PALEOCLIMATIC CONTROLS ON STABLE OXYGEN AND CARBON ISOTOPES IN CALICHE OF THE ABO FORMATION (PERMIAN), SOUTH-CENTRAL NEW-MEXICO, USA

The stable oxygen and carbon isotopic composition of caliche in fluvial and supratidal rocks of the Abo Formation (Permian), south-central New Mexico, is controlled by palecoclimate and depositional environment. Fluvial caliche consists of low-Mg calcite nodules and vertically oriented tubules that display stage II texture. Micrite matrix support, brecciation, ooids/pisoliths, aveolar-septal texture, and peloids are common in the fluvial caliche and, along with red color and slickensides in the host shale, indicate pedogenesis in a well-oxidized vadose zone. In contrast, periodic waterlogging of the supratidal paleosols, probably due to high water table, is indicated by drab colors, carbonaceous flecks, horizontal rhizoliths, and the paucity of vadose textures in the stage II caliche nodules.Stable oxygen isotopes are similar in the fluvial and supratidal caliches and range from 21.6 to 30.5 parts per thousand (SMOW). The data exhibit a crude bimodality and delta-O-18 enrichment with a decrease in age (higher in the section). Consideration of these data in the context of delta-temperature relations suggests that 1) surface waters responsible for caliche formation increased in delta-O-18 (from roughly -8 to + 1 parts per thousand) over the 18 m.y. time interval that separated the lowest stratigraphic nodule horizon from the highest, 2) the increasing delta-O-18 values also reflect a warming trend (approximately 15-degrees to nearly 30-degrees-C) in the mean monthly temperature over this same time period, with perhaps an associated increase in Permian ocean temperatures, and 3) the significant variation in delta-O-18 from oldest to youngest caliche was probably enhanced by the amount effect, such that as the temperature increased, the amount of precipitation decreased, resulting in high delta-O-18 values.Caliches in the Abo are enriched in heavy carbon (-7.2 to -1.5 part per thousand PDB) compared to that of soil carbonate derived exclusively from C3 plants (-12 part per thousand PDB), and the supratidal caliches contain somewhat heavier carbon compared to the fluvial caliche. The delta-C-13 values for both environments increase with a decrease in caliche age. These results indicate that as the temperature increased and rainfall decreased with time, the level of C3 plant productivity apparently declined, allowing a greater influx of atmospheric CO2 into the soil. This can only occur when soil respiration rates are quite low or at very shallow depths (less than 10 cm), or both. Atmospheric CO2 seems to have invaded the supratidal soils to a somewhat greater extent than the fluvial soils.

Characterisation of sugar cane combustion particles in the Araraquara region, Southeast Brazil

Biomass burning is an important primary and secondary source of aerosol particles. The presence of carbonaceous particles in the respirable size range makes the study of this fraction important in view of possible health and climatic effects. The annual burning of sugar cane plantations causes emission of huge amounts of pyrogenic particles. Aerosol samples were collected in Araraquara city, São Paulo state, Brazil, during the harvest season for fine and coarse particles and bulk; they were analysed by electron-probe microanalysis, including facilities for low-Z element determination (low-Z EPMA) and by energy-dispersive X-ray fluorescence (EDXRF), in order to investigate the elemental composition of individual particles and bulk samples, respectively. Numerical analysis of the EPMA results by hierarchical clustering shows high contributions of carbonaceous particles that can be distinguished mainly in two different types: biogenic and carbon-rich. Additionally, two significant contributions of aluminosilicate particles were identified: as rather pure aluminosilicates or mixed with carbonaceous species. The EDXRF results are compatible with those of aerosol particles in Amazon, which is nowadays one of the main sources of biogenic particles in the world.

Thermal behaviour of fumaric acid, sodium fumarate and its compounds with light trivalent lanthanides in air atmosphere

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Sewage sludge coke estimation using thermal analysis

The imposition of more stringent legislation by CETESB in the State of So Paulo (Brazil) governing the disposal and utilization of sewage sludge, coupled with the growth in its generation has prompted a drive for alternative uses of sewage sludge. One option that is especially promising, due to its potential to valorize sludge, is its conversion into carbonaceous adsorbents or coke for industrial effluents treatment. Thus, a methodology is presented to estimate the coke produced from the sludge of a sewage treatment station using thermal analysis. The used sewage sludge, which comes from aerobic treatment, was collected in the wastewater treatment station of Barueri, one of the largest of the So Paulo metropolitan area. The sludge samples were collected, dried, ground, and milled until they passed an ABNT 200 sieve. The inert ambient used during its thermal treatment produces inorganic matter and coke as residual materials. Coke formation occurs in the 200-500 A degrees C range and, between 500 and 900 A degrees C, its thermal decomposition occurs. The highest formation of coke occurs at 500 A degrees C.

Cogasification of solid fuels

High efficiency gas turbine based systems, utility deregulation and more stringent environmental regulations strongly favor the use of natural gas over coal and other solid fuels in new electricity generators. Solid fuels could continue to compete, however, if a low cost gasifier fed by low cost feedstocks can be coupled with a gas turbine system. We examine on-site gasification of coal with other domestic fuels in an indirectly heated gasifier as a strategy to lower the costs of solid fuel systems. The systematics of gaseous pyrolysis yields assembled with the help of thermal measurement data and molecular models suggests blending carbonaceous fuels such as coal, coke or char with oxygenated fuels such as biomass, RDF, MSW, or dried sewage sludge. Such solid fuel blending can, with the help of inexpensive catalysts, achieve an optimum balance of volatiles, heating values and residual char thus reducing the technical demands upon the gasifier. Such simplifications should lower capital and operating costs of the gasifier to the mutual benefit of both solid fuel communities.

