Seleção de genótipos de soja portadores ou não do gene RR por meio de análise multivariada e desempenho agronômico

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Influência da Diabetes Mellitus na movimentação ortodôntica associada a doença periodontal: avaliação histomorfométrica em ratos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Parâmetros oftálmicos em cachorro-do-mato (Cerdocyon thous, Linnaeus, 1766)

Pós-graduação em Cirurgia Veterinária - FCAV

Demarcação da madeira juvenil e adulta de Corymbia citriodora

This paper had the objective of determining the transition regions between the juvenile and mature wood of Corymbia citriodora (Eucalyptus citriodora) of 29 years of age from the Experimental Station of Forest Science (EECFA-LCF/ESALQ-USP), located in Anhembi, in the State of São Paulo. The regions of juvenile and mature wood were characterized through anatomical studies - axial fiber length - following the recommendations of the International Association of Wood Anatomists (1989) using disks at the DBH of the trees. The measurements of fiber length were made in equipment for acquisition, diagnosis and image analysis. Five slices were made for every centimeter, in the radial direction and six fiber lengths per slice were measured, producing 30 measurements per sample region. In the total, 1740 lengths of fiber were measured in three disks that were studied. Results indicate a trend of accentuated and linear increase for the length of fibers, from the pith to 11 cm of radial of about 79%. Between 12 cm and 19 cm of the radius, fibers length remained almost constant, and from that point on, the fiber length tended to slightly increase to the bark. It can be concluded that for these trees, at this height of sampling, when the tree has 29 years of age, the extension of the juvenile wood goes up to 52% of its radius.

Usinagem do alumínio da classe 6005 com uso de ferramenta cerâmica

The machining process is so much important in the economic world. Many machining parameters have been studied to maximize results, in terms of cost and lifetime. (decrease of cutting tool wear, improved surface finish, among others). The objective of this study is to evaluate the wear of a ceramic tool in the machining of the aluminum alloy 6005 A. The analysis of the wear of the cutting tools is very important due to its big impact on the final finishing of the piece as a whole. The evaluation took place in two stages, first it was done a detailed study of the literature of the whole machining process, where the study of the formation and swarf classification were among the most important steps in this phase. The second step consisted in the machining of the piece of aluminum 6005 A with a ceramic cutting tool constituded of aluminum oxide and magnesium oxide with silicon carbide impregnation. The swarf generated in this process was then photographed with a Zeiss optical microscope and analyzed for its size and shape. Through this comparison it was concluded that the swarf are generated shear swarfs, shaped like a tangled, fragmented and arcs connected, thus classifying the material as medium difficulty machining. Through the image analysis tool it was concluded that the parameter of lower wear was the: Vc = 500m / min, f = 0.10mm / rev and ap = 0.5mm