Determinação da composição e da octanagem de gasolinas C por espectroscopia de RMN 'INTPOT.1 H' e métodos quimiométricos

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Desenvolvimento e validação de método analítico para determinação de caprolactama em simulantes de alimentos: estudo de migração e efeito da irradiação

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Composição química e toxicidade de óleos essenciais para o pulgão-verde Schizaphis graminum (Rondani, 1852)

Este trabalho teve como objetivo identificar e quantificar os constituintes dos óleos essenciais de Illicum verum, Ageratum conyzoides, Piper hispidinervum e Ocotea odorifera, bem como avaliar a toxicidade para o pulgão-verde Schizaphis graminum. A qualificação dos constituintes foi realizada por meio de um cromatógrafo gasoso + espectrômetro de massas, e a quantificação, por um cromatógrafo gasoso + detector de ionização de chama, ambos com uma coluna DB5. O método de hidrodestilação promoveu um rendimento (p/p) de 3,81% para I. verum, 0,46% para A. conyzoides, 2,85% para P. hispidinervum e 0,68% para O. odorífera. Já os componentes majoritários foram: precoceno (87,0%) e (E)-cariofileno (7,1%) para A. conyzoides; (E)-anetol (90,4%), limoneno (2,6%) e metil-chavicol (1,3%) para I. verum; metil-eugenol (81,2%) e safrol (10,6%) para Ocotea odorífera; e safrol (82,5%) e α-terpinoleno (13,4%) para P. hispidinervum. Pelos testes de toxicidade aguda (24 horas) com folhas de sorgo ou papel-filtro contaminados, verificou-se que o óleo de A. conyzoides foi o mais tóxico para o pulgão, com CL50 de 7,13 e 7,08 µL óleo/cm2 respectivamente, seguido por O. odorifera com CL50 de 11,80 e 103,00 µL óleo/cm2 respectivamente; I. verum de 51,80 µL óleo/cm2 em ambos os substratos; e o menos tóxico foi o óleo essencial de P. hispidinervum, com CL50 de 62,50 e 143,00 µL óleo/cm2, respectivamente. Dessa maneira, sugere-se que o uso dos óleos essenciais pode representar uma nova ferramenta em programas de manejo integrado de pragas.

Potencial de produção de gás metano e dióxido de carbono in vitro dos ingredientes utilizados em dietas para ovinos

This study aimed to evaluate the potential of CH4 and CO2 in vitro production of soybean hulls, sunflower meal, corn, citrus pulp and corn silage. Four rumen-cannulated sheep were fed diets containing the evaluated ingredients at 40:60 forage:concentrate ratio. The gases produced by samples incubation were measured by injection into a gas chromatograph equipped with flame ionization detector. The experimental design was completely randomized with repeated measures, with three replicates for each evaluated food at four different periods. Under the experimental conditions, we verified different potential gas production among the ingredients. The citrus pulp meal was the ingredient with the greatest potential for CO2production. Corn silage and soybean hulls showed the greatest potential while citrus pulp and sunflower meal showed the least potential for CH4 production, when expressed in mL/g of degraded dry matter; therefore, they can be considered, among the evaluated ingredients, those with the lowest environmental impact.

The Use of Headspace Solid-Phase Microextraction (HS-SPME) to Assess the Quality and Stability of Fruit Products: An Example Using Red Mombin Pulp (Spondias purpurea L.)

The present study aimed to evaluate the volatiles profile of red mombin (Spondias purpurea) pulp and its powder produced by spray-drying (SD) as an example to show utility of headspace solid-phase microextraction (HS-SPME) in the analysis of parameters such as the quality and stability of fruit products. Volatiles profiles of the pulp were identified by gas chromatography-mass spectrometry (GC-MS), quantified by gas chromatography-flame ionization detector (GC-FID) and compared to the profile of the powder stored at 0, 60 and 120 days in plastic (PP) or laminated packages (LP). The results showed that the technique was able to identify 36 compounds in the red mombin pulp, 17 out of which have been described for the first time in this fruit, showing that red mombin fresh pulp appears to be unique in terms of volatiles composition. However, only 24 compounds were detected in the powder. This decrease is highly correlated (r(2) = 0.99), at least for the majority of compounds, to the degree of volatility of compounds. Furthermore, the powder stored in PP or LP showed no statistical differences in the amounts of its components for a period of 120 days of storage. Finally, this work shows how HS-SPME analysis can be a valuable tool to assess the quality and stability of fruit products.

