Comparative investigation of the cleavage step in the synthesis of model peptide resins: Implications for N-alpha-9-fluorenylmethyloxycarbonyl-solid phase peptide synthesis

Based on our studies of the stability of model peptide-resin linkage in acid media, we previously proposed a rule for resin selection and a final cleavage protocol applicable to the N-alpha-tert-butyloxycarbonyl (Boc)-peptide synthesis strategy. We found that incorrect choices resulted in decreases in the final synthesis yield, which is highly dependent on the peptide sequence, of as high as 30%. The present paper continues along this line of research but examines the N-alpha-9-fluorenylmethyloxycarbonyl (Fmoc)-synthesis strategy. The vasoactive peptide angiotensin II (All, DRVYIHPF) and its [Gly(8)]-All analogue were selected as model peptide resins. Variations in parameters such as the type of spacer group (linker) between the peptide backbone and the resin, as well as in the final acid cleavage protocol, were evaluated. The same methodology employed for the Boc strategy was used in order to establish rules for selection of the most appropriate linker-resin conjugate or of the peptide cleavage method, depending on the sequence to be assembled. The results obtained after treatment with four cleavage solutions and with four types of linker groups indicate that, irrespective of the circumstance, it is not possible to achieve complete removal of the peptide chains from the resin. Moreover, the Phe-attaching peptide at the C-terminal yielded far less cleavage (50-60%.) than that observed with the Gly-bearing sequences at the same position (70-90%). Lastly, the fastest cleavage occurred with reagent K acid treatment and when the peptide was attached to the Wang resin.

Microwave synthesis of YAG : Eu by sol-gel methodology

Yttrium-aluminum oxides are interesting compounds and they have been extensively used as host for lasers and phosphors, due to their stable physical and chemical properties. The fabrication of yttrium-aluminum garnet (YAG) has been investigated thoroughly. Single-crystal YAG is expensive and to produce it a new way has been investigated. This process consists of modifying the methodology of reagents mixture and the process of heating them. The microwave irradiation is used to heat-treat the oxide mixture. The traditional synthesis of YAG powders occurs through the reaction of aluminum and yttrium powders at high temperatures. With this work we investigated the preparation of YAG by non-hydrolytic sol-gel route as an alternative methodology to obtain yttrium-aluminum matrix from inorganic precursors (yttrium and aluminum chloride). The preparation of the gel was carried out in an oven-dried glassware. The AlCl3, YCl3 and ethanol were reacted in reflux under argon atmosphere. Europium III chloride was added as a structural probe. The powder was dried and heat-treated in modified microwaves. The samples were pre-treated at 50 and 800 C during I h and then heated in microwaves for 30 s, 2 and 4 min. The formation process and structure of the powders were studied by means of X-ray diffraction (XRD), photoluminescence (PL) and transmission electronic microscopy (TEM). XRD presents only picks corresponding to the YAG phase and confirmed by TEM. PL date showed that the YAG phase was formed in 2 min with the samples pre-treated at 50 C. For the samples pretreated at 800 degrees C, the YAG phase appears in 30s. The excitation spectra present a maximum of 394 nm corresponding to the L-5(6) level and emission spectra of Eu III ion present bands characteristic transitions arising from the D-5(0) -> F-7(J) (J= 1, 2, 3, 4) monifolds excited at their maximum. The magnetic dipole D-5(0) -> F-7(1) transition presents more intensity than the electric dipole D-5(0) -> F-7(2) transition. This methodology showed efficiency in obtaining YAG phase. (c) 2006 Elsevier B.V. All rights reserved.

A methodology and a tool to design of mixed-signal technology

This paper presents a tool box developed to read files describing a SIMULINK® model and translates it into a structural VHDL-AMS description. In translation process, all files and directory structures to simulate the translated model on SystemVision™ environment is generate. The tool box named MS2SV was tested by three models of commercially available digital-to-analogue converters. All models use the R2R ladder network to conversion, but the functionality of these three components is different. The methodology of conversion of the model is presents together with sort theory about R-2R ladder network. In the evaluation of the translated models, we used a sine waveform input signal and the waveform generated by D/A conversion process was compared by FFT analysis. The results show the viability of this type of approach. This work considers some of challenges set by the electronic industry for the further development of simulation methodologies and tools in the field of mixed-signal technology. © 2007 IEEE.

