Avaliação de desempenho do microaspersor amanco em bancada de testes

The need for a rational use of water and supply of food for a growing world population have led to the development of research in the area of irrigation systems. Thus, some irrigation systems which join efficiency with low cost of material have been developed. Although some technical characteristics are provided by the manufacturers, tests are required to verify functioning of the system and uniformity of water distribution. Continuous research on uniformity, characteristics of the materials and design of water distribution systems is essential for system improvement. Therefore, the objective of this work was to evaluate the CV (manufacturer's coefficient of variation) of Amanco microsprinkler (1.0 mm light green nipple) using bench testing in the laboratory of Irrigation at UNESP - FCA campus of Botucatu-SP. Twenty-five microsprinklers in a sequential design were used in the tests. Three flow systems were tested as follows: a Coil system based on serial connected pipes; a Lateral system, the most common system in which secondary lines are fed by a main line; and a Mesh system used in the urban water supply. The results showed that 4.17% CVf met the production standards and the Lateral and Mesh systems were similar regarding outflow using bench testing. The Mesh system presented the highest mean value of outflow and the lowest range of variation.

Crescimento e acúmulo de nitrogênio e potássio pelo melão pele de sapo fertirrigado

With the objective of obtaining dry matter curves, and nitrogen and potassium accumulation in Piel de Sapo melon (Cucumis melo L.) hybrid Sancho, an experiment was conducted in Mossoró - RN in a randomized blocks design with three repetitions. Treatments consisted of doses in kg ha-1 of nitrogen: 0, 91, 140 and 184 and potassium: 0, 174, 260 and 346; which were applied by fertigation in depths of 281, 349 and 423mm. Stems, leaves and fruits were harvested 5 times at 28 to 70 days after transplantation, in intervals of 10 days for analyses of aerial dry matter, nitrogen, and potassium accumulation. Doses higher than 140 and 260 kg ha-1 of N and K respectively, did not induce greater accumulation of these nutrients increasing levels throughout the plant cycle. Nitrogen doses of 91 and 140 kg ha-1, potassium doses of 174 and 260 kg ha-1 as well as depth of 348mm provided higher accumulation of potassium in the plant.

Alface americana fertirrigada com diferentes doses de ácido fosfórico e hidróxido de potássio

Fertirrigation with phosphoric acid has been considered as an option to avoid drips from clogging. In some cases, this acid cause soil acidification and it can be substituted bypotassium hydroxide. This study had the objective of evaluating the effects of different phosphoric acid and potassium hydroxide doses, applied via fertirrigation, on soil fertility, plant nutrition and lettuce yield, compared to the conventional fertilization system. The experiment was carried out in greenhouse, in the College of Agricultural Sciences, FCA/UNESP, Botucatu-SP-Brazil. The experimental design was the completely randomized block, with 6 treatments and 4 replications. Treatments consisted of the combinations of doses (25% and 50% of the recommended complete dose for the lettuce) and application ofcomplete dose (100%) of phosphorus (P) and potassium (K) applied via fertirrigation, and a control (conventional fertilization system). The results showed that P and K availability in soil and nutrient concentration in plants were affected by treatments. Low phosphorus and potassium doses, applied via fertirrigation, were not efficient for the appropriate development of lettuce plants. The results showed that agronomic characteristics and commercial lettuce were affected by doses and application systems, especially the treatment with application of P and K full dose fertirrigation.

Supressão de água em diferentes fases fenológicas do feijoeiro (Phaseolus vulgaris L.)

Bean (Phaseolus vulgaris L.) is widespread in the Brazilian social and economic scene. The hypothesis is that if the water supply is suppressed in just one of the five development stages of irrigated beans, it can result in yield reduction lower than 20%, allowing water economy. The objective of this study was to compare the performance of bean Carioca group IAC Alvorada yield components, with irrigation suppression in each of the five phenological phases (emergence, vegetative, flowering, grain filling and maturation) and no irrigation and irrigated in all stages. The study was conducted at Agronomical Sciences College, UNESP, Botucatu, SP, Brazil. The statistical design was the randomized block with seven treatments and four replications. Data were subjected to analysis of variance and t test at 5% probability. A rainfall event (58 mm) after planting allowed the successful emergence of seedling beans in plots where water would not be applied. The yield components were higher affect when there was irrigation's suppression at Vegetative phase and at Flowering phase. The treatments where occurred irrigation suppression at Maturation and at Emergence showed yield reduction of less than 20%, proving the hypothesis.