Quantificação de carbamato de etila em vinhos

The ethyl carbamate is a compound present in most foods yeast-distillates; due to its carcinogenic potential, national legislation has established a limit of 0.150 µg / mL for spirits, so the values above the same, pose a threat to both public health as well for the economic sector by preventing the export of these products. The aim of this work is to provide the optimization of an analytical method employing the technique of gas chromatography equipped with flame ionization detector (FID) to determine the concentration levels of ethyl carbamate in some samples of wine. The use of ethyl acetate as solvent employed in the extraction, the ethyl carbamate present in wine samples proved to be suitable, where Recoveries were between 97.6 to 103.3% (m / m), with a standard deviation for between 0.56 to 3.50%. The concentrations of ethyl carbamate in particular wine samples vary between 3.22 µg / ml and 3.80 µg / mL, with a mean of 3.48 µg / mL. These valuesare all above the limit set by law. Thus, the results indicate the need for changes in the process of wine production, in order to control the levels of the substance

Ethanol production by Zymomonas mobilis during sucrose fermentation: Optimization of culture conditions using factorial design

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Bioconversion of Cellulose to Hydrogen by dark fermentation

Hydrogen is known as a clean energy resource. The biological production of hydrogen has been attracting attention as an environmentally friendly processs that does not consume fossil fuels. Cellulosic plant and waste materials are potential resources for fermentative hydrogen production. Cellulose is a linear biopolymer of glucose molecules, connected by β-1,4-glycosidic bonds. Enzymatic hydrolysis of cellulose requires the presence of cellulase. The present study aimed to investigate the efficiency of acid pretreatment on ruminal fluid in order to enrich H2 producing bacteria consortia to enhance biohydrogen rate and substrate removal efficiency. In this study, fermentative hydrogen producers were enriched on cellulose (2g/L) in a modificated Del Nery medium (DNM) at 37ºC and initial pH 7.0 using rumen fluid (10% v/v) as inoculum. To increase the hydrogen production it was added cellulose (10mL) to the medium. The gas products (mainly H2 and CO2) was analyzed by gas chromatography (Shimadzu GC 2010) using a thermal conductivity detector. The volatile fatty acids and ethanol were also detected by GC using a flame ionization detector. Cellulose degradation was quantified by using the phenolsulfuric acid method. Analysis showed that the biogas produced from the anaerobic fermentation contained only hydrogen and carbon dioxide, without detectable methane after acid pretreatment test. On DNM the hydrogen production started with 4 h (5,3 x 105 mmol H2/L) of incubation, and the maximum H2 concentration was observed with 34 h (7,1 x 106 mmol H2/L) of incubation. During the process, it was observed a predominance of acetic acid and butyric acid as well as a low production of acetone, ethanol and nbutanol in all experimental phases. Butyrate accounted for more than 77% of total. As a result of the accumulation of volatile fatty acids (VFAs), the pH value in anaerobic digestion system was reduced to 4,0. On microscopy analyses there were observed rods with endospores. The batch anaerobic fermentation assays performed on anaerobic mixed inoculum from rumen fluid demonstrated the feasibility of H2 generation utilizing cellulose as substrate. Based on the results, it can be concluded that the acid treatment was efficient to inhibit the methanogenic archaea cells present in rumen fluid. The rumen fluid cells present a potential route in converting renewable biomass such as cellulose into hydrogen energy.

