The Brazilian Seismographic Integrated Systems (BRASIS): Infrastructure and data management

In geophysics and seismology, raw data need to be processed to generate useful information that can be turned into knowledge by researchers. The number of sensors that are acquiring raw data is increasing rapidly. Without good data management systems, more time can be spent in querying and preparing datasets for analyses than in acquiring raw data. Also, a lot of good quality data acquired at great effort can be lost forever if they are not correctly stored. Local and international cooperation will probably be reduced, and a lot of data will never become scientific knowledge. For this reason, the Seismological Laboratory of the Institute of Astronomy, Geophysics and Atmospheric Sciences at the University of São Paulo (IAG-USP) has concentrated fully on its data management system. This report describes the efforts of the IAG-USP to set up a seismology data management system to facilitate local and international cooperation. © 2011 by the Istituto Nazionale di Geofisica e Vulcanologia. All rights reserved.

Life cycle assessment applied to municipal solid waste management: a case study

This study analyzes the environmental performance of the Municipal Solid Waste Management System (MSWMS) of Piedade, São Paulo, from a systemic perspective. A life cycle assessment (LCA) technique was applied according to an attributional approach to evaluate both the current operational situation and different prospective scenarios, which were devised based on the application of targets for recycling dry and wet waste suggested by the pre-draft version of the Brazilian Plan for Solid Waste. The life cycle impact assessment method EcoIndicator 99, in association with normalization and weighting procedures, was used to conduct the analysis. It was observed that the adoption of goals of 30%, 50% and 70% for recovering of the recyclable dry waste, resulted in improvement of the environmental performance of the waste management system under analysis, respectively of 10%, 15% and 20%. It was also possible to detect an evolution in the order of 54% in reducing impacts resulting from the adoption of targets for composting. LCA proved to be effective for the evaluation of the environmental performance of MSWMS-Piedade. However, for future evaluations, the attributional approach should be replaced by the methodological practice of substitution to enable the avoided burdens to be considered in estimations of the environmental performance municipal solid waste management systems.

Comportamento de adesão da madeira de um híbrido clonal de Eucalyptus urophylla x Eucalyptus grandis proveniente de três condições de manejo

This study aimed to evaluate the adhesion ability of eucalyptus lumber from three tillage systems, using adhesives: resorcinol formaldehyde and two adhesives in water emulsion based on vinyl poly-acetate. The management systems were characterized by three strata, the stratum one (E1) characterized by wood from coppice and 70 months of age, the stratum two (E2) characterized by wood and retirement age of 166 months and stratum three (E3), also characterized by retirement at 70 months of age. The wood was derived from a random mixture of the first two sawn logs, each three feet from the base, which comprised three treatments on the adhesive used. We evaluated the shear strength by compression tests and the percentage of wood failure in the glue line. Based on the results obtained, it can be said that the adhesion had satisfactory performance with all the resins used, and the average values of shear strength of the glue line were shown to be equivalent to the shear strength of solid wood only for the samples which adhered with 'Wonderbond' adhesive and also provide higher values for wood failure (97.64%). The highest density present in the wood of the second stratum (E2) influenced only sticking with the resorcinol formaldehyde resin. For polyvinyl acetate (Cascorez 2590), shear values decreased in the third management condition (E3).

Diretrizes para implantação de sistemas de segurança e saúde do trabalho em empresas produtoras de baterias automotivas

O desenvolvimento de Sistemas de Gestão da Segurança e Saúde no Trabalho (SGSST) ganha um significado cada vez mais importante no desempenho das empresas, pois, por meio deles, é possível obter a promoção da saúde e satisfação dos trabalhadores e a redução dos riscos de acidentes. No entanto, para que um SGSST obtenha bons resultados, as empresas precisam estar atentas às dificuldades comumente encontradas durante o seu processo de implantação, procurando solucioná-las de maneira antecipada e estruturada. Pelo exposto, este trabalho tem como principal objetivo apresentar diretrizes, baseadas no referencial teórico e nos resultados dos estudos de caso realizados, para implantação de SGSSTs em empresas fabricantes de baterias automotivas. Para o seu desenvolvimento adotou-se o método de pesquisa qualitativa a partir da realização de dois estudos de caso em empresas fabricantes de baterias automotivas localizadas na cidade de Bauru. Os instrumentos de coleta de dados foram entrevistas semiestruturadas, análise de documentos e observação in loco. Ao final do artigo, são propostas diretrizes relacionadas aos seguintes elementos: alta direção, estratégia organizacional, cultura organizacional, departamento de Segurança e Saúde do Trabalho (SST), técnicos de SST, recursos humanos, treinamento, equipes multidisciplinares, comunicação interna, resistência à mudança, indicadores de desempenho, ferramentas gerenciais para solução de problemas de SST, gestão de projetos, recompensas e incentivos, e integração do sistema.

