Platinum Group Minerals in Eastern Brazil GEOLOGY AND OCCURRENCES IN CHROMITITE AND PLACERS

Brazil does not have working platinum mines, nor even large reserves of the platinum metals, but there is platinum in Brazil. In this paper, four massifs (mafic/ultramafic complexes) in eastern Brazil, in the states of Minas Gerais and Ceara, where platinum is found will be described. Three of these massifs contain concentrations of platinum group minerals or platinum group elements, and gold, associated with the chromitite rock found there. In the fourth massif, in Minas Gerais State, the platinum group elements are found in alluvial deposits at the Bom Sucesso occurrence. This placer is currently being studied.

Oxidative dissolution of research-grade minerals by Thiobacillus ferrooxidans and Thiobacillus thiooxidans

Solution- and solid-phase changes associated with galena (PbS) and sphalerite (ZnS) oxidation by T. ferrooxidans and T. thiooxidans, were determined. In experiments with galena, anglesite (PbSO4) was detected as a solid-phase product in biotic and abiotic experiments. In T. ferrooxidans cultures supplemented with FeSO4, jarosite [MFe3 (SO4)(2) (OH)(6)] was also detected as a new solid phase product, whereas SO was not detected in the residues. In sphalerite experiments, minor amounts of SO accumulated in FeSO4-amended sphalerite media with or without T. ferrooxidans or T. thiooxidans. Jarosite was only detected in T. ferrooxidans culture with FeSO4. By comparison with T. thiooxidans, T. ferrooxidans was more efficient in the oxidation of galena and sphalerite.

Preparation and thermal behavior of mixture of basic carbonate and 4-dimethylaminocinnamylidenepyruvate with lanthanides (III) and yttrium (III) in the solid state

Solid Ln-OKCO3-DMCP compounds, where Ln represents lanthanides (III) and yttrium (III) ions and DMCP is the anion 4-dimethyiaminocinnamylidenepyruvate, have been prepared. Thermogravimetry, derivative thermogravimetry (TG, DTG), differential scanning calorimetry (DSC), X-ray diffraction powder patterns and elemental analysis have been used to characterize the compounds. The thermal stability as well as the thermal decomposition of these compounds were studied using an alumina crucible in an air atmosphere.

Red and blue emissions of europium doped gadolinium silicate from porous silica matrix and hydroxide carbonate with spherical shaped particles

In this work, Eu(III) and Eu(II) doped gadolinium silicates has been obtained as compact tubes starting from spherical gadolinium hydroxide carbonate using the pores of silica matrix as support and its surface as reagent. Eu(III) doped gadolinium silicate with hexagonal phase shows an interesting visible shifted charge transfer band when compared to disilicate with orthorhombic phase that was also obtained. Eu(II) gadolinium silicate has been prepared using CO atmosphere presenting an intense blue emission. The divalent europium system shows a potential application as an UV-blue converter. The samples were characterized by scanning electron microscopy (SEM), X-ray powder diffractometry (XRD) and photoluminescence spectroscopy. (C) 2002 Elsevier B.V. B.V. All rights reserved.

Influence of synthesis conditions on carbonate entrapment in perovskite SrSnO(3)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Morphological evolution of zinc oxide originating from zinc hydroxide carbonate

Zinc oxide can be obtained by thermal decomposition of hydrozincite, a topochemical reaction. This work reports the relation between zinc oxide morphology and the precursor zinc hydroxide carbonate precipitation time. The morphological evolution was monitored by SEM, IR and XRD. Zinc oxide obtained from initially precipitated hydrozincite consists of porous spherical aggregates and shows a single Zn-O IR vibrational band. At longer periods of precipitation time the aggregates were transformed into spherulitic-shaped zinc oxide particles showing the Zn-O split vibrational band. X-ray patterns show that the hexagonal zinc oxide phase is substantially increased as a function of hydrozincite precipitation time. © 1997 Elsevier Science S.A.

