359 resultados para Full factorial design
Resumo:
Pós-graduação em Agronomia - FEIS
Resumo:
Pós-graduação em Agronomia (Produção Vegetal) - FCAV
Resumo:
Pós-graduação em Engenharia Mecânica - FEG
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
The aim of this study was to evaluate the influence of fine and medium droplets in the performance of flutriafol and thiophanate methyl + flutriafol for the control of Asian Soybean Rust (Phakopsora pachyrhizi Sydow & Sydow). The experiment was a 2 x 2 factorial design (2 droplet sizes x 2 fungicides) resulting in four treatments with six replications. The experimental area was set up with 24 plots (50 x 21 m). In each plot there was a central assessment area with 10 x 20 m. To the each plot there was a non-treated area placed in opposed direction to the wind. The evaluations of rust control were made by of the calculation of incidence (percentage of plants with rust), severity (level of infection), defoliations and soybean yield. The results were analyzed by the calculation of the confidence interval at 90%. The study was set up in curative control conditions with average infestation of 68.6%, average severity in the lower part of the canopy was of 35.9% and on the upper parte it was 4.57%. The results of severity, defoliation and productivity did not show statistical difference among the treatments. However, it was observed that in general there was tendency of better results with the application of flutriafol alone comparing with thiophanate methyl + flutriafol, since there was a small difference between two commercial products in the flutriafol active ingredient content (62.5 g ha-1 to the flutriafol alone and 60 g ha-1 to the thiophanate methyl + flutriafol). There was no statistical difference between fine and medium droplets. This fact can be explained by the characteristics of systemic action of the flutriafol and by the type of control made (curative). The flutriafol, being a systemic fungicide is less sensitive to the better coverage provided by the smaller droplets and, on the curative control, the amount of product deposited can became more import than coverage, mainly on the superior part of the leaves. These leaves are healthier than the inferior leaves that in general are the first to become completely compromised by the rust, losing importance to the plant. By this reason, medium droplets appear to have offered similar performance even not offering advantages in the leaf coverage. This fact may become important because in the practical side of the use of medium droplets, since this may increase the amount of time to spray, mainly because the fine and very fine droplets have more limitations related to drift and evaporation.
Resumo:
The effect of the contaminant fungi Trichoderma sp. and Chaetomium olivacearum on the cultivation of the ABL 99/30 and ABL 04/49 isolates of A. blazei in two compost formulations made up with tyfton (Cynodom dactylon) and oat (Avena sativa) was evaluated. The experimental design was a totally randomized 2 x 2 x 3 factorial design with 6 repetitions. The experimental unit consisted of 12-12.5 kg of wet compost. During the spawning, 150 g of Trichoderma sp. and C. olivacearum were added to the compost. The experiment was carried out in a climatized room, with humidity between 75-90% and temperature of 28º C. The productivity averages of the ABL 99/30 isolate of A. blazei were higher than those of ABL 04/49 and Trichoderma sp. and C. olivacearum negatively influenced the production of A. blazei. The different composts (based on tyfton and oat straw) did not influence the production of basidiomata.
Resumo:
The objective of the work was to evaluate the in vitro mycelial growth of five A. blazei strains (ABL-05/53, ABL-04/49, ABL-03/44, ABL-99/30 and ABL-02/51) when submitted to the temperatures of 20 and 25 ºC. In a laminar flow chamber, discs of the strains were inoculated in the middle of Petri’s plates containing CA (compost-agar) medium and incubated in BOD. After 48 hours, measurements of the mycelial growth began, with the help of a ruler with scale in millimeters, by means of four equidistant measurements, until the moment when the fungal colony reached near the edges of the Petri’s plate in one of the treatments. The experimental design was totally randomized, in 5 x 2 factorial design. Each treatment consisted of seven repetitions, corresponding to one Petri’s plate, totalizing seventy experimental units. We verified that A. blazei growth is influenced by incubation temperature, being that the temperature of 25 ºC was more favorable for the mycelial growth of all A. blazei strains tested, with attention for ABL-04/49 and ABL-03/44 strains, which obtained the highest averages for mycelial growth under this temperature condition at the end of the cultivation cycle.