Soil management and nitrogen fertilization for sprinkler-irrigated upland rice cultivars

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Gestão ambiental: uma súplica do planeta, um desafio para políticas públicas, incubadoras e pequenas empresas

O texto traz uma reflexão sobre o papel das incubadoras de empresas no apoio a práticas ambientais por micro e pequenas empresas. Reconhecendo as debilidades estruturais das empresas de pequeno porte e as dificuldades para a realização de investimentos ambientais, defende o uso de incubadoras como instrumento de política pública para estimular investimentos ambientais. Identifica um número restrito de incubadoras de tecnologias ambientais, em plano internacional. Relata os resultados de uma pesquisa que avaliou a aplicabilidade de um indicador para apurar o desempenho ambiental de incubadoras. Destacaram-se dois resultados: a) a baixa importância atribuída, pelas incubadoras (e pelas empresas abrigadas) ao desempenho ambiental; e b) a ausência de estímulos, pelas incubadoras, aos investimentos ambientais. Desse último resultado deriva importante conclusão: a de que, uma vez apurados os padrões insatisfatórios de desempenho ambiental, de incubadoras e empresas assistidas, ficariam criadas as condições para a formulação e a implementação de medidas indutoras de novas posturas.

Dynamics of aggregate stability influenced by soil management and crop residues

The type of tillage and crop systems used can either degrade or cause a recovery of the structure of agricultural soils. The objective of this study was to determine the structural stability of the soil using mean weight diameter (MWD) of soil aggregates in three different periods of a succession of crops consisting of beans/cover plants/maize under no tillage (NT) and conventional tillage (CT) management systems. Soils were sampled at 0- to 5-cm and 5- to 15-cm depths in three periods (P1, P2, P3): 1) November 2002 (spring/summer), 2) April 2003 (beginning of autumn), and 3) December 2003 (end of spring/beginning of summer). Aggregate stability was determined by wet sieving. The effects of the tillage systems, vegetal residues, and sampling depths on the structural stability of the aggregates were assessed and then related to organic matter (OM) contents. Aggregate stability showed temporal variation as a function of OM contents and sampling period. No tillage led to high MWD values in all study periods. The lowest MWD values and OM contents were observed 4 months after the management of the residues of cover plants. This finding is consistent with the fact that at the time of the samplings, most of the OM had already mineralized. The residues of sunn-hemp, millet, and spontaneous vegetation showed similar effects on soil aggregate stability.

Integration of the dispersed generators in the distribution management system

Since the 80s huge efforts have been made to utilize renewable energy sources to generate electric power. An important issue about using renewable energy sources is a Distribution Management System (DMS) in presence of dispersed generators. This paper reports some aspects of integration of the dispersed generators in the DMS. Besides, an investigation of impact of the dispersed generators on the overall performances of the distribution systems in steady state is performed. In order to observe losses in the distribution networks with dispersed generators, several loss allocation methods are applied. Results obtained from case study using IEEE test network, are presented and discussed. © 2003 IEEE.

A tool to simplify the management of homogeneous and heterogeneous grids

To simplify computer management, several system administrators are adopting advanced techniques to manage software configuration on grids, but the tight coupling between hardware and software makes every PC an individual managed entity, lowering the scalability and increasing the costs to manage hundreds or thousands of PCs. This paper discusses the feasibility of a distributed virtual machine environment, named Flexlab: a new approach for computer management that combines virtualization and distributed system architectures as the basis of a management system. Flexlab is able to extend the coverage of a computer management solution beyond client operating system limitations and also offers a convenient hardware abstraction, decoupling software and hardware, simplifying computer management. The results obtained in this work indicate that FlexLab is able to overcome the limitations imposed by the coupling between software and hardware, simplifying the management of homogeneous and heterogeneous grids. © 2009 IEEE.

