Analysis of natural cis- and trans-polyisoprene mixtures by near-infrared spectrophotometry

Natural trans- and cis-polyisoprenes and mixtures of these polymers were analysed by near-infrared spectrophotometry. The relative absorptivity data versus the amount of isomers in synthetic mixtures showed a non-linear behaviour. The results are compared with literature data from polyisoprenes extracted from other vegetal species. (C) 2000 Elsevier B.V. Ltd. All rights reserved.

Study of charge transport in blends of natural rubber and poly(o-methoxyaniline) based on a resistor network statistical model

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

A comparative study of the non-isothermal degradation of natural rubber from Mangabeira (Hancornia speciosa Gomes) and Seringueira (Hevea brasiliensis)

Due to the increasing search for alternative sources of natural rubber (NR) whose properties are similar to Hevea brasiliesis, several sources have been studied in the past few years. Among them, Mangabeira (Hancornia speciosa Gomes), which is native to Amazon rainforest and other regions of Brazil, has a potential as another viable rubber source. As a continuation of a series of comparative studies between Hancornia and Hevea (clone RRIM 600) these two species by our research team, their thermal behavior was analyzed by thermogravimetry (TG) using Flynn-Wall-Ozawa's approach in order to obtain kinetic parameters (reaction order, pre-exponential factor and activation energy) of the decomposition process. Results indicated that the thermal behavior of NR from Hancornia was comparable to Hevea with some differences observed as follows: reaction order for Hancornia was higher than for Hevea at the beginning of degradation and very close for temperatures over 350 A degrees C; activation energy and pre-exponential factor had the same trend, i.e., increased with increasing degree of conversion remaining almost constant between 20 and 70% and then increasing for higher degrees, although Hevea was slightly more thermally stable than Hancornia. These major influences in the degradation process in the early stage are attributed to differences in non-rubber constituents present in these two species.

Evaluation of a portable clinical analyzer for the determination of blood gas partial pressures, electrolyte concentrations, and hematocrit in venous blood samples collected from cattle, horses, and sheep

Objective To compare results reported for blood gas partial pressures, electrolyte concentrations, and Hct in venous blood samples collected from cattle, horses, and sheep and analyzed by use of a portable clinical analyzer (PCA) and reference analyzer (RA).Animals-Clinically normal animals (24 cattle, 22 horses, and 22 sheep).Procedures-pH; Pco(2); Po(2); total carbon dioxide concentration; oxygen saturation; base excess; concentrations of HCO(3)(-), Na(+), K(+), and ionized calcium; Hct; and hemoglobin concentration were determined with a PCA. Results were compared with those obtained for the same blood sample with an RA. Bias (mean difference) and variability (95% confidence interval) were determined for all data reported. Data were also subjected to analyses by Deming regression and Pearson correlation.Results-Analysis of Bland-Altman plots revealed good agreement between results obtained with the PCA and those obtained with the RA for pH and total carbon dioxide concentration in cattle, K(+) concentration in horses and sheep, and base excess in horses. Except for Na(+) concentration and Hct in horses and sheep, correlation was good or excellent for most variables reported.Conclusions and Clinical Relevance-Data from blood gas and electrolyte analyses obtained by use of the PCA can be used to evaluate the health status of cattle, horses, and sheep. Furthermore, the handheld PCA device may have a great advantage over the RA device as a result of the ability to analyze blood samples on farms that may be located far from urban centers. (Am J Vet Res 2010;71:515-521)

Effects of Natural Infestations of the Mite Varroa destructor on the Development of Africanized Honeybee Workers (Apis mellifera)

The mite Varroa destructor (Anderson & Treuman 2000) has caused extensive damage to beekeeping worldwide. In Brazil, weather conditions and the strains of bees do not provide ideal conditions for mite parasitism, which is reflected in the low number of deaths of colonies caused by varroatosis well as the stability of infestation levels. The aim of this study was to evaluate the damage caused by the mite infestation in hives maintained in natural conditions. For this purpose the number of mites per bee was calculated and used to quantify the level of infestation in each colony. To record the mortality rates of parasitized bees during development daily checks were performed. The data were analyzed by G test of independence and a Test of Proportions. The results indicate that the rate of mortality of pupae and larvae was proportional to the degree of infestation in each colony, and all colonies showed mortality rates significantly higher than the control rate. A significant interaction among death rates recorded between the third and fourth days of larval life and the total death of larvae was found (G Test = 50.22; P < 0.0001). So, it can be concluded that bee inbreeding contributed significantly to the increase of the larval rate of mortality. In Africanized honeybee colonies infested by the mite Varroa destructor mortality rates in conditions of natural infestation varied from 6.65 to 9.89% in pupae (<(x)over bar>= 8.78%) and from 6.13 to 13.48% in larvae ((x) over bar = 9.91%), against 3.85% and 3.74% in the control colony, respectively. Therefore, in the infested colonies the average rates of mortality caused by the harmful effects of the mite were, respectively, 2.28 times and 2.65 times greater in those two developmental stages.