Reactores aeróbios de lecho fluidizado trifásico con circulación interna: Caracterización hidrodinámica y del soporte

Aerobic internal-loop reactors use active biomass attached in a supporting media (biofilm) with the advantage of retaining a big biomass concentration in a small physical space, removing carbonaceous matter and nitrogen in only one reactor. Liquid circulation occurs due to hydrostatic pressure difference produced by air injection in the riser. In biphasic conditions liquid circulation velocities, gas holdup and oxygen transfer coefficient in four different reactor configurations were studied. For the three-phase conditions, the same parameters in just one of those configurations were evaluated. Also, there were three granular supporting media characterized. On the other hand, the relationship between internal and external tube areas and supporting media concentrations influence the liquid velocity, gas holdup and oxygen mass transfer values and some important supporting media characteristics were observed and compared.

Thermal behaviour of succinic acid, sodium succinate and its compounds with some bivalent transitions metal ions in dynamic N 2 and CO 2 atmospheres

Thermal stability and thermal decomposition of succinic acid, sodium succinate and its compounds with Mn(II), Fe(II), Co(II), Ni(II), Cu(II) and Zn(II) were investigated employing simultaneous thermogravimetry and differential thermal analysis (TG-DTA) in nitrogen and carbon dioxide atmospheres and TG-FTIR in nitrogen atmosphere. On heating, in both atmospheres the succinic acid melt and evaporate, while for the sodium succinate the thermal decomposition occurs with the formation of sodium carbonate. For the transition metal succinates the final residue up to 1180 °C in N 2 atmosphere was a mixture of metal and metal oxide in no simple stoichiometric relation, except for Zn compound, where the residue was a small quantity of carbonaceous residue. For the CO 2 atmosphere the final residue up to 980 °C was: MnO, Fe 3O 4, CoO, ZnO and mixtures of Ni, NiO and Cu, Cu 2O.

Viscosity, pH, and moisture effect in the porosity of poly(furfuryl alcohol)

The poly(furfuryl alcohol) is highly indicated to obtain advanced carbonaceous materials due mainly to its good carbon yield (around 50%) and a controllable cure reaction. In the processing of some carbonaceous materials, such as monolithic vitreous carbon, it is necessary to make sure that the material has the smallest porosity to be used in nobler applications such as heart valves and aerospace integrated systems. In this manuscript, a design of experiments was used to study the influence of viscosity, pH, and moisture in the porosity of the cured material. This study shows that the moisture exerts a significant influence on the porosity and the trend of the results lead to conclude that lower viscosity and moisture, and the use of non-neutralized poly(furfuryl alcohol) resins lead to obtain materials with better quality. © 2012 Wiley Periodicals, Inc.

A comparative study of glycerol dehydration catalyzed by micro/mesoporous MFI zeolites

The catalytic properties of monomodal microporous and bimodal micro-mesoporous zeolites were investigated in the gas-phase dehydration of glycerol. The desilication methodology used to produce the mesoporous zeolites minimized diffusion limitations and increased glycerol conversion in the catalytic reaction due to the hierarchical system of secondary pores created in the zeolite crystals. The chemical and structural properties of the catalyst were studied by X-ray diffraction, nitrogen adsorption-desorption isotherms, NH3-TPD and pyridine chemisorption followed by IR-spectroscopy. Although the aim was to desilicate to create mesoporosity in the zeolite crystals, the desilication promoted the formation of extra-framework aluminum species that affected the conversion of glycerol and the products distribution. The results clearly show that the mesoporous zeolites with designed mesopore structure allowed a rapid diffusion and consequently improved the reaction kinetics. However, especial attention must be given to the desilication procedure because the severity of the treatment negatively interfered on the Brønsted and Lewis acid sites relative concentration and, consequently, in the efficiency of the catalysis performed by these materials. On the other hand, during the catalytic reaction, the intracrystalline mesopores allowed carbonaceous compounds to be deposited herein, resulting in less blocked micropores and catalysts with higher long-term stability.

Transformação do glicerol em compostos de interesse petroquímico catalisada por zeólitas com ordem hierárquica de poros

Pós-graduação em Química - IQ

Avaliação da remoção de matéria orgânica carbonácea e nitrogenada de águas residuárias utilizando biorreator de membranas

Pós-graduação em Engenharia Civil - FEIS

Efeito da concentração do meio suporte e relação entre áreas no desempenho de reatores aeróbios de leito fluidizado com circulação interna no tratamento de esgoto doméstico

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Tratamento de águas residuárias por alagados construídos de fluxo subsuperficial horizontal, utilizando Vetiver (Chrysopogon zizanoides L.): avaliação e desempenho de três leitos distintos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Produção e caracterização de carbono vítreo monolítico a partir das resinas poliarilacetileno e furfurílica

Pós-graduação em Engenharia Mecânica - FEG

Monitoramento do processo de densificação de compósitos termoestruturais de carbono reforçado com fibras de carbono por tomografia computadorizada e resistividade elétrica

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)