Stimuli-responsive controlled growth of mono- and bidimensional particles from basic zirconium sulfate hydrosols

A thermostimulated sol-gel transition in a system prepared by mixing a ZrOCl(2) acidified solution to a hot H(2)SO(4) aqueous solution was studied by dynamic theological measurements and quasi-elastic light scattering. The effect of temperature and of molar ratio R(S) = [Zr]/[SO(4)] on the gelation kinetics was analyzed using the mass fractal aggregate growth model. This study shows that the linear growth of aggregates occurs at the early period of transformation, while bidimensional growth occurs at the advanced stage. The bidimensional growth can be shifted toward monodimensional growth by decreasing the aggregation rate by controlling the temperature and/or molar ratio R(S). EXAFS and Raman results gave evidence that the linear chain growth is supported by covalent sulfate bonding between primary building blocks. At the advanced stage of aggregation, the assembly of linear chains through hydrogen bonding gave rise to the growth of bidimensional particles.

Stimulation of polygalacturonase production in an immobilized system by Aspergillus sp.: effect of pectin and glucose

The synthesis of polygalacturonases (PG) is known to be influenced by Aspergillus growth conditions, namely, environmental factors and pectin content in the cultivation medium containing a mixed carbon source. Optimal conditions were attained at a temperature of 30 A degrees C and an initial pH of 4.5. PG activity (3.29 and 2.48 U/mL) was determined after a two-day culture of Aspergillus sp. HC1 and Aspergillus sp. CC1, respectively, in a basic medium containing 2% citrus pectin as the sole carbon source. The addition of glucose (2% w/v) to the basic medium led to a 2-fold increase in PG production. However, enzyme synthesis was repressed when a higher concentration of glucose was used in the medium containing the mixed carbon source. Spores from the two fungi were immobilized in a 3% Ca-alginate system and the mechanical strength of the gel beads allowed the use of this process system 6-fold longer (288 h) than the free culture. In the Aspergillus sp. CC1 immobilized system, PG production increased nearly 10-fold in the medium with 2% glucose added (5.95 U/mL) in comparison to the medium without sugar (0.55 U/mL). The results demonstrate that a different response in activity was produced by free and entrapped spore systems. PG production remained approximately constant throughout the six 48 h cycles in the medium containing citrus pectin (2% w/v) as the sole carbon source.

Expert system for hot forging design

Planning hot forging processes is a time-consuming activity with high costs involved because of the trial-and-error iterative methods used to design dies and to choose equipment and process conditions. Some processes demand many months to produce forged parts with controlled shapes, dimensions and microstructure. This paper shows how expert systems can help engineers to reduce the time needed to design precision forged parts and dies from machined parts. The software ADHFD interfacing MS Visual Basic v.5.0 and SolidEdge v.3.0 was used to design flashless hot forged gears, chosen from families of gears. © 1998 Elsevier Science S.A. All rights reserved.

Extended Hierarchical Censored Production Rules (EHCPRs) system: An approach toward generalized knowledge representation

One common problem in all basic techniques of knowledge representation is the handling of the trade-off between precision of inferences and resource constraints, such as time and memory. Michalski and Winston (1986) suggested the Censored Production Rule (CPR) as an underlying representation and computational mechanism to enable logic based systems to exhibit variable precision in which certainty varies while specificity stays constant. As an extension of CPR, the Hierarchical Censored Production Rules (HCPRs) system of knowledge representation, proposed by Bharadwaj & Jain (1992), exhibits both variable certainty as well as variable specificity and offers mechanisms for handling the trade-off between the two. An HCPR has the form: Decision If(preconditions) Unless(censor) Generality(general_information) Specificity(specific_information). As an attempt towards evolving a generalized knowledge representation, an Extended Hierarchical Censored Production Rules (EHCPRs) system is suggested in this paper. With the inclusion of new operators, an Extended Hierarchical Censored Production Rule (EHCPR) takes the general form: Concept If (Preconditions) Unless (Exceptions) Generality (General-Concept) Specificity (Specific Concepts) Has_part (default: structural-parts) Has_property (default:characteristic-properties) Has_instance (instances). How semantic networks and frames are represented in terms of an EHCPRs is shown. Multiple inheritance, inheritance with and without cancellation, recognition with partial match, and a few default logic problems are shown to be tackled efficiently in the proposed system.

The caste system of Coptotermes gestroi (Isoptera: Rhinotermitidae)

Coptotermes gestroi is an oriental species introduced to Brazil and considered, in the São Paulo State area, one of the most economically important pests. Although there are a few works concerning the basic biology of this species, its post-embryonic development has been poorly studied. The aim of the present research was to study the post-embryonic development of C. gestroi for a better knowledge of the caste system in this termite. The post-embryonic development of C. gestroi starts with two larval instars of whitish appearance and different sizes. A separation of the neutral and imaginal developmental pathways occurs following the second larval instar. The second-instar larva originates alates after six molts. The worker caste presents five instars and also develops from the second larval instar. Soldiers develop from younger workers in laboratory colonies and from older workers in field colonies.