Perda de carga em mangueiras gotejadoras novas e usadas

This paper aims to determine the importance of emitter ́s local head loss in the hydraulic design of hose drip lines, as well as comparing the result of equations that calculate the local head loss; besides verifying the influence of iron precipitated at the hose head loss made in Brazil. The result found that localized head loss represents 23% of the total head loss; the equations showed significant results and the total head loss increased in an average of 20% after the irrigation system was used with water rich in iron.

Níveis de fertirrigação na avaliação das características morfofisiológicas em mudas de pimenta malagueta

O presente trabalho teve o objetivo de avaliar as características morfofisiológicas de mudas de pimenta malagueta (Capsicum frutescens) sob diferentes níveis de fertirrigação, utilizando-se fertilizante líquido 10-10-10 (N-P-K). O experimento foi realizado na Faculdade de Ciências Agrárias da Universidade Federal da Grande Dourados. O delineamento experimental foi em blocos casualizados (DBC), com seis doses de fertilizante líquido (0; 2,5; 5,0; 10,0; 20,0 e 40 mL L-1) diluídos na água de irrigação e quatro repetições. As mudas foram produzidas em viveiro telado, em bandejas de 128 células preenchidas com substrato. Realizou-se uma fertirrigação, aos 15 dias após a semeadura ( DAS). Avaliou-se, aos 30 dias após a semeadura, o número de folhas, o comprimento da parte aérea e da raiz, a massa fresca e seca da parte aérea e da raiz, a área foliar e o teor de clorofila. A dose de 25 mL L-1 do fertilizante líquido 10-10-10, aplicada via fertirrigação, é recomendada para a produção de mudas de pimenta malagueta, embora tenha havido aumento da massa seca de raízes e parte aérea em dose maior.

Networked control system for the guidance of a four-wheel steering agricultural robotic platform

A current trend in the agricultural area is the development of mobile robots and autonomous vehicles for precision agriculture (PA). One of the major challenges in the design of these robots is the development of the electronic architecture for the control of the devices. In a joint project among research institutions and a private company in Brazil a multifunctional robotic platform for information acquisition in PA is being designed. This platform has as main characteristics four-wheel propulsion and independent steering, adjustable width, span of 1,80m in height, diesel engine, hydraulic system, and a CAN-based networked control system (NCS). This paper presents a NCS solution for the platform guidance by the four-wheel hydraulic steering distributed control. The control strategy, centered on the robot manipulators control theory, is based on the difference between the desired and actual position and considering the angular speed of the wheels. The results demonstrate that the NCS was simple and efficient, providing suitable steering performance for the platform guidance. Even though the simplicity of the NCS solution developed, it also overcame some verified control challenges in the robot guidance system design such as the hydraulic system delay, nonlinearities in the steering actuators, and inertia in the steering system due the friction of different terrains. Copyright © 2012 Eduardo Pacincia Godoy et al.

Uso de Dois Espaçamentos Entre Gotejadores na Mesma Linha Lateral e Seus Efeitos Sobre a Formação do Bulbo Molhado no Solo e Parâmetros Físicos de Rabanete

The use of irrigation systems that consume lower water and energy in agriculture is important to supply the growing global demand for food. In this way, it's important to develop techniques that will increase the uniformity of water application on drip irrigation systems. The aim of the work was to compare the provision of lateral lines in drip irrigation, through the formation of wet bulbs in soil and physical parameters of radish, composed of single spacing between drippers in relation to lateral lines composed of two segments, each one composed by different spacing between emitters. Two distributions of evaluation were carried out: 1) conventional drip lateral lines with 20 cm emitter spacing were compared to proposed drip lines, with 24 emitter spacing in the initial section and 20 cm emitter spacing in the final section; 2) conventional drip lateral lines with 30 cm emitter spacing were compared to proposed drip lines, with 36 emitter spacing in the initial section and 30 cm emitter spacing in the final section. The experiment was carried out in a greenhouse of the Sao Manuel Experimental Farm, located at Sao Manuel, SP. The experimental design was entirely randomized, with six treatments and four replications. Results showed no difference among treatments for the most of the evaluated variables. So it is possible to conclude that the use of different spacing between emitters in the same lateral line can be used to increase the line length.