Uso do AHP na avaliação do desempenho do sistema de gestão da qualidade, meio ambiente e segurança e saúde ocupacional integrados

The paper analyses the application of the AHP method together with the attach A of ISO 9004:2000 in order to evaluate the performance of two industrial organizations, both possessing quality management systems with ISO 9001:2000 certifications, based on the specific requirements of quality, environment, occupational health and management systems. The evaluated organizations were a government-owned company from the science and technology sector that works in the nuclear area, and a private company that works in the automotive and railroad area. The open software Web-Hipre version 1.22 from Helsinki University of Technology, Finland, was used. The results demonstrated that the AHP method together with the attach A of ISO 9004:2000 is adequate to evaluate organizational performances. Both organizations presented similar performance levels.

Restoration of a degraded area using soil tillage systems in Campinas, São Paulo, Brazil

In Brazil the intensive agriculture use, mainly pasture, is the main cause of the presence of extensive areas of degraded lands. This study aimed to assess the impact of different soil management practices in a pasture degraded area used as garbage disposal. The experiment was performed at the Faculdade de Engenharia Agrícola, Universidade Estadual de Campinas - UNICAMP, in Campinas, state of São Paulo, Brazil, from 1990 to 1996. This area has undergone a process of recovery through removal of trash deposited on the surface, in 1985, levelling of soil, followed by application of limestone, subsoiling, planting of legumes (Crotalaria juncea) and crop rotation (soybean and maize). Since 1990 only popcorn maize was grown and established plots managed with different soil tillage systems, including harrow, chisel plow, moldboard plow, no tillage, disk plow and revolving hoe. One plot was planted exclusively with guinea grass (Panicum maximum) to serve as a reference for minimum loss of soil and another grown on a downhill direction to correspond to the expected maximum erosion. There were differences in sediment loss, nutrient loss and productivity of the popcorn maize in the period analyzed. The chisel plow and no tillage treatments caused the slightest loss of soil and nutrients, compared to other tillage systems. The results show that the soil management systems influenced the physical and chemical characteristics of soil, allowing an economical and environmental recovery of the area, providing the conditions for grain agricultural production.

Managing object identity with less I/O operations

Non-conventional database management systems are used to achieve a better performance when dealing with complex data. One fundamental concept of these systems is object identity (OID). Two techniques can be used for the implementation of OIDs: physical or logical. A logical implementation of OIDs, based on an Indirection Table, is used by NuGeM, a multimedia data manager kernel which is described in this paper. NuGeM Indirection Table allows the relocation of all pages in a database. The proposed strategy modifies the workings of this table so that it is possible to reduce considerably the number of I/O operations during the request and release of pages containing objects and their OIDs. Tests show a reduction of 84% in reading operations and a 67% reduction in writing operations when pages are requested. Although no changes were observed in writing operations during the release of pages, a 100% of reduction in reading operations was obtained. © 2012 IEEE.

Factors affecting the adoption of green supply chain management practices in Brazil: Empirical evidence

The aim of this study is to identify and analyse the factors that affect the adoption of Green Supply Chain Management practices based on empirical evidence from the Brazilian electronics sector. Data are collected in a survey of 100 electronics companies and analysed using statistical analysis of variance and regression methods. The study finds that the size of the company, previous experience with Environmental Management Systems, and the use of hazardous inputs are positively correlated with GSCM practices adoption. Surprisingly, formal pressure from the stronger tier/player in the supply chain is not correlated with the adoption of GSCM practices. Finally, we present some explanations for these findings and suggestions for future research. © 2013 Copyright Taylor and Francis Group, LLC.

Incerteza espacial da emissão de 'CO IND.2' do solo em dois sistemas de manejo da palhada da cana-de-açúcar

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Gestão do desempenho organizacional em empresas do setor de construção civil: uma aplicação do Balanced Scorecard

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)