Biomass production and secretion of hydrolytic enzymes are influenced by the structural complexity of the nitrogen source in Fusarium oxysporum and Aspergillus nidulans

The structural complexity of the nitrogen sources strongly affects biomass production and secretion of hydrolytic enzymes in filamentous fungi. Fusarium oxysporum and Aspergillus nidulans were grown in media containing glucose or starch, and supplemented with a nitrogen source varying from a single ammonium salt (ammonium sulfate) to free amino acids (casamino acids), peptides (peptone) and protein (gelatin). In glucose, when the initial pH was adjusted to 5.0, for both microorganisms, higher biomass production occurred upon supplementation with a nitrogen source in the peptide form (peptone and gelatin). With a close to neutrality pH, biomass accumulation was lower only in the presence of the ammonium salt. When grown in starch, biomass accumulation and secretion of hydrolytic enzymes (amylolytic and proteolytic) by Fusarium also depended on the nature of the nitrogen supplement and the pH. When the initial pH was adjusted to 5.0, higher growth and higher amylolytic activities were detected in the media supplemented with peptone, gelatin and casamino acids. However, at pH 7.0, higher biomass accumulation and higher amylolytic activities were observed upon supplementation with peptone or gelatin. Ammonium sulfate and casamino acids induced a lower production of biomass, and a different level of amylolytic enzyme secretion: high in ammonium sulfate and low in casamino acids. Secretion of proteolytic activity was always higher in the media supplemented with peptone and gelatin. Aspergillus, when grown in starch, was not as dependent as Fusarium on the nature of nitrogen source or the pH. The results described in this work indicate that the metabolism of fungi is regulated not only by pH, but also by the level of structural complexity of the nitrogen source in correlation to the carbon source.

Determination of soybean seed respiration rate by the titulation method

This trial was carried out under laboratory conditions, with three lots of Iguacu soybean seeds, to determine the respiration rate by the titulation method. A randomized complete block design was used, with four repetitions, each one of them with 50 seeds and a control without seeds for each lot. The seeds were placed in gerbox with 40 mi of KOH 0.1N, on distilled water wet blotting paper for fixing the CO2 produced by seeds respiration. The material was placed in germinator at constant 25 degrees C for 16, 24 and 48 hours. After these periods, the titulation of the fixative solution was performed with HCl 0.1N to check the respiration rate. The most deteriorated seeds were those that presented the highest respiration rates, which were measured in mg of CO2/g of dry matter, when compared with the most vigorous lots. The titulation method was suitable for the evaluation of soybean seed respiration rate because the final results separated the lots in three different quality levels that were compatible with the results obtained from the accelerated aging and emergence.

Neodymium biosorption from acidic solutions in batch system

Biosorption of neodymium in batch experiments took similar to 2 h to achieve the equilibrium biosorbent-metal for all microorganisms tested. The best biosorption coefficient at a constant pH value of 1.5 was obtained using the microalgae Monoraphidium sp. (1521 mg g(-1) cell), followed by Bakers' yeast (313 mg g(-1) cell), Penicillium sp. (178 mg g(-1) cell), and activated carbon (61 mg g(-1) cell). When compared to the biosorption of other metals, these results pointed out to the application of biosorption in neodymium recovery from acidic solutions. (C) 2000 Elsevier B.V. Ltd. All rights reserved.

Studies of the voltammetric behavior and determination of diazo reactive dyes at mercury electrode

The electrochemical reduction of two reactive dyes: Procion Red HE-3B 9 (RR120) and Procion Green HE-4BD (RG19) was investigated using cyclic voltammetry, differential pulse and DC, polarography, chronoamperometry and controlled potential electrolysis at mercury electrodes. The bis-azo groups of the RR120 dye are reduced together in one single step of four electrons, the bis-azo groups of the RG19 dye are reduced in two steps owing to the difference in the electron densities promoted by the different substituents in the benzene rings adjacent to the azo groups. The bis-monochlorotriazine reactive groups in both dyes are reduced only in acidic medium in their protonated form, leading to the reduction of the triazine groups. The reduction mechanism of both reactive dyes is discussed. Both dyes can be quantified in aqueous medium by differential pulse polarography in the concentration range of 1 x 10(-7) mol L-1 to 1 x 10(-5) mol L-1 by monitoring the reduction of the chromophore group or the reactive group.