Dynamics of change of mathematics education in Brazil and a scenario of current research

Mathematics education in Brazil, if we consider what one may call the scientific phase, is about 30 years old. The papers for this special issue focus mainly on this period. During these years, many trends have emerged in mathematics education to address the complex problems facing Brazilian society. However, most Brazilian mathematics educators feel that the separation of research into trends is a theoretical idealization that does not respond to the dynamics of the problems we face. We raise the conjecture that the complexity of Brazilian society, where pockets of wealth coexist with the most shocking poverty, has contributed to the adoption and generation of different strands in mathematics education, crossing the boundaries between trends. At a more micro level, we also raise the conjecture that Brazilian trends in research are interwoven because of the way that Brazilian mathematics educators have experienced the process of globalization over these 30 years. This tapestry of trends is a predominant characteristic of mathematics education in Brazil. © FIZ Karlsruhe 2009.

An application of a modified constructive heuristic algorithm to transmission expansion planning

Transmission expansion planning (TEP) is a non-convex optimization problem that can be solved via different heuristic algorithms. A variety of classical as well as heuristic algorithms in literature are addressed to solve TEP problem. In this paper a modified constructive heuristic algorithm (CHA) is proposed for solving such a crucial problem. Most of research papers handle TEP problem by linearization of the non-linear mathematical model while in this research TEP problem is solved via CHA using non-linear model. The proposed methodology is based upon Garver's algorithm capable of applying to a DC model. Simulation studies and tests results on the well known transmission network such as: Garver and IEEE 24-bus systems are carried out to show the significant performance as well as the effectiveness of the proposed algorithm. © 2011 IEEE.

Recovery of degraded areas using topsoil in the Amazon rainforest

This study is aimed at evaluating the effect of placing the top soil cover areas, such as tailings degraded by tin mining, in the Amazon rainforest in Brazil. The evaluations of the planting sites occurred in areas where tin mining was carried out, basically planting native trees over a period of seven years. This work did not come from a pre-decreed methodology of experimental design, and data was collected only seven years after planting. Thus, it was not possible to identify all variables that contributed to a better recovery of the areas. Sampling was done about seven years after placing the top soil and is determined: pH, organic matter content, P, K, Ca, Mg, Al, cation exchange capacity (T), base saturation (V%), B, Fe, Zn, Cu and Mn. The native forest species existing at the site were evaluated in relation to height (in meters) and diameter of the base. For all sites where the surface layer of soil was applied, there were significant differences in the growth of native species. A fundamental aspect in the rehabilitation of areas degraded by mining, in general, is the knowledge about the soil where that recovery must be conducted. The specific procedures in the rehabilitation of those areas depend essentially on the physical, chemical, biological and mineralogical properties of the soil, which must present conditions for the adequate development of the plants. The initial idea of implanting a project of recovery of soils degraded by mining in the Amazon Forest emerged from a first visit to the field, carried out in 1998. The conditions of the already mined areas, in comparison to the exuberant forest of the surroundings caught our attention. The mining company that acts in the area had already been trying for some time to implant a plan of recovery of these mining areas, however without reaching any significant positive results. The loss of organic matter is one of the main problems of degraded areas in Brazil. The storage and reuse of a blanket of soil (topsoil) produce excellent results, but most of the miners consider this technique expensive and difficult because of operational costs and the sharp topographical condition of the mine site. Therefore, a research project was elaborated prioritizing the recovery of the soil degraded by the tin mining as a prior step to the recovery activities with native forest species. The formation of a superficial pseudo-horizon that supported the vegetation and the time that it would take for its establishment became the main objective of this research. The objective of this work is to verify the levels of elements and their traces in areas where top soils were applied for the remediation of degraded areas with local re-vegetation. © 2011 WIT Press.

