Vermiculita como substrato para o teste de germinação de sementes de barbatimão

The objective of this research was to evaluate the use of vermiculite as a substrate for the germination test of 'barbatimao' seeds and to establish what would be the best granulometry and the best moisture intensity to germinate 'barbatimao' seeds. Four replications of 50 seeds were previously scarified with H(2)SO(4) for 60 minutes. Afterwards, the following germination substrates were evaluated: paper rolls moistened with water equivalent to 2.5 times the weight of the dry paper (control); micron, super thin, thin and average sized vermiculite moistened with 0.5, 1.0, 1.5 and 2.0 times the weight of the dry paper. The germination temperature was 30 C. The percentage of normal seedlings was obtained seven days after sowing (first count) and, then, weekly (up to 28 days). Average time and relative distribution of germination were calculated. It was concluded that the germination of 'barbatimao' seeds can be carried out with either fine vermiculite moistened with water equivalent to 2.0 times the weight of the dry paper or average sized substrate moistened with water equivalent to 0.5 to 2.0 times the weight of dry paper. These treatments resulted in higher and faster germination (21 days), similarly to the paper roll method.

Influência da granulometria de grânulos de amido sobre a densidade aparente de extratos atomizados

Starches and modified starch derivations are used as carriers in the spray drying processing where apparent density is an important characteristic and should be controlled in dehydrated products for pharmaceutical use. In Brazil, the commercial starches are made from corn and cassava, but there are others with potential for extraction. The canna and taro starches were selected because they represent the extremes of granule size and thus allow the effect of this size on the apparent density of spray dried products to be tested. For comparison, commercial cassava and corn starches which are used in spray-drying and have granules of intermediate size, were also tested. The spray-drying process was carried out with a LabPlant SD 04 Spray Dryer, operating at a pressure of 6 lb/in2, air of 7,6 mL/minute, and 1 cm atomizing nozzle. The air inlet temperature was set at 200°C this model does not allow regulating outlet temperature. The spray-dryer products had boldo leaf extract as base, using the four starches as carrier. The dry product was evaluated for humidity, water activity (Aw), granulometry and apparent density. The results showed that the size of the particles, which was a consequence of the size of the starch granules, influenced the apparent density of the spray dried products, which as higher (694, 27 g/mL) for the canna starch and lower (456, 13 g/mL) for taro starch. Corn and cassava starches showed very close and intermediate values, 521,51 and 58,48 g/mL, which also represent the standard range of starch granule size.

Protocolo para ensaios físico-químicos de estabilidade de fitocosméticos

The growing demand for stable, safe and effective cosmetics has required increasingly complex studies by the scientific community and the use of more efficient techniques to determine the stability of these products. The use of active principles from the Brazilian flora has led to the development of numerous products, in the most varied pharmaceutical forms, making it, even more difficult to standardize experimental protocols to certify the stability of cosmetic preparations. While in Brazil there is no one protocol that standardizes the tests that should be carried out to determine product stability, several studies have been conducted in academic laboratories to determine the stability of specific raw materials. The rheological properties of topical use products have to be taken into account in their manufacture, storage and application. The determination of the rheological behavior of a formulation helps in evaluating the physicochemical nature of the vehicle, allowing early signs of physical instability to be detected and thus enabling quality control of the constituents, test formulations and final products. Thermal analysis has also been used to assist in the study of cosmetic stability and differential scanning calorimetry to guide the development of new products. Other tools, such as fluorimetry and laser granulometry can be used to help the study and development of both emulsified and non-emulsified systems. The aim of the present study is to develop a protocol for the investigation of the physical and chemical stability of phytocosmetics - systems containing active compounds extracted from the Brazilian biodiversity.

Iron determination by FAAS in fish feed and feces after ultrasound-assisted extraction

This paper proposes a method to determine iron in samples of fish feed and feces using ultrasound in the extraction of the analyte and in subsequent quantification by flame atomic absorption spectrometry. Using HCl 0.10 mol L -1 as the extraction solution, the optimal conditions of extraction were found to be: granulometry of the sample <60 μm; a sonication time of five cycles of 10 s and sonication power of 136 W. The method was applied in studies of the availability of iron in four food sources used in the diet of Nile Tilapia. The results obtained with the proposed extraction method allowed us to calculate the coefficients of apparent digestibility of iron in the food sources, which was not possible when using results obtained from samples mineralized by acid digestion. © Springer Science+Business Media, LLC 2008.

Variação das características hidrosedimentares e geomorfologia do leito do Rio Ivaí - PR, em seu curso inferior

In the present study were observed changes in morphology of the bed of the lower course of the river Ivaí, made by bathymetric surveys, granulometric analysis and measures the flow velocity. Changes made considerable changes in relation to flow and bad load. The study was conducted in the last 110 km of the river Ivaí, between the municipalities Tapira and Icaraíma - PR. In this section the channel flows with meandering pattern, embedded in sandstone Caiuá and sediment modern of its flood plain. This is the only major river in the state that so far has no modifications, making it an important site for studies of fluvial geomorphology.