Minerals in the nutrition of extremely low birth weight infants

Objective: To review the literature on the role of calcium, phosphorus and trace elements in the nutrition of extremely low birth weight infants, considering their importance for metabolism, bone mineralization and as dietary components. Sources of data: MEDLINE, the Cochrane Database of Systematic Reviews and books on nutrition were searched between 1994 and 2004. Original research studies and reviews were selected. Summary of the findings: Extremely preterm infants are frequently growth-restricted at hospital discharge as a consequence of difficulties in the provision of adequate nutrition. The long-term effects of this growth restriction need to be determined. There is a paucity of studies about the role of minerals, especially micronutrients, in the nutrition of extremely preterm infants. The principal focus of this review was on calcium and phosphorus metabolism, bone mineralization and parenteral and enteral supplementation. A critical evaluation of post-discharge nutrition and its influence upon growth and bone mineralization was presented. Selenium and zinc requirements and the role of selenium as an antioxidant with possible effects on free radical diseases of the preterm infant were discussed. Conclusions: Extremely preterm infants have low mineral reserves and, as a consequence, may have deficiencies in the postnatal period if they do not receive parenteral or enteral supplementation. More studies are needed to elucidate the actual requirements and the appropriate supplementation of micronutrients. There are controversies about the outcome and the influence of post-discharge nutrition on bone disease of prematurity. Copyright © 2005 by Sociedade Brasileira de Pediatria.

Thermodynamic analysis of direct steam reforming of ethanol in molten carbonate fuel cell

Fuel cell as MCFC (molten carbonate fuel cell) operate at high temperatures, and due to this issue, cogeneration processes may be performed, sending heat for own process or other purposes as steam generation in an industry. The use of ethanol for this purpose is one of the best options because this is a renewable and less environmentally offensive fuel, and cheaper than oil-derived hydrocarbons (in the case of Brazil). In the same country, because of technical, environmental and economic advantages, the use of ethanol by steam reforming process have been the most investigated process. The objective of this study is to show a thermodynamic analysis of steam reforming of ethanol, to determine the best thermodynamic conditions where are produced the highest volumes of products, making possible a higher production of energy, that is, a most-efficient use of resources. To attain this objective, mass and energy balances are performed. Equilibrium constants and advance degrees are calculated to get the best thermodynamic conditions to attain higher reforming efficiency and, hence, higher electric efficiency, using the Nernst equation. The advance degree of reforming increases when the operation temperature also increases and when the operation pressure decreases. But at atmospheric pressure (1 atm), the advance degree tends to the stability in temperatures above 700°C, that is, the volume of supplemental production of reforming products is very small for the high use of energy resources necessary. Reactants and products of the steam-reforming of ethanol that weren't used may be used for the reforming. The use of non-used ethanol is also suggested for heating of reactants before reforming. The results show the behavior of MCFC. The current density, at same tension, is higher at 700°C than other studied temperatures as 600 and 650°C. This fact occurs due to smaller use of hydrogen at lower temperatures that varies between 46.8 and 58.9% in temperatures between 600 and 700°C. The higher calculated current density is 280 mA/cm 2. The power density increases when the volume of ethanol to be used also increases due to higher production of hydrogen. The highest produced power at 190 mW/cm 2 is 99.8, 109.8 and 113.7 mW/cm2 for 873, 923 and 973K, respectively. The thermodynamic efficiency has the objective to show the connection among operational conditions and energetic factors, which are some parameters that describes a process of internal steam reforming of ethanol.