Model to increase the lateral line length of drip irrigation systems

Non-pressure compensating drip hose is widely used for irrigation of vegetables and orchards. One limitation is that the lateral line length must be short to maintain uniformity due to head loss and slope. Any procedure to increase the length is appropriate because it represents low initial cost of the irrigation system. The hypothesis of this research is that it is possible to increase the lateral line length combining two points: using a larger spacing between emitters at the beginning of the lateral line and a smaller one after a certain distance; and allowing a higher pressure variation along the lateral line under an acceptable value of distribution uniformity. To evaluate this hypothesis, a nonlinear programming model (NLP) was developed. The input data are: diameter, roughness coefficient, pressure variation, emitter operational pressure, relationship between emitter discharge and pressure. The output data are: line length, discharge and length of the each section with different spacing between drippers, total discharge in the lateral line, multiple outlet adjustment coefficient, head losses, localized head loss, pressure variation, number of emitters, spacing between emitters, discharge in each emitter, and discharge per linear meter. The mathematical model developed was compared with the lateral line length obtained with the algebraic solution generated by the Darcy-Weisbach equation. The NLP model showed the best results since it generated the greater gain in the lateral line length, maintaining the uniformity and the flow variation under acceptable standards. It had also the lower flow variation, so its adoption is feasible and recommended.

Manejo da Irrigação Para Otimização da Produtividade E Qualidade de Frutos de Tomateiro em Sistema de Plantio Direto

There is much information on the adequate soil water matrix potential for returning irrigation in conventional soil tillage systems; however there is not enough information on the best soil water matrix potential for no-tillage production systems. This work aimed to study the effect of five irrigation levels on yield, soluble solids, and fruit acidity of the Hypeel tomato, cultivated for industrial processing and cropped on no-tillage system in Yellow Latosol. The experiment was carried out on a randomized block design with five treatments and four replications. The treatments consisted in different soil water matrix potentials for returning irrigation (m at 13cm of soil depth): -15, -30, -45, -60 and -75 kPa. The results obtained showed that the soil water matrix potential of -28.5 kPa resulted in maximum yields for tomato crop; whereas the value of -50.8 kPa resulted in the maximum fruit soluble solids concentration.

Análise das tensões de água no solo cultivado com morangueiro sob poda

Strawberry yield and quality was evaluated after drastic pruning (second cycle), under different soil water tensions, drip irrigation. The experiment was conducted on beds at a greenhouse, located at Engineering Department, Federal University of Lavras (UFLA), from April to December of 2010. An experimental design was in randomized blocks with three replicates. The treatments were composed of six different soil water tension, 15, 25, 35, 45, 55 e 70 kPa. Results obtained allowed to verify that to higher values of: total and commercial fresh weight of fruits per plant, total and commercial number fruits per plant and total and commercial yield, it is necessary to irrigate when soil water tension gets approximately to 15 kPa, at 0.15 m deep. Commercial average fruit mass and noncommercial fresh weight of fruits per plant, were not reduced under different soil water tensions applied.

Produção de videira 'Superior Seedless', cultivadas em diferentes tensões de água no solo

The aim of this study was to evaluate the total number of clusters per plant and the sugar concentration of Superior Seedless grapevine branches under different soil water tensions conditions. The statistical design was a randomized block with 4 treatments (a) control, b) 70 kPa tension, c) 50 kPa tension, d) 30 kPa tension, and 6 replications, each plot consisting of two plants. Soil moisture curves were plotted in laboratory and field conditions, potential bud fertility (carried out with the help of a 30x magnifier glass and collecting 17 branches in the primary arm of the plant with 15 buds each), actual fertility (given by the fertile buds to sprouted buds per plant ratio) and total sugars. Laboratory conditions helped stress to reach a -70 kPa level in just 21 days during the procedure to determine the retention curve in the laboratory. The different stress levels applied to the soil did not cause significant differences in the total number of clusters per plant. However, a -30 kPa stress showed a 68% reduction in water depth when compared to control and different soil water stress affected the carbohydrate percentage in branches of the Superior Seedless vine.

Efeitos fisiológicos da piraclostrobina em plantas de feijão (Phaseolus vulgaris L.) condicionado sob diferentes tensões de água no solo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Amostragem de folhas em cafeeiro para fins de diagnose do estado nutricional

Pós-graduação em Agronomia (Ciência do Solo) - FCAV

Design instrucional: uma abordagem do design gráfico para o desenvolvimento de ferramentas de suporte à Educação a Distância

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)