The Karyotype of Holoaden luederwaldti (Anura, Strabomantidae), with Report of Natural Triploidy

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

VCD to determine absolute configuration of natural product molecules: secolignans from Peperomia blanda

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

The use of standard methodology for determination of antifungal activity of natural products against medical yeasts Candida sp and Cryptococcus sp

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Quality of natural coffee subjected to different rest periods during the drying process

O parcelamento da secagem pode ser eficiente tanto no que diz respeito à qualidade final do café, quanto na redução do consumo específico de energia. Diante disso, objetivou-se, com o presente trabalho, avaliar o efeito do teor de água dos frutos no momento da interrupção da secagem e do período de repouso até a retomada da secagem na qualidade do café natural, por meio da análise sensorial e dos testes de condutividade elétrica e lixiviação de potássio. Frutos de café maduros foram colhidos manual e seletivamente e, em seguida, secados ao sol em terreiros de concreto por dois dias e, então, submetidos à secagem mecânica em secadores de camada fixa. Quando o café atingiu os teores de água de 20%, 17% e 14% (base úmida, bu), a secagem foi interrompida e o café permaneceu em repouso por cinco, quinze e trinta dias e, posteriormente, foi secado em secadores mecânicos até o teor de água de 11% (bu). O controle constituiu-se na secagem completa em terreiro. Observou-se que as combinações entre o menor teor de água e o maior período de repouso e entre o maior teor de água e o menor período de repouso, proporcionam menores valores de lixiviação de potássio. A qualidade da bebida melhora progressivamente com o aumento do período de repouso. A interrupção da secagem com teores de água de 17% e 20% (bu) não altera a qualidade do café natural, comparativamente à secagem completa em terreiro.

FACTORS THAT AFFECT THE ENZYMATIC DEGRADATION OF NATURAL STARCH GRANULES - EFFECT OF THE SIZE OF THE GRANULES

In this study the relationship between the enzymatic susceptibility and the size of the com and cassava starch granules was studied. The starch granules were separated by size and classified according to their average diameter in: a) larger than 16 mum; b) between 15 and 10 mum and c) smaller than 10 mum. The starch granules of various sizes were hydrolyzed by bacterial alpha-amylase and fungal amyloglucosidase. The results showed a relationship between the enzymatic susceptibility and the size of the starch granules; smaller size of the starch granules resulted in a higher percentage of hydrolysis. A basic difference in the mode of action of enzymes on small and large granules was observed. Enzymatic attack on the large granules was characterized by considerable surface corrosion, mainly at the radial axis. For small granules, the enzymatic action occurred on the surface of the granules and was characterized by an erosion with solubilization of the granules. Chemical and physical analysis of the starches suggested that hydrolysis should occur mainly at the amorphous areas of the granules.

Chemosystematic studies of natural compounds isolated from Asteraceae: characterization of tribes by principal component analysis

This work describes an application of principal component analysis (PCA) on a database of secondary metabolites from the Asteraceae family. The numbers of occurrences of metabolites in 11 chemical classes for the different vibes of the family were used as variables, PCA allows the identification of chemical classes that contribute most to the subgroups classification within the family. Relationships between chemical composition and botanical classification were made. (C) 2001 Elsevier B.V. B.V. All rights reserved.

Influence of annealing on X-ray diffraction of natural alexandrite

In this work we present results of X-ray diffraction using powder method, on natural alexandrite samples from Minas Gerais State (Brazil), as a function of a sequence of annealing. From these measurements we determine lattice parameters before (a = 9.405 Angstrom, b = 5.471 Angstrom, c = 4.409 Angstrom) and after annealing, and its structure is confirmed as orthorhombic. Measurements done after an annealing of 15 minutes at 700 degreesC and for 5 hours at 1000 degreesC indicate the migration of atoms present in the sample through different phases, which were also identified by Microprobe Analysis (WDS). However we have verified that such migration does not modify the structure. X-ray diffraction measurements have been carried out in conjunction with optical absorption in the UV-Vis as a function of annealing. (C) 2002 International Centre for Diffraction Data.

Annealing effects on optical properties of natural alexandrite

Natural alexandrite (BeAl2O4:Cr3+) crystals are investigated as regards the effects of annealing on their optical properties. Optical absorption spectra are measured from the ultraviolet (190 nm) to the near infrared (900 nm), for a sample subjected to consecutive annealing processes, where time and temperature are varied. Besides this, luminescence spectra are simultaneously obtained for this sample, excited with a Kr+ laser source, tuned on an ultraviolet multi-line mode (337.5, 350.7 and 356.4 nm). We observe from absorption as well as from emission data that annealing mainly influences the distribution of Cr3+ and Fe3+ ions, located on sites of a mirror plane (C-s symmetry), which are responsible for the optical properties of alexandrite. The results obtained lead to the conclusion that annealing induces a modification of the population of Cr3+ on C-s sites as well as on sites located on an inversion plane (C-i). Annealing could improve the optical properties of this material, as regards its application as a tunable laser.

Numerical and experimental analysis of natural convection in a cavity heated from below

In this work, an analysis of the natural convection flow caused by heat sources dissipating energy at a constant rate simulating electronic components mounted at the bottom surface of a cavity symmetrically cooled from the sides and insulated at the top is performed. This problem was studied numerically and experimentally for several aspect ratios (height/width), for different levels of dissipation in the sources, and for different side wall temperatures. Temperature and velocity fields were determined as well as the temperature variation along the surface where the sources are mounted and the average Nusselt number in the source surfaces. Numerical and experimental results were found to agree.