Rapid determination of zinc in foods by flow injection analysis with flame AAS using gradient calibration method

A calibration method was developed using flow injection analysis (FI) with a Gradient Calibration Method (GCM). The method allows the rapid determination of zinc In foods (approximately 30 min) after treatment with concentrated sulphuric acid and 30% hydrogen peroxide, and analysis with flame atomic absorption spectrometry (FAAS). The method provides analytical results with a relative standard deviation of about 2% and requires less time than by conventional FI calibration. The electronic selection of different segments along the gradient and monitoring of the technique covers wide concentration ranges while maintaining the inherent high precision of flow injection analysis. Concentrations, flow rates, and flow times of the reagents were optimized in order to obtain best accuracy and precision. Flow rates of 10 mL/min were selected for zinc. In addition, the system enables electronic dilution and calibration where a multipoint curve can be constructed using a single sample injection.

2,3,4,6-Tetra-O-(3-nitropropanoyl)-O-β-D-glucopyranoside, a new antimicrobial from the roots of Heteropteris aphrodisiaca

A new 2,3,4,6-tetra-O-(3-nitropropanoyl)-O-β-D-glucopyranoside anomer was isolated from the roots of Heteropteris aphrodisiaca and characterized by spectroscopic methods. Activity against Staphylococcus aureus, Bacillus subtilis, Candida albicans, C. parapsilosis, C. krusei, and C. tropicalis was demonstrated.

The influence of the flame structure on the combustion oscillations in a cylindrical chamber

An experimental study has been conducted with the objective of investigating the effects of the flame structure in the combustion oscillation conditions into a laboratorial scale cylindrical chamber. The experiments were conducted in a water-jacketed 1-m long by 25-cm internal diameter stainless steel vertical tube. The combustor operated with liquefied petroleum gas (LPG) in both oscillatory and non oscillatory conditions, under the same input conditions. Part of the reactant mixture was excited acoustically, before the burner exit, by a speaker positioned strategically. The burner was aligned with the chamber longitudinal axis and positioned at its bottom. The experiments were conducted for 0.16 g/s of LPG burning in stoichiometric equivalence ratio. To analyze the flame structure the image tomographic reconstruction process were used, and the resultant images were associated to the oscillatory conditions (frequency and amplitude) into the combustion chamber. The main conclusions were: 1) when the flame premixed condition increase, for example 60% of the total air flow rate is premixed with LPG, the region of intense energy released is close to burner exit and strong amplitudes of oscillation (close to 50 mbar) were obtained into the chamber; 2) for long flames, predominantly diffusive flames, just weak amplitudes were detected, in the spite of the speaker exiting the premixed flow; 3) when the energy is released distributed through the combustion chamber, the long flame acts like a baffle. Copyright © 2006 by the American Institute of Aeronautics and Astronautics, Inc. All rights reserved.

Determination of calcium and magnesium in hydroethanolic extracts of propolis by atomic absorption flame spectrophotometry

Propolis is a natural product collected by honeybees and has a large range of pharmacological activity, including antimicrobial, antitumoral, antioxidant and anti-inflammatory. Its use as a popular medicine is increasing all over the world, creating a need for quality control of the commercial products. In this study the levels of calcium and magnesium in commercial hydroalcoholic propolis extracts from varies states of Brazil were determined by atomic absorption flame spectrophotometry and different values were obtained for northern and southern states. This study can be extended to the analysis of metals that are harmful to health. The results showed that the calibration curves were linear over a wide concentration range (0.5-4.0 μg.mL -1 for calcium and 0.05-0.4 μg.mL -1 for magnesium) with good correlation coefficients (0.999 and 0.988, respectively). Good analytical recovery (94%) was obtained. The proposed method showed adequate precision and relative standard deviation lower than 2 %. The method is accurate and precise as well as having advantages such as simplicity and speed.

Determination of copper at wide range concentrations using instrumental features of high-resolution continuum source flame atomic absorption spectrometry

This work describes a method to determine Cu at wide range concentrations in a single run without need of further dilutions employing high-resolution continuum source flame atomic absorption spectrometry. Different atomic lines for Cu at 324. 754 nm, 327. 396 nm, 222. 570 nm, 249. 215 nm and 224. 426 nm were evaluated and main figures of merit established. Absorbance measurements at 324. 754 nm, 249. 215 nm and 224. 426 nm allows the determination of Cu in the 0. 07-5. 0 mg L -1, 5. 0-100 mg L -1 and 100-800 mg L -1 concentration intervals respectively with linear correlation coefficients better than 0. 998. Limits of detection were 21 μg L -1, 310 μg L -1 and 1400 μg L -1 for 324. 754 nm, 249. 215 nm and 224. 426 nm, respectively and relative standard deviations (n = 12) were ≤ 2. 7%. The proposed method was applied to water samples spiked with Cu and the results were in agreement at a 95% of confidence level (paired t-test) with those obtained by line-source flame atomic absorption spectrometry.

Eficácia do tetra-test como ferramenta de gestão da qualidade do leite cru refrigerado

The effectiveness of a new management tool for screening refrigerated raw milk quality in a dairy industry is provided. Three hundred and seventy-four samples of raw milk from individual producers and 125 samples from bulk milk carriers from the same producers were analyzed. Producers' samples underwent a fast tube reduction test, or Tetra-Test, to estimate total bacteriological charge and their predominant microbiota. Bulk milk samples underwent standard plate count (SPC) as reference method. Tetra-test was effective in screening and assessing the microbiological quality of refrigerated raw milk, since 82.4% of samples with more than 106UFC/mL were readily detected (5 minutes to 2h). The test may be employed as a management tool either in screening or in interventions on the detected problem. In fact, its results provided complementary information on the characteristics of dominant microbiota. Most samples failed in compliance to IN 51 requirements. Further, 211 samples (56.4%) showed high microbial charge and, consequently, poor quality raw milk. Psychrotrophic groups were not yet the main degrading factors of cooled raw milk, albeit present in 76.8% of samples.

