414 resultados para Densidade da madeira


Relevância:

20.00% 20.00%

Publicador:

Resumo:

The aim of this paper was to perform an energy assessment of firewood and woodshaving use for energy generation in sericulture agroindustry boilers. In this research, we used a boiler from a silk spinning factory located in the city of Duartina, São Paulo, Brazil, that currently uses eucalyptus firewood as fuel to generate water vapour used in silk fiber production. In the studied fuels utilization system energy consumption structure development, we considered energy input in Megajoule (MJ) by type, source and form involved in several firewood use technical itinerary operations, as well as in woodshaving use technical itinerary operations. From these fuels utilization built structure, we performed a firewood- and woodshaving-generated energy input comparative analysis, in Megajoule/hour (MJ.h-1), to produce 2.968,80 kg.h-1 of vapour, which is the boiler average production, during the following years: 2004, 2005, and 2006. The energy analysis results revealed that to replace eucalyptus firewood with woodshaving is something possible in the boiler, reducing total energy consumption approximately by 21%.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Soil bulk density is an attribute often used to characterize soil physical structure, being an indicator of soil compaction. The objective of this study was to compare the values ​​of bulk density measured by the paraffin sealed clod and volumetric ring methods in conventional, no-tillage and minimum tillage systems on a Dystroferric Red Nitosol, clayey, in Botucatu, SP. The experiment design was a 3x2 factorial arrangement in randomized block with four replications. The density values ​​obtained by the paraffin sealed clod method were statistically higher than those obtained by the volumetric ring method. There was no difference between the managements when comparing the values ​​of soil density obtained by the paraffin sealed clod method. The soil under conventional management showed lower density when comparing the values ​​of soil density obtained by the volumetric ring. The volumetric ring method was more sensitive to show differences between the management systems than the paraffin sealed clod method.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

No-till has been used in many different regions of Brazil. However, depending on the location and intensity of machinery traffic, this has caused the problem of soil compaction and many producers are scarification the land as a solution to break through the layer that is restricting plant growth. The objective of this study was to evaluate the influence of scarification (0.30 m) in the physical properties of a dystrophic Alfisol comparing the results with a non-scarified contiguous area; both were previously conducted using no-till. The density and pressure of pre-consolidation were sampled in two areas of non-tillage, one with chiseling (PDCE) and one without (PDSE) by using the UMAS -Mobile Soil Sampling Unit built by NEMPA – Agroforestry Machinery and Tire Testing Center/FCA / UNESP, Botucatu ,SP. The UMAS is equipped with GPS which allows the samples to be georeferenced. The samples were evaluated in the laboratory through the collection of standardized rings. Sampling was performed at a dimension of 15 x 50 m, with 160 rings being collected. The samples containing rings which were used in determining the density and also for testing the consolidometer, were collected from the layers of 0 to 0.10 m, 0.10 to 0.20 m, 0.20 to 0.30 0.30 to I 0.40 m. For the odometer test the undisturbed sample rings were used in obtaining the load bearing capacity of the soil. The soil management adopted provided a decrease in soil density using no-tillage with scarification depths from 0.0 to 0.10 0.10 to 0.20 m while the other depths did not show any decrease. The pre-consolidation pressure in combination with soil aggregate resistance identified that the management process PDCE within all layers was subjected to water content reliability regarding a greater load bearing capacity of the soil. For the PDSE that only was possible in the 0 to 0.10 m, showing greater consolidation of this layer.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

This paper had the objective of determining the transition regions between the juvenile and mature wood of Corymbia citriodora (Eucalyptus citriodora) of 29 years of age from the Experimental Station of Forest Science (EECFA-LCF/ESALQ-USP), located in Anhembi, in the State of São Paulo. The regions of juvenile and mature wood were characterized through anatomical studies - axial fiber length - following the recommendations of the International Association of Wood Anatomists (1989) using disks at the DBH of the trees. The measurements of fiber length were made in equipment for acquisition, diagnosis and image analysis. Five slices were made for every centimeter, in the radial direction and six fiber lengths per slice were measured, producing 30 measurements per sample region. In the total, 1740 lengths of fiber were measured in three disks that were studied. Results indicate a trend of accentuated and linear increase for the length of fibers, from the pith to 11 cm of radial of about 79%. Between 12 cm and 19 cm of the radius, fibers length remained almost constant, and from that point on, the fiber length tended to slightly increase to the bark. It can be concluded that for these trees, at this height of sampling, when the tree has 29 years of age, the extension of the juvenile wood goes up to 52% of its radius.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

In this work, we address the informational Density Index (IDI) a methodological Option How To be used on the Research Procedures Analysis of Commerce Geography. The IDI and an indicator of Technological Complexity level of economic activities and a review and made a database from CNEFE / NCEA, where the first signifies the National Register of Establishments for statistical purposes and the second means a National Classification Economic Activities. Elaborated with emphasis on discussion of between center and centrality relations, wish to present a constitution of a data base on level sampling with an analysis elaboration do IDI from the criteria: home-page and e - commerce. This methodology helps us understand how polycentric structures, locational enterprise well as a reflection on the middle cities using a through the analysis on city of São Carlos/SP. Where we see the establishments with greater and lesser content as well as its geographical distribution, noting of according to the criteria listed number of establishments with IDI 0 very relevant. Our analysis as well as such divisions that meet greater index, so, IDI 2 like to financial activities. Also present at methodological level the city of São José do Rio Preto/SP paragraph seizure of care when working there in database