Synthesis and properties of branched polyethylene/high-density polyethylene blends using a homogeneous binary catalyst system composed of early and late transition metal complexes

Branched polyethylene/high-density polyethylene blends (BPE/HDPE) with a wide range of molecular weights, melt flow indexes (MFI), and intrinsic viscosity were prepared using the homogeneous binary catalyst system composed by Ni(alpha-diimine)Cl-2 (1) (alpha-diimine = 1,4-bis(2,6-diisopropylphenyl)-acenaphthenediimine) and {Tp(Ms*)} TiCl3 (2) (Tp(Ms*)=hydridobis(3-mesitylpyrazol-1-yl)(5-mesityl-pyrazol-1-yl)) activated with MAO and/or TIBA in hexane at two different polymerization temperatures (30 and 55 degreesC) and by varying the nickel loading molar fraction (x(Ni)). At all Temperatures, a non-linear correlation between the x(Ni) and the productivity was observed, suggesting the occurrence of a synergistic effect between the nickel and the titanium catalyst precursors, which is more pronounced at 55 degreesC. The molecular weight of the BPE/HDPE blends considerably decreases with increasing Al/M molar ratio. The melt flow indexes (MFI) and intrinsic viscosities (eta) are strongly affected by x(Ni), but the melting temperatures are nearly constant, 132 +/- 3 degreesC. Dynamic mechanical thermal analysis (DMTA) shows the formation of different polymeric materials where the stiffness vanes according, to the x(Ni) and temperature used in the polymerization reaction. The surface morphology of the BPE/HDPE blends studied by scanning electron microscopy (SEM) revealed a low miscibility between the PE phases resulting in the formation of a sandwich structure after etching with o-xylene.

Combination of nickel and titanium complexes containing nitrogen ligands as catalyst for polyethylene reactor blending

Ethylene was polymerized using a combination of Ni(diimine)Cl-2 (1) (diimine = 1,4-bis(2,6-di-isopropylphenyl)-acenaphthenediimine) and {Tp(Ms)*} TiCl3 (2) (Tp(Ms)* = hydridobis(3-mesitylpyrazol-1-yl)(5-mesityl-pyrazol-1-yl)) compounds in the presence of methyl-aluminoxane (MAO) at 30 degrees C. The productivity reaches a maximum at X-Ni = 0.75 (1400 kg of PE/mol[M] . h), and the produced polyethylene (PE) showed maximal melt flow index (0.13 g/10 min) and minimal intrinsic viscosity (2.24 dL/g) compared to polyethylenes obtained with different values of nickel loading fractions (X-Ni). Productivity intrinsic viscosity data, as well as melt flow index measurements markedly depend upon the content of the late transition metal, thus suggesting a synergic effect between nickel and titanium catalysts.

A new method to control particle size and particle size distribution of SnO2 nanoparticles for gas sensor applications

The controlled growth of SnO2 nanoparticles for gas sensor applications is reported by these authors. Nb2O5 additive is used to control nucleation and growth of the SnO2 (see Figure), which is synthesized by the polymeric precursor method. Preliminary gas sensing measurements are performed and it is demonstrated that the response time of the Nb2O5-doped SnO2 is faster than that of the undoped material.

Effect of Supragingival plaque control in smokers and never-smokers: 6-month evaluation of patients with periodontitis

Background: the effect of supragingival plaque control on clinical signs of periodontitis is controversial, particularly when smoking habits are considered. This study evaluated the clinical effects of supragingival plaque control on clinical signs of periodontitis in smokers and never-smokers.Methods: the following data were collected for 25 never-smokers and 25 smokers at baseline and 30, 90, and 180 days: visible plaque index (VPI), gingival bleeding index (GBI), bleeding on probing (BOP), periodontal probing depth (PD), and clinical attachment loss (CAL). After baseline examinations, supragingival scaling was performed. Oral hygiene practices were reinforced and reevaluated weekly during the experimental period. Linear models adjusted for clustering of observations within individuals were used for statistical analysis.Results: Reductions in VPI were significant for both groups, with no intergroup differences. GBI at baseline was similar between groups, and at 30, 90, and 180 days, smokers had a lower GBI than never-smokers. Significant reductions were observed in PD for shallow (1 to 3 mm), moderate (4 to 5 mm), and deep sites (>= 6 mm) in both groups. CAL was significantly greater in smokers throughout the study, but gains in attachment were similar for both groups (0.71 to 1.00 mm). BOP reductions were similar in both groups.Conclusions: Supragingival plaque control resulted in significant changes in clinical parameters associated with gingivitis and periodontitis. Smoking did not affect results, regardless of initial PD.

Bootstrap confidence regions for canonical variates: Application to studies of evolutionary differentiation

Theory recently developed to construct confidence regions based on the parametric bootstrap is applied to add inferential information to graphical displays of sample centroids in canonical variate analysis. Problems of morphometric differentiation among subspecies and species are addressed using numerical resampling procedures.

