388 resultados para Poluição radioativa


Relevância:

10.00% 10.00%

Publicador:

Resumo:

Water and soil pollution caused by the waste from the swine production causes severe environmental impacts in producing areas. An efficient alternative to reduce these impacts can be the use of high-rate anaerobic reactors. In this work, it was evaluated the effect of the swine wastewater with total suspended solids concentrations around 6.000 mg.L-1 in the anaerobic baffled reactor with three compartments. The volume of the first compartment was 210 L and of the second and third ones of 160 L. The anaerobic baffled reactor was submitted at hydraulic detention times of 56, 28 and 18 hours and to organic load rates of 5.0 to 10.1 g total COD (L.d)(-1). The highest total COD removals, of 42 to 68%, and volumetric methane productions, of 0.261 to 0.454 L CH4 (L reactor d)(-1), occurred in the second compartment.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Heavy metals are found naturally in soils at low concentrations, but their content may be increased by human activity, making them one of the barriers in management of tropical soils. These chemical elements can be found in the composition of organic and inorganic fertilizers, insecticides, fungicides, mine tailings, and urban waste, and may cause serious damage to the environment and human health. Thus, adsorption studies are essential in assessing the behavior of heavy metals in the soil. The objective of this study was to evaluate the influence of soil chemical, particle size, and mineralogical properties on adsorption of cadmium (Cd), evaluated by Langmuir and Freundlich models, in Latossolos (Oxisols) with or without human activity. Soil samples were collected from the surface layer, 0.00-0.20 m, and chemical, particle size, and mineralogical analyzes were performed. In the adsorption study, concentrations of 0, 5, 25, 50, 100, 200, 300, and 400 mu g L-1 of Cd were used in the form of Cd(NO3)(2). The empirical mathematical models of Langmuir and Freundlich were used for construction of adsorption isotherms. Data were analyzed by means of multivariate statistical techniques, Cluster Analysis and Principal Component Analysis. The data from the adsorption experiment showed a good fit to the Langmuir and Freundlich models. Soils with a lower goethite/hematite ratio and greater cation exchange capacity and pH, showed higher maximum adsorption capacity of Cd.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Pós-graduação em Geociências e Meio Ambiente - IGCE

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Pós-graduação em Engenharia Mecânica - FEG

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Este trabalho teve como objetivo estudar o tratamento da manipueira pelo processo de flotação, visando estabelecer os melhores parâmetros operacionais a serem adotados, sem o uso de agentes químicos. Foram realizados os tratamentos em dois tipos de processo de flotação: por ar dissolvido e ar induzido, sendo as colunas desenvolvidas em acrílico e PVC para operação contínua em uma planta piloto. Os dois sistemas de flotação não demonstraram diferenças em relação à recuperção de proteínas, amidos e matéria graxa, porém, o processo de flotação por ar dissolvido torna a manipueira diluída devido ao volume de água utilizada, o que acaba gerando um volume de resíduo ainda maior e aumentando o custo do processo. Utilizando o processo por ar induzido, foram realizados ensaios variando vazão e temperatura, sendo os melhores resultados obtidos nas seguintes condições: vazão na faixa entre 120 e 420 mL/min e temperatura na faixa de 33 a 36 °C. Foi observada uma redução nos percentuais de remoção de matéria graxa e proteínas de 44,4% e 32,8%, respectivamente.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Among the harmful health agents, it is given to the noise, one of the most present in urban and social environments. There are efficient measures to control the noise and the auricular Individual Protection Equipment (IPEa) is the most used. It has been observed the shortage in the comfortable and functional individual auditory protection products, related to durability, face to the efficiency right of the equipment. The main objective of this study was to recognize if there is effectiveness loss toward the used time on the Auditory Equipment, intra-auricular Individual Protection, of foam (3M), model 1110. It has been verified that the equipments suffer efficiency alteration according to the time of use, and the material consuming initiates reliable loss, mainly in audible frequencies going up to 100Hz, and from 16 days for sonorous pressure suffered started in 101dB 20Hz. For sonorous pressure suffered from 107dB to 20Hz, the reliable loss for the usage was of 8 days. The IPEas do not lose effectiveness on important attenuation by the daily use in frequencies from 1KHz until 20KHz. It has been concluded that there is effectiveness loss, according to the daily and frequent use of the IPEa studied.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

The main purpose of this article is to relate two among the most important themes of the current organizational dynamic: organizational culture, innovation and environmental management. Great part of the literature about environmental management and environmental innovation refers to organizational culture as the most arduous wall or the most significant element to develop effective practices of business environmental management. However, relationship among such concepts is, many times, superficial or camouflaging the necessary analytic depth. To solve this challenge, this article integrates the levels of the organizational culture (workmanships, values and presupposed unconscious), the typologies of environmental innovation (total productivity of resources, innovations for the segregation of materials and articulation of bio-systems), and the environmental technologies (end-of-pipe, environmental measurement, pollution prevention and zero-impact technology). Recommendations and challenges for the continuity of this research are registered.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

This work evaluated the rainwater chemical composition and the annual atmospheric deposition in Sorocaba, (Sao Paulo State), Brazil. One sampling ˜ point was chosen and forty samples were collected between January and December 2006. The analyses were performed for pH, electrical conductivity, sodium, calcium, potassium, magnesium, sulphate, nitrate, phosphate, alkalinity and chloride. The rainwater pH varied from 5.20 to 6.40, being Ca2+ the main ion responsible for controlling the rainwater pH. The ionic concentration decreases in the following order: Ca2+>Na+> K+>Mg2+ for cations and SO2− 4 >HCO− 3 >NO− 3 >Cl−>PO3− 4 for anions. The annual atmospheric deposition appears to be controlled by the following sources: mining activities and cement factories (Ca2+ and HCO− 3 ), agricultural activities (K+, NO− 3 and PO3− 4 ), soil dust (Na+, Mg2+ and HCO− 3 ) and fossil fuel burning (SO2− 4 )

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Com o atual índice de poluição gerada por resíduos industriais prejuduciais à saúde do ser humano, as indústrias, universidades e centros de pesquisa são influenciados a pesquisar métodos alternativos menos danosas. O uso do fluido de corte, por exemplo, tem sido constantemente estudado para que este possa ser eliminado, substituído ou utilizado na mínima quantidade possível. Entre as alternativas, destacam-se a usinagem a seco e a utilização da MQL, que também pode ser utilizada com adição de água. Esta é a opção deste estudo no processo de retificação de cerâmicas avançadas, assunto pouco divulgado na literatura formal. Para isso, foram avaliadas as variáveis de saída na retificação externa, como o comportamento da rugosidade do material retificado e desgaste diametral do rebolo. Com os resultados obtidos, foi possível avaliar a técnica da MQL com água, interpretando-a como um método alternativo bem-sucedido: houve melhoria consistente da rugosidade e diminuição do desgaste do rebolo.