Influence of ankle functional instability on the ankle electromyography during landing after volleyball blocking

The purpose of this study was to describe, interpret and compare the EMG activation patterns of ankle muscles - tibialis anterior (TA), peroneus longus (PL) and gastrocnemius lateralis (GL) - in volleyball players with and without ankle functional instability (FI) during landing after the blocking movement. Twenty-one players with FI (IG) and 19 controls (CG) were studied. The cycle of movement analyzed was the time period between 200 ms before and 200 ms after the time of impact determined by ground reaction forces. The variables were analyzed for two different phases: pre-landing (200 ms before impact) and post-landing (200 ms after impact). The RMS values and the timing of onset activity were calculated for the three studied muscles, in both periods and for both groups. The co-activation index for TA and PL, TA and GL were also calculated. Individuals with FI presented a lower RMS value pre-landing for PL (CG = 43.0 perpendicular to 22.0; IG = 26.2 perpendicular to 8.4, p < 0.05) and higher RMS value post-landing (CG = 47.5 perpendicular to 13.3; IG = 55.8 perpendicular to 21.6, p < 0.10). Besides that, in control group PL and GL activated first and simultaneously, and TA presented a later activation, while in subjects with FI all the three muscles activated simultaneously. There were no significant differences between groups for co-activation index. Thus, the rate of contraction between agonist and antagonist muscles is similar for subjects with and without FI but the activation individually was different. Volleyball players with functional instability of the ankle showed altered patterns of the muscles that play an important role in the stabilization of the foot-ankle complex during the performance of the blocking movement, to the detriment of the ligament complex, and this fact could explain the usual complaints in these subjects. (C) 2007 Elsevier Ltd. All rights reserved.

Hydrothermal surface-wave instability and the Kuramoto-Sivashinsky equation

We consider a system formed by an infinite viscous liquid layer with a constant horizontal temperature gradient and a basic nonlinear bulk velocity profile. In the limit of long wavelength and large nondimensional surface tension we show that hydrothermal surface-wave instabilities may give rise to disturbances governed by the Kuramoto-Sivashinsky equation. A possible connection to hot-wire experiments is also discussed. © 1994.

Modulational instability analysis of surface-waves in the Bénard-Marangoni phenomenon

By using the long-wave approximation, a system of coupled evolutions equations for the bulk velocity and the surface perturbations of a Bénard-Marangoni system is obtained. It includes nonlinearity, dispersion and dissipation, and it is interpreted as a dissipative generalization of the usual Boussinesq system of equations. Then, by considering that the Marangoni number is near the critical value M = -12, we show that the modulation of the Boussinesq waves is described by a perturbed Nonlinear Schrödinger Equation, and we study the conditions under which a Benjamin-Feir instability could eventually set in. The results give sufficient conditions for stability, but are inconclusive about the existence or not of a Benjamin-Feir instability in the long-wave limit. © 1995.

Thermally activated dynamics of the tilts of the CuO6 octahedra, hopping of interstitial O, and possible instability towards the LTT phase in La2CuO4+δ

The anelastic spectrum (dynamic Young's modulus and elastic energy absorption) of La2CuO4+δ has been measured between 1 and 700 K with 0<δ<0.02. The spectrum of stoichiometric La2CuO4 in the low-temperature orthorhombic (LTO) phase is dominated by two intense relaxation processes which cause softenings of 16% around 150 K and 9% below 30 K at f∼1 kHz. The relaxation at 150 K is attributed to the presence of a fraction of the CuO6 octahedra which are able to change their tilted configuration by thermal activation between orientations which are nearly energetically equivalent, possibly within the twin boundaries. The relaxation below 30 K is governed by tunneling, and involves a considerable fraction of the lattice atoms. It is proposed that the double-well potentials for the low-temperature relaxation are created by the tendency of the LTO phase to form low-temperature tetragonal (LTT) domains, which however are not stabilized like when La is partially substituted with Ba. On doping with excess O, the relaxation rates of these processes are initially enhanced by hole doping, while their intensities are depressed by lattice disorder; an explanation of this behavior is provided. Excess O also causes two additional relaxation processes. The one appearing at lower values of δ is attributed to the hopping of single interstitial O2- ions, with a hopping rate equal to τ-1=2×10-14exp(-5600/T) s. The second process is slower and can be due to O pairs or other complexes containing excess O.

