70 resultados para Specialty
Resumo:
Objective: To increase the knowledge base regarding pulmonology research in Brazil. Methods: A retrospective, observational study of the abstracts published in the Annals of the Brazilian Pulmonology and Phthisiology Conferences held from 1986 to 2004, quantifying the institutions of origin by geographic distribution and type, as well as categorizing the abstracts by study design and topic. Results: A total of 6467 abstracts were published. The institutions of origin were located, variously, in the Southeast (3870 abstracts), South (1309), Northeast (783), Central-West (267) and North (84). There were 94 abstracts originating from foreign institutions, especially from institutions in Portugal (56.3%) and the United States (13.8%). Most of the studies (5825) were conducted in public Brazilian institutions. There were 4234 clinical studies, 1994 case reports and 239 original research articles. A marked, progressive increase was observed in the number of clinical studies and case reports during the period evaluated. Overall, the most common themes were tuberculosis and other infections diseases (25.2%), following by oncology (11.6%), interstitial lung diseases (8.8%) and thoracic surgery (8.5%). Nevertheless, the number of abstracts on each topic varied widely from year to year. Conclusion: Public Brazilian institutions are the principal sources of pulmonology research in Brazil. Such research activity is concentrated in the southeastern part of the country. Case reports account for one-third of this activity. Although there was great variability in the subjects addressed, diseases that are highly prevalent in Brazil, such as tuberculosis and other infections diseases, were the most common topics.
Resumo:
Cold-formed steel members are subject to failure caused by buckling, normally under loads smaller than those corresponding to partial or total yielding of the cross section. The buckling of members in bending can be classified as local or global, and the occurrence of one or the other type is expected by the members' geometric characteristics and by the constraints and load conditions. One of the local instability modes that can characterize a member's failure is distortional buckling of the cross section occurring on its own plane and involving lateral displacements and rotations. This paper presents and discusses the procedures and results obtained from experimental tests of cold-formed steel members under bending. Forty-eight beams were carried out on members in simple lipped channel, in pairs, with 6-meter spans and loads applied by concentrated forces at every 1/3 of the span. The thickness, width and dimensions, of the stiffeners were chosen so that the instability by distortion buckling of the cross section was the principal failure mode expected. The experimental results are compared with the obtained results by using the direct strength method.
Resumo:
Introduction: The cost of orthodontic treatment is a very important issue. The aim of this study was to analyze the current Indicative Values for Dental Procedures (IVDP) for orthodontic procedures. Methods: Laws, dental entities papers and scientific literature were utilized. Results: Laws are too general and only offer abstract parameters when define remunerations. Current IVDP vary in the same State, according to the consultant entity. Dental entities interpret that general clinicians can practice Corrective Orthodontics, but new scientific studies begin to question this understanding. The Brazilian Association of Orthodontics and Dentofacial Orthopedics (ABOR) suggests that IVDP for orthodontic specialty must be formulated. Conclusion: Current IVDP are not standardized and are below the correct values for orthodontic procedures, because they are the mean of general clinicians and orthodontists remunerations; and ABOR is legally and ethically supported to claim specific IVDP for orthodontic specialty.
Resumo:
Pós-graduação em Estudos Linguísticos - IBILCE
Resumo:
Pós-graduação em Estudos Linguísticos - IBILCE
Resumo:
Pós-graduação em Biologia Geral e Aplicada - IBB
Resumo:
Pós-graduação em Bases Gerais da Cirurgia - FMB
Resumo:
Pós-graduação em Bases Gerais da Cirurgia - FMB
Resumo:
Pós-graduação em Letras - FCLAS
Resumo:
Pós-graduação em Ciência da Informação - FFC
Resumo:
Pós-graduação em Ciência da Informação - FFC
Resumo:
Pós-graduação em Odontologia Preventiva e Social - FOA
Resumo:
Pós-graduação em Enfermagem (mestrado profissional) - FMB
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Pós-graduação em Psicologia - FCLAS