The role of interleukin-10 in the differential expression of interleukin-12p70 and its beta 2 receptor on patients with active or treated paracoccidioidomycosis and healthy infected subjects

Paracoccidioidomycosis patients present an antigen-specific Th1 immunosuppression. To better understand this phenomenon, we evaluated the interleukin (IL)-12 pathway by measuring IL-12p70 production and CD3(+) T cell expression of the IL-12 receptor (IL-12R)beta1/beta2 chains, induced with the main fungus antigen (gp43) and a control antigen, from Candida albicans (CMA). We showed that gp43-induced IL-12p70 production and IL-12Rbeta2 expression were significantly decreased in acute and chronic patients as compared to healthy subjects cured from PCM or healthy infected subjects from endemic areas. Interestingly, the healthy infected Subjects had higher gp43-induced IL12p70 production and beta2 expression than the cured subjects. The addition of a neutralizing anti-IL-10 antibody to the cultures increased IL12p70 levels and beta2 expression in acute and chronic patients to levels observed in Cured subjects. Conversely, addition of the cytokine IL-10 strongly inhibited both parameters in the latter group. In conclusion, we have shown that paracoccidioidomycosis-related Th1 immunosuppression is associated with down-modulation of the IL-12 pathway, that IL-10 may participate in this process, and that patients cured from paracoccidioidomycosis may not fully recover their immune responsiveness. (C) 2004 Elsevier B.V. All rights reserved.

Paediatric rheumatology - A global perspective

This chapter aims to give a global perspective to paediatric rheumatology. The main points covered are the incidence, recognition of paediatric autoimmune diseases, and ethnic/geographic distribution. The most prevalent disease is juvenile idiopathic arthritis; robust data are still required for childhood-onset systemic lupus erythematosus, dermatomyositis, and scleroderma. Mimicking or overlapping infections are a major challenge in developing countries, and immunization policies in our patients in these areas need specific attention. The delivery of paediatric rheumatology care is also overviewed. Discrepancies in health-care resources and priorities are found in developing countries. Although most anti-rheumatic treatments are available worldwide, they are prohibitively expensive in many countries. For more traditional antirheumatic drugs there is still an ongoing need for good core outcome data across the world to ensure valid comparisons. Parent/patient education has been implemented worldwide in paediatric rheumatology through the power of the Internet. Physician and undergraduate training goals must be met to facilitate competent musculoskeletal assessment, a proper understanding of age-dependent variations, diagnosis, referral to specialists, and improved standards of care.

A generalized theory of electrical characteristics of schottky barriers for amorphous materials

In the present paper, we discuss a generalized theory of electrical characteristics for amorphous semiconductor (or insulator) Schottky barriers, considering: (i) surface states, (ii) doping impurity states at a single energy level and (iii) energetically distributed bulk impurity states. We also consider a thin oxide layer (≈10 Å) between metal and semiconductor. We develop current versus applied potential characteristics considering the variation of the Fermi level very close to contact inside the semiconductor and decrease in barrier height due to the image force effect as well as potential fall on the oxide layer. Finally, we discuss the importance of each parameter, i.e. surface states, distributed impurity states, doping impurity states, thickness of oxide layer etc. on the log I versus applied potential characteristics. The present theory is also applicable for intimate contact, i.e. metal-semiconductor contact, crystalline material structures or for Schottky barriers in insulators or polymers.

The structure of waxy corn starch: Effect of granule size

The granules of waxy corn starch were isolated and various samples were separated by size and classified according to their average diameter in: non-separated granules (N), granules with diameter < 15 μm (S) and granules with diameter ≥ 15 μm (L). The samples were hydrolyzed by bacterial α-amylase and fungal amyloglucosidase. The starch granules remaining after enzymatic hydrolysis were analysed by X-ray diffraction and optical and scanning electron microscopy. Sephadex G-50 gel permeation chromatography of the dissolved residues from the hydrolysis of the N and S samples was performed directly and after successive enzymatic digestion with pullulanase and β-amylase. The results showed that the percentage of hydrolysis increased with a decrease in diameter. No apparent differences in waxy corn starch when observed under light and scanning electronic microscope were observed, regardless of diameter and enzyme action, although both large and small granules showed extensive surface corrosion after enzymatic attack. X-ray analysis suggested a decrease in the quantity of crystalline areas in the smaller granules, which would explain the high percentage of hydrolysis evidenced by these granules. The elution patterns of the α-glucans of both starches (N and S) were similar and reveled the presence of two fractions which were not susceptible to a-amylase and amyloglucosidase attack suggesting that these fractions were involved in the waxy corn starch crystalline regions. Debranching with pullulanase followed by gel-permeation chromatography showed that the amylopectins from the starch granules studied contained three groups of unit chains instead of the two reported in the literature.