Níveis críticos de fósforo no solo e nas folhas para a implantação de Eucalyptus grandis Hill ex Maiden, em quatro tipos de solos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Envelhecimento acelerado em sementes de Eucalyptus grandis Hill ex Maiden classificadas por tamanho

Two experiments of seed ageing of Eucalyptus grandis Hill ex Maiden were carried out at laboratory conditions. In the first experiment, two seed lots were classified in two square mesh screens (< 0.84 to ≥ 0.71 mm and < 0.71 mm to ≥ 0.59 mm), submitted to 42 °C and 100% relative humidity, for 0, 8, 12, 24, and 32 hours of stress treatments. Seed germination tests were done with just aged seeds. The results showed that the stress period was not sufficient for ageing the seeds. In the second experiment, the best quality seed lot was separated in the same two sizes. The seeds were submitted under the same stress conditions of the first experiment but for 0, 48, 72, and 96 hours. The germination test was done right after the seeds were taken from the stress conditions, and with stored seeds at dry chamber (2 weeks and 26 months). It was concluded that both seed sizes reached 30% of moisture content under 72 hours of ageing conditions and showed significant germination losses when compared with seeds without ageing (control), as the moist seeds as the stored ones at dry chamber, for both 2 weeks and 26 months.

Efeito da densidade de plantas de Bracharia decumbens Stapf sobre o crescimento inicial de mudas de Eucalyptus grandis W. Hill ex Maiden

In order to verify the effect of Brachiaria decumbens plant density on the initial growth of Eucalyptus grandis plants, one assay was conducted under semi-controlled conditions of soil fertility and humidity. Dark red Latossol, collected from the arable layer, was used as substrate in 50 liters amianthus cement boxes. One seedling of Eucalyptus was planted in each box. Fifteen days later, seedlings of B. decumbens were transplanted on the same box. The treatments consisted of 0, 4, 8, 12, 16, 20, 24, 28, 32, 36, 40, 60, 80, 100, and 120 plants of B. decumbens. The experimental design was the complete randomized design, with 15 treatments and four replicates. The Eucalyptus plants that lived with B. decumbens were evaluated for stem diameter, plant high, leaf area, and dry weight of stem, branches and leaves. B. decumbens plants were evaluated for dry weight of aerial parts. B. decumbens, at the density level of four plants per m 2 and over, reduced of the initial growth of the Eucalyptus plants. B. decumbens reduced on average 27.78% stem diameter, 18.47% plant high, 70.56% leaf number, 63.26% leaf area, and 55.22%, 77.29% and 55.30% of stem, branch and leaf dry weight, respectively. Plant high was not a good parameter to evaluate the B. decumbens interference.

Efeito da densidade de plantas de Panicum maximum Jacq. sobre o crescimento inicial de Eucalyptus grandis W.Hill ex Maiden

In order to verify the effect of Panicum maximum plant density on the initial growth of Eucalyptus grandis plants, one assay was conducted under semi-controlled conditions of soil fertility and humidity. Dark red Latossol, collected from the arable layer, was used as substrate in 50 liters amianthus cement boxes. One seedling of Eucalyptus was planted in each box. Fifteen days later, seedlings of P. maximum were transplanted on the same box. The treatments consisted of 0, 4, 8, 12, 16 and 20 plants of P. maximum per m 2. The experimental design was the complete randomized design, with six treatments and eight replicates for P. maximum. One hundred and ten and 190 days after transplanting, Eucalyptus plants grown among P. maximum showed an average reduction of 30.80 and 46.55% stem diameter, 25.10 and 22.50 plant high, 40.18 and 31.29% stem dry weight, 61.32 and 54.06% branch dry weight, 53.72 and 51.82% root dry weight, 44.62 and 38.50% leaf dry weight, 22.51 and 23.16 branch number, 20.72 and 19.97% leaf number, and 33.88 and 17.05% leaf area, respectively.

Pharmacognostical evaluation of fruits of Solanum lycocarpum A. St.-Hill. (Solanaceae)

This study describes the chemical and physical-chemical profile of plant drug and ethanolic extract obtained from fruits of Solanum lycocarpum A. St.-Hill. (Solanaceae). The physical and chemical analysis involved the granulometry determination, non-compacted apparent density, loss on drying in oven and in infrared scale, pH, ash values and extractive values. The results determined the physical-chemical characteristics of the drug plant. It was also carried out the microbiological control of the plant drug. The preliminary phytochemical screening featured the presence of tannins, flavonoids and saponins in the plant drug and alkaloids and steroids in the ethanolic exctract. The solamargine and solasonine glycoalkaloids were identified through TLC and GC/ MS. The levels of total phenols and tannins were quantified in the extract (8.90% and 6,85% respectively). Such studies contribute to the chemical identification and quality control of S. lycocarpum fruits. © 2010 Phcog.net.