Automatic system for thermal damage detection in manufacturing process with Internet monitoring

This work involved the development of a smart system dedicated to surface burning detection in the grinding process through constant monitoring of the process by acoustic emission and electrical power signals. A program in Visual Basic® for Windows® was developed, which collects the signals through an analog-digital converter and further processes them using burning detection algorithms already known. Three other parameters are proposed here and a comparative study carried out. When burning occurs, the newly developed software program sends a control signal warning the operator or interrupting the process, and delivers process information via the Internet. Parallel to this, the user can also interfere in the process via Internet, changing parameters and/or monitoring the grinding process. The findings of a comparative study of the various parameters are also discussed here. Copyright © 2006 by ABCM.

Decentralized AC power flow for real-time multi-TSO power system operation

This paper adjusts decentralized OPF optimization to the AC power flow problem in power systems with interconnected areas operated by diferent transmission system operators (TSO). The proposed methodology allows finding the operation point of a particular area without explicit knowledge of network data of the other interconnected areas, being only necessary to exchange border information related to the tie-lines between areas. The methodology is based on the decomposition of the first-order optimality conditions of the AC power flow, which is formulated as a nonlinear programming problem. To allow better visualization of the concept of independent operation of each TSO, an artificial neural network have been used for computing border information of the interconnected TSOs. A multi-area Power Flow tool can be seen as a basic building block able to address a large number of problems under a multi-TSO competitive market philosophy. The IEEE RTS-96 power system is used in order to show the operation and effectiveness of the decentralized AC Power Flow. ©2010 IEEE.

Developing a system for down-hole seismic testing together with the CPTU

This paper presents a system for performing down-hole seismic test together with the piezocone test in order to determine the shear wave velocity (Vs) and for calculating the maximum shear modulus (Go); a basic parameter for analyzing the dynamic soil behavior and a reference value of the soil stiffness. The system components are described and tests results for checking the geophone response are also presented, both before and after installation into the probe. The system was used in down-hole tests carried out at three experimental research sites located in the interior of Sao Paulo State, Brazil, where in situ seismic test results are available. The Vs values measured in down-hole tests carried out with this system were consistent with those determined in cross-hole tests and with a commercial seismic piezocone, which enabled to validate the developed system.

Risk factors for low birth weight in Botucatu city, SP state, Brazil: A study conducted in the public health system from 2004 to 2008

Background: Low birth weight (LBW), defined as birth weight less than 2500 g, has a complex etiology and may be a result of premature interruption of pregnancy or intrauterine growth restriction. The objective of this study was to provide information on determinants of LBW and contribute to the understanding of the problem in Brazil. Methods. A case-control study was conducted in Botucatu city, SP state, Brazil. The study population consisted of 2 groups with 860 newborns in each group as follows: low weight newborns (LWNB) and a control group (weight ≤ 2500 g). Secondary data from 2004 to 2008 were collected using the Live Birth Certificate (LBC) and records from medical charts of pregnant women in Basic Health Units (BHU) and in the Public University Hospital (UH). Variables were as follows: maternal socio-demographic characteristics, pregnancy and birth conditions including quality of prenatal care according to 3 criteria. They were based on parameters established by the Ministry of Health (MH), one of them, the modified Kessner Index. The multivariable analysis by logistic regression was used to evaluate the association between variables and LBW. Results: According to the analysis, the factors associated with LBW were as follows: prematurity (OR = 56.98, 95% CI 29.52-109.95), twin pregnancy (OR = 20.00, 95% CI 6.25-100.00), maternal smoking (OR = 2.12, 95% CI 1.33-3.45), maternal malnourishment (OR = 2.30, 95% CI 1.08-5.00), maternal obesity (OR = 2.30, 95% IC 1.18-4.48), weight gain during pregnancy less than 5 kg (OR = 2.63, 95% CI 1.35-5.00) and weight gain during pregnancy more than 15 kg (OR = 2.26, 95% CI 1.16-4.41). Adequacy of prenatal care visits adjusted to gestational age was less frequent in the LBW group than in the control group (68.7% vs. 80.5%, x 2 p < 0.001). According to the modified Kessner Index, 64.4% of prenatal visits in the LWNB group were adequate. Conclusion: LWNB are a quite heterogeneous group of infants concerning their determinants and prevention actions against LBW and the follow-up of these infants have also been very complex. Therefore, improvement in the quality of care provided should be given priority through concrete actions for prevention of LBW. © 2012 Fonseca et al; licensee BioMed Central Ltd.

