Structural characterization of the cell wall D-glucans isolated from the mycelium of Botryosphaeria rhodina MAMB-05

Three D-glucans were isolated from the mycelium of the fungus Botryosphaeria rhodina MAMB-05 by sequential extraction with hot-water and hot aqueous KOH (2% w/v) followed by ethanol precipitation. Following their purification by gel permeation chrornatography on Sepharose CL-4B, the structural characteristics of the D-glucans were determined by FT-IR and C-13 NMR spectroscopy and, after methylation, by GC-MS. The hot-water extract produced a fraction designated Q(1A) that was a beta-(1 -> 6)-D-glucan with the following structure:[GRAPHICS]The alkaline extract, when subjected to repeated freeze-thawing, yielded two fractions: KIP (insoluble) that comprised a beta-(1 -> 3)-D-glucan with beta-D-glucose branches at C-6 with the structure:[GRAPHICS]and K1SA (soluble) consisting of a backbone chain of alpha-(1 -> 4)-linked D-glucopyranosyl residues substituted at O-6 with alpha-D-glucopyranosyl residues:[GRAPHICS](c) 2008 Elsevier Ltd. All rights reserved.

Cinética da remoção dos extrativos da madeira de Eucalyptus grandis durante polpação Kraft

Kinetics of the removal of Eucalyptus grandis wood extractives during Kraft pulping. The objective of this work was to study the kinetics of the removal of Eucalyptus grandis wood extractives during Kraft pulping. The pulping was done in steel tubular reactors using wood saw under the following conditions: active alkali = 14%, sulfidity = 25%; liquor-to-wood ratio = 10 L kg(-1) of dry wood; and temperatures of 130, 150, 160 and 180 C during 30, 60, 90, 120, 150 and 180 minutes. After pulping, analyses were conducted of the yield and extractives in residue (pulp and reject). Total extractives (ethyl alcohol-toluene (1:2), ethyl alcohol and hot water, respectively) and soluble extractives in acetone were analyzed. The results showed that most extractives are degraded in the first 30 minutes of the pulping process. It was observed that the removal occurs in two different stages: the first is rapid, where the majority of the extractives are removed, and the last is slow, where few extractives are removed.

Avaliação energética de um sistema de refrigeração por absorção utilizando gás de aterro e gás natural

The current technological development made by the absorption refrigeration system is an economic and ambient alternative in comparison to the vapor cycle, possessing an advantage that uses thermal energy that is less noble. Chillers of absorption are used widely in the air conditioned industries, because they can be set in motion through hot water vapors that burn natural gas, solar energy, biomasses amongst others instead of electricity. These systems allow it to reduce the tips of electric demand and balance the rocking of energy demand. This work has had a main objective to simulate a absorption refrigeration cycle with lithium-water bromide solution using biogas of sanitary landfill, and mixtures of this with natural gas. These results shown to the energy viability of the system burning biogas and its mixtures with natural gas in the generator, when compared with equipments that uses traditional fuels (natural gas, oil diesel, amongst others), for operation the commercial chillers with 15 kW of the refrigeration capacity and temperature of the water in the entrance of 14°C and the exit of 7°C.

Postharvest characteristics and treatments to overcome latex exuded from cut flowers of lotus