Pharmacognostical evaluation of fruits of Solanum lycocarpum A. St.-Hill. (Solanaceae)

This study describes the chemical and physical-chemical profile of plant drug and ethanolic extract obtained from fruits of Solanum lycocarpum A. St.-Hill. (Solanaceae). The physical and chemical analysis involved the granulometry determination, non-compacted apparent density, loss on drying in oven and in infrared scale, pH, ash values and extractive values. The results determined the physical-chemical characteristics of the drug plant. It was also carried out the microbiological control of the plant drug. The preliminary phytochemical screening featured the presence of tannins, flavonoids and saponins in the plant drug and alkaloids and steroids in the ethanolic exctract. The solamargine and solasonine glycoalkaloids were identified through TLC and GC/ MS. The levels of total phenols and tannins were quantified in the extract (8.90% and 6,85% respectively). Such studies contribute to the chemical identification and quality control of S. lycocarpum fruits. © 2010 Phcog.net.

O meteorito condrítico Saulo Gomes

This paper aims to present the results of petrographic and lithochemical studies obtained in one of the three artifacts, which fell on the farm Buritis in Buritizal County in August 1967, which were collected and stored until the present by reporter Saulo Gomes. The petrographic analysis showed that the artifact is composed by spherical and irregular chondrules with serial granulometry and size averaging around 1 mm and the largest reaching about 6 mm in diameter. The chondrules are made of olivine, ortho and clinopyroxene, crystallite glass, nickel iron alloy and troillite (kamacite and/or taenite/tetrataenite) and inter chondrules glassy material occurs in association with troillite, nickel and other alloy iron-based compounds. The lithochemical data show excellent correlation with the C chondrite, noting only small differences above or between them. The study made it possible to classify the artifact as type L3 and L4 ordinary chondrite.

Physical factors affecting plasmid DNA compaction in stearylamine-containing nanoemulsions intended for gene delivery

Cationic lipids have been used in the development of non-viral gene delivery systems as lipoplexes. Stearylamine, a cationic lipid that presents a primary amine group when in solution, is able to compact genetic material by electrostatic interactions. In dispersed systems such as nanoemulsions this lipid anchors on the oil/water interface confering a positive charge to them. The aim of this work was to evaluate factors that influence DNA compaction in cationic nanoemulsions containing stearylamine. The influence of the stearylamine incorporation phase (water or oil), time of complexation, and different incubation temperatures were studied. The complexation rate was assessed by electrophoresis migration on agarose gel 0.7%, and nanoemulsion and lipoplex characterization was done by Dynamic Light Scattering (DLS). The results demonstrate that the best DNA compaction process occurs after 120 min of complexation, at low temperature (4 ± 1 °C), and after incorporation of the cationic lipid into the aqueous phase. Although the zeta potential of lipoplexes was lower than the results found for basic nanoemulsions, the granulometry did not change. Moreover, it was demonstrated that lipoplexes are suitable vehicles for gene delivery. © 2012 by the authors; licensee MDPI, Basel, Switzerland.

Automated determination of the orientation of dust devil tracks in mars orbiter images

The paper presents and evaluates three methods for automatically estimating the main orientation of Martian dust devil tracks in MOC and HiRISE images. Inferring such information about dust devils from their tracks is important to better understand the near surface wind. The methods considered were based on gradient direction, directional openings and morphological granulometry. The accuracy of the methods was asserted by comparing the results to a set of directions estimated visually and assumed to be the ground truth. The higher accuracy was reached using directional openings. Besides, the directions inferred by this method were compared to those predicted by the GCM and the results agreed. © 2013 COSPAR.

Biosorption of cadmium (II) and lead (II) from aqueous solution using exopolysaccharide and biomass produced by Colletotrichum sp.

The biosorption of Cd(II) and Pb(II) ions on biomass and exopolysaccharide (EPS) produced by Colletotrichum sp. fungus has been investigated as a function of contact time, initial pH, initial metal ion concentration, and initial adsorbent concentration in a batch system. Adsorption equilibrium was described by Freundlich and Langmuir isotherms. Adsorption was characterized through granulometry, SEM and EDX analysis. Then, studies were performed to regenerate the adsorbent. Biosorption of metals by biomass and EPS were best described by the Langmuir and Freundlich isotherm, respectively. Results of thermodynamic investigations showed that adsorption reactions were spontaneous (ΔG° < 0), exothermal, and mainly physical. The EPS was able to remove 79 and 98% of cadmium and lead, respectively, and the biomass removed 85 and 84% of cadmium and lead, respectively, in a solution with initial concentration 100 mg L-1, and the four adsorption-desorption cycles of all adsorbents showed up with great regenerative capacity and relative stability after these four cycles, the high potential of these biological materials in sorption has been shown. © 2013 Copyright Balaban Desalination Publications.

Caracterização química da farinha de vísceras de avestruz e seu valor nutritivo para tilápia-do-Nilo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Aproveitamento de rejeitos oriundos da extração de minério de ferro na fabricação de cerâmicas vermelhas

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Culturas de cobertura, doses e tipos de calcário em superfície na implantação do sistema plantio direto com a cultura da soja irrigada

Pós-graduação em Agronomia - FEIS

Reconstrução paleolimnológica da eutrofização na represa Guarapiranga com base em multitraçadores biogeoquímicos

Pós-graduação em Ciências Biológicas (Biologia Vegetal) - IBRC

Caracterização pedométrica de atributos de argissolos coesos do leste Maranhense

Pós-graduação em Agronomia (Ciência do Solo) - FCAV