Resumo:
The nutritional requirements of crops, in general, becomes more intense with the beginning of the reproductive phase, being more critical at the time of seed formation, when considerable amounts of nutrients are they translocation, this requirement should be increased to the fact that nutrients are essential to training and development of new bodies of booking. This study aimed to evaluate the agronomic efficiency of foliar application of zinc (zinc oxide Zn 700 g L-1 ) in bean plant, compared to leaf application of zinc sulphate (ZnSO4) and control (without application of Zn). The experiment was installed in the Faculty of Agricultural Sciences - UNESP / Campus de Botucatu-SP. Was placed in containers with a capacity of 20L of soil and leaf applications encompassing four schemes and two of rain, with 5 replicates per treatment, a total of 40 vessels. The results for the factorial design did not show in general, significantly different answers when evaluated on the simulation of rain or the lack of simulation. The treatment (700g L-1 of ZnO) has demonstrated agronomic efficiency as its foliar application, with results equal or exceed the application of ZnSO4 and control when applied at the same dose of Zn.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
The aim of this study was to evaluate the effect of gamma irradiation associated with modified atmosphere in cold storage of guava ‘Pedro Sato’ minimally processed, checking their physical-chemical characteristics. Were used guavas from the region of Vista Alegre do Alto/São Paulo/Brazil. After harvest, fruits were immediately transported to the Fruit and Vegetables Laboratory from the Agroindustrial Management and Technology Department, Agronomic Sciences College - UNESP - Botucatu / SP, where they were kept at 10 ° C and 90-95% RH in cold storage, for 12 days. In the laboratory, fruits were selected by size and lack of defects in order to standardize the lot and then were cut into slices 0.5 cm thick. We used the completely randomized design, with factorial design 5 x 5, with three replications. The first factor consisted of the following effects: control 1 (without package or irradiation), control 2 (polystyrene package/PS + package low density polyethylene/LDPE and without irradiation), treatment 1 (PS + LDPE and 0.2 kGy ), treatment 2 (PS + LDPE and 0.6 kGy) and treatment 3 (PS + LDPE and 1.0 kGy). The second factor consisted of the evaluation periods: 0, 3, 6, 9 and 12 days. The analyses were: firmness, soluble solids (SS), titratable acidity (TA), maturity index, pH, breathing behavior. In the end of this work it was concluded that the lower dose of radiation associated with modified atmosphere promoted positive effect on physical-chemical characteristics of guava ‘Pedro Sato’, providing fruits with higher quality and durability, due to higher maintenance of pulp firmness, the highest pH and soluble solids obtained. Regarding the storage days, there were no beneficial effect of the treatments during storage, mainly due to the sensitivity of fruits submitted to gamma irradiation, where only the early days provided better values for the variables.
Resumo:
The aim of this study was to evaluate the efficacy of glyphosate and 2,4-D alone and in combination, in the control of Commelina villosa. We studied two methodologies for evaluating herbicide absorption in eight time intervals for washing (simulating rainfall after application) and cutting of leaves (simulating abortion as a defense strategy): 2, 4, 6, 8, 12, 24 and 48 hours after herbicide application, and a treatment without washing or cutting the leaves in a completely randomized design with four replications in a 3 x 7 + 1 factorial design (three herbicides x seven periods – hours after application). Herbicides and doses tested were: glyphosate (1,440 g ha-1), 2,4-D (720 g ha-1) and a mixture of glyphosate + 2,4-D (1,080 + 720 g ha-1). The simulation of rain interfered negatively in the plant control with glyphosate. The control with the herbicide 2,4-D was affected only for the period of 2 hours. Periods of rain simulation did not influence the control of plants with a mixture of glyphosate + 2,4-D. For the study with the cutting of treated leaves, all treatments regardless of the period of cutting the leaves were influenced negatively in terms of plant control, the plants showing regrowth when treated with 2,4-D alone.
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Pós-graduação em Agronomia - FEIS
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Pós-graduação em Agronomia - FEIS