Sequential Determination of Cd, Cu and Pb in Tea Leaves by Slurry Introduction to Thermospray Flame Furnace Atomic Absorption Spectrometry

A simple procedure for the sequential determination of Cd, Cu and Pb in tea leaves by slurry introduction to thermospray flame furnace atomic absorption spectrometry was developed. Detection limits were 0.05 mg kg-1 for Cd, 2.1 mg kg-1 for Cu and 0.68 mg kg-1 for Pb using 0.67 % (m/v) slurries (100 mg/15 mL). © 2013 Springer Science+Business Media New York.

Evaluation of lines of boron, phosphorus and sulfur by high-resolution continuum source flame atomic absorption spectrometry for plant analysis

The wavelength-integrated absorbance (WIA) and summation of absorbance (∑ lines) of different lines were evaluated to enhance sensitivity and determine B, P and S in medicinal plants by HR-CS FAAS. The lowest LOD for B (0.5mgL-1) and P (13.7mgL-1) was obtained by integration of lines 249.773nm (3pixels) and 247.620nm (5pixels), respectively. The ∑ lines for CS at 257.595nm and 257.958nm furnished LOD=30.5mgL-1, ca. 10% lower than the LOD obtained for the WIA using 257.595nm and 5pixels. Data showed the advantage of WIA over ∑ lines to improve sensitivity for all analytes. Under optimized conditions, calibration curves in the 1.0-100mgL-1 B and 50.0-2000mgL-1 P, S ranges were consistently obtained. Results obtained with the HR-CS FAAS method were in agreement at 98% and 95% confidence level with certified values for B and P, respectively. And results for S were in accordance to non-certified values. Concentrations of B, P, and S in 12 medicinal plants analyzed by the proposed method varied within the 19.4-34.5mgkg-1 B, 719-3910mgkg-1 P and 1469-7653mgkg-1 S ranges. © 2012 Elsevier B.V.

Avaliação da eficacia do tetra-test como ferramenta de gestão da qualidade do leite cru refrigerado

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Morfologia testicular e estrutura da espermatogênese em peixes ornamentais Tetra Negro, Gymnocorymbus ternetzi; Tetra Amarelo, Hyphessobrycon bifasciatus e Mato Grosso, Hyphessobrycon eques (Teleostei, Characiformes)

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Cross linked Poly (4-Vinylpyridine-Ethylene Glycol Dimethacrylate) Used for Preconcentration of Cd(II) and its Determination by Flow Injection Flame Atomic Absorption Spectrometry

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Flame retardant properties of the bark powder of Anadenanthera peregrina var. falcata (Benth.) Altschul (angico) studied by coupled thermogravimetry-Fourier transform infrared spectroscopy

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Síntese de tetra-hidropiridinas por meio de reações multicomponentes

Multicomponent Reactions are defined as reactions between three or more reagents in a single reaction step in the same reaction vial, forming a product that includes the majority of atoms and structural characteristics of the reagents. Thus these reactions save time and energy. One of the ways to improve the yield and reaction time of a multicomponent reaction is to use different catalysts, an example of catalyst that shows great potential and has been studied in recent years is the molecular iodine is known to be a Lewis acid with high catalytic power. The functionalized piperidines, also known as tetrahydropyridines, are alkaloids that have pharmacological potential, this is due to the piperidine ring present in many natural product structures with muscarinic activity, nicotine, analgesic, antipsychotic, anti-proliferative, among others. In this paper we describe studies about on the application of molecular iodine (I2) in the multicomponent reaction between aniline derivatives, benzaldehyde and β-ketoester (methyl acetoacetate) for the synthesis of functionalized piperidines and the synthesis of a corresponding piperidone by acid hydrolysis. Data analysis allowed us to demonstrate the efficacy of molecular iodine in the synthesis of functionalized piperidines, obtaining results with yields 44-87% and short reaction time of 8 to 24 hours, and the efficacy of acid hydrolysis of enamine in the structure of the tetrahydropyridine derivative in a yield of 81%

The effects of temperature and busulfan (Myleran) on the yellowtail tetra Astyanax altiparanae (Pisces, Characiformes) spermatogenesis

We aimed to standardize a protocol to suppress spermatogenesis in the characiform fish, Astyanax altiparanae, for future use as a host in germ cell transplant research, opening opportunities for a range of studies, such as spermatogenesis analyses and transgenesis because this species presents livestock characteristics to be used as a biological model. The effects of the chemotherapeutic busulfan (formulated as Myleran), which is used as medicine, therefore not as toxic to humans manipulation as analytical grade busulfan (Fluka) used in previous studies, were evaluated at physiological temperature of 28 °C, ideal for growth and reproduction of A altiparanae, and also at increased temperature 35 °C. The temperature groups were divided into three treatment groups: busulfan, DMSO only, and an untreated control. Macroscopic, histologic, stereological, and ultrastructure analysis showed that, at 28 °C, busulfan did not cause depletion of germ cells in A altiparanae. However, at 35 °C, sterilization was observed 3 weeks after the initial application. Similar results were obtained with maintenance of fish at 35 °C for a longer period with no accompanying Myleran treatment. This procedure allows reduction in stress and lower mortality resulting from manipulation during busulfan injection and is also suitable for mass treatment because large numbers of fish can be incubated in warm water.