidae studied exhibit many characteristics that are not found in other siluriform families, mainly the type III spermiogenesis. (C) 2007 Elsevier GmbH. All rights reserved.

The Sao Vicente earthquake of 2008 April and seismicity in the continental shelf off SE Brazil: further evidence for flexural stresses

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Electromyographic study of the trapezius (middle portion) and rhomboideus major muscles in movements of the trunk

The authors studied the trapezius (middle portion) and rhomboideus major muscles in movements of flexion, extension, inclination and rotation of the trunk. The electromyographic records demonstrate that such muscles show activity only at the ending of flexion, being inactive in the other movements.

Electromyographic study of the trapezius (pars media) and rhomboideus major muscles in free movements of the head

The authors studied the trapezius (pars media) and rhomboideus major muscles in movements of flexion, extension, inclination and rotation of the head. The electromyographic records demonstrated that referred muscles are inactive in these different movements.

A case study of the 9 August 1988 South Atlantic storm: Numerical simulations of the wave activity

During 9-11 August 1988, a cyclone developed over Uruguay in the lee of the Andes Mountains and moved over the South Atlantic Ocean, where it redeveloped into an intense storm. This storm was responsible for unusual wave activity along the Brazilian shoreline from 22° to 32°S. The Brazilian news media reported the loss of at least one life, waves of 3 m and higher, and the disappearance of a drainage pipe, which weighed 8000 kg, off the shores of Rio de Janeiro. In this paper, the evolution of this intense storm and the associated ocean wave response is studied through European Centre for Medium-Range Weather Forecasts analyses, a hydrostatic limited-area meteorological model, and a second-generation prognostic wave model. The atmospheric model results indicated the presence of a long-lived and large fetch with surface wind velocities higher than 12 m s -1 directed toward the coast. Some areas with velocities of 20 m s -1 were embedded in the fetch. The wave model forced by this wind field was able to simulate waves with a significant height of 8 m far from the coast and about 4 m in regions very close to the Brazilian coast in agreement with the occurrence reported at Rio de Janeiro. The swell propagation toward the coast of Rio de Janeiro was obstructed by a northeastward 10-m wind during the first 24-h period of the model's integration. During the second 24-h period, the fetch was still large and strong, but the obstacle was removed by a counterclockwise rotation of wind direction favoring the swell and windsea propagation toward the Rio de Janeiro coast.

Eucalyptus ESTs associated with resistance to herbicide inhibitors of aromatic and branched-chain amino acid synthesis

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Influence of the construction bite vertical and horizontal dimensions on dentoskeletal structures induced by the Klammt appliance in Class II treatment

Aim: To evaluate the influence of construction bite in the dentoskeletal changes induced by Klammt Appliance. Methods: The sample consisted of 17 children, with Class II malocclusion and initial mean age of 8.5 years. The construction bite was obtained using an Exactobite on edge-toedge anteroposterior relationship with 3 mm interincisal clearance. The height of the acrylic was determined by initial overbite associated to interincisal clearance and measured with digital caliper. The amount of advancement was obtained and measured by initial overjet in the lateral radiography. Pearson's correlation, linear regression and ANOVA were used to determine the relationship between dentoskeletal and construction bite variables. Results: The increase in the height of the acrylic promotes a greater inhibition of the forward displacement of the nasal spine and reduction in the facial growth index. The increase in the mandibular advancement induces more downward displacement of nasal spine and pogonion; a counter-clockwise rotation of palatine plane; an increase in mandibular length, maxillary alveolar height and interincisal angle; a decrease in mandibular alveolar height, the intermaxillary discrepancy and overjet; and palatal tipping of upper incisors. Conclusions: The different dimensions of the construction bite influence the dentoskeletal changes induced by the appliance in Class II treatment.