286 resultados para PRODUTIVIDADE NO TRABALHO


Relevância:

30.00% 30.00%

Publicador:

Resumo:

A região de Registro é conhecida pelo baixo grau de desenvolvimento econômico, incluindo o setor agropecuário, o que a difere do restante do estado de São Paulo, não obstante, a região de Registro se destaca pela produção de banana. Neste projeto buscamos efetuar o cálculo da Produtividade Total dos Fatores (PTF), de forma a observar como se comporta a produtividade da agricultura daquela região nos últimos anos. Será feito o levantamento de dados da região para a construção dos indicadores da Produtividade Total dos Fatores (PTF) pelo índice de Törnqvist

Relevância:

30.00% 30.00%

Publicador:

Resumo:

O objetivo da seguinte pesquisa é analisar a diversidade e o desempenho do EDR (Escritório de Desenvolvimento Rural) da região de Ribeirão Preto nos períodos recentes, de 1995/1996 e 2007/2008, por meio do cálculo da PTF (Produtividade Total de Fatores), a partir dos dados obtidos no IEA (Instituto Econômico Agrícola) e no LUPA (Levantamento das Unidades de Produção Agropecuária)

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Pós-graduação em Agronomia (Ciência do Solo) - FCAV

Relevância:

30.00% 30.00%

Publicador:

Resumo:

The right choose of the cultivar influences greatly the potato yield. It is very important to know its agronomic behavior in the region where it is planted, as well its nutritional status, in order to supply the best package in the fertilization operations. In this work the tuber yield, the nutritional status of plants and the exportation of nutrients were studied in eighteen potato cultivars. A randomized blocks experimental design, with four replicates, was used. Mondial showed the highest total and commercial yields. The nutrient concentrations in fourth leaf of potato plant followed the decreasing order: N>K>Ca>P>Mg>B>Zn. The exportation of nutrients by the tubers followed the decreasing order: K>N>P>Mg>Ca. B and Zn had different behavior according the cultivars.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Corn cultivation is part of crop rotation used by irrigation farmers from the southwestern region of São Paulo state, Brazil, who use no-tillage soil management as a kind of sustainable use of soil. The effect of this conservative practice on physical and hydrical properties of the soil, root development and corn crop yield compared to the conventional management was the objective of this work. The experiment was held at the Buriti-Mirim Farm, Angatuba, SP, Brazil, using an irrigated area with a center pivot system and two types of soil management: conventional and no-tillage systems. Although the no-tillage management had higher soil density and less water availability, no significant difference was found for both management systems concerning soil resistance to penetration, root development and crop yield. In both systems of soil management, 90% of roots were concentrated in the first 0-20cm of soil layer.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

The objective of this study was to simulate the potential stem and sugar yield of sugar cane (Saccharum officinarum L.) in the Northeastern Brazil (Petrolina-PE and Teresina-PI) and analyze 4 varieties in different planting seasons in two environments: irrigated and rainfed cultivars. The model of simulation was DSSAT/CANEGRO (Decision Support System for Agrotechnology Transfer) and the four sugar cane varieties were as follows: RB86 7515, CTC 4, CTC 7 and CTC 20 (all in 1.5 year cycle). Analysis of variance was performed on the results and means were compared using the Tukey test with probability level at 5%. March is the recommended month for planting in Teresina, PI. In Petrolina, PE, rainfed planting is not advisable because of the extended water deficit all year long. In an irrigated environment, no difference was found concerning stem yield as a function of planting season, for all varieties in the study regions. The stem and sugar yields were always higher in irrigated environment as compared with those in rainfed environment in all municipalities and study varieties. The simulation model provided good estimate of stem and sugar yields as compared with experimental data in Teresina, PI.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Sewage sludge, as a soil fertilizer for crop production, has become a very important agricultural input since it is rich in nutrients, adds carbon to the soil and improves its chemical, physical, and biological characteristics. The aim of this study was to evaluate the effects of sewage sludge applied as a fertilizer for two consecutive years on sunflower plant growth and productivity. The experiment was conducted at the Experimental Farm of the College of Agriculture, a unit of the São Paulo State University (UNESP), in São Manuel, state of São Paulo, Brazil. The soil where the experiment was set is a Red Oxissol. The experiment consisted of 6 treatments with 5 replications. The experimental units were distributed in the field according to a randomized complete block design. ‘HELIO 251’ was the sunflower cultivar used in the experiment. The treatments were as follows: T0: check (no nitrogen applied); T1: conventional chemical fertilization; T2: 50% of the N dose from sewage sludge and 50% from a chemical fertilizer in side dress application; T3: 100% of the N dose from sewage sludge; T4: 150% of the N dose from sewage sludge; T5: 200% of the N dose from sewage sludge. The 150% of the N dose from sewage sludge treatment caused the plants to increase in height, in stem diameter, and in number of leaves per plant. The mixture in equal proportion of sewage sludge and a chemical fertilizer (treatment T2) resulted in an achene yield higher than that of the chemical fertilizer alone (treatment T1).