Estudo fitoquímico preliminar e bioensaio toxicológico frente a larvas de Artemia salina Leach. de extrato obtido de frutos de Solanum lycocarpum A. St.-Hill (Solanaceae)

The phytochemical profile of ethanolic extract of Solanum lycocarpum fruits was analyzed and preliminary toxicity tests were performed against brine shrimp larvae. The extract was subjected to preliminary phytochemical analysis to identify the main classes of secondary metabolites and tested against the larvae of A. salina to obtain the median lethal concentrations (LC50%). The phytochemical tests showed the presence of phenols, tannins, saponins, alkaloids and free steroids. The extract was fractionated with various solvents for toxicity testing against the larvae and the hydroalcoholic fraction showed considerable cytotoxicity (CL50% = 285.546 g/mL).

Qualidade fisiológica de sementes de diferentes árvores matrizes de Corymbia citriodora (Hook.) K.D.Hill & L.A.S. Johnson

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Heritability for resistance to Puccinia psidii Winter rust in Eucalyptus grandis Hill ex Maiden in Southwestern Brazil

The climates of the central and southern regions of São Paulo state in Brazil favor pathogens such as Puccinia psidii Winter, which causes a common and severe disease in Eucalyptus plantations under 2 years old. We studied genetic parameters including genotype by environment interaction (G × E) of resistance to P. psidii rust in Eucalyptus grandis at nine sites in São Paulo State. Open-pollinated progeny from ten 'provenances' were established in a randomized complete block design; at individual sites there were from 134 to 160 progenies, from four to eight blocks, and five to six trees per plot. Significant provenance and progeny(provenance) differences were detected, as was G × E involving progeny(provenance). However, the G × E involved little if any rank changes, indicating that selection can be done efficiently at a single site, if the disease level is sufficient. The estimated coefficient of genetic variation among the progeny within provenances CVg was high and variable among the sites (ranging from 11 % to 36. 7 %), demonstrating different expression of genetic variability among the sites. The estimated heritability at the individual-tree level h2 and within a plot hw 2 ranged from low to intermediate (ranging from 0. 04 to 0. 46) and was high at the progeny-mean level hf 2 (ranging from 0. 30 to 0. 86). Our study shows good prospects of controlling this disease by selection among and within progenies in a single site. © 2012 Springer-Verlag Berlin Heidelberg.

Ferroelectric and structural instability of (Pb,Ca)TiO3 thin films prepared in an oxygen atmosphere and deposited on LSCO thin films which act as a buffer layer

Structural, microstructural and ferroelectric properties of Pb0.90Ca0.10TiO3 (PCT10) thin films deposited using La0.50Sr0.50CoO3 (LSCO) thin films which serve only as a buffer layer were compared with properties of the thin films grown using a platinum-coated silicon substrate. LSCO and PCT10 thin films were grown using the chemical solution deposition method and heat-treated in an oxygen atmosphere at 700 °C and 650 °C in a tube oven, respectively. X-ray diffraction (XRD) and Raman spectroscopy results showed that PCT10 thin films deposited directly on a platinum-coated silicon substrate exhibit a strong tetragonal character while thin films with the LSCO buffer layer displayed a smaller tetragonal character. Surface morphology observations by atomic force microscopy (AFM) revealed that PCT10 thin films with a LSCO buffer layer had a smoother surface and smaller grain size compared with thin films grown on a platinum-coated silicon substrate. Additionally, the capacitance versus voltage curves and hysteresis loop measurement indicated that the degree of polarization decreased for PCT10 thin films on a LSCO buffer layer compared with PCT10 thin films deposited directly on a platinum-coated silicon substrate. This phenomenon can be described as the smaller shift off-center of Ti atoms along the c-direction 〈001〉 inside the TiO6 octahedron unit due to the reduction of lattice parameters. Remnant polarization (P r ) values are about 30 μC/cm2 and 12 μC/cm2 for PCT10/Pt and PCT10/LSCO thin films, respectively. Results showed that the LSCO buffer layer strongly influenced the structural, microstructural and ferroelectric properties of PCT10 thin films. © 2013 Elsevier Ltd and Techna Group S.r.l.

Expressão de genes em sementes de lobeira (Solanum Lycocarpum St Hill) submetidas ao condicionamento fisiológico

Pós-graduação em Agronomia (Agricultura) - FCA