Spectrophotometric flow-injection determination of sulphite in white wines involving gas diffusion through a concentric tubular membrane

A flow-injection system is proposed for the spectrophotometric determination of sulphite in white wines. The method involves analyte conversion to SO2, gas diffusion through a Teflon® semi-permeable membrane, collection into an alkaline stream (pH 8), reaction with Malachite green (MG) and monitoring at 620 nm. With a concentric tubular membrane, the system design was simplified. Influence of reagent concentrations, pH of donor and acceptor streams, temperature, timing, surfactant addition and presence of potential interfering species of the wine matrix were investigated. A pronounced (ca. 100%) enhancement in sensitivity was noted by adding cetylpyridinium chloride (CPC). The proposed system is robust and baseline drift is not observed during 4 h operating periods. Only 400 μL of sample and 0.32 mg MG are required per determination. The system handles 30 samples per hour, yielding precise results (r.s.d. < 0.015 for 1.0 - 20.0 mg L-1 SO2) in agreement with those obtained by an alternative procedure.

Flow injection amperometric determination of persulfate in cosmetic products using a Prussian Blue film-modified electrode

A flow-injection system with a glassy carbon disk electrode modified with Prussian Blue film is proposed for the determination of persulfate in commercial samples of hair bleaching boosters by amperometry. The detection was obtained by chronoamperometric technique and the sample is injected into the electrochemical cell in a wall jet configuration. Potassium chloride at concentration of 0.1 mol L-1 acted as sample carrier at a flow rate of 4.0 mL min-1 and supporting-electrolyte. For 0.025 V (vs. Ag/AgCl) applied voltage, the proposed system handles ca. 160 samples per hour (1.0 10-4 - 1.0 10-3 mol L-1 of persulfate), consuming about 200 μL sample and 11 mg KCl per determination. Typical linear correlations between electrocatalytic current and persulfate concentration was ca. 0.9998. The detection limit is 9.0 10-5 mol L-1 and the calculated amperometric sensibility 3.6 103 μA L mol -1. Relative standard deviation (n =12) of a 1.0 10-4 mol L-1 sample is about 2.2%. The method was applied to persulfate determination in commercial hair-bleaching samples and results are in agreement with those obtained by titrimetry at 95% confidence level and good recoveries (95 - 112%) of spiked samples were found. © 2003 by MDPI.

Kant e as analogias musicais

Besides a philosophical glossary, Kant handles many other linguistic repertoires; among them, for instance, the musical ones. The present study, by considering the kantian musical lexicon, is not intended to promote the music in the realm of critical philosophy from a aesthetic point of view, but to recognize and to examine in a preliminary manner an argumentative resource used by the philosopher, namely, the musical analogy.

Investigação tecnológica de arenitos silicificados da Formação Botucatu (ne do Paraná) para uso como rocha de revestimento

For many years the silicified sandstone associated of the Botucatu Formation has been the target of interest to researchers and miners, either for understanding the genesis of silicification or for your use as dimension stone and covering on the building industry. If in the first there are several articles available in the geological literature the second there are only technical data marketing available. In the northeast portion of the Paraná State and southwest of the São Paulo State these rocks are mined and traded as covering stones. Not much is known about their intrinsic characteristics and technological properties. To improve the knowledge of the technological behavior of these materials, samples from a quarry from Ribeirao Claro region were petrographically and physically characterized according to the standards established by the Brazilian Association of Technical Standards to dimension stones. Therefore, two bulk samples of silicified sandstone of the Ribeirão Claro/PR region were studied and characterized following the norms established by Brazilian Association of Technical Standards for dimension stones. The results obtained in the petrographical and technological studies are presented and indicated that, in general, the technological performance presented by sandstone studied induces limitations of use as covering materials, mainly horizontally as pavements, door stone and step ladder.

Grip and load force coordination in cyclical isometric manipulation task is not affected by the feedback type

Background: The relationship between normal and tangential force components (grip force - GF and load force - LF, respectively) acting on the digits-object interface during object manipulation reveals neural mechanisms involved in movement control. Here, we examined whether the feedback type provided to the participants during exertion of LF would influence GF-LF coordination and task performance. Methods. Sixteen young (24.7 ±3.8 years-old) volunteers isometrically exerted continuously sinusoidal FZ (vertical component of LF) by pulling a fixed instrumented handle up and relaxing under two feedback conditions: targeting and tracking. In targeting condition, FZ exertion range was determined by horizontal lines representing the upper (10 N) and lower (1 N) targets, with frequency (0.77 or 1.53 Hz) dictated by a metronome. In tracking condition, a sinusoidal template set at similar frequencies and range was presented and should be superposed by the participants' exerted FZ. Task performance was assessed by absolute errors at peaks (AEPeak) and valleys (AEValley) and GF-LF coordination by GF-LF ratios, maximum cross-correlation coefficients (r max), and time lags. Results: The results revealed no effect of feedback and no feedback by frequency interaction on any variable. AE Peak and GF-LF ratio were higher and rmax lower at 1.53 Hz than at 0.77 Hz. Conclusion: These findings indicate that the type of feedback does not influence task performance and GF-LF coordination. Therefore, we recommend the use of tracking tasks when assessing GF-LF coordination during isometric LF exertion in externally fixed instrumented handles because they are easier to understand and provide additional indices (e.g., RMSE) of voluntary force control. © 2013 Pedão et al.; licensee BioMed Central Ltd.

Simulation-based cutaneous surgical-skill training on a chicken-skin bench model in a medical undergraduate program

Background: Because of ethical and medico-legal aspects involved in the training of cutaneous surgical skills on living patients, human cadavers and living animals, it is necessary the search for alternative and effective forms of training simulation. Aims: To propose and describe an alternative methodology for teaching and learning the principles of cutaneous surgery in a medical undergraduate program by using a chicken-skin bench model. Materials and Methods: One instructor for every four students, teaching materials on cutaneous surgical skills, chicken trunks, wings, or thighs, a rigid platform support, needled threads, needle holders, surgical blades with scalpel handles, rat-tooth tweezers, scissors, and marking pens were necessary for training simulation. Results: A proposal for simulation-based training on incision, suture, biopsy, and on reconstruction techniques using a chicken-skin bench model distributed in several sessions and with increasing levels of difficultywas structured. Both feedback and objective evaluations always directed to individual students were also outlined. Conclusion: The teaching of a methodology for the principles of cutaneous surgery using a chicken-skin bench model versatile, portable, easy to assemble, and inexpensive is an alternative and complementary option to the armamentarium of methods based on other bench models described. © Indian Journal of Dermatology 2013.

Os Olhos no outro: estudo da sensibilidade na imagem fotográfica de pessoas de diferentes culturas

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Caracterização mecânica e microestrutural de aços Bake hardening graus 180 e 210 aplicados na indústria automotiva

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Monitoramento e avaliação dos ovos férteis de avestruz submetidos à incubação artificial

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Prevalência e sensibilidade aos antimicrobianos de microrganismos potencialmente superinfectantes na cavidade bucal de pacientes com espondilite anquilosante em uso de terapia anti TNF

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

O tempo e o espaço do comércio 24 horas na metrópole paulista

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

(Re)Iventando realidades: jogos espacio-temporais em três contos de Julio Cortázar

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Desempenho motor de alunos com paralisia cerebral frente à adaptação de recursos pedagógicos

Pós-graduação em Educação - FFC

Mitos bíblicos e contos de fadas revisitados na metaficção de Robert Coover

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Revista Gil Blas e o nacionalismo de combate (1919-1923)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)