Mechanisms of action of fluoride for caries control

Fluoride was introduced into dentistry over 70 years ago, and it is now recognized as the main factor responsible for the dramatic decline in caries prevalence that has been observed worldwide. However, excessive fluoride intake during the period of tooth development can cause dental fluorosis. In order that the maximum benefits of fluoride for caries control can be achieved with the minimum risk of side effects, it is necessary to have a profound understanding of the mechanisms by which fluoride promotes caries control. In the 1980s, it was established that fluoride controls caries mainly through its topical effect. Fluoride present in low, sustained concentrations (sub-ppm range) in the oral fluids during an acidic challenge is able to absorb to the surface of the apatite crystals, inhibiting demineralization. When the pH is re-established, traces of fluoride in solution will make it highly supersaturated with respect to fluorhydroxyapatite, which will speed up the process of remineralization. The mineral formed under the nucleating action of the partially dissolved minerals will then preferentially include fluoride and exclude carbonate, rendering the enamel more resistant to future acidic challenges. Topical fluoride can also provide antimicrobial action. Fluoride concentrations as found in dental plaque have biological activity on critical virulence factors of S. mutans in vitro, such as acid production and glucan synthesis, but the in vivo implications of this are still not clear. Evidence also supports fluoride's systemic mechanism of caries inhibition in pit and fissure surfaces of permanent first molars when it is incorporated into these teeth pre-eruptively. © 2011 S. Karger AG, Basel.

Glass-ceramic material from the SiO 2-Al 2O 3-CaO system using sugar-cane bagasse ash (SCBA)

Brazil is the world's largest producer of alcohol and sugar from sugarcane. Currently, sugarcane bagasse is burned in boilers to produce steam and electrical energy, producing a huge volume of ash. The major component of the ash is SiO 2, and among the minor components there are some mineralizing agents or fluxing. Published works have shown the potential of transforming silicate-based residues into glass-ceramic products of great utility. This work reports the research results of SCBA use to produce glass-ceramics with wollastonite, rankinite and gehlenite as the major phases. These silicates have important applications as building industry materials, principally wollastonite, due to their special properties: high resistance to weathering, zero water absorption, and hardness among others. The glasses (frits) were prepared mixing ash, calcium carbonate and sodium or potassium carbonates as flux agents, in different concentrations. X-ray fluorescence was used to determine the chemical composition of the glasses and their crystallization was assessed by using thermal analysis (DTA/DSC/TGA) and X-ray diffraction. The crystallization kinetics was evaluated using the Kissinger method, giving activation energies ranging from 200 to 600 kJ/mol. © 2011 Ceramic Society of Japan.

Broiler breeder feeding programs and trace minerals on maternal antibody transfer and broiler humoral immune response

Breeder feed restriction may negatively affect broiler progeny immunity. Sources of trace minerals (TM) with higher bioavailability in breeder diets have been reported to enhance humoral and cellular immunity in broiler progeny. An experiment was conducted to examine the effects of breeder feeding programs and TM dietary sources on maternal antibody transfer and humoral immune response of progeny to a live vaccine against Newcastle disease virus (NDV). Cobb 500 breeders were fed according to 2 feed allocation programs, sigmoid late fast and sigmoid late slow, from 14 to 29 wk of age. From 56 to 62 wk of age, breeders were fed with either inorganic TM or an organic source (OTM) to replace 30% of Cu, Zn, and Mn. Progeny broilers were vaccinated intraocularly with La Sota NDV vaccine at 7 d of age. Blood samples were collected at hatching, 4, and 14 d postvaccination. Serum antibody levels against NDV were assessed by ELISA and cytokine expression by real time PCR. At hatching, late slow breeder progeny fed diets with 30% OTM had higher antibody titers as compared with progeny of breeders fed 100% inorganic TM. Similar results were observed 2 wk postvaccination. Breeder feeding programs and TM sources affected the expression level of IL-4 in NDV vaccinated broiler progeny. It was concluded that breeder feeding programs influenced humoral immune response to NDV vaccine in the broiler progeny, and 30% OTM may increase these responses. © 2013 Poultry Science Association, Inc.

Gênese dos corpos de sulfeto maciço hidrotermal e platinóides associados no depósito de Fortaleza de Minas (MG)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Estudo hidrogeoquímico da porção meridional do sistema aquífero Bauru no estado de São Paulo

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)