Towards criterion validity in classroom language analysis: methodological constraints of metadiscourse and inter-rater agreement

This paper reports on a process to validate a revised version of a system for coding classroom discourse in foreign language lessons, a context in which the dual role of language (as content and means of communication) and the speakers' specific pedagogical aims lead to a certain degree of ambiguity in language analysis. The language used by teachers and students has been extensively studied, and a framework of concepts concerning classroom discourse well-established. Models for coding classroom language need, however, to be revised when they are applied to specific research contexts. The application and revision of an initial framework can lead to the development of earlier models, and to the re-definition of previously established categories of analysis that have to be validated. The procedures followed to validate a coding system are related here as guidelines for conducting research under similar circumstances. The advantages of using instruments that incorporate two types of data, that is, quantitative measures and qualitative information from raters' metadiscourse, are discussed, and it is suggested that such procedure can contribute to the process of validation itself, towards attaining reliability of research results, as well as indicate some constraints of the adopted research methodology.

Comparative anatomy of reproductive structures in Cyclanthaceae (Pandanales)

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Biological studies of puccina species using germinatelia

Despite the importance of plant pathogens belonging to the Order Pucciniales (=Uredinales), popularly called rusts, certain peculiarities of its biology is poorly known, mainly due to the difficulty of growing them in culture media and also by the lack of appropriate methodologies for the development of research. Therefore, this study was to verify the efficiency of apparatus called germinatelia to obtain data about the basidiospores production biology of different Pucciniales species. Were used in the study Puccinia pampeana, P. psidii, P. pelargonii-zonalis, P. arachidis, P. mogiphanis, P. emiliae, P. hetereospora, P. malvacearum and P. cnici-oleracei. The use of germinatelia have revealed high basidiospores production for a period up to 5 months at temperatures between 12 degrees and 21 degrees C. Furthermore, in P. malvacearum was possible to record the germination by repetition (survival strategy) in 4.5% of basidiospores produced. All species were favored to mild temperatures. These results therefore demonstrate that the use of germinatelios is efficient, assisting in obtaining data about the biology and cycles of different Puccinia species, enabling better understanding of these pathogens, resulting in management and control measures most appropriate/accurate.

Ethanol production by Zymomonas mobilis during sucrose fermentation: Optimization of culture conditions using factorial design

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Anther wall development, microsporogenesis, and microgametogenesis in abolboda and orectanthe: contributions to the embryology of xyridaceae (poales)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Colleters on the inflorescence axis of croton glandulosus (euphorbiaceae): structural and functional characterization

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Developmental Morphology of a Dimorphic Grass Inflorescence: The Brazilian Bamboo Eremitis (Poaceae)

Premise of research.The highly specialized grass inflorescence varies with respect to phyllotaxis, with the reproductive meristem forming primary lateral branches that are either spirally arranged or distichous. The Brazilian bamboo Eremitis is highly unusual in that it has a dimorphic inflorescence, typically composed of an apical gynecandrous whorl of both male and female spikelets and basal whorls of male spikelets. Although not closely related to them, Eremitis shares some structural similarities with some early-divergent grasses.Methodology.We use SEM and LM to describe the development of the reproductive structures of Eremitis to clarify our understanding of the highly specialized grass inflorescence and flower.Pivotal results.Developmental studies show that the inflorescence of Eremitis is actually partially whorled and partially distichous. The apical whorl is abortive. The female spikelet is not terminal on the axis, in contrast with the majority of grasses. All the male spikelets are distichously attached to the inflorescence axis and separated into groups. There is a hollow style with two vascular bundles.Conclusions.The strong morphological similarities between Eremitis and some early-divergent grasses are here supplemented by several anatomical similarities, perhaps due to a shared pollination syndrome.

Improving business innovation and research through the application of neuromarketing with ethics: a framework

The objective of this paper is to analyse and to discuss the ethical issues in the field of research known as neuromarketing, a tool used to improve innovation in companies. It uses techniques available to neuroscientists, both newer and more sophisticated ones along with traditional ones, but now for new purposes. From the beginning, this new area has evoked discussions about ethical aspects related to the results presented. Despite the unrestricted controversy surrounding the theme, few studies have discussed ethical issues involved in this line of research in a pragmatic manner. In this sense, this paper seeks to analyse and discuss ethical issues in neuromarketing research through a literature review and the proposal for a framework of ethical mapping. This framework revealed the ethical implications that would be most prominent in certain research situations: the purpose of utilising neuromarketing techniques, organisational type, and industrial sector, among others.