Lotus (Nelumbo nucifera Gaertn.) is a perennial herbaceous aquatic ornamental plant with potential to be used as a new cut flower for the Brazilian ornamental market. It shows exotic and attractive flowers and has a strong market appeal, once it is known as a symbol of purity, holiness and immortality. However, flowers have a short-vase life. Lotus flower stem exudes a large quantity of sticky milky sap from the cut surface, which is produced in laticifers, spatially associated with both xylem and phloem. It has been reported that latex coagulates on the cut surface preventing or reducing water absorption and reducing flowers' vaselife, requiring treatments to stop the flow of latex. The objective of this study was to report observations of lotus postharvest characteristics and evaluate treatments to overcome latex flow. The experiment was conducted as a complete randomized design with three replications of four stems in each vase and eight treatments; a control (distilled water), pretreatment of cut stem-ends with hot water (40° C/1 minute), boiling water (3 seconds), isopropyl alcohol 90% (10 minutes) or citric acid (pH = 2.8/1h) and, maintenance of stems in a holding solution of Tween® 20 (0.01%), citric acid (200 mg L-1) or Tween® 20 (0.01%) plus citric acid (200 mg L-1). Treatments had no significant effect on flowers vaselife which was only about three days, although isopropyl alcohol, hot and boiling water completely stopped latex flow. Cut stem-ends pretreated with citric acid (pH = 2.8/1 h) showed a significantly higher relative water content of petals compared to others treatments. The senescence symptom of lotus cut flowers was mainly characterized by abscission of turgid petals and dehiscence of stamens without any visual change of petal color and brightness.

Coeficiente de operación de un sistema formado por un refrigerador doméstico acoplado a un acumulador de agua caliente para la recuperación de energía

An experimental apparatus containing a domestic refrigerator coupled to a vertical hot water storage tank was used for energy recovery. The original condenser of the refrigerator was maintained, but modified with a concentric tubes heat exchanger with countercurrent water and refrigerating gas flows. The coefficient of performance for the heat pump is calculated by the ratio of energy in the heat storage and the electric power consumed by the domestic refrigerator compressor. The results show that the increasing of hydrostatic pressure in the storage tank increases the water flow rate and the coefficient of performance. The proposed device also reduces the heat dissipation to the surroundings. This is more important in small confinements found in low-cost houses.

From coffee industry waste materials to skin-friendly products with improved skin fat levels

Spent coffee grounds (SCG), which are the residue obtained from the treatment of coffee with hot water or steam, can be used for industrial applications, due to the high content in lipids. The cosmetic products might be a suitable application for these types of residues because the barrier properties of the stratum corneum (SC) are largely dependent on the intactness of the lipid lamellae that surrounds the corneocytes. The purpose of this work was to assess the feasibility of using the lipid fraction of SCG extracted with supercritical carbon dioxide in the development of new cosmetic formulations with improved skin lipids (sebum) and hydration. The use of spent coffee lipid extract in cosmetic industry seems to be a suitable approach to recycle the wastes from coffee industry. Emulsion containing 10% of the lipid fraction of SCG (SpentCofOil cream) presented promising characteristics in the improvement of sebum skin levels with a good acceptance by consumers when compared to an emulsion containing 10% w/w of green coffee oil (GreenCofOil cream) and a placebo without coffee oil (NoCofOil cream). Practical applications: In this work, the authors develop and characterize a cream containing 10% of the lipid fraction of SCG extracted with supercritical carbon dioxide with improved skin lipids (sebum) and hydration. © 2013 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.

Avaliação da disponibilidade de boro em um latossolo de Mato Grosso/MT

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Extratores para nitrogênio disponível do solo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Produção de enzimas celulolíticas pelos fungos thermoascus aurantiacus CBMAI 756, thermomyces lanuginosus, Trichoderma reesei QM9414 e Penicillium viridicatum RFC3 e aplicação na sacarificação do bagaço de cana de açucar com diferentes pré-tratamentos

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Avaliação do tempo e métodos de aquecimento de toras de Eucalyptus grandis Hill ex-Maiden e sua influência no rendimento em laminação e na qualidade das lâminas

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Estudo da viabilidade técnica e econômica para aproveitamento de cascas de eucalyptus gerados no processo de fabricação de painéis de madeira

Pós-graduação em Agronomia (Energia na Agricultura) - FCA

Análise de coletores solares com armazenadores integrados baseado na geometria cubóide utilizando CFD

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Levantamento de coeficientes de desempenho de armazenador térmico associado a refrigerador doméstico modificado

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Análise numérica da convecção natural em dispositivos solar integrados coletor-tanque

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Atividade antioxidante, compostos fenólicos totais e cor em abacate ‘hass’ submetido a diferentes tratamentos físicos

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)