Chemical Composition of Lipids Present in Cat and Dog Oocyte by Matrix-Assisted Desorption Ionization Mass Spectrometry (MALDI- MS)

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Thermal analysis of an enriched flame incinerator for aqueous residues

The use of oxygen to enrich the combustion air can be an attractive technique to increase capacity of an incinerator originally designed to operate with air, If incinerator parameters such as operation temperature, turbulence level and residence time are fixed for a certain fuel supply rate, it is possible to increase the residue consumption rate using enriched air. This paper presents the thermal analysis for operation with enriched air of an aqueous residue experimental incinerator. The auxiliary fuel was diesel oil. The theoretical results showed that there is a considerable increase in the incineration ratio up to approximately 50% of O-2 in the oxidiser. The tendency was confirmed experimentally. Thermal analysis was demonstrated to be an important tool to predict possible incinerator capacity increase. (C) 2005 Published by Elsevier Ltd.

Properties of DLC films deposited by an oxyacetylene flame

Diamond-like carbon (DLC) films were obtained by spinning a tungsten carbide substrate at a high speed using an oxyacetylene flame. The films deposited at a typical experimental condition of substrate temperature of 810 degrees C, rotation of 600 rpm and 3 h deposition time, exhibited an uniform, very smooth, hard and glassy surface covering the entire exposed face of the substrate. These films were identified as DLC by their characteristic broad Raman spectra centered at 1554 cm(-1) and micro-Vicker's hardness > 3400 kg mm(-2). For substrate temperatures < 800 degrees C the film started losing the uniform glassy surface and the hardness deteriorated. For temperatures > 950 degrees C the film was still hard and shiny, but black in color. DLC films were also obtained in a wide range of speeds of rotation (300-750 rpm), as long as the temperature remained close to 850 degrees C. (C) 1999 Elsevier B.V. S.A. All rights reserved.

Application of cellulose modified with p-aminobenzoic groups in preconcentration system for determination of Cu, Fe, Ni, and Zn in fuel ethanol samples by flame atomic absorption spectrometry

Cellulose chemically modified with p-aminobenzoic groups, abbreviated as Cel-PAB, was used for preconcentration of copper, iron, nickel, and zinc from ethanol fuel, normally used in Brazil as engine fuel. The surface characteristics and the surface area of the cellulose were obtained before and after chemical modification using FT-IR, elemental analysis, and surface area analysis (B.E.T.). The retention and recovery of the analyte elements were studied by applying batch and column techniques.

Flame AAS determination of metal ions in fuel ethanol after preconcentration on acid carboxymethylcellulose (CMCH)

This paper describes the preparation of acid carboxymethylcellulose (CMCH), and the results of a study on the adsorption and preconcentration (using batch and flow-through column methods) of Cd(II), Cu(II), Cr(III), Fe(III), Ni(II) and Zn(II) in ethanol medium. The adsorption capacities for each metallic ion were (in mmol g(-1)) Cd(II) = 0.92; Cu(II) = 1.45; Cr(III) = 1.70; Fe(III) = 1.60; Ni(II) = 1.30; and Zn(II) = 1.10. By means of the flow-through method, a recovery of ca. 100% of the metallic ions adsorbed in a column packed with 2 g of CMCH was found when 5.0 mL of 1.0 mol L-1 hydrochloric acid were used as eluent. An enrichment factor of 20 (100 mt solution containing 50 mu g L-1 of the metallic ions, concentrated to 5.0 mt) was obtained by this preconcentration procedure. The sorption-desorption procedure applied allowed the development of a preconcentration and Flame AAS quantification method of metallic ions in fuel ethanol at trace levels.

Determination of metal ions in natural waters by flame-AAS after preconcentration on a 5-amino-1,3,4-thiadiazole-2-thiol modified silica gel.

5-amino-1,3,4-thiadiazole-2-thiol groups attached on a silica gel surface have been used for adsorption of Cd(II), Co(II), Cu(II), Fe(III), Ni(II), Pb(II) and Zn(II) from aqueous solutions. The adsorption capacities for each metal ion were (in mmol.g(-1)): Cd(II)= 0.35, Co(II)= 0.10, Cu(II)= 0.15, Fe(III)= 0.20, Hg(Il)= 0.46, Ni(II)= 0.16, Pb(II)= 0.13 and Zn(II)= 0.15. The modified silica gel was applied in the preconcentration and quantification of trace level metal ions present in water samples (river, and bog water).