A system for environmental monitoring of hydroelectric reservoirs in Brazil

Environmental monitoring of aquatic systems is an important tool to support policy makers and environmental managers' decisions. Long-term, continuous collection of environmental data is fundamental to the understanding of an aquatic system. This paper aims to present the integrated system for environmental monitoring (SIMA), a long-term temporal series system with a web-based archive for limnological and meteorological data. The following environmental parameters are measured by SIMA: chlorophyll-a (µgL-1), water surface temperature (ºC), water column temperature by a thermistor string (ºC), turbidity (NTU), pH, dissolved oxygen concentration (mg L-1), electric conductivity (µS cm-1), wind speed (ms-1) and direction (º), relative humidity (%), shortwave radiation (Wm-2) and barometric pressure (hPa). The data were collected in a preprogrammed time interval (1 hour) and were transmitted by satellite in quasi-real time for any user within 2500 km of the acquisition point. So far, 11 hydroelectric reservoirs are being monitored with the SIMA buoy. Basic statistics (mean and standard deviation) and an example of the temporal series of some parameters were displayed at a database with web access. However, sensor and satellite problems occurred due to the high data acquisition frequency. Sensors problems occurred due to the environmental characteristics of each aquatic system. Water quality sensors rapidly degrade in acidic waters, rendering the collected data invalid. Data is also rendered invalid when sensors become infested with periphyton. Problems occur with the satellites' reception of system data when satellites pass over the buoy antenna. However, the data transfer at some inland locations was not completed due to the satellite constellation position. Nevertheless, the integrated system of water quality and meteorological parameters is an important tool in understanding the aquatic system dynamic. It can also be used to create hydrodynamics models of the aquatic system to allow for the study of meteorological implications to the water body.

Highly Ordered TiO2 Nanotubes for Electrochemical Sensing of Hair Dye Basic Brown 17

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Physical activity, adiposity and hypertension among patients of public healthcare system

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

An Informatics Technical Note on Interaction of DNA - Graphene Chemical Sensor System as Reaction-Diffusion Wave-Based Computing System in Ionised Gaseous environments and their Applications Using Theoretical Studies and Scientific Computation Overview

The physics of plasmas encompasses basic problems from the universe and has assured us of promises in diverse applications to be implemented in a wider range of scientific and engineering domains, linked to most of the evolved and evolving fundamental problems. Substantial part of this domain could be described by R–D mechanisms involving two or more species (reaction–diffusion mechanisms). These could further account for the simultaneous non-linear effects of heating, diffusion and other related losses. We mention here that in laboratory scale experiments, a suitable combination of these processes is of vital importance and very much decisive to investigate and compute the net behaviour of plasmas under consideration. Plasmas are being used in the revolution of information processing, so we considered in this technical note a simple framework to discuss and pave the way for better formalisms and Informatics, dealing with diverse domains of science and technologies. The challenging and fascinating aspects of plasma physics is that it requires a great deal of insight in formulating the relevant design problems, which in turn require ingenuity and flexibility in choosing a particular set of mathematical (and/or experimental) tools to implement them.

Pension legislation for federal public servants in Brazil

This paper addresses the creation of pension funds for federal civil servants in Brazil, analyzing the existing legislation and regulation on this issue. To this end, it takes off based on the genesis of the Brazilian private pension plans, logging the emergence of private funds as well as the existence of various laws and constitutional amendments prior to Law 12.618/2012, which provided for the pension funds system for Brazilian federal public servants. It also identifies proponents and opponents to the Foundation for Pension Funds of Federal Civil Servants (FUNPRESP), signaling the discursive construction of the pension fund schemes as central character in contemporary welfare capitalism. Finally, presents controversial aspects of the new pension fund law developments in Brazil.

On an energy exchange process and appearance of chaos in a non-ideal portal frame dynamical system

In this paper, we consider non-ideal excitation devices such as DC motors with restrictenergy output capacity. When such motors are attached to structures which needexcitation power levels similar to the source power capacity, jump phenomena and theincrease in power required near resonance characterize the Sommerfeld Effect, actingas a sort of an energy sink. One of the problems often faced by designers of suchstructures is how to drive the system through resonance and avoid this energy sink.Our basic structural model is a simple portal frame driven by a num-ideal powersource-(NIPF). We also investigate the absorption of resonant vibrations (nonlinearand chaotic) by means of a nonlinear sub-structure known as a Nonlinear Energy Sink(NES). An energy exchange process between the NIPF and NES in the passagethrough resonance is investigated, as well the suppression of chaos.