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Nitrogen, along with K, is the most limiting nutrient for sunflower productivity. The objective of this research work was to determine the best level of nitrogen in a fertilization formula for the cultivation of sunflower of the ‘HELIO – 251’ cultivar. The fertilization procedure was that recommended for the state of São Paulo for sunflower crop, except that, in each one of the treatments, N doses were of 50, 70, 90, 110, and 130 kg ha-1 . These treatments were distributed in the field according to a randomized complete block design with 4 replications. The N dose which resulted in the highest grain yield, highest oil content, and plant dry matter was of 100 kg ha-1 . Leaf N content and 1,000 grains weight increased with N doses.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

The objective of this research was to estimate the productivity (PRODUT) in sc/ha of coffee conilon through the technique of cokriging, using as covariate the production of humid coffee (PROD) in kg and compare the results with estimates obtained by kriging ordinary. The study was conducted in a commercial area of conilon coffee, Coffea canephora Pierre var. conilon, located in São Mateus Municipality, Espirito Santo State. For the field work was sampled the humid coffee production in a sampling grid irregular of 18.5 ha, 87 sampling points in the total. We also determined the production of dry coffee beans and coffee benefited 12% moisture, to obtain the PRODUT variable. After exploratory data analysis, which showed the correlation between variables in the order of 0.899, was performed variogram analysis. Were adjusted theoretical variograms to PROD and PRODUT and cross variogram between two variables. Finally we estimated the value of productivity, both by ordinary kriging as per cokriging. The validation of the estimation by cokriging not shows, however, significant gains in relation to validation by ordinary kriging.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

30.00% 30.00%

Publicador:

Resumo:

The purpose of the ergonomics is to generate adequate working conditions, by the correct use of equipment and appropriate anatomic positions. Ergonomics has become essential in the dentist's life while in the dental practice. The misuse of equipment in performing tasks or the wrong choice of equipment can initiate various problems like back pain, bursitis, repetitive strain injury (RSI), limitation of movement, and stress. Using a survey that was implemented with professional dentists linked to Paulista Association of Dental Surgeons (APCD) and graduate students at the Universidade Estadual Paulista (UNESP) in the São José dos Campos (SP) region, this study intends to propose an adequate research instrument to identify ergonomic critical factors of dental stools and their relation to productivity and satisfaction of dentists. The survey was developed with Google Docs Forms tool and was designed by analysis of other studies, existing surveys and other papers in this area. Relevant content were discussed and developed questions about the stool used by dentists in their activities, the occurrence of any problems arising from the exercise of their profession and the views of respondents about the influence of using the dental stool in these cited problems as well as their productivity. Due to obstacles encountered during the project, particularly bureaucratic issues, the survey cannot be implemented as needed, resulting in a test with reduced number of answers. The users' opinion varies according to the stool used, bringing some difficulty to generalizing the answers, but if treated properly, it is possible to obtain relevant conclusions about the main aspects perceived by users in relation to the stool and the needs pointed as most important